IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i9p3062-d799541.html
   My bibliography  Save this article

Experimental Research on the Dynamic Characteristics and Voltage Uniformity of a PEMFC Stack under Subzero Temperatures

Author

Listed:
  • Pengcheng Liu

    (School of Automotive Studies, Tongji University, Shanghai 201804, China)

  • Sichuan Xu

    (School of Automotive Studies, Tongji University, Shanghai 201804, China)

Abstract

The working life of a stack is basically determined by the behavior of its weakest monomer; therefore, during a dynamic loading process, high-voltage uniformity plays a key role in stack durability. This work experimentally investigated dynamic responses and voltage uniformity with different loading strategies from an initial state (open-circuit state) to a target current at subzero temperatures. The results presented that the maximum voltage coefficient variation Cv values, representing the relative standard deviation of the monomer voltage, increased from 19.75 to 35.65 and the voltage uniformity sharply decreased with the increase in loading sizes at the stack temperature of −4 °C. It was possible that this could result in the instability of the single cell voltage output and a voltage uniformity fluctuation with a high step loading amplitude. The voltage uniformity became worse as the stack temperature decreased from −2 °C to −8 °C, the voltage uniformity between single cells of the stack continued to deteriorate under a step current density of 0.15 A/cm 2 at a relatively low temperature of −8 °C. By comparing several constant loading rate strategies, it could be ascertained that reducing the loading rate was conducive to voltage uniformity in the whole investigated process. A comparison of the different loading rates indicated that the square increasing loading rate strategy is the best strategy among them and a Cv threshold of 5.5 can be obtained during the whole load process at a temperature of −4 °C, which might be a guideline and provide a reference in actual engineering applications for PEMFC dynamic loading responses.

Suggested Citation

  • Pengcheng Liu & Sichuan Xu, 2022. "Experimental Research on the Dynamic Characteristics and Voltage Uniformity of a PEMFC Stack under Subzero Temperatures," Energies, MDPI, vol. 15(9), pages 1-14, April.
  • Handle: RePEc:gam:jeners:v:15:y:2022:i:9:p:3062-:d:799541
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/9/3062/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/15/9/3062/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Baik, Kyung Don & Hong, Bo Ki & Kim, Min Soo, 2013. "Effects of operating parameters on hydrogen crossover rate through Nafion® membranes in polymer electrolyte membrane fuel cells," Renewable Energy, Elsevier, vol. 57(C), pages 234-239.
    2. Corbo, P. & Migliardini, F. & Veneri, O., 2009. "Dynamic behaviour of hydrogen fuel cells for automotive application," Renewable Energy, Elsevier, vol. 34(8), pages 1955-1961.
    3. Zhong, Di & Lin, Rui & Jiang, Zhenghua & Zhu, Yike & Liu, Dengchen & Cai, Xin & Chen, Liang, 2020. "Low temperature durability and consistency analysis of proton exchange membrane fuel cell stack based on comprehensive characterizations," Applied Energy, Elsevier, vol. 264(C).
    4. Lin, Rui & Zhu, Yike & Ni, Meng & Jiang, Zhenghua & Lou, Diming & Han, Lihang & Zhong, Di, 2019. "Consistency analysis of polymer electrolyte membrane fuel cell stack during cold start," Applied Energy, Elsevier, vol. 241(C), pages 420-432.
    5. Knorr, Florian & Sanchez, Daniel Garcia & Schirmer, Johannes & Gazdzicki, Pawel & Friedrich, K.A., 2019. "Methanol as antifreeze agent for cold start of automotive polymer electrolyte membrane fuel cells," Applied Energy, Elsevier, vol. 238(C), pages 1-10.
    6. Amamou, A. & Kandidayeni, M. & Boulon, L. & Kelouwani, S., 2018. "Real time adaptive efficient cold start strategy for proton exchange membrane fuel cells," Applied Energy, Elsevier, vol. 216(C), pages 21-30.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Tao, Xingxiao & Sun, Kai & Chen, Rui & Li, Qifeng & Liu, Huaiyu & Zhang, Wenzhe & Che, Zhizhao & Wang, Tianyou, 2024. "Effect of gas diffusion layer parameters on cold start of PEMFCs with metal foam flow field," Applied Energy, Elsevier, vol. 364(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yang, Zirong & Jiao, Kui & Wu, Kangcheng & Shi, Weilong & Jiang, Shangfeng & Zhang, Longhai & Du, Qing, 2021. "Numerical investigations of assisted heating cold start strategies for proton exchange membrane fuel cell systems," Energy, Elsevier, vol. 222(C).
    2. Lin, Rui & Zhong, Di & Lan, Shunbo & Guo, Rong & Ma, Yunyang & Cai, Xin, 2021. "Experimental validation for enhancement of PEMFC cold start performance: Based on the optimization of micro porous layer," Applied Energy, Elsevier, vol. 300(C).
    3. Wu, Kangcheng & Du, Qing & Zu, Bingfeng & Wang, Yupeng & Cai, Jun & Gu, Xin & Xuan, Jin & Jiao, Kui, 2021. "Enabling real-time optimization of dynamic processes of proton exchange membrane fuel cell: Data-driven approach with semi-recurrent sliding window method," Applied Energy, Elsevier, vol. 303(C).
    4. Li, Linjun & Wang, Shixue & Yue, Like & Wang, Guozhuo, 2019. "Cold-start method for proton-exchange membrane fuel cells based on locally heating the cathode," Applied Energy, Elsevier, vol. 254(C).
    5. Yang, Liu & Cao, Chenxi & Gan, Quanquan & Pei, Hao & Zhang, Qi & Li, Ping, 2022. "Revealing failure modes and effect of catalyst layer properties for PEM fuel cell cold start using an agglomerate model," Applied Energy, Elsevier, vol. 312(C).
    6. Montaner Ríos, G. & Schirmer, J. & Gentner, C. & Kallo, J., 2020. "Efficient thermal management strategies for cold starts of a proton exchange membrane fuel cell system," Applied Energy, Elsevier, vol. 279(C).
    7. Pan, Weitong & Li, Ping & Gan, Quanquan & Chen, Xueli & Wang, Fuchen & Dai, Gance, 2020. "Thermal stability analysis of cold start processes in PEM fuel cells," Applied Energy, Elsevier, vol. 261(C).
    8. Chunjuan Shen & Sichuan Xu & Lei Pan & Yuan Gao, 2021. "A High-Efficiency Cooperative Control Strategy of Active and Passive Heating for a Proton Exchange Membrane Fuel Cell," Energies, MDPI, vol. 14(21), pages 1-11, November.
    9. Zhang, Zhuo & Wang, Qi-yao & Bai, Fan & Chen, Li & Tao, Wen-quan, 2023. "Performance simulation and key parameters in-plane distribution analysis of a commercial-size PEMFC," Energy, Elsevier, vol. 263(PC).
    10. Zhao, Chen & Wang, Fei & Wu, Xiaoyu, 2024. "Analysis and review on air-cooled open cathode proton exchange membrane fuel cells: Bibliometric, environmental adaptation and prospect," Renewable and Sustainable Energy Reviews, Elsevier, vol. 197(C).
    11. Bai, Xingying & Luo, Lizhong & Huang, Bi & Huang, Zhe & Jian, Qifei, 2021. "Flow characteristics analysis for multi-path hydrogen supply within proton exchange membrane fuel cell stack," Applied Energy, Elsevier, vol. 301(C).
    12. Li, Bing & Wan, Kechuang & Xie, Meng & Chu, Tiankuo & Wang, Xiaolei & Li, Xiang & Yang, Daijun & Ming, Pingwen & Zhang, Cunman, 2022. "Durability degradation mechanism and consistency analysis for proton exchange membrane fuel cell stack," Applied Energy, Elsevier, vol. 314(C).
    13. Chen, Dongfang & Pei, Pucheng & Ren, Peng & Song, Xin & Wang, He & Zhang, Lu & Wang, Mingkai, 2022. "Analytical methods for the effect of anode nitrogen concentration on performance and voltage consistency of proton exchange membrane fuel cell stack," Energy, Elsevier, vol. 258(C).
    14. Tao, Xingxiao & Sun, Kai & Chen, Rui & Li, Qifeng & Liu, Huaiyu & Zhang, Wenzhe & Che, Zhizhao & Wang, Tianyou, 2024. "Effect of gas diffusion layer parameters on cold start of PEMFCs with metal foam flow field," Applied Energy, Elsevier, vol. 364(C).
    15. Yanbo Yang & Tiancai Ma & Boyu Du & Weikang Lin & Naiyuan Yao, 2021. "Investigation on the Operating Conditions of Proton Exchange Membrane Fuel Cell Based on Constant Voltage Cold Start Mode," Energies, MDPI, vol. 14(3), pages 1-10, January.
    16. Lin, Rui & Zhu, Yike & Ni, Meng & Jiang, Zhenghua & Lou, Diming & Han, Lihang & Zhong, Di, 2019. "Consistency analysis of polymer electrolyte membrane fuel cell stack during cold start," Applied Energy, Elsevier, vol. 241(C), pages 420-432.
    17. Baik, Kyung Don & Hong, Bo Ki & Han, Kookil & Kim, Min Soo, 2014. "Effects of anisotropic bending stiffness of gas diffusion layers on the performance of polymer electrolyte membrane fuel cells with bipolar plates employing different channel depths," Renewable Energy, Elsevier, vol. 69(C), pages 356-364.
    18. Chang, Huawei & Cai, Fengyang & Yu, Xianxian & Duan, Chen & Chan, Siew Hwa & Tu, Zhengkai, 2023. "Experimental study on the thermal management of an open-cathode air-cooled proton exchange membrane fuel cell stack with ultra-thin metal bipolar plates," Energy, Elsevier, vol. 263(PA).
    19. Culubret, S. & Rubio, M.A. & Sanchez, D.G. & Urquia, A., 2024. "Performance uniformity analysis in polymer electrolyte fuel cell using long-term dynamic simulation," Applied Energy, Elsevier, vol. 365(C).
    20. Ren, Peng & Pei, Pucheng & Chen, Dongfang & Li, Yuehua & Wu, Ziyao & Zhang, Lu & Li, Zizhao & Wang, Mingkai & Wang, He & Wang, Bozheng & Wang, Xizhong, 2022. "Novel analytic method of membrane electrode assembly parameters for fuel cell consistency evaluation by micro-current excitation," Applied Energy, Elsevier, vol. 306(PB).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:9:p:3062-:d:799541. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.