IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2022i1p139-d1012638.html
   My bibliography  Save this article

The Impact of Fuel Injection Timing and Charge Dilution Rate on Low Temperature Combustion in a Compression Ignition Engine

Author

Listed:
  • Asish K. Sarangi

    (Department of Energy Science and Engineering, Indian Institute of Technology Bombay, Mumbai 400076, India)

  • Gordon P. McTaggart-Cowan

    (School of Sustainable Energy Engineering, Simon Fraser University, Surrey, BC V3T 0A3, Canada)

  • Colin P. Garner

    (School of Mechanical, Electrical and Manufacturing Engineering, Loughborough University, Loughborough LE11 3TU, UK)

Abstract

Using high charge dilution low temperature combustion (LTC) strategies in a diesel engine offers low emissions of nitrogen oxides (NOx). These strategies are limited to part-load conditions and involve high levels of charge dilution, typically achieved through the use of recirculated exhaust gases (EGR). The slow response of the gas handling system, compared to load demand and fuelling, can lead to conditions where dilution levels are higher or lower than expected, impacting emissions and combustion stability. This article reports on the sensitivity of high-dilution LTC to variations in EGR rate and fuel injection timing. Impacts on engine efficiency, combustion stability and emissions are assessed in a single-cylinder engine and compared to in-cylinder flame temperatures measured using a borescope-based two-colour pyrometer. The work focuses on low-load conditions (300 kPa gross indicated mean effective pressure) and includes an EGR sweep from conventional diesel mode to high-dilution LTC, and sensitivity studies investigating the effects of variations in charge dilution and fuel injection timing at the high-dilution LTC condition. Key findings from the study include that the peak flame temperature decreased from ~2580 K in conventional diesel combustion with no EGR to 1800 K in LTC with low-NOx, low-soot operation and an EGR rate of 57%. Increasing the EGR to 64% reduced flame temperatures to 1400 K but increased total hydrocarbon (THC) and carbon monoxide (CO) emissions by 30–50% and increased fuel consumption by 5–7%. Charge dilution was found to have a stronger effect on the combustion process than the diesel injection timing under these LTC conditions. Advancing fuel injection timings at increasing dilution kept combustion instability below 2.5%. Peak in-cylinder temperatures were maintained in the 2000–2100 K range, while THC and CO emissions were controlled by delaying the onset of bulk quenching. Very early injection (earlier than 24 °CA before top-dead-centre) resulted in spray impingement on the piston crown, resulting in degraded efficiency and higher emissions. The results of this study demonstrate the potential of fuel injection timing modification to accommodate variations in charge dilution rates while maintaining low NOx and PM emissions in a diesel engine using low-temperature combustion strategies at part loads.

Suggested Citation

  • Asish K. Sarangi & Gordon P. McTaggart-Cowan & Colin P. Garner, 2022. "The Impact of Fuel Injection Timing and Charge Dilution Rate on Low Temperature Combustion in a Compression Ignition Engine," Energies, MDPI, vol. 16(1), pages 1-21, December.
    • Handle: RePEc:gam:jeners:v:16:y:2022:i:1:p:139-:d:1012638
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/1/139/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/1/139/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Paykani, Amin & Garcia, Antonio & Shahbakhti, Mahdi & Rahnama, Pourya & Reitz, Rolf D., 2021. "Reactivity controlled compression ignition engine: Pathways towards commercial viability," Applied Energy, Elsevier, vol. 282(PA).
    2. Han, Sangwook & Kim, Jaeheun & Bae, Choongsik, 2014. "Effect of air–fuel mixing quality on characteristics of conventional and low temperature diesel combustion," Applied Energy, Elsevier, vol. 119(C), pages 454-466.
    3. Lee, Jeongwoo & Chu, Sanghyun & Lim, Donghyun & Jung, Hyunsung & Chi, Yohan & Min, Kyoungdoug, 2022. "Comparison of combustion and emission characteristics under single-fueled and dual-fueled conditions with premixed compression ignition," Energy, Elsevier, vol. 241(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Jan Verhaegh & Frank Kupper & Frank Willems, 2022. "Data-Driven Air-Fuel Path Control Design for Robust RCCI Engine Operation," Energies, MDPI, vol. 15(6), pages 1-25, March.
    2. Raul Payri & José M. García-Oliver & Victor Mendoza & Alberto Viera, 2020. "Analysis of the Influence of Diesel Spray Injection on the Ignition and Soot Formation in Multiple Injection Strategy," Energies, MDPI, vol. 13(13), pages 1-22, July.
    3. Leach, Felix & Ismail, Riyaz & Davy, Martin, 2018. "Engine-out emissions from a modern high speed diesel engine – The importance of Nozzle Tip Protrusion," Applied Energy, Elsevier, vol. 226(C), pages 340-352.
    4. Wang, Yifeng & Yao, Mingfa & Li, Tie & Zhang, Weijing & Zheng, Zunqing, 2016. "A parametric study for enabling reactivity controlled compression ignition (RCCI) operation in diesel engines at various engine loads," Applied Energy, Elsevier, vol. 175(C), pages 389-402.
    5. Xie, Bo & Peng, Qingguo & E, Jiaqiang & Tu, Yaojie & Wei, Jia & Tang, Shihao & Song, Yangyang & Fu, Guang, 2022. "Effects of CO addition and multi-factors optimization on hydrogen/air combustion characteristics and thermal performance based on grey relational analysis," Energy, Elsevier, vol. 255(C).
    6. Pachiannan, Tamilselvan & Zhong, Wenjun & Rajkumar, Sundararajan & He, Zhixia & Leng, Xianying & Wang, Qian, 2019. "A literature review of fuel effects on performance and emission characteristics of low-temperature combustion strategies," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    7. Shim, Euijoon & Park, Hyunwook & Bae, Choongsik, 2018. "Intake air strategy for low HC and CO emissions in dual-fuel (CNG-diesel) premixed charge compression ignition engine," Applied Energy, Elsevier, vol. 225(C), pages 1068-1077.
    8. Maarten Vlaswinkel & Frank Willems, 2024. "Data-Based In-Cylinder Pressure Model with Cyclic Variations for Combustion Control: An RCCI Engine Application," Energies, MDPI, vol. 17(8), pages 1-19, April.
    9. Du, Wei & Zhang, Qiankun & Zhang, Zheng & Lou, Juejue & Bao, Wenhua, 2018. "Effects of injection pressure on ignition and combustion characteristics of impinging diesel spray," Applied Energy, Elsevier, vol. 226(C), pages 1163-1168.
    10. Mansir, Ibrahim B. & Nemitallah, Medhat A. & Habib, Mohamed A. & Khalifa, Atia E., 2018. "Experimental and numerical investigation of flow field and oxy-methane combustion characteristics in a low-power porous-plate reactor," Energy, Elsevier, vol. 160(C), pages 783-795.
    11. Zhong, Wenjun & Pachiannan, Tamilselvan & Li, Zilong & Qian, Yong & Zhang, Yanzhi & Wang, Qian & He, Zhixia & Lu, Xingcai, 2019. "Combustion and emission characteristics of gasoline/hydrogenated catalytic biodiesel blends in gasoline compression ignition engines under different loads of double injection strategies," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    12. Chehrmonavari, Hamed & Kakaee, Amirhasan & Hosseini, Seyed Ehsan & Desideri, Umberto & Tsatsaronis, George & Floerchinger, Gus & Braun, Robert & Paykani, Amin, 2023. "Hybridizing solid oxide fuel cells with internal combustion engines for power and propulsion systems: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 171(C).
    13. Jing, Wei & Wu, Zengyang & Zhang, Weibo & Fang, Tiegang, 2015. "Measurements of soot temperature and KL factor for spray combustion of biomass derived renewable fuels," Energy, Elsevier, vol. 91(C), pages 758-771.
    14. Giacomo Silvagni & Abhinandhan Narayanan & Vittorio Ravaglioli & Kalyan Kumar Srinivasan & Sundar Rajan Krishnan & Nik Collins & Paulius Puzinauskas & Fabrizio Ponti, 2023. "Experimental Characterization of Hydrocarbons and Nitrogen Oxides Production in a Heavy-Duty Diesel–Natural Gas Reactivity-Controlled Compression Ignition Engine," Energies, MDPI, vol. 16(13), pages 1-19, July.
    15. Payri, Raúl & Salvador, F.J. & Manin, Julien & Viera, Alberto, 2016. "Diesel ignition delay and lift-off length through different methodologies using a multi-hole injector," Applied Energy, Elsevier, vol. 162(C), pages 541-550.
    16. He, Hongwen & Meng, Xiangfei & Wang, Yong & Khajepour, Amir & An, Xiaowen & Wang, Renguang & Sun, Fengchun, 2024. "Deep reinforcement learning based energy management strategies for electrified vehicles: Recent advances and perspectives," Renewable and Sustainable Energy Reviews, Elsevier, vol. 192(C).
    17. Abhinandhan Narayanan & Deivanayagam Hariharan & Kendyl Ryan Partridge & Austin Leo Pearson & Kalyan Kumar Srinivasan & Sundar Rajan Krishnan, 2023. "Impact of Low Reactivity Fuel Type and Energy Substitution on Dual Fuel Combustion at Different Injection Timings," Energies, MDPI, vol. 16(4), pages 1-36, February.
    18. Zhang, Hao & Fan, Qinhao & Liu, Shang & Li, Shengbo Eben & Huang, Jin & Wang, Zhi, 2021. "Hierarchical energy management strategy for plug-in hybrid electric powertrain integrated with dual-mode combustion engine," Applied Energy, Elsevier, vol. 304(C).
    19. Wu, Jingtao & Zhang, Zhehao & Kang, Zhe & Deng, Jun & Li, Liguang & Wu, Zhijun, 2022. "An assessment methodology for fuel/water consumption co-optimization of a gasoline engine with port water injection," Applied Energy, Elsevier, vol. 310(C).
    20. García, Antonio & Monsalve-Serrano, Javier & Lago Sari, Rafael & Tripathi, Shashwat, 2022. "Pathways to achieve future CO2 emission reduction targets for bus transit networks," Energy, Elsevier, vol. 244(PB).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2022:i:1:p:139-:d:1012638. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.