IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v104y2016icp284-294.html
   My bibliography  Save this article

Effect of hydrogen addition on overall pollutant emissions of inverse diffusion flame

Author

Listed:
  • Miao, J.
  • Leung, C.W.
  • Cheung, C.S.
  • Huang, Z.H.
  • Zhen, H.S.

Abstract

In this paper, the effect of hydrogen (H2) addition on the pollutant emissions of an IDF (inverse diffusion flame) burning LPG (liquefied petroleum gas) has been studied. Pollutant emission behavior was intensively investigated at fuel lean condition, and CO2, CO, HC, and NOx emitted from the flame were measured with their emission indices reported. HC and CO emissions are highly dependent on overall equivalence ratio, and both HC and CO are very high at fuel lean condition while reduce to nearly zero at equivalence ratio larger than 0.8 in LPG-H2 IDF. NOx emission follows the trend of HC due to N2O-intermediate and Fenimore mechanisms at fuel lean condition while NOx emission increases with equivalence ratio at fuel rich condition due to thermal NOx mechanism. Hydrogen addition is found to promote the conversion of CO and HC into CO2, and there exists a threshold fraction of hydrogen over which a significant reduction of CO and HC occurs. High air jet Reynolds number tends to induce poor combustion and thus increasing HC, CO and NOx emissions. Compared to LPG IDF, LPG-H2 IDF starts to generate noticeably CO and HC emissions earlier, and both CO and HC emissions are heavier.

Suggested Citation

  • Miao, J. & Leung, C.W. & Cheung, C.S. & Huang, Z.H. & Zhen, H.S., 2016. "Effect of hydrogen addition on overall pollutant emissions of inverse diffusion flame," Energy, Elsevier, vol. 104(C), pages 284-294.
    • Handle: RePEc:eee:energy:v:104:y:2016:i:c:p:284-294
    DOI: 10.1016/j.energy.2016.03.114
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544216303619
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2016.03.114?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Choy, Y.S. & Zhen, H.S. & Leung, C.W. & Li, H.B., 2012. "Pollutant emission and noise radiation from open and impinging inverse diffusion flames," Applied Energy, Elsevier, vol. 91(1), pages 82-89.
    2. Zhen, H.S. & Leung, C.W. & Cheung, C.S., 2011. "Combustion characteristics of a swirling inverse diffusion flame upon oxygen content variation," Applied Energy, Elsevier, vol. 88(9), pages 2925-2933.
    3. Zhen, H.S. & Leung, C.W. & Cheung, C.S., 2011. "Emission of impinging swirling and non-swirling inverse diffusion flames," Applied Energy, Elsevier, vol. 88(5), pages 1629-1634, May.
    4. Zhen, H.S. & Choy, Y.S. & Leung, C.W. & Cheung, C.S., 2011. "Effects of nozzle length on flame and emission behaviors of multi-fuel-jet inverse diffusion flame burner," Applied Energy, Elsevier, vol. 88(9), pages 2917-2924.
    5. Dong, L.L. & Cheung, C.S. & Leung, C.W., 2011. "Combustion optimization of a port-array inverse diffusion flame jet," Energy, Elsevier, vol. 36(5), pages 2834-2846.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Wan, Huaxian & Gao, Zihe & Ji, Jie & Zhang, Yongming & Li, Kaiyuan, 2018. "Experimental and theoretical study on flame front temperatures within ceiling jets from turbulent diffusion flames of n-heptane fuel," Energy, Elsevier, vol. 164(C), pages 79-86.
    2. Kapusta, Łukasz Jan & Shuang, Chen & Aldén, Marcus & Li, Zhongshan, 2020. "Structures of inverse jet flames stabilized on a coaxial burner," Energy, Elsevier, vol. 193(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Rabee, Basem A., 2018. "The effect of inverse diffusion flame burner-diameter on flame characteristics and emissions," Energy, Elsevier, vol. 160(C), pages 1201-1207.
    2. Wang, Qiang & Tang, Fei & Zhou, Zheng & Liu, Huan & Palacios, Adriana, 2017. "Flame height of axisymmetric gaseous fuel jets restricted by parallel sidewalls: Experiments and theoretical analysis," Applied Energy, Elsevier, vol. 208(C), pages 1519-1526.
    3. Kapusta, Łukasz Jan & Shuang, Chen & Aldén, Marcus & Li, Zhongshan, 2020. "Structures of inverse jet flames stabilized on a coaxial burner," Energy, Elsevier, vol. 193(C).
    4. Shang, Fengju & Hu, Longhua & Sun, Xiepeng & Wang, Qiang & Palacios, Adriana, 2017. "Flame downwash length evolution of non-premixed gaseous fuel jets in cross-flow: Experiments and a new correlation," Applied Energy, Elsevier, vol. 198(C), pages 99-107.
    5. Wan, Huaxian & Gao, Zihe & Ji, Jie & Li, Kaiyuan & Sun, Jinhua & Zhang, Yongming, 2017. "Experimental study on ceiling gas temperature and flame performances of two buoyancy-controlled propane burners located in a tunnel," Applied Energy, Elsevier, vol. 185(P1), pages 573-581.
    6. Zare, Saeid & Lo, Hao Wei & Roy, Shrabanti & Askari, Omid, 2020. "On the low-temperature plasma discharge in methane/air diffusion flames," Energy, Elsevier, vol. 197(C).
    7. Yuan, Ye & Li, GuoXiu & Sun, ZuoYu & Li, HongMeng & Zhou, ZiHang, 2016. "Experimental study on the dynamical features of a partially premixed methane jet flame in coflow," Energy, Elsevier, vol. 111(C), pages 593-598.
    8. Gao, Zihe & Wan, Huaxian & Ji, Jie & Bi, Yubo, 2019. "Experimental prediction on the performance and propagation of ceiling jets under the influence of wall confinement," Energy, Elsevier, vol. 178(C), pages 378-385.
    9. Zaidani, Mouna & Tajik, Abdul Raouf & Qureshi, Zahid Ahmed & Shamim, Tariq & Abu Al-Rub, Rashid K., 2018. "Investigating the flue-wall deformation effects on performance characteristics of an open-top aluminum anode baking furnace," Applied Energy, Elsevier, vol. 231(C), pages 1033-1049.
    10. Lawal, Mohammed S. & Fairweather, Michael & Gogolek, Peter & Ingham, Derek B. & Ma, Lin & Pourkashanian, Mohamed & Williams, Alan, 2013. "CFD predictions of wake-stabilised jet flames in a cross-flow," Energy, Elsevier, vol. 53(C), pages 259-269.
    11. De Giorgi, Maria Grazia & Ficarella, Antonio & Sciolti, Aldebara & Pescini, Elisa & Campilongo, Stefano & Di Lecce, Giorgio, 2017. "Improvement of lean flame stability of inverse methane/air diffusion flame by using coaxial dielectric plasma discharge actuators," Energy, Elsevier, vol. 126(C), pages 689-706.
    12. Dong, L.L. & Cheung, C.S. & Leung, C.W., 2013. "Heat transfer optimization of an impinging port-array inverse diffusion flame jet," Energy, Elsevier, vol. 49(C), pages 182-192.
    13. Tajik, Abdul Raouf & Shamim, Tariq & Zaidani, Mouna & Abu Al-Rub, Rashid K., 2018. "The effects of flue-wall design modifications on combustion and flow characteristics of an aluminum anode baking furnace-CFD modeling," Applied Energy, Elsevier, vol. 230(C), pages 207-219.
    14. Maria Grazia De Giorgi & Aldebara Sciolti & Stefano Campilongo & Antonio Ficarella, 2017. "Flame Structure and Chemiluminescence Emissions of Inverse Diffusion Flames under Sinusoidally Driven Plasma Discharges," Energies, MDPI, vol. 10(3), pages 1-15, March.
    15. Luo, Minye & Liu, Dong, 2018. "Effects of dimethyl ether addition on soot formation, evolution and characteristics in flame-wall interactions," Energy, Elsevier, vol. 164(C), pages 642-654.
    16. De la Cruz-Ávila, M. & Martínez-Espinosa, E. & Polupan, Georgiy & Vicente, W., 2017. "Numerical study of the effect of jet velocity on methane-oxygen confined inverse diffusion flame in a 4 Lug-Bolt array," Energy, Elsevier, vol. 141(C), pages 1629-1649.
    17. Tang, Fei & Hu, Peng & Shi, Congling, 2021. "Ceiling thermal impingement spread characteristics induced by wall-attached fires under various sub-atmospheric pressures," Energy, Elsevier, vol. 215(PB).
    18. Wan, Huaxian & Gao, Zihe & Ji, Jie & Zhang, Yongming & Li, Kaiyuan, 2018. "Experimental and theoretical study on flame front temperatures within ceiling jets from turbulent diffusion flames of n-heptane fuel," Energy, Elsevier, vol. 164(C), pages 79-86.
    19. Haisheng Zhen & Zhilong Wei & Zhenbin Chen, 2018. "Effect of N 2 Replacement by CO 2 in Coaxial-Flow on the Combustion and Emission of a Diffusion Flame," Energies, MDPI, vol. 11(5), pages 1-16, April.
    20. Chih-Pin Chiu & Szu-I Yeh & Yu-Ching Tsai & Jing-Tang Yang, 2017. "An Investigation of Fuel Mixing and Reaction in a CH 4 /Syngas/Air Premixed Impinging Flame with Varied H 2 /CO Proportion," Energies, MDPI, vol. 10(7), pages 1-16, July.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:104:y:2016:i:c:p:284-294. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.