IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v160y2018icp1201-1207.html
   My bibliography  Save this article

The effect of inverse diffusion flame burner-diameter on flame characteristics and emissions

Author

Listed:
  • Rabee, Basem A.

Abstract

An experimental investigation was performed to study the effect of change of the IDF burner diameters on the flame characteristics (flame length, axial temperature distribution, and flame appearance) and flame emissions. The study was performed using a coaxial (CoA) circular inverse diffusion flame burners of different diameters. Burners' air diameters (da) were varied from 6 mm to 22.5 mm. The burner fuel diameters were varied according to the change of air diameter to preserve constant equivalence ratio and constant aspect ratio (0.5). The study is carried out at constant equivalence ratio (Φ = 3) and constant air Reynolds number (Rea = 2500). The measured parameters are the flame axial temperature, flame appearance, and emission along the flame center line. The results show significant differences in the flame appearance. The smaller diameters produce shorter flame lengths. The visible flame lengths were varied from 170 to 300 mm. Also, an early formation of CO & CO2and early depletion of O2 were obtained by reducing the burner's sizes. For all the experiments conducted in the present study, the centerline temperature distribution produced by the smaller nozzles diameters show higher flame temperature. The Peak temperatures were varied according to burner size, from 1600 to 950 °C.

Suggested Citation

  • Rabee, Basem A., 2018. "The effect of inverse diffusion flame burner-diameter on flame characteristics and emissions," Energy, Elsevier, vol. 160(C), pages 1201-1207.
    • Handle: RePEc:eee:energy:v:160:y:2018:i:c:p:1201-1207
    DOI: 10.1016/j.energy.2018.07.061
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544218313586
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2018.07.061?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Zhen, H.S. & Leung, C.W. & Cheung, C.S., 2011. "Emission of impinging swirling and non-swirling inverse diffusion flames," Applied Energy, Elsevier, vol. 88(5), pages 1629-1634, May.
    2. Zhen, H.S. & Choy, Y.S. & Leung, C.W. & Cheung, C.S., 2011. "Effects of nozzle length on flame and emission behaviors of multi-fuel-jet inverse diffusion flame burner," Applied Energy, Elsevier, vol. 88(9), pages 2917-2924.
    3. Dong, L.L. & Cheung, C.S. & Leung, C.W., 2011. "Combustion optimization of a port-array inverse diffusion flame jet," Energy, Elsevier, vol. 36(5), pages 2834-2846.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Kapusta, Łukasz Jan & Shuang, Chen & Aldén, Marcus & Li, Zhongshan, 2020. "Structures of inverse jet flames stabilized on a coaxial burner," Energy, Elsevier, vol. 193(C).
    2. Zare, Saeid & Lo, Hao Wei & Roy, Shrabanti & Askari, Omid, 2020. "On the low-temperature plasma discharge in methane/air diffusion flames," Energy, Elsevier, vol. 197(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Miao, J. & Leung, C.W. & Cheung, C.S. & Huang, Z.H. & Zhen, H.S., 2016. "Effect of hydrogen addition on overall pollutant emissions of inverse diffusion flame," Energy, Elsevier, vol. 104(C), pages 284-294.
    2. Kapusta, Łukasz Jan & Shuang, Chen & Aldén, Marcus & Li, Zhongshan, 2020. "Structures of inverse jet flames stabilized on a coaxial burner," Energy, Elsevier, vol. 193(C).
    3. Zare, Saeid & Lo, Hao Wei & Roy, Shrabanti & Askari, Omid, 2020. "On the low-temperature plasma discharge in methane/air diffusion flames," Energy, Elsevier, vol. 197(C).
    4. Yuan, Ye & Li, GuoXiu & Sun, ZuoYu & Li, HongMeng & Zhou, ZiHang, 2016. "Experimental study on the dynamical features of a partially premixed methane jet flame in coflow," Energy, Elsevier, vol. 111(C), pages 593-598.
    5. Wang, Qiang & Tang, Fei & Zhou, Zheng & Liu, Huan & Palacios, Adriana, 2017. "Flame height of axisymmetric gaseous fuel jets restricted by parallel sidewalls: Experiments and theoretical analysis," Applied Energy, Elsevier, vol. 208(C), pages 1519-1526.
    6. Lawal, Mohammed S. & Fairweather, Michael & Gogolek, Peter & Ingham, Derek B. & Ma, Lin & Pourkashanian, Mohamed & Williams, Alan, 2013. "CFD predictions of wake-stabilised jet flames in a cross-flow," Energy, Elsevier, vol. 53(C), pages 259-269.
    7. Shang, Fengju & Hu, Longhua & Sun, Xiepeng & Wang, Qiang & Palacios, Adriana, 2017. "Flame downwash length evolution of non-premixed gaseous fuel jets in cross-flow: Experiments and a new correlation," Applied Energy, Elsevier, vol. 198(C), pages 99-107.
    8. De Giorgi, Maria Grazia & Ficarella, Antonio & Sciolti, Aldebara & Pescini, Elisa & Campilongo, Stefano & Di Lecce, Giorgio, 2017. "Improvement of lean flame stability of inverse methane/air diffusion flame by using coaxial dielectric plasma discharge actuators," Energy, Elsevier, vol. 126(C), pages 689-706.
    9. Dong, L.L. & Cheung, C.S. & Leung, C.W., 2013. "Heat transfer optimization of an impinging port-array inverse diffusion flame jet," Energy, Elsevier, vol. 49(C), pages 182-192.
    10. Maria Grazia De Giorgi & Aldebara Sciolti & Stefano Campilongo & Antonio Ficarella, 2017. "Flame Structure and Chemiluminescence Emissions of Inverse Diffusion Flames under Sinusoidally Driven Plasma Discharges," Energies, MDPI, vol. 10(3), pages 1-15, March.
    11. Luo, Minye & Liu, Dong, 2018. "Effects of dimethyl ether addition on soot formation, evolution and characteristics in flame-wall interactions," Energy, Elsevier, vol. 164(C), pages 642-654.
    12. Wan, Huaxian & Gao, Zihe & Ji, Jie & Li, Kaiyuan & Sun, Jinhua & Zhang, Yongming, 2017. "Experimental study on ceiling gas temperature and flame performances of two buoyancy-controlled propane burners located in a tunnel," Applied Energy, Elsevier, vol. 185(P1), pages 573-581.
    13. De la Cruz-Ávila, M. & Martínez-Espinosa, E. & Polupan, Georgiy & Vicente, W., 2017. "Numerical study of the effect of jet velocity on methane-oxygen confined inverse diffusion flame in a 4 Lug-Bolt array," Energy, Elsevier, vol. 141(C), pages 1629-1649.
    14. Wan, Huaxian & Gao, Zihe & Ji, Jie & Zhang, Yongming & Li, Kaiyuan, 2018. "Experimental and theoretical study on flame front temperatures within ceiling jets from turbulent diffusion flames of n-heptane fuel," Energy, Elsevier, vol. 164(C), pages 79-86.
    15. Haisheng Zhen & Zhilong Wei & Zhenbin Chen, 2018. "Effect of N 2 Replacement by CO 2 in Coaxial-Flow on the Combustion and Emission of a Diffusion Flame," Energies, MDPI, vol. 11(5), pages 1-16, April.
    16. Chih-Pin Chiu & Szu-I Yeh & Yu-Ching Tsai & Jing-Tang Yang, 2017. "An Investigation of Fuel Mixing and Reaction in a CH 4 /Syngas/Air Premixed Impinging Flame with Varied H 2 /CO Proportion," Energies, MDPI, vol. 10(7), pages 1-16, July.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:160:y:2018:i:c:p:1201-1207. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.