IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v15y2023i16p12391-d1217556.html
   My bibliography  Save this article

Comparative Evaluation and Multi-Objective Optimization of Cold Plate Designed for the Lithium-Ion Battery Pack of an Electrical Pickup by Using Taguchi–Grey Relational Analysis

Author

Listed:
  • Muhsin Kılıç

    (Department of Mechanical Engineering, Engineering Faculty, Bursa Uludag University, 16059 Bursa, Türkiye)

  • Sevgül Gamsız

    (Department of Mechanical Engineering, Engineering Faculty, Bursa Uludag University, 16059 Bursa, Türkiye)

  • Zehra Nihan Alınca

    (Department of Mechanical Engineering, Engineering Faculty, Bursa Uludag University, 16059 Bursa, Türkiye)

Abstract

It is aimed to minimize carbon emissions and the spread of electric vehicles is supported for a more sustainable future. To increase the safety and life of these vehicles, cooling systems are added and developed to their energy storage systems. The aim of this study is to design and optimize the cooling plate for the lithium-ion battery pack used in a lightweight commercial electrical vehicle. Multi-objective optimization using Taguchi–grey relational analysis was performed by considering maximum temperature, the standard deviation of temperature, and pressure drop for the design of the cold plate. Channel number, channel height, and mass flow rate values were determined as parameters to be examined, and three different levels were selected for each parameter. Analysis was performed using water and 25% and 50% ethylene glycol–water solutions, which can work under sub-zero environmental conditions, employed as cooling fluid. It is shown that increasing the ethylene glycol ratio in the coolant allows it to work in colder environmental conditions, it is relatively worsening thermal performances in the cold plate applications. A new empirical correlation is proposed to predict the Nusselt number for the three coolants under all geometric and operating conditions considered in this study. Statistical analysis shows that the number of channels is the most effective parameter for the relatively low and homogenous temperature distribution on the cold plate surface. A sensitivity analysis was performed for Reynolds number ranges from 2500 to 15,000 using the optimum configurations of the three coolant fluids. It is shown that the same cooling effects could be obtained by using 1.56 times and 2.66 times more mass flow rates for 25% and 50% ethylene glycol–water solutions, respectively, compared to the water. However, rising mass flow rates result in a significant increase in the required pumping power.

Suggested Citation

  • Muhsin Kılıç & Sevgül Gamsız & Zehra Nihan Alınca, 2023. "Comparative Evaluation and Multi-Objective Optimization of Cold Plate Designed for the Lithium-Ion Battery Pack of an Electrical Pickup by Using Taguchi–Grey Relational Analysis," Sustainability, MDPI, vol. 15(16), pages 1-28, August.
    • Handle: RePEc:gam:jsusta:v:15:y:2023:i:16:p:12391-:d:1217556
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/15/16/12391/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/15/16/12391/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Bademlioglu, A.H. & Canbolat, A.S. & Kaynakli, O., 2020. "Multi-objective optimization of parameters affecting Organic Rankine Cycle performance characteristics with Taguchi-Grey Relational Analysis," Renewable and Sustainable Energy Reviews, Elsevier, vol. 117(C).
    2. Chunyu Zhao & Beile Zhang & Yuanming Zheng & Shunyuan Huang & Tongtong Yan & Xiufang Liu, 2020. "Hybrid Battery Thermal Management System in Electrical Vehicles: A Review," Energies, MDPI, vol. 13(23), pages 1-18, November.
    3. Andersen, Poul H. & Mathews, John A. & Rask, Morten, 2009. "Integrating private transport into renewable energy policy: The strategy of creating intelligent recharging grids for electric vehicles," Energy Policy, Elsevier, vol. 37(7), pages 2481-2486, July.
    4. Christopher Kennedy, 2002. "A comparison of the sustainability of public and private transportation systems: Study of the Greater Toronto Area," Transportation, Springer, vol. 29(4), pages 459-493, November.
    5. Naqiuddin, Nor Haziq & Saw, Lip Huat & Yew, Ming Chian & Yusof, Farazila & Poon, Hiew Mun & Cai, Zuansi & Thiam, Hui San, 2018. "Numerical investigation for optimizing segmented micro-channel heat sink by Taguchi-Grey method," Applied Energy, Elsevier, vol. 222(C), pages 437-450.
    6. Muhsin Kilic & Mehmet Aktas & Gokhan Sevilgen, 2020. "Thermal Assessment of Laminar Flow Liquid Cooling Blocks for LED Circuit Boards Used in Automotive Headlight Assemblies," Energies, MDPI, vol. 13(5), pages 1-19, March.
    7. Yu Miao & Patrick Hynan & Annette von Jouanne & Alexandre Yokochi, 2019. "Current Li-Ion Battery Technologies in Electric Vehicles and Opportunities for Advancements," Energies, MDPI, vol. 12(6), pages 1-20, March.
    8. Wang, Qian & Jiang, Bin & Li, Bo & Yan, Yuying, 2016. "A critical review of thermal management models and solutions of lithium-ion batteries for the development of pure electric vehicles," Renewable and Sustainable Energy Reviews, Elsevier, vol. 64(C), pages 106-128.
    9. Hasan, Husam Abdulrasool & Togun, Hussein & Abed, Azher M & Biswas, Nirmalendu & Mohammed, Hayder I., 2023. "Thermal performance assessment for an array of cylindrical Lithium-Ion battery cells using an Air-Cooling system," Applied Energy, Elsevier, vol. 346(C).
    10. Mohammad Joula & Savas Dilibal & Gonca Mafratoglu & Josiah Owusu Danquah & Mohammad Alipour, 2022. "Hybrid Battery Thermal Management System with NiTi SMA and Phase Change Material (PCM) for Li-ion Batteries," Energies, MDPI, vol. 15(12), pages 1-16, June.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Muhammad Umair Ali & Amad Zafar & Sarvar Hussain Nengroo & Sadam Hussain & Muhammad Junaid Alvi & Hee-Je Kim, 2019. "Towards a Smarter Battery Management System for Electric Vehicle Applications: A Critical Review of Lithium-Ion Battery State of Charge Estimation," Energies, MDPI, vol. 12(3), pages 1-33, January.
    2. Foad H. Gandoman & Emad M. Ahmed & Ziad M. Ali & Maitane Berecibar & Ahmed F. Zobaa & Shady H. E. Abdel Aleem, 2021. "Reliability Evaluation of Lithium-Ion Batteries for E-Mobility Applications from Practical and Technical Perspectives: A Case Study," Sustainability, MDPI, vol. 13(21), pages 1-24, October.
    3. Thomas Imre Cyrille Buidin & Florin Mariasiu, 2021. "Battery Thermal Management Systems: Current Status and Design Approach of Cooling Technologies," Energies, MDPI, vol. 14(16), pages 1-32, August.
    4. Liu, Huaqiang & Gao, Xiangcheng & Zhao, Jiyun & Yu, Minghao & Niu, Dong & Ji, Yulong, 2022. "Liquid-based battery thermal management system performance improvement with intersected serpentine channels," Renewable Energy, Elsevier, vol. 199(C), pages 640-652.
    5. Gökhan Sevilgen & Harun Dursun & Muhsin Kılıç, 2023. "Experimental and Numerical Investigations on the Thermal Performance of Three Different Cold Plates Designed for the Electrical Vehicle Battery Module," Sustainability, MDPI, vol. 15(19), pages 1-20, September.
    6. Mohammed, Abubakar Gambo & Elfeky, Karem Elsayed & Wang, Qiuwang, 2022. "Recent advancement and enhanced battery performance using phase change materials based hybrid battery thermal management for electric vehicles," Renewable and Sustainable Energy Reviews, Elsevier, vol. 154(C).
    7. Guimarães, Vanessa de Almeida & Leal Junior, Ilton Curty & da Silva, Marcelino Aurélio Vieira, 2018. "Evaluating the sustainability of urban passenger transportation by Monte Carlo simulation," Renewable and Sustainable Energy Reviews, Elsevier, vol. 93(C), pages 732-752.
    8. Kley, Fabian & Lerch, Christian & Dallinger, David, 2011. "New business models for electric cars--A holistic approach," Energy Policy, Elsevier, vol. 39(6), pages 3392-3403, June.
    9. Desreveaux, A. & Bouscayrol, A. & Trigui, R. & Hittinger, E. & Castex, E. & Sirbu, G.M., 2023. "Accurate energy consumption for comparison of climate change impact of thermal and electric vehicles," Energy, Elsevier, vol. 268(C).
    10. Abolhosseini, Shahrouz & Heshmati, Almas & Altmann, Jörn, 2014. "A Review of Renewable Energy Supply and Energy Efficiency Technologies," IZA Discussion Papers 8145, Institute of Labor Economics (IZA).
    11. Raja Mazuir Raja Ahsan Shah & Mansour Al Qubeissi & Hazem Youssef & Hakan Serhad Soyhan, 2023. "Battery Thermal Management: An Application to Petrol Hybrid Electric Vehicles," Sustainability, MDPI, vol. 15(7), pages 1-19, March.
    12. Tim Benijts, 2014. "A Business Sustainability Model for Government Corporations. A Belgian Case Study," Business Strategy and the Environment, Wiley Blackwell, vol. 23(3), pages 204-216, March.
    13. Anisa Surya Wijareni & Hendri Widiyandari & Agus Purwanto & Aditya Farhan Arif & Mohammad Zaki Mubarok, 2022. "Morphology and Particle Size of a Synthesized NMC 811 Cathode Precursor with Mixed Hydroxide Precipitate and Nickel Sulfate as Nickel Sources and Comparison of Their Electrochemical Performances in an," Energies, MDPI, vol. 15(16), pages 1-15, August.
    14. Alexandru Ciocan & Cosmin Ungureanu & Alin Chitu & Elena Carcadea & George Darie, 2020. "Electrical Longboard for Everyday Urban Commuting," Sustainability, MDPI, vol. 12(19), pages 1-14, September.
    15. Kim, Junghun & Seung, Hyunchan & Lee, Jongsu & Ahn, Joongha, 2020. "Asymmetric preference and loss aversion for electric vehicles: The reference-dependent choice model capturing different preference directions," Energy Economics, Elsevier, vol. 86(C).
    16. Piotr Krawczyk & Anna Śliwińska, 2020. "Eco-Efficiency Assessment of the Application of Large-Scale Rechargeable Batteries in a Coal-Fired Power Plant," Energies, MDPI, vol. 13(6), pages 1-16, March.
    17. Jack E. N. Swallow & Michael W. Fraser & Nis-Julian H. Kneusels & Jodie F. Charlton & Christopher G. Sole & Conor M. E. Phelan & Erik Björklund & Peter Bencok & Carlos Escudero & Virginia Pérez-Dieste, 2022. "Revealing solid electrolyte interphase formation through interface-sensitive Operando X-ray absorption spectroscopy," Nature Communications, Nature, vol. 13(1), pages 1-14, December.
    18. Hu, Xiaosong & Feng, Fei & Liu, Kailong & Zhang, Lei & Xie, Jiale & Liu, Bo, 2019. "State estimation for advanced battery management: Key challenges and future trends," Renewable and Sustainable Energy Reviews, Elsevier, vol. 114(C), pages 1-1.
    19. González, L.G. & Cordero-Moreno, Daniel & Espinoza, J.L., 2021. "Public transportation with electric traction: Experiences and challenges in an Andean city," Renewable and Sustainable Energy Reviews, Elsevier, vol. 141(C).
    20. Wang, Mengmeng & Liu, Kang & Dutta, Shanta & Alessi, Daniel S. & Rinklebe, Jörg & Ok, Yong Sik & Tsang, Daniel C.W., 2022. "Recycling of lithium iron phosphate batteries: Status, technologies, challenges, and prospects," Renewable and Sustainable Energy Reviews, Elsevier, vol. 163(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:15:y:2023:i:16:p:12391-:d:1217556. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.