IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i21p7431-d1273707.html
   My bibliography  Save this article

Performance Improvement and Emission Reduction Potential of Blends of Hydrotreated Used Cooking Oil, Biodiesel and Diesel in a Compression Ignition Engine

Author

Listed:
  • Ankit Sonthalia

    (Department of Automobile Engineering, Faculty of Engineering and Technology, SRM Institute of Science and Technology, NCR Campus, Ghaziabad 201204, India)

  • Naveen Kumar

    (Department of Mechanical Engineering, Delhi Technological University, Shahbad Daulatpur, Delhi 110042, India)

Abstract

The positive effect of decarbonizing the transport sector by using bio-based fuels is high. Currently, biodiesel and ethanol are the two biofuels that are blended with fossil fuels. Another technology, namely, hydroprocessing, is also gaining momentum for producing biofuels. Hydrotreated vegetable oil (HVO) produced using this process is a potential drop-in fuel due to its improved physiochemical properties. This study aimed to reduce the fossil diesel content by blending 20% and 30% HVO and 5%, 10% and 15% waste cooking oil biodiesel on a volume basis. The blends were used to conduct a thorough performance examination of a single-cylinder compression ignition engine. The thermal efficiency of the engine was enhanced by the addition of biodiesel to the blend. The efficiency increased as the proportion of biodiesel in the mix increased, although it was still less efficient than diesel. The maximum improvement in thermal efficiency of 4.35% was observed with 20% blending of HVO and 15% blending of biodiesel compared with 20% blending of HVO and diesel. However, the HC (decrease of 30%), CO (decrease of 23.5%) and smoke (decrease of 21.1%) emissions were observed to be the lowest with 30% blending of HVO and 15% blending of biodiesel. A fuzzy-logic-based Taguchi method and Grey’s method were then applied to find the best blend of HVO, biodiesel and diesel. The combination of the two methods made it easier to carry out multi-objective optimization. The brake thermal efficiency (BTE), smoke and NO emissions were selected as the output parameters to optimize the HVO and biodiesel blend. The optimization study showed that 30% blending of HVO and 15% blending of biodiesel was the best blend, which was authenticated using the confirmation experiment.

Suggested Citation

  • Ankit Sonthalia & Naveen Kumar, 2023. "Performance Improvement and Emission Reduction Potential of Blends of Hydrotreated Used Cooking Oil, Biodiesel and Diesel in a Compression Ignition Engine," Energies, MDPI, vol. 16(21), pages 1-23, November.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:21:p:7431-:d:1273707
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/21/7431/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/21/7431/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Wu, Horng-Wen & Wu, Zhan-Yi, 2012. "Combustion characteristics and optimal factors determination with Taguchi method for diesel engines port-injecting hydrogen," Energy, Elsevier, vol. 47(1), pages 411-420.
    2. Wu, Horng-Wen & Wu, Zhan-Yi, 2013. "Using Taguchi method on combustion performance of a diesel engine with diesel/biodiesel blend and port-inducting H2," Applied Energy, Elsevier, vol. 104(C), pages 362-370.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Chintala, V. & Subramanian, K.A., 2015. "Experimental investigations on effect of different compression ratios on enhancement of maximum hydrogen energy share in a compression ignition engine under dual-fuel mode," Energy, Elsevier, vol. 87(C), pages 448-462.
    2. Chintala, Venkateswarlu & Subramanian, K.A., 2017. "A comprehensive review on utilization of hydrogen in a compression ignition engine under dual fuel mode," Renewable and Sustainable Energy Reviews, Elsevier, vol. 70(C), pages 472-491.
    3. Ayhan, Vezir & Çangal, Çiçek & Cesur, İdris & Safa, Aykut, 2020. "Combined influence of supercharging, EGR, biodiesel and ethanol on emissions of a diesel engine: Proposal of an optimization strategy," Energy, Elsevier, vol. 207(C).
    4. Chintala, V. & Subramanian, K.A., 2017. "Experimental investigation of autoignition of hydrogen-air charge in a compression ignition engine under dual-fuel mode," Energy, Elsevier, vol. 138(C), pages 197-209.
    5. Bose, Probir Kumar & Deb, Madhujit & Banerjee, Rahul & Majumder, Arindam, 2013. "Multi objective optimization of performance parameters of a single cylinder diesel engine running with hydrogen using a Taguchi-fuzzy based approach," Energy, Elsevier, vol. 63(C), pages 375-386.
    6. Zhou, J.H. & Cheung, C.S. & Zhao, W.Z. & Leung, C.W., 2016. "Diesel–hydrogen dual-fuel combustion and its impact on unregulated gaseous emissions and particulate emissions under different engine loads and engine speeds," Energy, Elsevier, vol. 94(C), pages 110-123.
    7. Bo Zhang & Huaiyu Wang & Shuofeng Wang, 2023. "Computational Investigation of Combustion, Performance, and Emissions of a Diesel-Hydrogen Dual-Fuel Engine," Sustainability, MDPI, vol. 15(4), pages 1-15, February.
    8. Wu, Horng-Wen & Fan, Chen-Ming & He, Jian-Yi & Hsu, Tzu-Ting, 2017. "Optimal factors estimation for diesel/methanol engines changing methanol injection timing and inlet air temperature," Energy, Elsevier, vol. 141(C), pages 1819-1828.
    9. Zhang, Bo & Ji, Changwei & Wang, Shuofeng & Liu, Xiaolong, 2014. "Combustion and emissions characteristics of a spark-ignition engine fueled with hydrogen–methanol blends under lean and various loads conditions," Energy, Elsevier, vol. 74(C), pages 829-835.
    10. Chintala, V. & Subramanian, K.A., 2015. "An effort to enhance hydrogen energy share in a compression ignition engine under dual-fuel mode using low temperature combustion strategies," Applied Energy, Elsevier, vol. 146(C), pages 174-183.
    11. Wang, Shuofeng & Ji, Changwei & Zhang, Bo & Cong, Xiaoyu & Liu, Xiaolong, 2016. "Effect of CO2 dilution on combustion and emissions characteristics of the hydrogen-enriched gasoline engine," Energy, Elsevier, vol. 96(C), pages 118-126.
    12. Mohd Muqeem & Ahmad Faizan Sherwani & Mukhtar Ahmad & Zahid Akhtar Khan, 2018. "Optimization of diesel engine input parameters for reducing hydrocarbon emission and smoke opacity using Taguchi method and analysis of variance," Energy & Environment, , vol. 29(3), pages 410-431, May.
    13. Li, Jing & Yang, Wen Ming & Goh, Thong Ngee & An, Hui & Maghbouli, Amin, 2014. "Study on RCCI (reactivity controlled compression ignition) engine by means of statistical experimental design," Energy, Elsevier, vol. 78(C), pages 777-787.
    14. Gonca, Guven & Sahin, Bahri & Ust, Yasin, 2013. "Performance maps for an air-standard irreversible Dual–Miller cycle (DMC) with late inlet valve closing (LIVC) version," Energy, Elsevier, vol. 54(C), pages 285-290.
    15. Fakudze, Sandile & Zhang, Yu & Wei, Yingyuan & Li, Yueh-Heng & Chen, Jianqiang & Wang, Jiaxin & Han, Jiangang, 2023. "Taguchi-optimized oxy-combustion of hydrochar/coal blends for CO2 capture and maximized combustion performance," Energy, Elsevier, vol. 267(C).
    16. Donateo, Teresa & Tornese, Federica & Laforgia, Domenico, 2013. "Computer-aided conversion of an engine from diesel to methane," Applied Energy, Elsevier, vol. 108(C), pages 8-23.
    17. Feng, Hongqing & Zheng, Zunqing & Yao, Mingfa & Cheng, Gang & Wang, Meiying & Wang, Xin, 2013. "Effects of exhaust gas recirculation on low temperature combustion using wide distillation range diesel," Energy, Elsevier, vol. 51(C), pages 291-296.
    18. Lešnik, Luka & Vajda, Blaž & Žunič, Zoran & Škerget, Leopold & Kegl, Breda, 2013. "The influence of biodiesel fuel on injection characteristics, diesel engine performance, and emission formation," Applied Energy, Elsevier, vol. 111(C), pages 558-570.
    19. Li, Yueh-Heng & Lin, Hsien-Tsung & Xiao, Kai-Lin & Lasek, Janusz, 2018. "Combustion behavior of coal pellets blended with Miscanthus biochar," Energy, Elsevier, vol. 163(C), pages 180-190.
    20. Khandal, S.V. & Banapurmath, N.R. & Gaitonde, V.N. & Hiremath, S.S., 2017. "Paradigm shift from mechanical direct injection diesel engines to advanced injection strategies of diesel homogeneous charge compression ignition (HCCI) engines- A comprehensive review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 70(C), pages 369-384.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:21:p:7431-:d:1273707. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.