IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v12y2019i7p1262-d219164.html
   My bibliography  Save this article

Investigation on Long Term Operation of Thermochemical Heat Storage with MgO-Based Composite Honeycombs

Author

Listed:
  • Jae Yong Lee

    (Energy Network Laboratory, Korea Institute of Energy Research, Daejeon 34129, Korea)

  • Taesu Yim

    (Energy Network Laboratory, Korea Institute of Energy Research, Daejeon 34129, Korea)

  • Hyouck Ju Kim

    (Energy Network Laboratory, Korea Institute of Energy Research, Daejeon 34129, Korea)

  • Sungkook Hong

    (Energy Network Laboratory, Korea Institute of Energy Research, Daejeon 34129, Korea)

  • Doo Won Seo

    (Energy Materials Laboratory, Korea Institute of Energy Research, Daejeon 34129, Korea)

  • Hong Soo Kim

    (Energy Materials Laboratory, Korea Institute of Energy Research, Daejeon 34129, Korea)

Abstract

The efficient storing and utilizing of industrial waste heat can contribute to the reduction of CO 2 and primary energy. Thermochemical heat storage uses a chemical and/or an adsorption-desorption reaction to store heat without heat loss. This study aims to assess the long-term operational feasibility of thermochemical material based composite honeycombs, so that a new thermochemical heat storage and peripheral system were prepared. The evaluation was done by three aspects: The compressive strength of the honeycomb, heat charging, and the discharging capabilities of the thermochemical heat storage. The compressive strength exceeded 1 MPa and is sufficient for safe use. The thermal performance was also assessed in a variety of ways during 100 cycles, 550 h in total. By introducing a new process, the amount of thermochemical-only charging was successfully measured for the first time. Furthermore, the heat charging capabilities were measured at 55.8% after the end of the experiment. Finally, the heat discharging capability was decreased until 60 cycles and there was no further degradation thereafter. This degradation was caused by charging at a too high temperature (550 °C). In comparative tests using a low temperature (450 °C), the performance degradation became slow, which means that it is important to find the optimal charging temperature.

Suggested Citation

  • Jae Yong Lee & Taesu Yim & Hyouck Ju Kim & Sungkook Hong & Doo Won Seo & Hong Soo Kim, 2019. "Investigation on Long Term Operation of Thermochemical Heat Storage with MgO-Based Composite Honeycombs," Energies, MDPI, vol. 12(7), pages 1-18, April.
    • Handle: RePEc:gam:jeners:v:12:y:2019:i:7:p:1262-:d:219164
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/12/7/1262/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/12/7/1262/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Schmidt, Matthias & Linder, Marc, 2017. "Power generation based on the Ca(OH)2/ CaO thermochemical storage system – Experimental investigation of discharge operation modes in lab scale and corresponding conceptual process design," Applied Energy, Elsevier, vol. 203(C), pages 594-607.
    2. Shkatulov, Alexandr & Ryu, Junichi & Kato, Yukitaka & Aristov, Yury, 2012. "Composite material “Mg(OH)2/vermiculite”: A promising new candidate for storage of middle temperature heat," Energy, Elsevier, vol. 44(1), pages 1028-1034.
    3. Yan, J. & Zhao, C.Y., 2016. "Experimental study of CaO/Ca(OH)2 in a fixed-bed reactor for thermochemical heat storage," Applied Energy, Elsevier, vol. 175(C), pages 277-284.
    4. Taesu Yim & Hong Soo Kim & Jae Yong Lee, 2018. "Cyclic Assessment of Magnesium Oxide with Additives as a Thermochemical Material to Improve the Mechanical Strength and Chemical Reaction," Energies, MDPI, vol. 11(9), pages 1-15, September.
    5. Mastronardo, E. & Bonaccorsi, L. & Kato, Y. & Piperopoulos, E. & Lanza, M. & Milone, C., 2016. "Thermochemical performance of carbon nanotubes based hybrid materials for MgO/H2O/Mg(OH)2 chemical heat pumps," Applied Energy, Elsevier, vol. 181(C), pages 232-243.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Müller, Danny & Knoll, Christian & Gravogl, Georg & Artner, Werner & Welch, Jan M. & Eitenberger, Elisabeth & Friedbacher, Gernot & Schreiner, Manfred & Harasek, Michael & Hradil, Klaudia & Werner, An, 2019. "Tuning the performance of MgO for thermochemical energy storage by dehydration – From fundamentals to phase impurities," Applied Energy, Elsevier, vol. 253(C), pages 1-1.
    2. Yan, J. & Pan, Z.H. & Zhao, C.Y., 2020. "Experimental study of MgO/Mg(OH)2 thermochemical heat storage with direct heat transfer mode," Applied Energy, Elsevier, vol. 275(C).
    3. Piperopoulos, Elpida & Mastronardo, Emanuela & Fazio, Marianna & Lanza, Maurizio & Galvagno, Signorino & Milone, Candida, 2018. "Enhancing the volumetric heat storage capacity of Mg(OH)2 by the addition of a cationic surfactant during its synthesis," Applied Energy, Elsevier, vol. 215(C), pages 512-522.
    4. Risthaus, Kai & Linder, Marc & Schmidt, Matthias, 2022. "Experimental investigation of a novel mechanically fluidized bed reactor for thermochemical energy storage with calcium hydroxide/calcium oxide," Applied Energy, Elsevier, vol. 315(C).
    5. Sunku Prasad, J. & Muthukumar, P. & Desai, Fenil & Basu, Dipankar N. & Rahman, Muhammad M., 2019. "A critical review of high-temperature reversible thermochemical energy storage systems," Applied Energy, Elsevier, vol. 254(C).
    6. Yi Yuan & Yingjie Li & Jianli Zhao, 2018. "Development on Thermochemical Energy Storage Based on CaO-Based Materials: A Review," Sustainability, MDPI, vol. 10(8), pages 1-24, July.
    7. Takasu, Hiroki & Ryu, Junichi & Kato, Yukitaka, 2017. "Application of lithium orthosilicate for high-temperature thermochemical energy storage," Applied Energy, Elsevier, vol. 193(C), pages 74-83.
    8. Schmidt, Matthias & Linder, Marc, 2017. "Power generation based on the Ca(OH)2/ CaO thermochemical storage system – Experimental investigation of discharge operation modes in lab scale and corresponding conceptual process design," Applied Energy, Elsevier, vol. 203(C), pages 594-607.
    9. Emanuela Mastronardo & Yukitaka Kato & Lucio Bonaccorsi & Elpida Piperopoulos & Candida Milone, 2017. "Thermochemical Storage of Middle Temperature Wasted Heat by Functionalized C/Mg(OH) 2 Hybrid Materials," Energies, MDPI, vol. 10(1), pages 1-16, January.
    10. Wang, Mengyi & Chen, Li & He, Pu & Tao, Wen-Quan, 2019. "Numerical study and enhancement of Ca(OH)2/CaO dehydration process with porous channels embedded in reactors," Energy, Elsevier, vol. 181(C), pages 417-428.
    11. Funayama, Shigehiko & Takasu, Hiroki & Kim, Seon Tae & Kato, Yukitaka, 2020. "Thermochemical storage performance of a packed bed of calcium hydroxide composite with a silicon-based ceramic honeycomb support," Energy, Elsevier, vol. 201(C).
    12. Pan, Z.H. & Zhao, C.Y., 2017. "Gas–solid thermochemical heat storage reactors for high-temperature applications," Energy, Elsevier, vol. 130(C), pages 155-173.
    13. Wang, Mengyi & Chen, Li & Zhou, Yuhao & Tao, Wen-Quan, 2022. "Numerical simulation of the calcium hydroxide/calcium oxide system dehydration reaction in a shell-tube reactor," Applied Energy, Elsevier, vol. 312(C).
    14. Pelay, Ugo & Luo, Lingai & Fan, Yilin & Stitou, Driss & Castelain, Cathy, 2019. "Integration of a thermochemical energy storage system in a Rankine cycle driven by concentrating solar power: Energy and exergy analyses," Energy, Elsevier, vol. 167(C), pages 498-510.
    15. Mastronardo, E. & Bonaccorsi, L. & Kato, Y. & Piperopoulos, E. & Lanza, M. & Milone, C., 2016. "Thermochemical performance of carbon nanotubes based hybrid materials for MgO/H2O/Mg(OH)2 chemical heat pumps," Applied Energy, Elsevier, vol. 181(C), pages 232-243.
    16. Zhao, Y. & Zhao, C.Y. & Markides, C.N. & Wang, H. & Li, W., 2020. "Medium- and high-temperature latent and thermochemical heat storage using metals and metallic compounds as heat storage media: A technical review," Applied Energy, Elsevier, vol. 280(C).
    17. Taesu Yim & Hong Soo Kim & Jae Yong Lee, 2018. "Cyclic Assessment of Magnesium Oxide with Additives as a Thermochemical Material to Improve the Mechanical Strength and Chemical Reaction," Energies, MDPI, vol. 11(9), pages 1-15, September.
    18. Luo, Ji-Wang & Chen, Li & Wang, MengYi & Xia, Yang & Tao, WenQuan, 2022. "Particle-scale study of coupled physicochemical processes in Ca(OH)2 dehydration using the lattice Boltzmann method," Energy, Elsevier, vol. 250(C).
    19. Alva, Guruprasad & Lin, Yaxue & Fang, Guiyin, 2018. "An overview of thermal energy storage systems," Energy, Elsevier, vol. 144(C), pages 341-378.
    20. Shkatulov, A.I. & Houben, J. & Fischer, H. & Huinink, H.P., 2020. "Stabilization of K2CO3 in vermiculite for thermochemical energy storage," Renewable Energy, Elsevier, vol. 150(C), pages 990-1000.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:12:y:2019:i:7:p:1262-:d:219164. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.