IDEAS home Printed from https://ideas.repec.org/a/eee/renene/v177y2021icp1198-1211.html
   My bibliography  Save this article

The influence of cow dung and mixed straw ashes on steel corrosion

Author

Listed:
  • Maj, Izabella
  • Kalisz, Sylwester
  • Szymajda, Aneta
  • Łaska, Grażyna
  • Gołombek, Klaudiusz

Abstract

Presented paper identifies the possible corrosion problems related to animal waste incineration since it is a key issue for their use in the power sector. Cow dung as an example of animal-origin biomass is examined in terms of high-temperature corrosion and slagging hazards in comparison with commonly used mixed straw. Results of the laboratory-scale corrosion studies of pure ash deposits on two steel alloys: 16Mo3 and 10CrMo9–10 are reported. Selected steel types are commonly used in boiler construction for superheaters and waterwalls – parts of a boiler that are most exposed to the high-temperature corrosion risk. The corrosion experiments were carried out under oxidizing conditions at 460 °C, 510 °C and 560 °C for 168 h. To determine the corrosion rate the mass of steel samples was measured after 24, 72 and 168 h. For a better understanding of the corrosion process, a detailed chemical analysis of ashes was conducted together with SEM-EDS analysis of the corrosion products. Ash melting and deposition behavior of both ashes were predicted according to 11 indices. It was found that cow dung and mixed straw ash differ significantly in terms of quantitative chemical compositions and ash melting characteristics. Cow dung ash is characterized by a high concentration of alkali compounds (2.57 wt% Cl, 30.6 wt% CaO, 5.56 wt% K2O) together with high phosphorus content typical for animal manure. The presence of alkali chlorides in the cow dung ash deposits led to a build-up of chlorides on the steel surface, which caused accelerated corrosion. At 560 °C the corrosion rate was over 3 times higher for cow dung ash than for mixed straw ash. The corrosion occurred due to the formation of low-melting FeCl2 mixtures since chlorine- and iron-rich particles were found in the crevices and cracks within deposits. The results clearly demonstrated the high corrosive potential of animal-origin biomass and therefore indicate the potential problems related to its thermal conversion process. These adverse effects can be reduced by ash removal and maintaining the temperature of the heating surfaces below 560 °C.

Suggested Citation

  • Maj, Izabella & Kalisz, Sylwester & Szymajda, Aneta & Łaska, Grażyna & Gołombek, Klaudiusz, 2021. "The influence of cow dung and mixed straw ashes on steel corrosion," Renewable Energy, Elsevier, vol. 177(C), pages 1198-1211.
    • Handle: RePEc:eee:renene:v:177:y:2021:i:c:p:1198-1211
    DOI: 10.1016/j.renene.2021.06.019
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0960148121008831
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.renene.2021.06.019?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Sandberg, Jan & Karlsson, Christer & Fdhila, Rebei Bel, 2011. "A 7Â year long measurement period investigating the correlation of corrosion, deposit and fuel in a biomass fired circulated fluidized bed boiler," Applied Energy, Elsevier, vol. 88(1), pages 99-110, January.
    2. Mlonka-Mędrala, Agata & Gołombek, Klaudiusz & Buk, Paulina & Cieślik, Ewelina & Nowak, Wojciech, 2019. "The influence of KCl on biomass ash melting behaviour and high-temperature corrosion of low-alloy steel," Energy, Elsevier, vol. 188(C).
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Izabella Maj, 2022. "Significance and Challenges of Poultry Litter and Cattle Manure as Sustainable Fuels: A Review," Energies, MDPI, vol. 15(23), pages 1-17, November.
    2. Hernik, Bartłomiej & Wnorowska, Joanna, 2022. "Numerical research on combustion processes and deposit formation on the deposition probe in the pulverized drop chamber," Renewable Energy, Elsevier, vol. 187(C), pages 1-13.
    3. Izabella Maj & Krzysztof Matus, 2023. "Aluminosilicate Clay Minerals: Kaolin, Bentonite, and Halloysite as Fuel Additives for Thermal Conversion of Biomass and Waste," Energies, MDPI, vol. 16(11), pages 1-17, May.
    4. Izabella Maj & Sylwester Kalisz & Szymon Ciukaj, 2022. "Properties of Animal-Origin Ash—A Valuable Material for Circular Economy," Energies, MDPI, vol. 15(4), pages 1-15, February.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Anna Maciejczyk & Izabella Maj & Szymon Ciukaj & Bartłomiej Hernik & Arkadiusz Osuch, 2023. "The Influence of Protective Coatings on High-Temperature Corrosion under Biomass Ash Deposits," Energies, MDPI, vol. 16(21), pages 1-16, October.
    2. Munawar, Muhammad Assad & Khoja, Asif Hussain & Naqvi, Salman Raza & Mehran, Muhammad Taqi & Hassan, Muhammad & Liaquat, Rabia & Dawood, Usama Fida, 2021. "Challenges and opportunities in biomass ash management and its utilization in novel applications," Renewable and Sustainable Energy Reviews, Elsevier, vol. 150(C).
    3. Tong, Zi-Xiang & Li, Ming-Jia & He, Ya-Ling & Tan, Hou-Zhang, 2017. "Simulation of real time particle deposition and removal processes on tubes by coupled numerical method," Applied Energy, Elsevier, vol. 185(P2), pages 2181-2193.
    4. Lupiáñez, Carlos & Carmen Mayoral, M. & Díez, Luis I. & Pueyo, Eloy & Espatolero, Sergio & Manuel Andrés, J., 2016. "The role of limestone during fluidized bed oxy-combustion of coal and biomass," Applied Energy, Elsevier, vol. 184(C), pages 670-680.
    5. Badshah, Noor & Al-attab, K.A. & Zainal, Z.A., 2020. "Design optimization and experimental analysis of externally fired gas turbine system fuelled by biomass," Energy, Elsevier, vol. 198(C).
    6. Ziqiang Yang & Fenghai Li & Mingjie Ma & Xuefei Liu & Hongli Fan & Zhenzhu Li & Yong Wang & Yitian Fang, 2023. "Regulation Mechanism of Solid Waste on Ash Fusion Characteristics of Sorghum Straw under O 2 /CO 2 Atmosphere," Energies, MDPI, vol. 16(20), pages 1-17, October.
    7. Izabella Maj, 2022. "Significance and Challenges of Poultry Litter and Cattle Manure as Sustainable Fuels: A Review," Energies, MDPI, vol. 15(23), pages 1-17, November.
    8. Eo, Jae Won & Kim, Min Jun & Jeong, In Seon & Cho, LaHoon & Kim, Seok Jun & Park, Sunyong & Kim, Dae Hyun, 2021. "Enhancing thermal efficiency of wood pellet boilers by improving inlet air characteristics," Energy, Elsevier, vol. 228(C).
    9. Kafle, Sagar & Euh, Seung Hee & Cho, Lahoon & Nam, Yun Seong & Oh, Kwang Cheol & Choi, Yun Sung & Oh, Jae-Heun & Kim, Dae Hyun, 2017. "Tar fouling reduction in wood pellet boiler using additives and study the effects of additives on the characteristics of pellets," Energy, Elsevier, vol. 129(C), pages 79-85.
    10. Chen, Guanyi & Wenga, Terrence & Ma, Wenchao & Lin, Fawei, 2019. "Theoretical and experimental study of gas-phase corrosion attack of Fe under simulated municipal solid waste combustion: Influence of KCl, SO2, HCl, and H2O vapour," Applied Energy, Elsevier, vol. 247(C), pages 630-642.
    11. Salameh, Tareq & Tawalbeh, Muhammad & Al-Shannag, Mohammad & Saidan, Motasem & Melhem, Khalid Bani & Alkasrawi, Malek, 2020. "Energy saving in the process of bioethanol production from renewable paper mill sludge," Energy, Elsevier, vol. 196(C).
    12. Lee, Sang Yeol & Oh, Kwang Cheol & Lee, Chung Geon & Cho, La Hoon & Park, Sun Yong & Jeong, In Seon & Kim, Dae Hyun, 2018. "Improvement of thermal efficiency of wood pellet boilers through the refractory insulation in a combustion chamber and fire tube and baffle modification," Energy, Elsevier, vol. 161(C), pages 1115-1121.
    13. Liukkonen, Mika & Hälikkä, Eero & Hiltunen, Teri & Hiltunen, Yrjö, 2012. "Dynamic soft sensors for NOx emissions in a circulating fluidized bed boiler," Applied Energy, Elsevier, vol. 97(C), pages 483-490.
    14. Liu, Yacheng & Fan, Weidong & Guo, Hao, 2020. "A calculation model for the overall process of high temperature corrosion mechanism induced by firing coal with high chlorine and sodium content," Energy, Elsevier, vol. 205(C).
    15. Li, Guangyu & Xu, Shisen & Zhao, Xuebin & Sun, Ruijin & Wang, Chang’an & Liu, Kang & Mao, Qisen & Che, Defu, 2020. "Investigation of chemical composition and morphology of ash deposition in syngas cooler of an industrialized two-stage entrained-flow coal gasifier," Energy, Elsevier, vol. 194(C).
    16. Ghorashi, Seyed Amin & Khandelwal, Bhupendra, 2023. "Toward the ultra-clean and highly efficient biomass-fired heaters. A review," Renewable Energy, Elsevier, vol. 205(C), pages 631-647.
    17. Zhang, Yufeng & Xie, Xingyun & Zhao, Jing & Wei, Xiaolin, 2020. "The alkali metal occurrence characteristics and its release and conversion during wheat straw pyrolysis," Renewable Energy, Elsevier, vol. 151(C), pages 255-262.
    18. Namkung, Hueon & Xu, Li-Hua & Kang, Tae-Jin & Kim, Dae Sung & Kwon, Hyok-Bo & Kim, Hyung-Taek, 2013. "Prediction of coal fouling using an alternative index under the gasification condition," Applied Energy, Elsevier, vol. 102(C), pages 1246-1255.
    19. Symonds, Robert T. & Hughes, Robin W. & De Las Obras Loscertales, Margarita, 2020. "Oxy-pressurized fluidized bed combustion: Configuration and options analysis," Applied Energy, Elsevier, vol. 262(C).
    20. Tomasz Hardy & Amit Arora & Halina Pawlak-Kruczek & Wojciech Rafajłowicz & Jerzy Wietrzych & Łukasz Niedźwiecki & Vishwajeet & Krzysztof Mościcki, 2021. "Non-Destructive Diagnostic Methods for Fire-Side Corrosion Risk Assessment of Industrial Scale Boilers, Burning Low Quality Solid Biofuels—A Mini Review," Energies, MDPI, vol. 14(21), pages 1-15, November.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:renene:v:177:y:2021:i:c:p:1198-1211. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/renewable-energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.