IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i23p8888-d983067.html
   My bibliography  Save this article

Performance Comparison and Light Reflectance of Al, Cu, and Fe Metals in Direct Contact Flat Solar Heating Systems

Author

Listed:
  • Ehab AlShamaileh

    (Department of Chemistry, The University of Jordan, Amman 11942, Jordan)

  • Iessa Sabbe Moosa

    (Department of Chemistry, The University of Jordan, Amman 11942, Jordan)

  • Heba Al-Fayyad

    (Department of Chemistry, The University of Jordan, Amman 11942, Jordan
    Department of Chemical Engineering, The University of Jordan, Amman 11942, Jordan)

  • Bashar Lahlouh

    (Department of Physics, The University of Jordan, Amman 11942, Jordan)

  • Hussein A. Kazem

    (Faculty of Engineering, Sohar University, Sohar P.C. 311, Oman)

  • Qusay Abu-Afifeh

    (Department of Chemistry, The University of Jordan, Amman 11942, Jordan
    Department of Land, Water, and Environment, The University of Jordan, Amman 11942, Jordan)

  • Bety S. Al-Saqarat

    (Department of Geology, The University of Jordan, Amman 11942, Jordan)

  • Muayad Esaifan

    (Department of Chemistry, College of Arts and Sciences, University of Petra, Amman 11196, Jordan)

  • Imad Hamadneh

    (Department of Chemistry, The University of Jordan, Amman 11942, Jordan)

Abstract

The Sun is a huge and clean energy source that must be relied upon to reduce greenhouse gases and promote the renewable and sustainable energy transition. In this paper, the testing of Al, Cu, and Fe metals with different thicknesses, both bare and painted matte black, was investigated for solar water heating systems. The used technique was a direct contact flat solar heating system (DCFSHS). Many experiments were run to assess this system in terms of metals’ thicknesses and their thermal conductivities as well. Thicknesses of around 0.35 mm and 1 mm of Cu gave almost similar feedback. Maximum temperatures in the range of 93–97 °C were achieved during the autumn season in Amman, Jordan, while it was approximately 80 °C in winter. It has been confirmed that high water temperatures can be obtained in all used metals, regardless of their thermal conductivities. It was also found that a white color of the solar heater case inner wall leads to an increase in water temperature of approximately 4 °C in comparison to a black color. Furthermore, a light reflectance % test in the wavelength range of 240–840 nm for the studied metals, with both bare and black-painted surfaces, gave a superb result that was in line with the obtained results of the DCFSHS. Our innovative system design for solar water heating is due to improvements in many aspects, such as design, production costs, environment, and weight.

Suggested Citation

  • Ehab AlShamaileh & Iessa Sabbe Moosa & Heba Al-Fayyad & Bashar Lahlouh & Hussein A. Kazem & Qusay Abu-Afifeh & Bety S. Al-Saqarat & Muayad Esaifan & Imad Hamadneh, 2022. "Performance Comparison and Light Reflectance of Al, Cu, and Fe Metals in Direct Contact Flat Solar Heating Systems," Energies, MDPI, vol. 15(23), pages 1-15, November.
  • Handle: RePEc:gam:jeners:v:15:y:2022:i:23:p:8888-:d:983067
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/23/8888/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/15/23/8888/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Yassen, Tadahmun A. & Mokhlif, Nassir D. & Eleiwi, Muhammad Asmail, 2019. "Performance investigation of an integrated solar water heater with corrugated absorber surface for domestic use," Renewable Energy, Elsevier, vol. 138(C), pages 852-860.
    2. Kalogirou, Soteris, 2003. "The potential of solar industrial process heat applications," Applied Energy, Elsevier, vol. 76(4), pages 337-361, December.
    3. Davide De Maio & Carmine D’Alessandro & Antonio Caldarelli & Daniela De Luca & Emiliano Di Gennaro & Roberto Russo & Marilena Musto, 2021. "A Selective Solar Absorber for Unconcentrated Solar Thermal Panels," Energies, MDPI, vol. 14(4), pages 1-13, February.
    4. Abu Shadate Faisal Mahamude & Muhamad Kamal Kamarulzaman & Wan Sharuzi Wan Harun & Kumaran Kadirgama & Devarajan Ramasamy & Kaniz Farhana & Rosli Abu Bakar & Talal Yusaf & Sivarao Subramanion & Belal , 2022. "A Comprehensive Review on Efficiency Enhancement of Solar Collectors Using Hybrid Nanofluids," Energies, MDPI, vol. 15(4), pages 1-26, February.
    5. Mehran Dehghan & Carlos F. Pfeiffer & Elyas Rakhshani & Reza Bakhshi-Jafarabadi, 2021. "A Review on Techno-Economic Assessment of Solar Water Heating Systems in the Middle East," Energies, MDPI, vol. 14(16), pages 1-28, August.
    6. Xin Jin & Guiping Lin & Haichuan Jin & Zunru Fu & Haoyang Sun, 2021. "Experimental Research on the Selective Absorption of Solar Energy by Hybrid Nanofluids," Energies, MDPI, vol. 14(23), pages 1-18, December.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Akram Al-Mahrouk & Emad Awada & Wasseem Al-Rousan & Dana Al-Mahrouk, 2024. "The Design of a PV System of a Multi-Location Large Consumer: A Case Study from Al-Balqa Applied University," Sustainability, MDPI, vol. 16(21), pages 1-18, October.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Pankaj Kumar & Krishna Kumar Sinha & Bojan Đurin & Mukesh Kumar Gupta & Nishant Saxena & Malay Kumar Banerjee & Nikola Kranjčić & Suraj Kumar Singh & Shruti Kanga, 2022. "Economics of Implementing Solar Thermal Heating Systems in the Textile Industry," Energies, MDPI, vol. 15(12), pages 1-21, June.
    2. Wan Afin Fadzlin & Md. Hasanuzzaman & Nasrudin Abd Rahim & Norridah Amin & Zafar Said, 2022. "Global Challenges of Current Building-Integrated Solar Water Heating Technologies and Its Prospects: A Comprehensive Review," Energies, MDPI, vol. 15(14), pages 1-42, July.
    3. Deymi-Dashtebayaz, Mahdi & Kheir Abadi, Majid & Asadi, Mostafa & Khutornaya, Julia & Sergienko, Olga, 2024. "Investigation of a new solar-wind energy-based heat pump dryer for food waste drying based on different weather conditions," Energy, Elsevier, vol. 290(C).
    4. Lozano-Medina, Alexis & Manzano, Luis & Marcos, José D. & Blanco-Marigorta, Ana M., 2019. "Design of a concentrating solar thermal collector installation for a hotel complex in Gran Canaria," Energy, Elsevier, vol. 183(C), pages 803-811.
    5. Zaaoumi, Anass & Asbik, Mohamed & Hafs, Hajar & Bah, Abdellah & Alaoui, Mohammed, 2021. "Thermal performance simulation analysis of solar field for parabolic trough collectors assigned for ambient conditions in Morocco," Renewable Energy, Elsevier, vol. 163(C), pages 1479-1494.
    6. jia, Teng & Huang, Junpeng & Li, Rui & He, Peng & Dai, Yanjun, 2018. "Status and prospect of solar heat for industrial processes in China," Renewable and Sustainable Energy Reviews, Elsevier, vol. 90(C), pages 475-489.
    7. Singh, Sukhmeet & Gill, R.S. & Hans, V.S. & Mittal, T.C., 2022. "Experimental performance and economic viability of evacuated tube solar collector assisted greenhouse dryer for sustainable development," Energy, Elsevier, vol. 241(C).
    8. Nahin Tasmin & Shahjadi Hisan Farjana & Md Rashed Hossain & Santu Golder & M. A. Parvez Mahmud, 2022. "Integration of Solar Process Heat in Industries: A Review," Clean Technol., MDPI, vol. 4(1), pages 1-35, February.
    9. Mekhilef, S. & Saidur, R. & Safari, A., 2011. "A review on solar energy use in industries," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(4), pages 1777-1790, May.
    10. Naik, Hardik & Baredar, Prashant & Kumar, Anil, 2017. "Medium temperature application of concentrated solar thermal technology: Indian perspective," Renewable and Sustainable Energy Reviews, Elsevier, vol. 76(C), pages 369-378.
    11. Jayathunga, D.S. & Karunathilake, H.P. & Narayana, M. & Witharana, S., 2024. "Phase change material (PCM) candidates for latent heat thermal energy storage (LHTES) in concentrated solar power (CSP) based thermal applications - A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 189(PB).
    12. Mattes, Katharina & Müller, Simon & Jäger, Angela & Weidner, Nadezda & Weißfloch, Ute, 2014. "Adoption and diffusion of renewable energy technologies: Influence of the policy mix in the manufacturing industry," Working Papers "Sustainability and Innovation" S6/2014, Fraunhofer Institute for Systems and Innovation Research (ISI).
    13. Ajbar, Wassila & Parrales, A. & Huicochea, A. & Hernández, J.A., 2022. "Different ways to improve parabolic trough solar collectors’ performance over the last four decades and their applications: A comprehensive review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 156(C).
    14. Islam, Md. Parvez & Morimoto, Tetsuo, 2018. "Advances in low to medium temperature non-concentrating solar thermal technology," Renewable and Sustainable Energy Reviews, Elsevier, vol. 82(P3), pages 2066-2093.
    15. Wallerand, Anna S. & Kermani, Maziar & Voillat, Régis & Kantor, Ivan & Maréchal, François, 2018. "Optimal design of solar-assisted industrial processes considering heat pumping: Case study of a dairy," Renewable Energy, Elsevier, vol. 128(PB), pages 565-585.
    16. Madeti, Siva Ramakrishna & Singh, S.N., 2017. "Online fault detection and the economic analysis of grid-connected photovoltaic systems," Energy, Elsevier, vol. 134(C), pages 121-135.
    17. Ali M. H. A. Khajah & Simon P. Philbin, 2022. "Techno-Economic Analysis and Modelling of the Feasibility of Wind Energy in Kuwait," Clean Technol., MDPI, vol. 4(1), pages 1-21, January.
    18. Wang, Kai & Pantaleo, Antonio M. & Herrando, María & Faccia, Michele & Pesmazoglou, Ioannis & Franchetti, Benjamin M. & Markides, Christos N., 2020. "Spectral-splitting hybrid PV-thermal (PVT) systems for combined heat and power provision to dairy farms," Renewable Energy, Elsevier, vol. 159(C), pages 1047-1065.
    19. Li, Chennan & Goswami, Yogi & Stefanakos, Elias, 2013. "Solar assisted sea water desalination: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 19(C), pages 136-163.
    20. Rajput, Usman Jamil & Alhadrami, Hani & Al-Hazmi, Faten & Guo, Quiquan & Yang, Jun, 2017. "Initial investigations of a combined photo-assisted water cleaner and thermal collector," Renewable Energy, Elsevier, vol. 113(C), pages 235-247.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:23:p:8888-:d:983067. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.