IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i15p5651-d880045.html
   My bibliography  Save this article

Modeling the Performance Degradation of a High-Temperature PEM Fuel Cell

Author

Listed:
  • Mengfan Zhou

    (AAU Energy, Aalborg University, 9220 Aalborg Øst, Denmark)

  • Steffen Frensch

    (AAU Energy, Aalborg University, 9220 Aalborg Øst, Denmark)

  • Vincenzo Liso

    (AAU Energy, Aalborg University, 9220 Aalborg Øst, Denmark)

  • Na Li

    (AAU Energy, Aalborg University, 9220 Aalborg Øst, Denmark)

  • Simon Lennart Sahlin

    (AAU Energy, Aalborg University, 9220 Aalborg Øst, Denmark)

  • Giovanni Cinti

    (Department of Engineering, University of Perugia, Via G. Duranti 93, 06125 Perugia, Italy)

  • Samuel Simon Araya

    (AAU Energy, Aalborg University, 9220 Aalborg Øst, Denmark)

Abstract

In this paper, the performance of a high-temperature polymer electrolyte membrane fuel cell (HT-PEMFC) was modeled using literature data. The paper attempted to combine different sources from the literature to find trends in the degradation mechanisms of HT-PEMFCs. The model focused on the activation and ohmic losses. The activation losses were defined as a function of both Pt agglomeration and loss of catalyst material. The simulations revealed that the loss of electrochemical active surface area (ECSA) was a major contributor to the total voltage loss. The ohmic losses were defined as a function of changes of acid doping level in time. The loss of conductivity increased significantly on a percentage basis over time, but its impact on the overall voltage degradation was fairly low. It was found that the evaporation of phosphoric acid caused the ohmic overpotential to increase, especially at temperatures above 180 °C. Therefore, higher temperatures can lead to shorter lifetimes but increase the average power output over the lifetime of the fuel cell owing to a higher performance at higher temperatures. The lifetime prognosis was also made at different operating temperatures. It was shown that while the fuel cell performance increased linearly with increasing temperature at the beginning of its life, the voltage decay rate increased exponentially with an increasing temperature. Based on an analysis of the voltage decay rate and lifetime prognosis, the operating temperature range between 160 °C and 170 °C could be said to be optimal, as there was a significant increase in performance compared to lower operating temperatures without too much penalty in terms of lifetime.

Suggested Citation

  • Mengfan Zhou & Steffen Frensch & Vincenzo Liso & Na Li & Simon Lennart Sahlin & Giovanni Cinti & Samuel Simon Araya, 2022. "Modeling the Performance Degradation of a High-Temperature PEM Fuel Cell," Energies, MDPI, vol. 15(15), pages 1-21, August.
  • Handle: RePEc:gam:jeners:v:15:y:2022:i:15:p:5651-:d:880045
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/15/5651/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/15/15/5651/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Samuel Simon Araya & Vincenzo Liso & Xiaoti Cui & Na Li & Jimin Zhu & Simon Lennart Sahlin & Søren Højgaard Jensen & Mads Pagh Nielsen & Søren Knudsen Kær, 2020. "A Review of The Methanol Economy: The Fuel Cell Route," Energies, MDPI, vol. 13(3), pages 1-32, January.
    2. Gabriele Loreti & Andrea Luigi Facci & Stefano Ubertini, 2021. "High-Efficiency Combined Heat and Power through a High-Temperature Polymer Electrolyte Membrane Fuel Cell and Gas Turbine Hybrid System," Sustainability, MDPI, vol. 13(22), pages 1-24, November.
    3. Andreas Goldmann & Waldemar Sauter & Marcel Oettinger & Tim Kluge & Uwe Schröder & Joerg R. Seume & Jens Friedrichs & Friedrich Dinkelacker, 2018. "A Study on Electrofuels in Aviation," Energies, MDPI, vol. 11(2), pages 1-23, February.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Ruifeng Guo & Dongfang Chen & Yuehua Li & Wenlong Wu & Song Hu & Xiaoming Xu, 2023. "Anode Nitrogen Concentration Estimation Based on Voltage Variation Characteristics for Proton Exchange Membrane Fuel Cell Stacks," Energies, MDPI, vol. 16(5), pages 1-16, February.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Li, Na & Cui, Xiaoti & Zhu, Jimin & Zhou, Mengfan & Liso, Vincenzo & Cinti, Giovanni & Sahlin, Simon Lennart & Araya, Samuel Simon, 2023. "A review of reformed methanol-high temperature proton exchange membrane fuel cell systems," Renewable and Sustainable Energy Reviews, Elsevier, vol. 182(C).
    2. Stefan Arens & Sunke Schlüters & Benedikt Hanke & Karsten von Maydell & Carsten Agert, 2020. "Sustainable Residential Energy Supply: A Literature Review-Based Morphological Analysis," Energies, MDPI, vol. 13(2), pages 1-28, January.
    3. Li, Jiaxuan & Zhu, Xun & Djilali, Ned & Yang, Yang & Ye, Dingding & Chen, Rong & Liao, Qiang, 2022. "Comparative well-to-pump assessment of fueling pathways for zero-carbon transportation in China: Hydrogen economy or methanol economy?," Renewable and Sustainable Energy Reviews, Elsevier, vol. 169(C).
    4. Sofia Pinheiro Melo & Alexander Barke & Felipe Cerdas & Christian Thies & Mark Mennenga & Thomas S. Spengler & Christoph Herrmann, 2020. "Sustainability Assessment and Engineering of Emerging Aircraft Technologies—Challenges, Methods and Tools," Sustainability, MDPI, vol. 12(14), pages 1-27, July.
    5. Ngoc Van Trinh & Younghyeon Kim & Hongjip Kim & Sangseok Yu, 2021. "Evaporation of Methanol Solution for a Methanol Steam Reforming System," Energies, MDPI, vol. 14(16), pages 1-15, August.
    6. Lester, Mason Scott & Bramstoft, Rasmus & Münster, Marie, 2020. "Analysis on Electrofuels in Future Energy Systems: A 2050 Case Study," Energy, Elsevier, vol. 199(C).
    7. Marco-Osvaldo Vigueras-Zuniga & Maria-Elena Tejeda-del-Cueto & José-Alejandro Vasquez-Santacruz & Agustín-Leobardo Herrera-May & Agustin Valera-Medina, 2020. "Numerical Predictions of a Swirl Combustor Using Complex Chemistry Fueled with Ammonia/Hydrogen Blends," Energies, MDPI, vol. 13(2), pages 1-17, January.
    8. Ho, Calvin K. & McAuley, Kimberley B. & Peppley, Brant A., 2019. "Biolubricants through renewable hydrocarbons: A perspective for new opportunities," Renewable and Sustainable Energy Reviews, Elsevier, vol. 113(C), pages 1-1.
    9. Kim, Heehyang & Kim, Ayeon & Byun, Manhee & Lim, Hankwon, 2021. "Comparative feasibility studies of H2 supply scenarios for methanol as a carbon-neutral H2 carrier at various scales and distances," Renewable Energy, Elsevier, vol. 180(C), pages 552-559.
    10. Carlos Arnaiz del Pozo & Ángel Jiménez Álvaro & Schalk Cloete & Jose Antonio García del Pozo Martín de Hijas, 2023. "The Potential of Chemically Recuperated Power Cycles in Markets with High Shares of Variable Renewables," Energies, MDPI, vol. 16(20), pages 1-22, October.
    11. Anders Christian Olesen & Søren Knudsen Kær & Torsten Berning, 2022. "A Multi-Fluid Model for Water and Methanol Transport in a Direct Methanol Fuel Cell," Energies, MDPI, vol. 15(19), pages 1-23, September.
    12. Simone Speizer & Jay Fuhrman & Laura Aldrete Lopez & Mel George & Page Kyle & Seth Monteith & Haewon McJeon, 2024. "Integrated assessment modeling of a zero-emissions global transportation sector," Nature Communications, Nature, vol. 15(1), pages 1-15, December.
    13. Solmaz Nadiri & Paul Zimmermann & Laxmi Sane & Ravi Fernandes & Friedrich Dinkelacker & Bo Shu, 2021. "Kinetic Modeling Study on the Combustion Characterization of Synthetic C3 and C4 Alcohols for Lean Premixed Prevaporized Combustion," Energies, MDPI, vol. 14(17), pages 1-26, September.
    14. Magdalena Klopott & Marzenna Popek & Ilona Urbanyi-Popiołek, 2023. "Seaports’ Role in Ensuring the Availability of Alternative Marine Fuels—A Multi-Faceted Analysis," Energies, MDPI, vol. 16(7), pages 1-30, March.
    15. Sukhe Badmaev & Vladimir Sobyanin, 2020. "Production of Hydrogen-Rich Gas by Oxidative Steam Reforming of Dimethoxymethane over CuO-CeO 2 /γ-Al 2 O 3 Catalyst," Energies, MDPI, vol. 13(14), pages 1-10, July.
    16. Freire Ordóñez, Diego & Shah, Nilay & Guillén-Gosálbez, Gonzalo, 2021. "Economic and full environmental assessment of electrofuels via electrolysis and co-electrolysis considering externalities," Applied Energy, Elsevier, vol. 286(C).
    17. Giovanni Cinti & Vincenzo Liso & Simon Lennart Sahlin & Samuel Simon Araya, 2020. "System Design and Modeling of a High Temperature PEM Fuel Cell Operated with Ammonia as a Fuel," Energies, MDPI, vol. 13(18), pages 1-17, September.
    18. Lai, Y.Y. & Christley, E. & Kulanovic, A. & Teng, C.C. & Björklund, A. & Nordensvärd, J. & Karakaya, E. & Urban, F., 2022. "Analysing the opportunities and challenges for mitigating the climate impact of aviation: A narrative review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 156(C).
    19. Guoqiang Wang & Feng Wang & Bohong Chen, 2020. "Performance Study on Methanol Steam Reforming Rib Micro-Reactor with Waste Heat Recovery," Energies, MDPI, vol. 13(7), pages 1-18, March.
    20. Raffaele Salvucci & Stefan Petrović & Kenneth Karlsson & Markus Wråke & Tanu Priya Uteng & Olexandr Balyk, 2019. "Energy Scenario Analysis for the Nordic Transport Sector: A Critical Review," Energies, MDPI, vol. 12(12), pages 1-19, June.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:15:p:5651-:d:880045. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.