IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v297y2024ics0360544224010600.html
   My bibliography  Save this article

Conceptual design and multi-objective optimization of a hybrid system based on direct ammonia protonic ceramic fuel cell and alkali metal thermal electric converter

Author

Listed:
  • Han, Yuan
  • Gao, Wenzhi
  • Qin, Yanzhou

Abstract

As a power generation device, direct ammonia protonic ceramic fuel cells (NH3–PCFCs) also produce a significant amount waste heat, which not only results in energy wastage but also abnormal operation if the waste heat is not removed. To address these concerns and enhance generation electricity capacity, a novel waste heat recovery system based upon NH3-PCFC and alkali metal thermal electric converter (AMTEC) is first proposed, wherein the AMTEC converts the high-grade exhaust heat produced by the NH3-PCFC to extra electricity. Considering ammonia decomposition sluggish kinetics, various irreversible overpotential losses of NH3-PCFC as well as thermodynamic losses within the integrated system, the energetic/exergetic performance parameters evaluating the NH3-PCFC, AMTEC and the hybrid system are formulated. The general performance characteristics of the proposed system are revealed, along with a sensitive analysis conducted under specific operational conditions or structural parameters. Numerical calculation exhibited that the maximum attainable power density of the hybrid system has been promoted 20.5 % than that of stand-alone NH3-PCFC system. The multi-objective genetic algorithm is utilized to optimize the hybrid system performance for trade-off the power output and efficiency. Optimized results show the power density and corresponding efficiency of proposed system can respectively reach 6762.3 W m−2 and 49.8 % in the corresponding optimization conditions.

Suggested Citation

  • Han, Yuan & Gao, Wenzhi & Qin, Yanzhou, 2024. "Conceptual design and multi-objective optimization of a hybrid system based on direct ammonia protonic ceramic fuel cell and alkali metal thermal electric converter," Energy, Elsevier, vol. 297(C).
    • Handle: RePEc:eee:energy:v:297:y:2024:i:c:s0360544224010600
    DOI: 10.1016/j.energy.2024.131287
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544224010600
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2024.131287?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Li, Zheng & He, Qijiao & Wang, Chen & Yu, Na & Bello, Idris Temitope & Guo, Meiting & Ni, Meng, 2023. "Protonic ceramic fuel cells for power-ethylene cogeneration: A modelling study on structural parameters," Energy, Elsevier, vol. 264(C).
    2. Yang, Puqing & Zhang, Houcheng, 2015. "Parametric analysis of an irreversible proton exchange membrane fuel cell/absorption refrigerator hybrid system," Energy, Elsevier, vol. 85(C), pages 458-467.
    3. Menon, Vikram & Banerjee, Aayan & Dailly, Julian & Deutschmann, Olaf, 2015. "Numerical analysis of mass and heat transport in proton-conducting SOFCs with direct internal reforming," Applied Energy, Elsevier, vol. 149(C), pages 161-175.
    4. Lei, Libin & Mo, Yingyu & Huang, Yue & Qiu, Ruiming & Tian, Zhipeng & Wang, Junyao & Liu, Jianping & Chen, Ying & Zhang, Jihao & Tao, Zetian & Liang, Bo & Wang, Chao, 2023. "Revealing and quantifying the role of oxygen-ionic current in proton-conducting solid oxide fuel cells: A modeling study," Energy, Elsevier, vol. 276(C).
    5. Han, Yuan & Zhang, Houcheng, 2022. "Potentiality of elastocaloric cooling system for high-temperature proton exchange membrane fuel cell waste heat harvesting," Renewable Energy, Elsevier, vol. 200(C), pages 1166-1179.
    6. Sadrameli, S.M., 2016. "Mathematical models for the simulation of thermal regenerators: A state-of-the-art review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 58(C), pages 462-476.
    7. Chi, Yuanying & Xu, Weiyue & Xiao, Meng & Wang, Zhengzao & Zhang, Xufeng & Chen, Yahui, 2023. "Fuel-cycle based environmental and economic assessment of hydrogen fuel cell vehicles in China," Energy, Elsevier, vol. 282(C).
    8. Han, Yuan & Zhang, Houcheng & Hu, Ziyang & Hou, Shujin, 2021. "An efficient hybrid system using a graphene-based cathode vacuum thermionic energy converter to harvest the waste heat from a molten hydroxide direct carbon fuel cell," Energy, Elsevier, vol. 223(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Mingfei Li & Jingjing Wang & Zhengpeng Chen & Xiuyang Qian & Chuanqi Sun & Di Gan & Kai Xiong & Mumin Rao & Chuangting Chen & Xi Li, 2024. "A Comprehensive Review of Thermal Management in Solid Oxide Fuel Cells: Focus on Burners, Heat Exchangers, and Strategies," Energies, MDPI, vol. 17(5), pages 1-30, February.
    2. Zhang, Xin & Li, Jingwen & Xiong, Yi & Ang, Yee Sin, 2022. "Efficient harvesting of low-grade waste heat from proton exchange membrane fuel cells via thermoradiative power devices," Energy, Elsevier, vol. 258(C).
    3. Lei, Libin & Mo, Yingyu & Huang, Yue & Qiu, Ruiming & Tian, Zhipeng & Wang, Junyao & Liu, Jianping & Chen, Ying & Zhang, Jihao & Tao, Zetian & Liang, Bo & Wang, Chao, 2023. "Revealing and quantifying the role of oxygen-ionic current in proton-conducting solid oxide fuel cells: A modeling study," Energy, Elsevier, vol. 276(C).
    4. Khojaste Effatpanah, Saeed & Rahbari, Hamid Reza & Ahmadi, Mohammad H. & Farzaneh, Ali, 2023. "Green hydrogen production and utilization in a novel SOFC/GT-based zero-carbon cogeneration system: A thermodynamic evaluation," Renewable Energy, Elsevier, vol. 219(P2).
    5. Hanif, Muhammad Bilal & Rauf, Sajid & Sultan, Amir & Tayyab, Zuhra & Zheng, Kun & Makarov, Hryhorii & Madej, Dominika & Łasocha, Wiesław & Roch, Tomas & Mosiałek, Michał & Baker, Richard T. & Li, Chen, 2024. "Boosting the electrochemical performance of oxygen electrodes via the formation of LSCF-BaCe0.9–xMoxY0.1O3–δ triple conducting composite for solid oxide fuel cells: Part II," Energy, Elsevier, vol. 289(C).
    6. Wang, Baoxuan & Zhu, Jiang & Lin, Zijing, 2016. "A theoretical framework for multiphysics modeling of methane fueled solid oxide fuel cell and analysis of low steam methane reforming kinetics," Applied Energy, Elsevier, vol. 176(C), pages 1-11.
    7. Xu, Haoran & Chen, Bin & Tan, Peng & Zhang, Houcheng & Yuan, Jinliang & Liu, Jiang & Ni, Meng, 2017. "Performance improvement of a direct carbon solid oxide fuel cell system by combining with a Stirling cycle," Energy, Elsevier, vol. 140(P1), pages 979-987.
    8. Silva-Mosqueda, Dulce María & Elizalde-Blancas, Francisco & Pumiglia, Davide & Santoni, Francesca & Boigues-Muñoz, Carlos & McPhail, Stephen J., 2019. "Intermediate temperature solid oxide fuel cell under internal reforming: Critical operating conditions, associated problems and their impact on the performance," Applied Energy, Elsevier, vol. 235(C), pages 625-640.
    9. Yu, Xianxian & Liu, Yang & Tu, Zhengkai & Chan, Siew Hwa, 2023. "Endplate effect in an open-cathode proton exchange membrane fuel cell stack: Phenomenon and resolution," Renewable Energy, Elsevier, vol. 219(P1).
    10. Lei, Libin & Keels, Jayson M. & Tao, Zetian & Zhang, Jihao & Chen, Fanglin, 2018. "Thermodynamic and experimental assessment of proton conducting solid oxide fuel cells with internal methane steam reforming," Applied Energy, Elsevier, vol. 224(C), pages 280-288.
    11. Zhao, Jian & Ozden, Adnan & Shahgaldi, Samaneh & Alaefour, Ibrahim E. & Li, Xianguo & Hamdullahpur, Feridun, 2018. "Effect of Pt loading and catalyst type on the pore structure of porous electrodes in polymer electrolyte membrane (PEM) fuel cells," Energy, Elsevier, vol. 150(C), pages 69-76.
    12. Chen, Xiaohang & Wang, Yuan & Zhao, Yingru & Zhou, Yinghui, 2016. "A study of double functions and load matching of a phosphoric acid fuel cell/heat-driven refrigerator hybrid system," Energy, Elsevier, vol. 101(C), pages 359-365.
    13. Rashid, Kashif & Dong, Sang Keun & Mehran, Muhammad Taqi & Lee, Dong Won, 2017. "Design and analysis of compact hotbox for solid oxide fuel cell based 1kW-class power generation system," Applied Energy, Elsevier, vol. 208(C), pages 620-636.
    14. Zou, Wen-Jiang & Shen, Kun-Yang & Jung, Seunghun & Kim, Young-Bae, 2021. "Application of thermoelectric devices in performance optimization of a domestic PEMFC-based CHP system," Energy, Elsevier, vol. 229(C).
    15. Shiyou Tao & Zhaohui Peng & Weiguang Zheng, 2024. "Energy Management Strategy of Fuel Cell Commercial Vehicles Based on Adaptive Rules," Sustainability, MDPI, vol. 16(17), pages 1-22, August.
    16. Taner, Tolga, 2018. "Energy and exergy analyze of PEM fuel cell: A case study of modeling and simulations," Energy, Elsevier, vol. 143(C), pages 284-294.
    17. Andrés Meana-Fernández & Juan M. González-Caballín & Roberto Martínez-Pérez & Francisco J. Rubio-Serrano & Antonio J. Gutiérrez-Trashorras, 2022. "Power Plant Cycles: Evolution towards More Sustainable and Environmentally Friendly Technologies," Energies, MDPI, vol. 15(23), pages 1-27, November.
    18. Putilov, L.P. & Demin, A.K. & Tsidilkovski, V.I. & Tsiakaras, P., 2019. "Theoretical modeling of the gas humidification effect on the characteristics of proton ceramic fuel cells," Applied Energy, Elsevier, vol. 242(C), pages 1448-1459.
    19. Wang, Shengnan & Li, Yunhua & Li, Yun-Ze & Peng, Xing & Mao, Yufeng, 2018. "Exergy based parametric analysis of a cooling and power co-generation system for the life support system of extravehicular spacesuits," Renewable Energy, Elsevier, vol. 115(C), pages 1209-1219.
    20. Liang, Tao & Chen, Jingyi & Chen, Xiaohang & Su, Shanhe & Chen, Jincan, 2022. "Trade-off between the near-field heat transfer and the space charge effect in graphene-anode thermionic energy converters," Energy, Elsevier, vol. 260(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:297:y:2024:i:c:s0360544224010600. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.