IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v189y2019ics0360544219320584.html
   My bibliography  Save this article

Performance of a direct-injection natural gas engine with multiple injection strategies

Author

Listed:
  • Li, Menghan
  • Liu, Gengfei
  • Liu, Xiaori
  • Li, Zhijie
  • Zhang, Qiang
  • Shen, Boxiong

Abstract

This paper presents the experimental results for the performance of a direct-injection natural gas marine engine with different multiple injection strategies. In order to investigate the effects of natural gas post injection proportion and natural gas injection separation, a series of tests were performed at five different injection proportions (8%, 10%, 15%, 20%, 25%) and injection separation from 100μs to 700 μs at every 100 μs. The averaged cylinder pressure traces and combustion parameters (MFB50%, MFB90% and MFB5-90%) of each test point were calculated for combustion analysis. HC, CO and NOx emissions were collected to reveal the emissions characteristics. The results showed that the peak values of cylinder pressure and heat release rate will be lower than that of natural gas single injection strategy when multiple natural gas injection strategies are applied. Though the phase angle of 50% mass fraction burned is advanced at medium natural gas injection separations, the phase angle of 90% mass fraction burned is more likely to occur early at longer natural gas injection separations. With regard to emissions, HC and NOx emissions can benefit from using shorter natural gas injection separations while CO can only be reduced with small post injection proportions with certain natural gas injection separations.

Suggested Citation

  • Li, Menghan & Liu, Gengfei & Liu, Xiaori & Li, Zhijie & Zhang, Qiang & Shen, Boxiong, 2019. "Performance of a direct-injection natural gas engine with multiple injection strategies," Energy, Elsevier, vol. 189(C).
  • Handle: RePEc:eee:energy:v:189:y:2019:i:c:s0360544219320584
    DOI: 10.1016/j.energy.2019.116363
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544219320584
    Download Restriction: Full text for ScienceDirect subscribers only

    File URL: https://libkey.io/10.1016/j.energy.2019.116363?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Suh, Hyun Kyu, 2011. "Investigations of multiple injection strategies for the improvement of combustion and exhaust emissions characteristics in a low compression ratio (CR) engine," Applied Energy, Elsevier, vol. 88(12), pages 5013-5019.
    2. Jeftić, Marko & Zheng, Ming, 2015. "A study of the effect of post injection on combustion and emissions with premixing enhanced fueling strategies," Applied Energy, Elsevier, vol. 157(C), pages 861-870.
    3. Huang, Haozhong & Zhou, Chengzhong & Liu, Qingsheng & Wang, Qingxin & Wang, Xueqiang, 2016. "An experimental study on the combustion and emission characteristics of a diesel engine under low temperature combustion of diesel/gasoline/n-butanol blends," Applied Energy, Elsevier, vol. 170(C), pages 219-231.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Yang, Xiyu & Wang, Xiaoyan & Dong, Quan & Ni, Zuo & Song, Jingdong & Zhou, Tanqing, 2022. "Experimental study on the two-phase fuel transient injection characteristics of the high-pressure natural gas and diesel co-direct injection engine," Energy, Elsevier, vol. 243(C).
    2. Pei, Zhongwen & Liu, Kaimin & Luo, Wusheng & Yang, Jing & Li, Yangtao, 2023. "Experimental study on the effect of aftertreatment system on the energy flow pattern and emission reduction of a natural gas engine under world harmonized transient cycle," Energy, Elsevier, vol. 263(PB).
    3. Yang, Xiyu & Dong, Quan & Wang, Xiaoyan & Zhou, Tanqing & Wei, Daijun, 2023. "An experimental study on the needle valve motion characteristics of high pressure natural gas and diesel co-direct injector," Energy, Elsevier, vol. 265(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Liu, Junheng & Sun, Ping & Huang, He & Meng, Jian & Yao, Xiaohua, 2017. "Experimental investigation on performance, combustion and emission characteristics of a common-rail diesel engine fueled with polyoxymethylene dimethyl ethers-diesel blends," Applied Energy, Elsevier, vol. 202(C), pages 527-536.
    2. Li, Hao & Song, Chonglin & Lv, Gang & Pang, Huating & Qiao, Yuehan, 2017. "Assessment of the impact of post-injection on exhaust pollutants emitted from a diesel engine fueled with biodiesel," Renewable Energy, Elsevier, vol. 114(PB), pages 924-933.
    3. Jaliliantabar, Farzad & Ghobadian, Barat & Carlucci, Antonio Paolo & Najafi, Gholamhassan & Mamat, Rizalman & Ficarella, Antonio & Strafella, Luciano & Santino, Angelo & De Domenico, Stefania, 2020. "A comprehensive study on the effect of pilot injection, EGR rate, IMEP and biodiesel characteristics on a CRDI diesel engine," Energy, Elsevier, vol. 194(C).
    4. Lapuerta, Magín & Hernández, Juan José & Fernández-Rodríguez, David & Cova-Bonillo, Alexis, 2017. "Autoignition of blends of n-butanol and ethanol with diesel or biodiesel fuels in a constant-volume combustion chamber," Energy, Elsevier, vol. 118(C), pages 613-621.
    5. Wang, Yifeng & Yao, Mingfa & Li, Tie & Zhang, Weijing & Zheng, Zunqing, 2016. "A parametric study for enabling reactivity controlled compression ignition (RCCI) operation in diesel engines at various engine loads," Applied Energy, Elsevier, vol. 175(C), pages 389-402.
    6. Pachiannan, Tamilselvan & Zhong, Wenjun & Rajkumar, Sundararajan & He, Zhixia & Leng, Xianying & Wang, Qian, 2019. "A literature review of fuel effects on performance and emission characteristics of low-temperature combustion strategies," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    7. Catania, A.E. & Ferrari, A., 2012. "Development and performance assessment of the new-generation CF fuel injection system for diesel passenger cars," Applied Energy, Elsevier, vol. 91(1), pages 483-495.
    8. Shen, Shiquan & Sun, Kai & Che, Zhizhao & Wang, Tianyou & Jia, Ming & Cai, Junqian, 2020. "Mechanism of micro-explosion of water-in-oil emulsified fuel droplet and its effect on soot generation," Energy, Elsevier, vol. 191(C).
    9. Chen, Longfei & Ding, Shirun & Liu, Haoye & Lu, Yiji & Li, Yanfei & Roskilly, Anthony Paul, 2017. "Comparative study of combustion and emissions of kerosene (RP-3), kerosene-pentanol blends and diesel in a compression ignition engine," Applied Energy, Elsevier, vol. 203(C), pages 91-100.
    10. Kamil, Mohammed & Ramadan, Khalid M. & Olabi, Abdul Ghani & Al-Ali, Eman I. & Ma, Xiao & Awad, Omar I., 2020. "Economic, technical, and environmental viability of biodiesel blends derived from coffee waste," Renewable Energy, Elsevier, vol. 147(P1), pages 1880-1894.
    11. Yanuandri Putrasari & Ocktaeck Lim, 2019. "A Review of Gasoline Compression Ignition: A Promising Technology Potentially Fueled with Mixtures of Gasoline and Biodiesel to Meet Future Engine Efficiency and Emission Targets," Energies, MDPI, vol. 12(2), pages 1-27, January.
    12. Haifeng Liu & Xichang Wang & Diping Zhang & Fang Dong & Xinlu Liu & Yong Yang & Haozhong Huang & Yang Wang & Qianlong Wang & Zunqing Zheng, 2019. "Investigation on Blending Effects of Gasoline Fuel with N-Butanol, DMF, and Ethanol on the Fuel Consumption and Harmful Emissions in a GDI Vehicle," Energies, MDPI, vol. 12(10), pages 1-21, May.
    13. Tamilvanan, A. & Mohanraj, T. & Ashok, B. & Santhoshkumar, A., 2023. "Enhancement of energy conversion and emission reduction of Calophyllum inophyllum biodiesel in diesel engine using reactivity controlled compression ignition strategy and TOPSIS optimization," Energy, Elsevier, vol. 264(C).
    14. Sheriff, S. Abdul & Kumar, Indrala Kishan & Mandhatha, Petluri Sai & Jambal, Samraj Sunder & Sellappan, Raja & Ashok, B. & Nanthagopal, K., 2020. "Emission reduction in CI engine using biofuel reformulation strategies through nano additives for atmospheric air quality improvement," Renewable Energy, Elsevier, vol. 147(P1), pages 2295-2308.
    15. Zhao, Wenbin & Mi, Shijie & Wu, Haoqing & Zhang, Yaoyuan & Zhang, Qiankun & He, Zhuoyao & Qian, Yong & Lu, Xingcai, 2022. "Towards a comprehensive understanding of mode transition between biodiesel-biobutanol dual-fuel ICCI low temperature combustion and conventional CI combustion – Part Ⅰ: Characteristics from medium to ," Energy, Elsevier, vol. 246(C).
    16. Natascia Palazzo & Lars Zigan & Franz J. T. Huber & Stefan Will, 2020. "Impact of Oxygenated Additives on Soot Properties during Diesel Combustion," Energies, MDPI, vol. 14(1), pages 1-21, December.
    17. Alagumalai, Avinash, 2014. "Internal combustion engines: Progress and prospects," Renewable and Sustainable Energy Reviews, Elsevier, vol. 38(C), pages 561-571.
    18. Huang, Haozhong & Wang, Qingxin & Shi, Cheng & Liu, Qingsheng & Zhou, Chengzhong, 2016. "Comparative study of effects of pilot injection and fuel properties on low temperature combustion in diesel engine under a medium EGR rate," Applied Energy, Elsevier, vol. 179(C), pages 1194-1208.
    19. How, H.G. & Teoh, Y.H. & Masjuki, H.H. & Nguyen, H.-T. & Kalam, M.A. & Chuah, H.G. & Alabdulkarem, A., 2019. "Impact of two-stage injection fuel quantity on engine-out responses of a common-rail diesel engine fueled with coconut oil methyl esters-diesel fuel blends," Renewable Energy, Elsevier, vol. 139(C), pages 515-529.
    20. Han, Taehoon & Singh, Ripudaman & Lavoie, George & Wooldridge, Margaret & Boehman, André, 2020. "Multiple injection for improving knock, gaseous and particulate matter emissions in direct injection SI engines," Applied Energy, Elsevier, vol. 262(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:189:y:2019:i:c:s0360544219320584. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.