IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v172y2019icp881-891.html
   My bibliography  Save this article

Analysis of thermal and flow phenomena in natural circulation boiler evaporator

Author

Listed:
  • Grądziel, Sławomir

Abstract

An original in-house mathematical model enabling the analysis of thermal and flow phenomena occurring in the evaporator of a natural circulation boiler is proposed herein. It is a distributed parameter model based on an original approach to the problem of solving the equations describing the principles of mass, momentum, and energy conservation. The equations are solved using the method of lines. Space derivatives are written on the left side of the equations and time derivatives are approximated using difference quotients. This system of ordinary differential equations is solved using the Runge–Kutta method. Such an approach is characterised by high stability and accurate calculations. The developed model is applied to obtain the fluid mass flow, pressure, and enthalpy (temperature) values in the boiler evaporator. It can be applied in single- and two-phase flows. This paper presents the original results of the testing of the flow phenomena occurring in the boiler evaporator in steady and transient states. Steady-state tests were performed for different boiler loads. The operating multiplicity of the fluid circulation in the boiler evaporator was determined. A flow meter was installed on a downcomer, which enabled a comparison between the measured values of the water mass flow and those calculated using the developed model. The presented model can also be applied for the analysis of the boiler evaporator operation at an abrupt increase or decrease in pressure in emergency situations. Such occurrences may cause water stagnation in the evaporator tubes; therefore, the tubes may crack.

Suggested Citation

  • Grądziel, Sławomir, 2019. "Analysis of thermal and flow phenomena in natural circulation boiler evaporator," Energy, Elsevier, vol. 172(C), pages 881-891.
    • Handle: RePEc:eee:energy:v:172:y:2019:i:c:p:881-891
    DOI: 10.1016/j.energy.2019.02.003
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544219301926
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2019.02.003?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Sreepradha, Chandrasekharan & Panda, Rames Chandra & Bhuvaneswari, Natrajan Swaminathan, 2017. "Mathematical model for integrated coal fired thermal boiler using physical laws," Energy, Elsevier, vol. 118(C), pages 985-998.
    2. Zima, Wiesław & Nowak-Ocłoń, Marzena & Ocłoń, Paweł, 2018. "Novel online simulation-ready models of conjugate heat transfer in combustion chamber waterwall tubes of supercritical power boilers," Energy, Elsevier, vol. 148(C), pages 809-823.
    3. Sunil, P.U. & Barve, Jayesh & Nataraj, P.S.V., 2017. "Mathematical modeling, simulation and validation of a boiler drum: Some investigations," Energy, Elsevier, vol. 126(C), pages 312-325.
    4. Zima, Wiesław & Nowak-Ocłoń, Marzena & Ocłoń, Paweł, 2015. "Simulation of fluid heating in combustion chamber waterwalls of boilers for supercritical steam parameters," Energy, Elsevier, vol. 92(P1), pages 117-127.
    5. Taler, Jan & Dzierwa, Piotr & Taler, Dawid & Harchut, Piotr, 2015. "Optimization of the boiler start-up taking into account thermal stresses," Energy, Elsevier, vol. 92(P1), pages 160-170.
    6. Taler, Jan & Węglowski, Bohdan & Taler, Dawid & Sobota, Tomasz & Dzierwa, Piotr & Trojan, Marcin & Madejski, Paweł & Pilarczyk, Marcin, 2015. "Determination of start-up curves for a boiler with natural circulation based on the analysis of stress distribution in critical pressure components," Energy, Elsevier, vol. 92(P1), pages 153-159.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Taler, Jan & Zima, Wiesław & Ocłoń, Paweł & Grądziel, Sławomir & Taler, Dawid & Cebula, Artur & Jaremkiewicz, Magdalena & Korzeń, Anna & Cisek, Piotr & Kaczmarski, Karol & Majewski, Karol, 2019. "Mathematical model of a supercritical power boiler for simulating rapid changes in boiler thermal loading," Energy, Elsevier, vol. 175(C), pages 580-592.
    2. Zhou, Jing & Zhu, Meng & Su, Sheng & Chen, Lei & Xu, Jun & Hu, Song & Wang, Yi & Jiang, Long & Zhong, Wenqi & Xiang, Jun, 2020. "Numerical analysis and modified thermodynamic calculation methods for the furnace in the 1000 MW supercritical CO2 coal-fired boiler," Energy, Elsevier, vol. 212(C).
    3. Zima, Wiesław & Grądziel, Sławomir & Cebula, Artur & Rerak, Monika & Kozak-Jagieła, Ewa & Pilarczyk, Marcin, 2023. "Mathematical model of a power boiler operation under rapid thermal load changes," Energy, Elsevier, vol. 263(PC).
    4. Majdak, Marek & Grądziel, Sławomir, 2020. "Influence of thermal and flow conditions on the thermal stresses distribution in the evaporator tubes," Energy, Elsevier, vol. 209(C).
    5. Zima, Wiesław, 2019. "Simulation of steam superheater operation under conditions of pressure decrease," Energy, Elsevier, vol. 172(C), pages 932-944.
    6. Romero-Anton, N. & Martin-Escudero, K. & Portillo-Valdés, L.A. & Gómez-Elvira, I. & Salazar-Herran, E., 2018. "Improvement of auxiliary BI-DRUM boiler operation by dynamic simulation," Energy, Elsevier, vol. 148(C), pages 676-686.
    7. Taler, Dawid & Dzierwa, Piotr & Taler, Jan, 2020. "New method for determining the optimum fluid temperature when heating pressure thick-walled components with openings," Energy, Elsevier, vol. 200(C).
    8. Omar Mohamed & Ashraf Khalil & Jihong Wang, 2020. "Modeling and Control of Supercritical and Ultra-Supercritical Power Plants: A Review," Energies, MDPI, vol. 13(11), pages 1-23, June.
    9. Hübel, Moritz & Meinke, Sebastian & Andrén, Marcus T. & Wedding, Christoffer & Nocke, Jürgen & Gierow, Conrad & Hassel, Egon & Funkquist, Jonas, 2017. "Modelling and simulation of a coal-fired power plant for start-up optimisation," Applied Energy, Elsevier, vol. 208(C), pages 319-331.
    10. Taler, Jan & Taler, Dawid, 2024. "Analysis of the possibility of reducing the heating time of thick-walled cylindrical components with holes," Energy, Elsevier, vol. 303(C).
    11. Rúa, Jairo & Nord, Lars O., 2020. "Optimal control of flexible natural gas combined cycles with stress monitoring: Linear vs nonlinear model predictive control," Applied Energy, Elsevier, vol. 265(C).
    12. Taler, Dawid & Dzierwa, Piotr & Kaczmarski, Karol & Taler, Jan, 2022. "Increase the flexibility of steam boilers by optimisation of critical pressure component heating," Energy, Elsevier, vol. 250(C).
    13. Zhang, Hengliang & Xie, Danmei & Yu, Yanzhi & Yu, Liangying, 2016. "Online optimal control schemes of inlet steam temperature during startup of steam turbines considering low cycle fatigue," Energy, Elsevier, vol. 117(P1), pages 105-115.
    14. Zima, Wiesław & Nowak-Ocłoń, Marzena & Ocłoń, Paweł, 2018. "Novel online simulation-ready models of conjugate heat transfer in combustion chamber waterwall tubes of supercritical power boilers," Energy, Elsevier, vol. 148(C), pages 809-823.
    15. Nowak, Grzegorz & Rusin, Andrzej & Łukowicz, Henryk & Tomala, Martyna, 2020. "Improving the power unit operation flexibility by the turbine start-up optimization," Energy, Elsevier, vol. 198(C).
    16. Trojan, Marcin, 2019. "Modeling of a steam boiler operation using the boiler nonlinear mathematical model," Energy, Elsevier, vol. 175(C), pages 1194-1208.
    17. Rusin, Andrzej & Nowak, Grzegorz & Łukowicz, Henryk & Kosman, Wojciech & Chmielniak, Tadeusz & Kaczorowski, Maciej, 2021. "Selecting optimal conditions for the turbine warm and hot start-up," Energy, Elsevier, vol. 214(C).
    18. Andrzej Rusin & Martyna Tomala & Henryk Łukowicz & Grzegorz Nowak & Wojciech Kosman, 2021. "On-Line Control of Stresses in the Power Unit Pressure Elements Taking Account of Variable Heat Transfer Conditions," Energies, MDPI, vol. 14(15), pages 1-21, August.
    19. Konstantin Osintsev & Sergei Aliukov & Yuri Prikhodko, 2021. "Management of the Torch Structure with the New Methodological Approaches to Regulation Based on Neural Network Algorithms," Energies, MDPI, vol. 14(7), pages 1-17, March.
    20. Hou, Guolian & Gong, Linjuan & Huang, Congzhi & Zhang, Jianhua, 2020. "Fuzzy modeling and fast model predictive control of gas turbine system," Energy, Elsevier, vol. 200(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:172:y:2019:i:c:p:881-891. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.