IDEAS home Printed from https://ideas.repec.org/a/gam/jworld/v3y2022i3p23-448d860799.html
   My bibliography  Save this article

Economic Analysis of a Conceptual Industrial Route for Printed Circuit Boards Processing Based on Mass and Energy Balances

Author

Listed:
  • Felipe Seabra d’Almeida

    (Department of Chemical and Materials Engineering, Pontifical Catholic University of Rio de Janeiro, Rio de Janeiro 22451-900, Brazil)

  • Roberto Bentes de Carvalho

    (Department of Chemical and Materials Engineering, Pontifical Catholic University of Rio de Janeiro, Rio de Janeiro 22451-900, Brazil)

  • Felipe Sombra dos Santos

    (School of Chemistry, Federal University of Rio de Janeiro, Rio de Janeiro 21941-901, Brazil)

  • Rodrigo Fernandes Magalhães de Souza

    (Department of Chemical and Materials Engineering, Pontifical Catholic University of Rio de Janeiro, Rio de Janeiro 22451-900, Brazil)

Abstract

With a generation of more than 2 million metric tons per year, Brazil is the largest producer of waste electrical and electronic equipment in Latin America. However, Brazil does not have its own way for treating printed circuit boards, a key component present in this type of waste. In this context, the processing of these components would allow the extraction of metals with high added value, mainly copper, silver, gold, and palladium. The purpose of this research is to design a conceptual treatment route, based on the integration of technologies described in the literature. After creating the route design, a mass and energy balances were performed, considering two printed circuit board source as raw material: (Case A) Wasted equipment in general; (Case B) Using only cell phones. For both cases, the treatment of 2 t·h −1 was considered. In addition, cost estimates and plant sensitivity analysis were carried out. For 15 years of plant production, the calculated Capex was USD 2,002,682, where an internal return rate of 140.1% and 3933.0% was obtained for Case A and B, respectively, and a net present value of USD 44,403,373 and USD 3,210,393,496 for Case A and B, respectively. Additionally, it was observed that Case A has a great sensitivity to the variation of the processing volume. Based on the present findings, this theoretical research has the potential to be a nucleation point in the design of a future industrial plant dedicated to the recycling of printed circuit boards, as well as to understand the key variables for the processing these components, based on Brazilian circumstances. Additionally, the project presents the hypothetical investment required for the creation of such conceptual plant, which is a crucial piece of information for potential investors.

Suggested Citation

  • Felipe Seabra d’Almeida & Roberto Bentes de Carvalho & Felipe Sombra dos Santos & Rodrigo Fernandes Magalhães de Souza, 2022. "Economic Analysis of a Conceptual Industrial Route for Printed Circuit Boards Processing Based on Mass and Energy Balances," World, MDPI, vol. 3(3), pages 1-15, July.
    • Handle: RePEc:gam:jworld:v:3:y:2022:i:3:p:23-448:d:860799
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2673-4060/3/3/23/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2673-4060/3/3/23/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Nadiri, M Ishaq & Prucha, Ingmar R, 1996. "Estimation of the Depreciation Rate of Physical and R&D Capital in the U.S. Total Manufacturing Sector," Economic Inquiry, Western Economic Association International, vol. 34(1), pages 43-56, January.
    2. Qian, Yao & Ralescu, Dan A. & Zhang, Bo, 2019. "The analysis of factors affecting global gold price," Resources Policy, Elsevier, vol. 64(C).
    3. Lopes, Daniela de Carvalho & Steidle Neto, Antonio José & Mendes, Adriano Aguiar & Pereira, Débora Tamires Vítor, 2013. "Economic feasibility of biodiesel production from Macauba in Brazil," Energy Economics, Elsevier, vol. 40(C), pages 819-824.
    4. Alvarado, S & Maldonado, P & Barrios, A & Jaques, I, 2002. "Long term energy-related environmental issues of copper production," Energy, Elsevier, vol. 27(2), pages 183-196.
    5. Felipe Seabra D’Almeida & Roberto Bentes de Carvalho & Felipe Sombra dos Santos & Rodrigo Fernandes Magalhães de Souza, 2021. "On the Hibernating Electronic Waste in Rio de Janeiro Higher Education Community: An Assessment of Population Behavior Analysis and Economic Potential," Sustainability, MDPI, vol. 13(16), pages 1-16, August.
    6. Qadan, Mahmoud, 2019. "Risk appetite and the prices of precious metals," Resources Policy, Elsevier, vol. 62(C), pages 136-153.
    7. Roberta Alves & Karen Lana Alves Ferreira & Renato da Silva Lima & Flavia Tuane Ferreira Moraes, 2021. "An Action Research Study for Elaborating and Implementing an Electronic Waste Collection Program in Brazil," Systemic Practice and Action Research, Springer, vol. 34(1), pages 91-108, February.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Elliott, Robert J.R. & Sun, Puyang & Xu, Qiqin, 2015. "Energy distribution and economic growth: An empirical test for China," Energy Economics, Elsevier, vol. 48(C), pages 24-31.
    2. Steve Newbold & Charles Griffiths & Christopher C. Moore & Ann Wolverton & Elizabeth Kopits, 2010. "The "Social Cost of Carbon" Made Simple," NCEE Working Paper Series 201007, National Center for Environmental Economics, U.S. Environmental Protection Agency, revised Aug 2010.
    3. Ignacio Mauleón & Jordi Sardá, 2000. "Income measurement and comparisons," International Advances in Economic Research, Springer;International Atlantic Economic Society, vol. 6(3), pages 475-487, August.
    4. Fthenakis, Vasilis & Wang, Wenming & Kim, Hyung Chul, 2009. "Life cycle inventory analysis of the production of metals used in photovoltaics," Renewable and Sustainable Energy Reviews, Elsevier, vol. 13(3), pages 493-517, April.
    5. Jeffrey Bernstein, 1997. "Interindustry R&D Spillovers for Electrical and Electronic Products: The Canadian Case," Economic Systems Research, Taylor & Francis Journals, vol. 9(1), pages 111-125.
    6. Francesco Bogliacino & Marco Vivarelli, 2012. "The Job Creation Effect Of R&D Expenditures," Australian Economic Papers, Wiley Blackwell, vol. 51(2), pages 96-113, June.
    7. Luo, Yulei & Nie, Jun & Young, Eric R., 2014. "Robust control, informational frictions, and international consumption correlations," European Economic Review, Elsevier, vol. 67(C), pages 1-27.
    8. Ortega-Argilés, Raquel & Piva, Mariacristina & Vivarelli, Marco, 2011. "Productivity Gains from R&D Investment: Are High-Tech Sectors Still Ahead?," IZA Discussion Papers 5975, Institute of Labor Economics (IZA).
    9. Raffaele Paci & Stefano Usai, 1998. "Innovative Efforts, Technological Opportunity And Changes In Market Structure In Italian Manufacturing," Economics of Innovation and New Technology, Taylor & Francis Journals, vol. 7(4), pages 345-369.
    10. Tommaso Ciarli & André Lorentz & Marco Valente & Maria Savona, 2019. "Structural changes and growth regimes," Journal of Evolutionary Economics, Springer, vol. 29(1), pages 119-176, March.
    11. Daniel J. Wilson, 2002. "Is Embodied Technology the Result of Upstream R&D? Industry-Level Evidence," Review of Economic Dynamics, Elsevier for the Society for Economic Dynamics, vol. 5(2), pages 285-317, April.
    12. Aqib Aslam & Enrico Berkes & Martin Fukac & Jeta Menkulasi & Axel Schimmelpfennig, 2014. "Afghanistan: Balancing Social and Security Spending in the Context of a Shrinking Resource Envelope," Asian Development Review, MIT Press, vol. 31(2), pages 165-197, September.
    13. Xiaoguang Chen & Madhu Khanna & Lu Yang, 2022. "The impacts of temperature on Chinese food processing firms," Australian Journal of Agricultural and Resource Economics, Australian Agricultural and Resource Economics Society, vol. 66(2), pages 256-279, April.
    14. Adediran, Idris A. & Yinusa, Olalekan D. & Lakhani, Kanwal Hammad, 2021. "Where lies the silver lining when uncertainty hang dark clouds over the global financial markets?," Resources Policy, Elsevier, vol. 70(C).
    15. Carneiro, Fernando Moraes & Turnovsky, Stephen J. & Tourinho, Octavio Augusto Fontes, 2022. "Economic growth and inequality tradeoffs under progressive taxation," Journal of Economic Dynamics and Control, Elsevier, vol. 143(C).
    16. Böckerman, Petri & Eero, Lehto & Huovari, Janne, 2008. "The return to the technological frontier: The conditional effect of plants’ R&D on their productivity in Finnish manufacturing," MPRA Paper 8715, University Library of Munich, Germany.
    17. Esposti, Roberto & Pierani, Pierpaolo, 2000. "Modelling technical change in Italian agriculture: a latent variable approach," Agricultural Economics, Blackwell, vol. 22(3), pages 261-270, April.
    18. Talbi, Marwa & de Peretti, Christian & Belkacem, Lotfi, 2020. "Dynamics and causality in distribution between spot and future precious metals: A copula approach," Resources Policy, Elsevier, vol. 66(C).
    19. Ning Huang & Erwin Diewert, 2011. "Estimation of R&D depreciation rates: a suggested methodology and preliminary application," Canadian Journal of Economics, Canadian Economics Association, vol. 44(2), pages 387-412, May.
    20. Gerhard Glomm & Juergen Jung, 2013. "The Timing of Redistribution," Southern Economic Journal, John Wiley & Sons, vol. 80(1), pages 50-80, July.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jworld:v:3:y:2022:i:3:p:23-448:d:860799. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.