IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i2p751-d1029619.html
   My bibliography  Save this article

Numerical Analysis of Two-Stage Turbine System for Multicylinder Engine under Pulse Flow Conditions with High Pressure-Ratio Turbine Rotor

Author

Listed:
  • Dariusz Kozak

    (Department of Aircraft Engines, Faculty of Power and Aeronautical Engineering, Institute of Heat Engineering, Warsaw University of Technology, 00-665 Warsaw, Poland)

  • Paweł Mazuro

    (Department of Aircraft Engines, Faculty of Power and Aeronautical Engineering, Institute of Heat Engineering, Warsaw University of Technology, 00-665 Warsaw, Poland)

Abstract

Internal combustion engine (ICE) exhaust gases provide a high amount of energy which is partially lost to the environment. Such energy can be recovered with a turbocharger turbine or other after-treatment device. As the engine exhaust flow varies not only with the engine load but also with the opening and closing of the exhaust valves, a proper matching between the engine and the turbine should be established to maximize the recovery of waste energy. That is why a twin-scroll or dual turbocharging system is implemented, especially in multi-cylinder engines. Such systems require a very complex pipeline to eliminate the interference of the exhaust pulses between the adjacent cylinder ignitions. In this study, the two-stage, multi-channel turbine system was investigated for two different rotor geometries: the old, high-performance rotor A and the smaller but more modern rotor B, which was scaled to match rotor A. Both geometries were compared at three different turbine speeds and variable turbine geometry (VTG) vane positions. It was found that the two-stage turbine system with rotor B geometry provided an 8% higher total efficiency than rotor A due to the lower flow losses within the rotor passage.

Suggested Citation

  • Dariusz Kozak & Paweł Mazuro, 2023. "Numerical Analysis of Two-Stage Turbine System for Multicylinder Engine under Pulse Flow Conditions with High Pressure-Ratio Turbine Rotor," Energies, MDPI, vol. 16(2), pages 1-46, January.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:2:p:751-:d:1029619
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/2/751/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/2/751/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Dariusz Kozak & Paweł Mazuro & Andrzej Teodorczyk, 2021. "Numerical Simulation of Two-Stage Variable Geometry Turbine," Energies, MDPI, vol. 14(17), pages 1-34, August.
    2. Beichuan Hong & Varun Venkataraman & Andreas Cronhjort, 2021. "Numerical Analysis of Engine Exhaust Flow Parameters for Resolving Pre-Turbine Pulsating Flow Enthalpy and Exergy," Energies, MDPI, vol. 14(19), pages 1-24, September.
    3. Hanwei Wang & Yue Chao & Tian Tang & Kai Luo & Kan Qin, 2021. "A Comparison of Partial Admission Axial and Radial Inflow Turbines for Underwater Vehicles," Energies, MDPI, vol. 14(5), pages 1-20, March.
    4. Vittorio Usai & Silvia Marelli, 2021. "Steady State Experimental Characterization of a Twin Entry Turbine under Different Admission Conditions," Energies, MDPI, vol. 14(8), pages 1-17, April.
    5. Chiong, M.S. & Rajoo, S. & Romagnoli, A. & Costall, A.W. & Martinez-Botas, R.F., 2016. "One-dimensional pulse-flow modeling of a twin-scroll turbine," Energy, Elsevier, vol. 115(P1), pages 1291-1304.
    6. Marelli, Silvia & Capobianco, Massimo, 2011. "Steady and pulsating flow efficiency of a waste-gated turbocharger radial flow turbine for automotive application," Energy, Elsevier, vol. 36(1), pages 459-465.
    7. Galindo, J. & Fajardo, P. & Navarro, R. & García-Cuevas, L.M., 2013. "Characterization of a radial turbocharger turbine in pulsating flow by means of CFD and its application to engine modeling," Applied Energy, Elsevier, vol. 103(C), pages 116-127.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ding, Zhanming & Zhuge, Weilin & Zhang, Yangjun & Chen, Hua & Martinez-Botas, Ricardo & Yang, Mingyang, 2017. "A one-dimensional unsteady performance model for turbocharger turbines," Energy, Elsevier, vol. 132(C), pages 341-355.
    2. Zhao, Rongchao & Li, Weihua & Zhuge, Weilin & Zhang, Yangjun & Yin, Yong & Wu, Yonghui, 2018. "Characterization of two-stage turbine system under steady and pulsating flow conditions," Energy, Elsevier, vol. 148(C), pages 407-423.
    3. Xue, Yingxian & Yang, Mingyang & Pan, Lei & Deng, Kangyao & Wu, Xintao & Wang, Cuicui, 2021. "Gasdynamic behaviours of a radial turbine with pulsating incoming flow," Energy, Elsevier, vol. 218(C).
    4. Afrouzi, Hamid Hassanzadeh & Ahmadian, Majid & Moshfegh, Abouzar & Toghraie, Davood & Javadzadegan, Ashkan, 2019. "Statistical analysis of pulsating non-Newtonian flow in a corrugated channel using Lattice-Boltzmann method," Physica A: Statistical Mechanics and its Applications, Elsevier, vol. 535(C).
    5. Zhu, Dengting & Zheng, Xinqian, 2018. "A new asymmetric twin-scroll turbine with two wastegates for energy improvements in diesel engines," Applied Energy, Elsevier, vol. 223(C), pages 263-272.
    6. José Galindo & Andrés Tiseira & Roberto Navarro & Lukas Benjamin Inhestern & Juan David Echavarría, 2022. "Numerical Analysis of the Effects of Different Rotor Tip Gaps in a Radial Turbine Operating at High Pressure Ratios Reaching Choked Flow," Energies, MDPI, vol. 15(24), pages 1-30, December.
    7. Kim, Jeong Ho & Kim, Tong Seop, 2019. "A new approach to generate turbine map data in the sub-idle operation regime of gas turbines," Energy, Elsevier, vol. 173(C), pages 772-784.
    8. Liu, Zheng & Copeland, Colin, 2018. "New method for mapping radial turbines exposed to pulsating flows," Energy, Elsevier, vol. 162(C), pages 1205-1222.
    9. Marelli, Silvia & Marmorato, Giulio & Capobianco, Massimo, 2016. "Evaluation of heat transfer effects in small turbochargers by theoretical model and its experimental validation," Energy, Elsevier, vol. 112(C), pages 264-272.
    10. Zhu, Dengting & Zheng, Xinqian, 2019. "Fuel consumption and emission characteristics in asymmetric twin-scroll turbocharged diesel engine with two exhaust gas recirculation circuits," Applied Energy, Elsevier, vol. 238(C), pages 985-995.
    11. Wei, Jiangshan & Xue, Yingxian & Deng, Kangyao & Yang, Mingyang & Liu, Ying, 2020. "A direct comparison of unsteady influence of turbine with twin-entry and single-entry scroll on performance of internal combustion engine," Energy, Elsevier, vol. 212(C).
    12. Serrano, José Ramón & Olmeda, Pablo & Tiseira, Andrés & García-Cuevas, Luis Miguel & Lefebvre, Alain, 2013. "Theoretical and experimental study of mechanical losses in automotive turbochargers," Energy, Elsevier, vol. 55(C), pages 888-898.
    13. Tregenza, Owen & Olshina, Noam & Hield, Peter & Manzie, Chris & Hulston, Chris, 2022. "A comparison of turbine mass flow models based on pragmatic identification data sets for turbogenerator model development," Energy, Elsevier, vol. 247(C).
    14. Sheng Yin & Jimin Ni & Houchuan Fan & Xiuyong Shi & Rong Huang, 2022. "A Study of Evaluation Method for Turbocharger Turbine Based on Joint Operation Curve," Sustainability, MDPI, vol. 14(16), pages 1-18, August.
    15. Wang, Hanwei & Luo, Kai & Huang, Chuang & Zou, Aihong & Li, Daijin & Qin, Kan, 2022. "Numerical investigation of partial admission losses in radial inflow turbines," Energy, Elsevier, vol. 239(PA).
    16. Serrano, José Ramón & Navarro, Roberto & García-Cuevas, Luis Miguel & Inhestern, Lukas Benjamin, 2018. "Turbocharger turbine rotor tip leakage loss and mass flow model valid up to extreme off-design conditions with high blade to jet speed ratio," Energy, Elsevier, vol. 147(C), pages 1299-1310.
    17. Luján, José Manuel & Bermúdez, Vicente & Piqueras, Pedro & García-Afonso, Óscar, 2015. "Experimental assessment of pre-turbo aftertreatment configurations in a single stage turbocharged diesel engine. Part 1: Steady-state operation," Energy, Elsevier, vol. 80(C), pages 599-613.
    18. Galindo, J. & Fajardo, P. & Navarro, R. & García-Cuevas, L.M., 2013. "Characterization of a radial turbocharger turbine in pulsating flow by means of CFD and its application to engine modeling," Applied Energy, Elsevier, vol. 103(C), pages 116-127.
    19. Khalil, Khalil M. & Mahmoud, S. & Al- Dadah, R.K., 2020. "Experimental and numerical investigation of blade height effects on micro-scale axial turbines performance using compressed air open cycle," Energy, Elsevier, vol. 211(C).
    20. Wang, Chongming & Xu, Hongming & Herreros, Jose Martin & Wang, Jianxin & Cracknell, Roger, 2014. "Impact of fuel and injection system on particle emissions from a GDI engine," Applied Energy, Elsevier, vol. 132(C), pages 178-191.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:2:p:751-:d:1029619. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.