IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i5p1940-d765975.html
   My bibliography  Save this article

Effect of Ignition Energy and Hydrogen Addition on Laminar Flame Speed, Ignition Delay Time, and Flame Rising Time of Lean Methane/Air Mixtures

Author

Listed:
  • Minh Tien Nguyen

    (Department of Mechanical Engineering, The University of Danang—University of Technology and Education, Da Nang 50000, Vietnam)

  • Van Van Luong

    (Faculty of Automotive Engineering Technology, Vinh Long University of Technology Education, Vinh Long 85000, Vietnam)

  • Quoc Thai Pham

    (Faculty of Transportation, The University of Danang—University of Science and Technology, Da Nang 50000, Vietnam)

  • Minh Tung Phung

    (Department of Mechanical Engineering, The University of Danang—University of Technology and Education, Da Nang 50000, Vietnam)

  • Phu Nguu Do

    (Department of Mechanical Engineering, The University of Danang—University of Technology and Education, Da Nang 50000, Vietnam)

Abstract

A series of experiments were performed to investigate the effect of ignition energy (E ig ) and hydrogen addition on the laminar burning velocity ( S u 0 ), ignition delay time ( t delay ), and flame rising time ( t rising ) of lean methane−air mixtures. The mixtures at three different equivalence ratios ( ϕ ) of 0.6, 0.7, and 0.8 with varying hydrogen volume fractions from 0 to 50% were centrally ignited in a constant volume combustion chamber by a pair of pin-to-pin electrodes at a spark gap of 2.0 mm. In situ ignition energy (E ig ∼2.4 mJ ÷ 58 mJ) was calculated by integration of the product of current and voltage between positive and negative electrodes. The result revealed that the S u 0 value increases non-linearly with increasing hydrogen fraction at three equivalence ratios of 0.6, 0.7, and 0.8, by which the increasing slope of S u 0 changes from gradual to drastic when the hydrogen fraction is greater than 20%. t delay and t rising decrease quickly with increasing hydrogen fraction; however, t rising drops faster than t delay at ϕ = 0.6 and 0.7, and the reverse is true at ϕ = 0.8. Furthermore, t delay transition is observed when E ig > E ig,critical , by which t delay drastically drops in the pre-transition and gradually decreases in the post-transition. These results may be relevant to spark ignition engines operated under lean-burn conditions.

Suggested Citation

  • Minh Tien Nguyen & Van Van Luong & Quoc Thai Pham & Minh Tung Phung & Phu Nguu Do, 2022. "Effect of Ignition Energy and Hydrogen Addition on Laminar Flame Speed, Ignition Delay Time, and Flame Rising Time of Lean Methane/Air Mixtures," Energies, MDPI, vol. 15(5), pages 1-10, March.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:5:p:1940-:d:765975
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/5/1940/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/5/1940/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Jung, Dongwon & Sasaki, Kosaku & Iida, Norimasa, 2017. "Effects of increased spark discharge energy and enhanced in-cylinder turbulence level on lean limits and cycle-to-cycle variations of combustion for SI engine operation," Applied Energy, Elsevier, vol. 205(C), pages 1467-1477.
    2. Tsuboi, Seima & Miyokawa, Shinji & Matsuda, Masayoshi & Yokomori, Takeshi & Iida, Norimasa, 2019. "Influence of spark discharge characteristics on ignition and combustion process and the lean operation limit in a spark ignition engine," Applied Energy, Elsevier, vol. 250(C), pages 617-632.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Maria Mitu & Codina Movileanu & Venera Giurcan, 2022. "The Laminar Burning Velocities of Stoichiometric Methane–Air Mixture from Closed Vessels Measurements," Energies, MDPI, vol. 15(14), pages 1-17, July.
    2. Simon Drost & Sven Eckart & Chunkan Yu & Robert Schießl & Hartmut Krause & Ulrich Maas, 2023. "Numerical and Experimental Investigations of CH 4 /H 2 Mixtures: Ignition Delay Times, Laminar Burning Velocity and Extinction Limits," Energies, MDPI, vol. 16(6), pages 1-17, March.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yin, Xiaojun & Sun, Nannan & Sun, Ting & Shen, Hongguang & Mehra, Roopesh Kumar & Liu, Junlong & Wang, Ying & Yang, Bo & Zeng, Ke, 2022. "Experimental investigation the effects of spark discharge characteristics on the heavy-duty spark ignition natural gas engine at low load condition," Energy, Elsevier, vol. 239(PC).
    2. Discepoli, G. & Cruccolini, V. & Ricci, F. & Di Giuseppe, A. & Papi, S. & Grimaldi, C.N., 2020. "Experimental characterisation of the thermal energy released by a Radio-Frequency Corona Igniter in nitrogen and air," Applied Energy, Elsevier, vol. 263(C).
    3. Liu, Zuowen & Zheng, Zhaolei, 2024. "Effects of in-cylinder water injection on knocking and combustion stability generated by expanding the lean burn limit," Applied Energy, Elsevier, vol. 367(C).
    4. Wei, Haiqiao & Zhang, Ren & Chen, Lin & Pan, Jiaying & Wang, Xuan, 2021. "Effects of high ignition energy on lean combustion characteristics of natural gas using an optical engine with a high compression ratio," Energy, Elsevier, vol. 223(C).
    5. Liu, Zuowen & Zheng, Zhaolei, 2024. "The effect of ignition energy on the lean combustion limitation in high compression ratio engines," Energy, Elsevier, vol. 301(C).
    6. Cinzia Tornatore & Magnus Sjöberg, 2021. "Optical Investigation of a Partial Fuel Stratification Strategy to Stabilize Overall Lean Operation of a DISI Engine Fueled with Gasoline and E30," Energies, MDPI, vol. 14(2), pages 1-32, January.
    7. Gong, Changming & Yi, Lin & Zhang, Zilei & Sun, Jingzhen & Liu, Fenghua, 2020. "Assessment of ultra-lean burn characteristics for a stratified-charge direct-injection spark-ignition methanol engine under different high compression ratios," Applied Energy, Elsevier, vol. 261(C).
    8. Yurii Gutarevych & Vasyl Mateichyk & Jonas Matijošius & Alfredas Rimkus & Igor Gritsuk & Oleksander Syrota & Yevheniy Shuba, 2020. "Improving Fuel Economy of Spark Ignition Engines Applying the Combined Method of Power Regulation," Energies, MDPI, vol. 13(5), pages 1-19, March.
    9. Ghaderi Masouleh, M. & Keskinen, K. & Kaario, O. & Kahila, H. & Karimkashi, S. & Vuorinen, V., 2019. "Modeling cycle-to-cycle variations in spark ignited combustion engines by scale-resolving simulations for different engine speeds," Applied Energy, Elsevier, vol. 250(C), pages 801-820.
    10. Zhang, Zhiyuan & Feng, Huihua & He, Hongwen & Jia, Boru & Zuo, Zhengxing & Liu, Chang & Smallbone, Andrew & Roskilly, Anthony Paul, 2023. "Demonstration of a single/dual cylinder free-piston engine generator prototype: Milestone achieved on system stability," Energy, Elsevier, vol. 278(PA).
    11. Huang, Shuai & Li, Tie & Zhang, Zhifei & Ma, Pengfei, 2019. "Rotational and vibrational temperatures in the spark plasma by various discharge energies and strategies," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    12. d'Adamo, A. & Iacovano, C. & Fontanesi, S., 2020. "Large-Eddy simulation of lean and ultra-lean combustion using advanced ignition modelling in a transparent combustion chamber engine," Applied Energy, Elsevier, vol. 280(C).
    13. Ghaderi Masouleh, M. & Keskinen, K. & Kaario, O. & Kahila, H. & Wright, Y.M. & Vuorinen, V., 2018. "Flow and thermal field effects on cycle-to-cycle variation of combustion: scale-resolving simulation in a spark ignited simplified engine configuration," Applied Energy, Elsevier, vol. 230(C), pages 486-505.
    14. Federico Ricci & Francesco Mariani & Stefano Papi & Jacopo Zembi & Michele Battistoni & Carlo Nazareno Grimaldi, 2024. "The Synergy between Methanol M100 and Plasma-Assisted Ignition System PAI to Achieve Increasingly Leaner Mixtures in a Single-Cylinder Engine," Energies, MDPI, vol. 17(7), pages 1-14, March.
    15. He, Bang-Quan & Xu, Si-Peng & Fu, Xue-Qing & Zhao, Hua, 2020. "Combustion and emission characteristics of an ultra-lean burn gasoline engine with dimethyl ether auto-ignition," Energy, Elsevier, vol. 209(C).
    16. Schröder, Lukas & Hillenbrand, Thomas & Brüggemann, Dieter, 2024. "Evaluation of the combustion process of directly injected methane in a rapid compression machine with a laser-based ignition system and an electrical ignition system," Energy, Elsevier, vol. 289(C).
    17. Tsuboi, Seima & Miyokawa, Shinji & Matsuda, Masayoshi & Yokomori, Takeshi & Iida, Norimasa, 2019. "Influence of spark discharge characteristics on ignition and combustion process and the lean operation limit in a spark ignition engine," Applied Energy, Elsevier, vol. 250(C), pages 617-632.
    18. Huang, Shuai & Li, Tie & Zhang, Zhifei & Wang, Linyan & Yu, Xiao & Zheng, Ming & Yang, Rundai & Zhao, Xinwu, 2021. "Influencing factors on the vibrational and rotational temperatures in the spark discharge channel," Energy, Elsevier, vol. 222(C).
    19. Haruki Tajima & Takuya Tomidokoro & Takeshi Yokomori, 2022. "Deep Learning for Knock Occurrence Prediction in SI Engines," Energies, MDPI, vol. 15(24), pages 1-14, December.
    20. Jung, Dongwon & Iida, Norimasa, 2018. "An investigation of multiple spark discharge using multi-coil ignition system for improving thermal efficiency of lean SI engine operation," Applied Energy, Elsevier, vol. 212(C), pages 322-332.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:5:p:1940-:d:765975. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.