IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v13y2020i15p3770-d388104.html
   My bibliography  Save this article

Distributed Power Hardware-in-the-Loop Testing Using a Grid-Forming Converter as Power Interface

Author

Listed:
  • Steffen Vogel

    (RWTH Aachen University, 52062 Aachen, Germany
    These authors contributed equally to this work.)

  • Ha Thi Nguyen

    (Technical University of Denmark, 2800 Kgs. Lyngby, Denmark
    These authors contributed equally to this work.)

  • Marija Stevic

    (RWTH Aachen University, 52062 Aachen, Germany
    These authors contributed equally to this work.)

  • Tue Vissing Jensen

    (Technical University of Denmark, 2800 Kgs. Lyngby, Denmark
    These authors contributed equally to this work.)

  • Kai Heussen

    (Technical University of Denmark, 2800 Kgs. Lyngby, Denmark
    These authors contributed equally to this work.)

  • Vetrivel Subramaniam Rajkumar

    (Delft University of Technology, 2628 CD Delft, The Netherlands)

  • Antonello Monti

    (RWTH Aachen University, 52062 Aachen, Germany)

Abstract

This paper presents an approach to extend the capabilities of smart grid laboratories through the concept of Power Hardware-in-the-Loop (PHiL) testing by re-purposing existing grid-forming converters. A simple and cost-effective power interface, paired with a remotely located Digital Real-time Simulator (DRTS), facilitates Geographically Distributed Power Hardware Loop (GD-PHiL) in a quasi-static operating regime. In this study, a DRTS simulator was interfaced via the public internet with a grid-forming ship-to-shore converter located in a smart-grid testing laboratory, approximately 40 km away from the simulator. A case study based on the IEEE 13-bus distribution network, an on-load-tap-changer (OLTC) controller and a controllable load in the laboratory demonstrated the feasibility of such a setup. A simple compensation method applicable to this multi-rate setup is proposed and evaluated. Experimental results indicate that this compensation method significantly enhances the voltage response, whereas the conservation of energy at the coupling point still poses a challenge. Findings also show that, due to inherent limitations of the converter’s Modbus interface, a separate measurement setup is preferable. This can help achieve higher measurement fidelity, while simultaneously increasing the loop rate of the PHiL setup.

Suggested Citation

  • Steffen Vogel & Ha Thi Nguyen & Marija Stevic & Tue Vissing Jensen & Kai Heussen & Vetrivel Subramaniam Rajkumar & Antonello Monti, 2020. "Distributed Power Hardware-in-the-Loop Testing Using a Grid-Forming Converter as Power Interface," Energies, MDPI, vol. 13(15), pages 1-24, July.
    • Handle: RePEc:gam:jeners:v:13:y:2020:i:15:p:3770-:d:388104
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/13/15/3770/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/13/15/3770/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Kai Heussen & Cornelius Steinbrink & Ibrahim F. Abdulhadi & Van Hoa Nguyen & Merkebu Z. Degefa & Julia Merino & Tue V. Jensen & Hao Guo & Oliver Gehrke & Daniel Esteban Morales Bondy & Davood Babazade, 2019. "ERIGrid Holistic Test Description for Validating Cyber-Physical Energy Systems," Energies, MDPI, vol. 12(14), pages 1-31, July.
    2. Juan Montoya & Ron Brandl & Keerthi Vishwanath & Jay Johnson & Rachid Darbali-Zamora & Adam Summers & Jun Hashimoto & Hiroshi Kikusato & Taha Selim Ustun & Nayeem Ninad & Estefan Apablaza-Arancibia & , 2020. "Advanced Laboratory Testing Methods Using Real-Time Simulation and Hardware-in-the-Loop Techniques: A Survey of Smart Grid International Research Facility Network Activities," Energies, MDPI, vol. 13(12), pages 1-38, June.
    3. Luigi Pellegrino & Carlo Sandroni & Enea Bionda & Daniele Pala & Dimitris T. Lagos & Nikos Hatziargyriou & Nabil Akroud, 2020. "Remote Laboratory Testing Demonstration," Energies, MDPI, vol. 13(9), pages 1-16, May.
    4. Falko Ebe & Basem Idlbi & David E. Stakic & Shuo Chen & Christoph Kondzialka & Matthias Casel & Gerd Heilscher & Christian Seitl & Roland Bründlinger & Thomas I. Strasser, 2018. "Comparison of Power Hardware-in-the-Loop Approaches for the Testing of Smart Grid Controls," Energies, MDPI, vol. 11(12), pages 1-29, December.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Annette von Jouanne & Emmanuel Agamloh & Alex Yokochi, 2023. "Power Hardware-in-the-Loop (PHIL): A Review to Advance Smart Inverter-Based Grid-Edge Solutions," Energies, MDPI, vol. 16(2), pages 1-27, January.
    2. Juan Montoya & Ron Brandl & Keerthi Vishwanath & Jay Johnson & Rachid Darbali-Zamora & Adam Summers & Jun Hashimoto & Hiroshi Kikusato & Taha Selim Ustun & Nayeem Ninad & Estefan Apablaza-Arancibia & , 2020. "Advanced Laboratory Testing Methods Using Real-Time Simulation and Hardware-in-the-Loop Techniques: A Survey of Smart Grid International Research Facility Network Activities," Energies, MDPI, vol. 13(12), pages 1-38, June.
    3. Meysam Yousefzadeh & Shahin Hedayati Kia & Mohammad Hoseintabar Marzebali & Davood Arab Khaburi & Hubert Razik, 2022. "Power-Hardware-in-the-Loop for Stator Windings Asymmetry Fault Analysis in Direct-Drive PMSG-Based Wind Turbines," Energies, MDPI, vol. 15(19), pages 1-17, September.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Michał Michna & Filip Kutt & Łukasz Sienkiewicz & Roland Ryndzionek & Grzegorz Kostro & Dariusz Karkosiński & Bartłomiej Grochowski, 2020. "Mechanical-Level Hardware-In-The-Loop and Simulation in Validation Testing of Prototype Tower Crane Drives," Energies, MDPI, vol. 13(21), pages 1-25, November.
    2. Pedro Faria & Zita Vale, 2022. "Realistic Load Modeling for Efficient Consumption Management Using Real-Time Simulation and Power Hardware-in-the-Loop," Energies, MDPI, vol. 16(1), pages 1-15, December.
    3. Cezar-Petre Simion & Cătălin-Alexandru Verdeș & Alexandra-Andreea Mironescu & Florin-Gabriel Anghel, 2023. "Digitalization in Energy Production, Distribution, and Consumption: A Systematic Literature Review," Energies, MDPI, vol. 16(4), pages 1-30, February.
    4. Annette von Jouanne & Emmanuel Agamloh & Alex Yokochi, 2023. "Power Hardware-in-the-Loop (PHIL): A Review to Advance Smart Inverter-Based Grid-Edge Solutions," Energies, MDPI, vol. 16(2), pages 1-27, January.
    5. Jana Ihrens & Stefan Möws & Lennard Wilkening & Thorsten A. Kern & Christian Becker, 2021. "The Impact of Time Delays for Power Hardware-in-the-Loop Investigations," Energies, MDPI, vol. 14(11), pages 1-15, May.
    6. Yuko Hirase & Yuki Ohara & Naoya Matsuura & Takeaki Yamazaki, 2021. "Dynamics Analysis Using Koopman Mode Decomposition of a Microgrid Including Virtual Synchronous Generator-Based Inverters," Energies, MDPI, vol. 14(15), pages 1-20, July.
    7. Ode Bokker & Henning Schlachter & Vanessa Beutel & Stefan Geißendörfer & Karsten von Maydell, 2022. "Reactive Power Control of a Converter in a Hardware-Based Environment Using Deep Reinforcement Learning," Energies, MDPI, vol. 16(1), pages 1-12, December.
    8. Baoling Guo & Amgad Mohamed & Seddik Bacha & Mazen Alamir & Cédric Boudinet & Julien Pouget, 2020. "Reduced-Scale Models of Variable Speed Hydro-Electric Plants for Power Hardware-in-the-Loop Real-Time Simulations," Energies, MDPI, vol. 13(21), pages 1-22, November.
    9. Pejman Peidaee & Akhtar Kalam & Juan Shi, 2020. "Integration of a Heuristic Multi-Agent Protection System into a Distribution Network Interconnected with Distributed Energy Resources," Energies, MDPI, vol. 13(20), pages 1-25, October.
    10. Thomas I. Strasser & Sebastian Rohjans & Graeme M. Burt, 2019. "Methods and Concepts for Designing and Validating Smart Grid Systems," Energies, MDPI, vol. 12(10), pages 1-5, May.
    11. Michael H. Spiegel & Eric M. S. P. Veith & Thomas I. Strasser, 2020. "The Spectrum of Proactive, Resilient Multi-Microgrid Scheduling: A Systematic Literature Review," Energies, MDPI, vol. 13(17), pages 1-37, September.
    12. Ri Piao & Deok-Joo Lee & Taegu Kim, 2020. "Real-Time Pricing Scheme in Smart Grid Considering Time Preference: Game Theoretic Approach," Energies, MDPI, vol. 13(22), pages 1-19, November.
    13. Manuel Barragán-Villarejo & Francisco de Paula García-López & Alejandro Marano-Marcolini & José María Maza-Ortega, 2020. "Power System Hardware in the Loop (PSHIL): A Holistic Testing Approach for Smart Grid Technologies," Energies, MDPI, vol. 13(15), pages 1-22, July.
    14. Gaspar, José F. & Pinheiro, Rafael F. & Mendes, Mário J.G. C. & Kamarlouei, Mojtaba & Guedes Soares, C., 2024. "Review on hardware-in-the-loop simulation of wave energy converters and power take-offs," Renewable and Sustainable Energy Reviews, Elsevier, vol. 191(C).
    15. Juan Montoya & Ron Brandl & Keerthi Vishwanath & Jay Johnson & Rachid Darbali-Zamora & Adam Summers & Jun Hashimoto & Hiroshi Kikusato & Taha Selim Ustun & Nayeem Ninad & Estefan Apablaza-Arancibia & , 2020. "Advanced Laboratory Testing Methods Using Real-Time Simulation and Hardware-in-the-Loop Techniques: A Survey of Smart Grid International Research Facility Network Activities," Energies, MDPI, vol. 13(12), pages 1-38, June.
    16. Taha Selim Ustun & Shuichi Sugahara & Masaichi Suzuki & Jun Hashimoto & Kenji Otani, 2020. "Power Hardware in-the-Loop Testing to Analyze Fault Behavior of Smart Inverters in Distribution Networks," Sustainability, MDPI, vol. 12(22), pages 1-18, November.
    17. Moiz Muhammad & Holger Behrends & Stefan Geißendörfer & Karsten von Maydell & Carsten Agert, 2021. "Power Hardware-in-the-Loop: Response of Power Components in Real-Time Grid Simulation Environment," Energies, MDPI, vol. 14(3), pages 1-20, January.
    18. Hossein Abedini & Tommaso Caldognetto & Paolo Mattavelli & Paolo Tenti, 2020. "Real-Time Validation of Power Flow Control Method for Enhanced Operation of Microgrids," Energies, MDPI, vol. 13(22), pages 1-19, November.
    19. Yuko Hirase & Kazusa Uezaki & Dai Orihara & Hiroshi Kikusato & Jun Hashimoto, 2021. "Characteristic Analysis and Indexing of Multimachine Transient Stabilization Using Virtual Synchronous Generator Control," Energies, MDPI, vol. 14(2), pages 1-23, January.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:13:y:2020:i:15:p:3770-:d:388104. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.