IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v12y2019i4p758-d208791.html
   My bibliography  Save this article

Study on the Cooling Effect of Attached Fins on PV Using CFD Simulation

Author

Listed:
  • Jaemin Kim

    (Department of Architectural Engineering, Pusan National University, 2 Busandaehak-ro 63, Geomjeong-gu, Busan 46241, Korea)

  • Yujin Nam

    (Department of Architectural Engineering, Pusan National University, 2 Busandaehak-ro 63, Geomjeong-gu, Busan 46241, Korea)

Abstract

The issue of efficiency decrease according to temperature increase is a pending problem in the PV market. Several active and passive technologies have been suggested but few quantitative studies on the estimation of the cooling effect have been carried out. In this study, a CFD (computational fluid dynamics) simulation model was developed to analyze a passive cooling technology using fins attached to the back of the PV module. Furthermore, a method to improve airflow at the back of the PV module by forming slits in the frame was analyzed. The simulation model reproduced the indoor test that uses a solar simulator and the cooling performance was analyzed according to the shape of the fins and the presence of slits. In the simulation results, the surface temperature and expected electrical efficiency without cooling were 62.78 °C and 13.24% respectively under nominal operating cell temperature conditions. Moreover, the temperature reduced by approximately 15.13 °C because the fins attached at the bottom of the PV module increased the heat transfer area with airflow. Thus, the electrical efficiency according to the PV module temperature was predicted as 14.39%. Furthermore, when slits were installed between the fins, they increased the airflow velocity and accelerated the formation of turbulence, thereby improving the cooling performance of the fins. The simulation results showed that the temperature could be further reduced by approximately 8.62 °C at a lower air velocity. As the fins and slits can also reduce the non-uniformity of the temperature, they are expected to supplement the efficiency and durability reduction of the PV modules caused by the hot spot phenomenon. In addition, it was shown that slits in the frame could further improve the cooling performance of the fins at a low-velocity airflow.

Suggested Citation

  • Jaemin Kim & Yujin Nam, 2019. "Study on the Cooling Effect of Attached Fins on PV Using CFD Simulation," Energies, MDPI, vol. 12(4), pages 1-12, February.
    • Handle: RePEc:gam:jeners:v:12:y:2019:i:4:p:758-:d:208791
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/12/4/758/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/12/4/758/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Teo, H.G. & Lee, P.S. & Hawlader, M.N.A., 2012. "An active cooling system for photovoltaic modules," Applied Energy, Elsevier, vol. 90(1), pages 309-315.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Antonio D’Angola & Diana Enescu & Marianna Mecca & Alessandro Ciocia & Paolo Di Leo & Giovanni Vincenzo Fracastoro & Filippo Spertino, 2020. "Theoretical and Numerical Study of a Photovoltaic System with Active Fluid Cooling by a Fully-Coupled 3D Thermal and Electric Model," Energies, MDPI, vol. 13(4), pages 1-17, February.
    2. Khan, Sheher Yar & Waqas, Adeel & Kumar, Mahesh & Liu, Shuli & Shen, Yongliang & Chen, Tingsen & Shoaib, Muhammad & Khan, Muhammad Omair, 2024. "Experimental, numerical, and 4E assessment of photovoltaic module using macro-encapsulation of pure and nano phase change material: A comparative analysis," Energy, Elsevier, vol. 290(C).
    3. Yamuna Munusamy & John Wong Lin Onn & Mohammed Alquraish & Mohamed Kchaou & Sumathi Sethupathi, 2021. "Thermal Performance of Finned Heat Sinks Embedded with Form-Stable Myristic Acid Phase Change Material in Photovoltaic Cooling for Green Energy Storage," Energies, MDPI, vol. 14(21), pages 1-14, October.
    4. Alberto Benato & Anna Stoppato, 2019. "An Experimental Investigation of a Novel Low-Cost Photovoltaic Panel Active Cooling System," Energies, MDPI, vol. 12(8), pages 1-24, April.
    5. Gabriella-Stefánia Szabó & Róbert Szabó & Loránd Szabó, 2022. "A Review of the Mitigating Methods against the Energy Conversion Decrease in Solar Panels," Energies, MDPI, vol. 15(18), pages 1-21, September.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Basem, Ali & Alhuyi Nazari, Mohammad & Mehrabi, Ali & Ahmadi, Mohammad Hossein & Atamurotov, Farruh, 2024. "Effect of applying serpentine channels and hybrid nanofluid for thermal management of photovoltaic cell: Numerical simulation, ANN and sensitivity analysis," Renewable Energy, Elsevier, vol. 232(C).
    2. Perwez, Ashif & Ahmaed, Ashwaq & Li, Da & Zheng, Xiong & Qin, Guangzhao, 2024. "Performance enhancement of photovoltaic/thermal system using dimpled channel subjected to forced convection," Renewable Energy, Elsevier, vol. 237(PC).
    3. Sueyoshi, Toshiyuki & Goto, Mika, 2017. "Measurement of returns to scale on large photovoltaic power stations in the United States and Germany," Energy Economics, Elsevier, vol. 64(C), pages 306-320.
    4. Wassim Salameh & Jalal Faraj & Elias Harika & Rabih Murr & Mahmoud Khaled, 2021. "On the Optimization of Electrical Water Heaters: Modelling Simulations and Experimentation," Energies, MDPI, vol. 14(13), pages 1-12, June.
    5. Sueyoshi, Toshiyuki & Goto, Mika, 2014. "Photovoltaic power stations in Germany and the United States: A comparative study by data envelopment analysis," Energy Economics, Elsevier, vol. 42(C), pages 271-288.
    6. Kane, Aarti & Verma, Vishal & Singh, Bhim, 2017. "Optimization of thermoelectric cooling technology for an active cooling of photovoltaic panel," Renewable and Sustainable Energy Reviews, Elsevier, vol. 75(C), pages 1295-1305.
    7. Ahmed, Hossam A. & Megahed, Tamer F. & Mori, Shinsuke & Nada, Sameh & Hassan, Hamdy, 2023. "Novel design of thermo-electric air conditioning system integrated with PV panel for electric vehicles: Performance evaluation," Applied Energy, Elsevier, vol. 349(C).
    8. Saxena, Ashish & Deshmukh, Sandip & Nirali, Somanath & Wani, Saurabh, 2018. "Laboratory based Experimental Investigation of Photovoltaic (PV) Thermo-control with Water and its Proposed Real-time Implementation," Renewable Energy, Elsevier, vol. 115(C), pages 128-138.
    9. Alami, Abdul Hai, 2016. "Synthetic clay as an alternative backing material for passive temperature control of photovoltaic cells," Energy, Elsevier, vol. 108(C), pages 195-200.
    10. Zhou, Yuekuan & Zheng, Siqian & Zhang, Guoqiang, 2019. "Study on the energy performance enhancement of a new PCMs integrated hybrid system with the active cooling and hybrid ventilations," Energy, Elsevier, vol. 179(C), pages 111-128.
    11. Kim, Namsu & Kim, Dajung & Kang, Hanjun & Park, Yong-Gi, 2016. "Improved heat dissipation in a crystalline silicon PV module for better performance by using a highly thermal conducting backsheet," Energy, Elsevier, vol. 113(C), pages 515-520.
    12. Hussain, F. & Othman, M.Y.H & Sopian, K. & Yatim, B. & Ruslan, H. & Othman, H., 2013. "Design development and performance evaluation of photovoltaic/thermal (PV/T) air base solar collector," Renewable and Sustainable Energy Reviews, Elsevier, vol. 25(C), pages 431-441.
    13. Choi, Seok Min & Kwon, Hyun Goo & Kim, Taehyun & Moon, Hee Koo & Cho, Hyung Hee, 2022. "Active cooling of photovoltaic (PV) cell by acoustic excitation in single-dimpled internal channel," Applied Energy, Elsevier, vol. 309(C).
    14. Ashwini Pavgi & Jaewon Oh & GovindaSamy TamizhMani, 2021. "Thermally Conductive Backsheets (TCB) of PV Modules: Positive Impacts on Performance, Lifetime and LCOE," Energies, MDPI, vol. 14(5), pages 1-14, February.
    15. Karkaba, H. & Etienne, L. & Pelay, U. & Russeil, S. & Simo tala, J. & Boonaert, J. & Lecoeuche, S. & Bougeard, D., 2023. "Performance improvement of air cooled photo-voltaic thermal panel using economic model predictive control and vortex generators," Renewable Energy, Elsevier, vol. 218(C).
    16. Lucas, M. & Ruiz, J. & Aguilar, F.J. & Cutillas, C.G. & Kaiser, A.S. & Vicente, P.G., 2019. "Experimental study of a modified evaporative photovoltaic chimney including water sliding," Renewable Energy, Elsevier, vol. 134(C), pages 161-168.
    17. Oruc, Muhammed E. & Desai, Amit V. & Kenis, Paul J.A. & Nuzzo, Ralph G., 2016. "Comprehensive energy analysis of a photovoltaic thermal water electrolyzer," Applied Energy, Elsevier, vol. 164(C), pages 294-302.
    18. Deka, Manash Jyoti & Kamble, Akash Dilip & Das, Dudul & Sharma, Prabhakar & Ali, Shahadath & Kalita, Paragmoni & Bora, Bhaskor Jyoti & Kalita, Pankaj, 2024. "Enhancing the performance of a photovoltaic thermal system with phase change materials: Predictive modelling and evaluation using neural networks," Renewable Energy, Elsevier, vol. 224(C).
    19. Amori, Karima E. & Taqi Al-Najjar, Hussein M., 2012. "Analysis of thermal and electrical performance of a hybrid (PV/T) air based solar collector for Iraq," Applied Energy, Elsevier, vol. 98(C), pages 384-395.
    20. Han, Youhua & Liu, Yang & Lu, Shixiang & Basalike, Pie & Zhang, Jili, 2021. "Electrical performance and power prediction of a roll-bond photovoltaic thermal array under dewing and frosting conditions," Energy, Elsevier, vol. 237(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:12:y:2019:i:4:p:758-:d:208791. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.