IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v178y2019icp195-206.html
   My bibliography  Save this article

Effect of blade tip leakage flow on erosion of a radial inflow turbine for compressed air energy storage system

Author

Listed:
  • Wang, Xing
  • Zhang, Xuehui
  • Zhu, Yangli
  • Zhang, Xinjing
  • Li, Wen
  • Chen, Haisheng

Abstract

The erosion caused by sand particles significantly influences the safety of radial inflow turbine in Compressed Air Energy Storage (CAES) system which operated in desert area. In present study, effects of tip leakage flow on erosion of a CAES radial inflow turbine are investigated at different tip clearances and total pressure ratios. A CFD model coupling Tabakoff and Grant erosion model is utilized for the analysis. Results illustrate that the trailing edge of stator, the leading edge of rotor blades, the shroud and hub surfaces near inlet of rotor cause more severe erosion at each tip clearance. Therefore, wear-resistant coating should be adopted. The severe erosion can also be found at blade tip of rotor. However, it is gradually suppressed with the increase of tip clearance. With the increase of total pressure ratio, the region with higher erosion rate on the shroud of rotor gradually extends to downstream. However, the erosion rate at leading edge of rotor blades is decreased obviously. In conclusion, the erosion effect can be alleviated remarkably when the tip clearance size is of 2% and total pressure ratio is more than 1.84, while the isentropic efficiency is almost kept the same.

Suggested Citation

  • Wang, Xing & Zhang, Xuehui & Zhu, Yangli & Zhang, Xinjing & Li, Wen & Chen, Haisheng, 2019. "Effect of blade tip leakage flow on erosion of a radial inflow turbine for compressed air energy storage system," Energy, Elsevier, vol. 178(C), pages 195-206.
    • Handle: RePEc:eee:energy:v:178:y:2019:i:c:p:195-206
    DOI: 10.1016/j.energy.2019.04.139
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544219307728
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2019.04.139?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Kim, Do-Yeop & Kim, You-Taek, 2017. "Preliminary design and performance analysis of a radial inflow turbine for ocean thermal energy conversion," Renewable Energy, Elsevier, vol. 106(C), pages 255-263.
    2. Cai, Liuxi & Xiao, Junfeng & Wang, Shunsen & Gao, Song & Duan, Jingyao & Mao, Jingru, 2017. "Gas-particle flows and erosion characteristic of large capacity dry top gas pressure recovery turbine," Energy, Elsevier, vol. 120(C), pages 498-506.
    3. Fu, Lei & Feng, Zhenping & Li, Guojun, 2017. "Experimental investigation on overall performance of a millimeter-scale radial turbine for micro gas turbine," Energy, Elsevier, vol. 134(C), pages 1-9.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Yao, Liming & Liu, Yuxi & Xiao, Zhongmin & Chen, Yang, 2023. "An algorithm combining sedimentation experiments for pipe erosion investigation," Energy, Elsevier, vol. 270(C).
    2. Zhang, Jiankun & Liu, Haihu, 2023. "Multi-objective optimization of aerodynamic and erosion resistance performances of a high-pressure turbine," Energy, Elsevier, vol. 277(C).
    3. Zhang, Jiankun & Liu, Haihu, 2023. "Effect of solid particles on performance and erosion characteristics of a high-pressure turbine," Energy, Elsevier, vol. 272(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Jung-Bo Sim & Se-Jin Yook & Young Won Kim, 2023. "Development of 180 kW Organic Rankine Cycle (ORC) with a High-Efficiency Two-Stage Axial Turbine," Energies, MDPI, vol. 16(20), pages 1-20, October.
    2. Włodarski, Wojciech, 2018. "Experimental investigations and simulations of the microturbine unit with permanent magnet generator," Energy, Elsevier, vol. 158(C), pages 59-71.
    3. Wenjiao Qi & Qinghua Deng & Yu Jiang & Qi Yuan & Zhenping Feng, 2018. "Disc Thickness and Spacing Distance Impacts on Flow Characteristics of Multichannel Tesla Turbines," Energies, MDPI, vol. 12(1), pages 1-25, December.
    4. Witanowski, Łukasz & Ziółkowski, Paweł & Klonowicz, Piotr & Lampart, Piotr, 2023. "A hybrid approach to optimization of radial inflow turbine with principal component analysis," Energy, Elsevier, vol. 272(C).
    5. Li, Jian & Peng, Xiayao & Yang, Zhen & Hu, Shuozhuo & Duan, Yuanyuan, 2022. "Design, improvements and applications of dual-pressure evaporation organic Rankine cycles: A review," Applied Energy, Elsevier, vol. 311(C).
    6. Peng Li & Zhonghe Han & Xiaoqiang Jia & Zhongkai Mei & Xu Han, 2018. "Analysis of the Effects of Blade Installation Angle and Blade Number on Radial-Inflow Turbine Stator Flow Performance," Energies, MDPI, vol. 11(9), pages 1-15, August.
    7. Jun-Seong Kim & Do-Yeop Kim, 2020. "Preliminary Design and Off-Design Analysis of a Radial Outflow Turbine for Organic Rankine Cycles," Energies, MDPI, vol. 13(8), pages 1-18, April.
    8. Vera, D. & Baccioli, A. & Jurado, F. & Desideri, U., 2020. "Modeling and optimization of an ocean thermal energy conversion system for remote islands electrification," Renewable Energy, Elsevier, vol. 162(C), pages 1399-1414.
    9. Chen, Yun & Liu, Yanjun & Liu, Weimin & Ge, Yunzheng & Xue, Yifan & Zhang, Li, 2022. "Optimal design of radial inflow turbine for ocean thermal energy conversion based on the installation angle of nozzle blade," Renewable Energy, Elsevier, vol. 184(C), pages 857-870.
    10. Wang, Zhiqi & Pan, Huihui & Xia, Xiaoxia & Xie, Baoqi & Peng, Deqi & Yang, Huya, 2022. "Experimental investigation on steady and dynamic performance of organic Rankine cycle with R245fa/R141b under different cooling and expander speed conditions," Energy, Elsevier, vol. 241(C).
    11. Deligant, Michael & Sauret, Emilie & Danel, Quentin & Bakir, Farid, 2020. "Performance assessment of a standard radial turbine as turbo expander for an adapted solar concentration ORC," Renewable Energy, Elsevier, vol. 147(P3), pages 2833-2841.
    12. Moriguchi, Shota & Miyazawa, Hironori & Furusawa, Takashi & Yamamoto, Satoru, 2021. "Large eddy simulation of a linear turbine cascade with a trailing edge cutback," Energy, Elsevier, vol. 220(C).
    13. Li, Jinxing & Liu, Tianyuan & Wang, Yuqi & Xie, Yonghui, 2022. "Integrated graph deep learning framework for flow field reconstruction and performance prediction of turbomachinery," Energy, Elsevier, vol. 254(PC).
    14. Zou, Aihong & Chassaing, Jean-Camille & Persky, Rodney & Gu, YuanTong & Sauret, Emilie, 2019. "Uncertainty Quantification in high-density fluid radial-inflow turbines for renewable low-grade temperature cycles," Applied Energy, Elsevier, vol. 241(C), pages 313-330.
    15. Gulfam, Raza & Zhang, Peng, 2019. "Power generation and longevity improvement of renewable energy systems via slippery surfaces – A review," Renewable Energy, Elsevier, vol. 143(C), pages 922-938.
    16. Zhang, Chengbin & Wu, Zhe & Wang, Jiadian & Ding, Ce & Gao, Tieyu & Chen, Yongping, 2023. "Thermodynamic performance of a radial-inflow turbine for ocean thermal energy conversion using ammonia," Renewable Energy, Elsevier, vol. 202(C), pages 907-920.
    17. Wang, Zhiqi & Xie, Baoqi & Xia, Xiaoxia & Luo, Lan & Yang, Huya & Li, Xin, 2023. "Entropy production analysis of a radial inflow turbine with variable inlet guide vane for ORC application," Energy, Elsevier, vol. 265(C).
    18. Sheng Yin & Jimin Ni & Houchuan Fan & Xiuyong Shi & Rong Huang, 2022. "A Study of Evaluation Method for Turbocharger Turbine Based on Joint Operation Curve," Sustainability, MDPI, vol. 14(16), pages 1-18, August.
    19. Yao, Liming & Liu, Yuxi & Xiao, Zhongmin & Chen, Yang, 2023. "An algorithm combining sedimentation experiments for pipe erosion investigation," Energy, Elsevier, vol. 270(C).
    20. Ma, Qingfen & Gao, Zezhou & Huang, Jie & Mahian, Omid & Feng, Xin & Lu, Hui & Wang, Shenghui & Wang, Chengpeng & Tang, Rongnian & Li, Jingru, 2023. "Thermodynamic analysis and turbine design of a 100 kW OTEC-ORC with binary non-azeotropic working fluid," Energy, Elsevier, vol. 263(PE).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:178:y:2019:i:c:p:195-206. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.