IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v118y2017icp1286-1294.html
   My bibliography  Save this article

Design of large scale oxy-fuel fluidized bed boilers: Constant thermal power and constant furnace size scenarios

Author

Listed:
  • Seddighi, Sadegh

Abstract

This work investigates the design of large scale oxy-fuel circulating fluidized bed (CFB) boilers in two industrial pathways of constant thermal power scenario and constant furnace size scenario using a new version of a model validated with 100 kWth and 4 MWth oxy-fuel CFB boilers. This work suggests that the major approach for elevating the circulating solids flux is to utilize more efficient cyclones with better efficiency which leads to higher share of fines and nanoparticles in the CFB loop while the amount of aerosols is reduced. Maximum heat flux from furnace walls is 2.4 times and CO peak is 2.2 times in constant furnace size scenario compared to constant thermal power scenario respectively, showing more intense combustion in the prior scenario. Based on the results found in this work, if the industry is to aim to operate the large-scale oxy-fuel CFB boilers at high O2 concentrations, the utilization of the constant thermal power scenario is much safer for the industry compared to constant furnace size scenario. This work shows that the aspect ratio of future large-scale oxy-fuel CFB furnaces are larger than the current air-fired ones leading the oxy-CFB furnace geometry to approach the fluid catalytic cracking fluidized beds.

Suggested Citation

  • Seddighi, Sadegh, 2017. "Design of large scale oxy-fuel fluidized bed boilers: Constant thermal power and constant furnace size scenarios," Energy, Elsevier, vol. 118(C), pages 1286-1294.
    • Handle: RePEc:eee:energy:v:118:y:2017:i:c:p:1286-1294
    DOI: 10.1016/j.energy.2016.11.004
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544216315936
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2016.11.004?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Leckner, Bo & Gómez-Barea, Alberto, 2014. "Oxy-fuel combustion in circulating fluidized bed boilers," Applied Energy, Elsevier, vol. 125(C), pages 308-318.
    2. Pettinau, Alberto & Ferrara, Francesca & Amorino, Carlo, 2012. "Techno-economic comparison between different technologies for a CCS power generation plant integrated with a sub-bituminous coal mine in Italy," Applied Energy, Elsevier, vol. 99(C), pages 32-39.
    3. Tan, Y. & Jia, L. & Wu, Y. & Anthony, E.J., 2012. "Experiences and results on a 0.8MWth oxy-fuel operation pilot-scale circulating fluidized bed," Applied Energy, Elsevier, vol. 92(C), pages 343-347.
    4. Wu, Yinghai & Wang, Chunbo & Tan, Yewen & Jia, Lufei & Anthony, Edward J., 2011. "Characterization of ashes from a 100kWth pilot-scale circulating fluidized bed with oxy-fuel combustion," Applied Energy, Elsevier, vol. 88(9), pages 2940-2948.
    5. Pettinau, Alberto & Ferrara, Francesca & Amorino, Carlo, 2013. "Combustion vs. gasification for a demonstration CCS (carbon capture and storage) project in Italy: A techno-economic analysis," Energy, Elsevier, vol. 50(C), pages 160-169.
    6. Duan, Lunbo & Liu, Daoyin & Chen, Xiaoping & Zhao, Changsui, 2012. "Fly ash recirculation by bottom feeding on a circulating fluidized bed boiler co-burning coal sludge and coal," Applied Energy, Elsevier, vol. 95(C), pages 295-299.
    7. Burdyny, Thomas & Struchtrup, Henning, 2010. "Hybrid membrane/cryogenic separation of oxygen from air for use in the oxy-fuel process," Energy, Elsevier, vol. 35(5), pages 1884-1897.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Abdolahi-Mansoorkhani, Hamed & Seddighi, Sadegh, 2019. "H2S and CO2 capture from gaseous fuels using nanoparticle membrane," Energy, Elsevier, vol. 168(C), pages 847-857.
    2. Adamczyk, Wojciech P. & Myöhänen, Kari & Hartge, Ernst-Ulrich & Ritvanen, Jouni & Klimanek, Adam & Hyppänen, Timo & Białecki, Ryszard A., 2018. "Generation of data sets for semi-empirical models of circulated fluidized bed boilers using hybrid Euler-Lagrange technique," Energy, Elsevier, vol. 143(C), pages 219-240.
    3. Mohammadpour, Mohammadreza & Ashjaee, Mehdi & Houshfar, Ehsan, 2022. "Thermal performance and heat transfer characteristics analyses of oxy-biogas combustion in a swirl stabilized boiler under various oxidizing environments," Energy, Elsevier, vol. 261(PA).
    4. Seddighi, Sadegh & Clough, Peter T. & Anthony, Edward J. & Hughes, Robin W. & Lu, Ping, 2018. "Scale-up challenges and opportunities for carbon capture by oxy-fuel circulating fluidized beds," Applied Energy, Elsevier, vol. 232(C), pages 527-542.
    5. Moon, Ji-Hong & Jo, Sung-Ho & Park, Sung Jin & Khoi, Nguyen Hoang & Seo, Myung Won & Ra, Ho Won & Yoon, Sang-Jun & Yoon, Sung-Min & Lee, Jae-Goo & Mun, Tae-Young, 2019. "Carbon dioxide purity and combustion characteristics of oxy firing compared to air firing in a pilot-scale circulating fluidized bed," Energy, Elsevier, vol. 166(C), pages 183-192.
    6. Bashtani, Javad & Seddighi, Sadegh & Bahrabadi-Jovein, Iman, 2018. "Control of nitrogen oxide formation in power generation using modified reaction kinetics and mixing," Energy, Elsevier, vol. 145(C), pages 567-581.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Seddighi, Sadegh & Clough, Peter T. & Anthony, Edward J. & Hughes, Robin W. & Lu, Ping, 2018. "Scale-up challenges and opportunities for carbon capture by oxy-fuel circulating fluidized beds," Applied Energy, Elsevier, vol. 232(C), pages 527-542.
    2. Xu, Mingxin & Li, Shiyuan & Wu, Yinghai & Jia, Lufei & Lu, Qinggang, 2017. "The characteristics of recycled NO reduction over char during oxy-fuel fluidized bed combustion," Applied Energy, Elsevier, vol. 190(C), pages 553-562.
    3. Li, Shiyuan & Li, Haoyu & Li, Wei & Xu, Mingxin & Eddings, Eric G. & Ren, Qiangqiang & Lu, Qinggang, 2017. "Coal combustion emission and ash formation characteristics at high oxygen concentration in a 1MWth pilot-scale oxy-fuel circulating fluidized bed," Applied Energy, Elsevier, vol. 197(C), pages 203-211.
    4. Janusz Kotowicz & Sebastian Michalski & Mateusz Brzęczek, 2019. "The Characteristics of a Modern Oxy-Fuel Power Plant," Energies, MDPI, vol. 12(17), pages 1-34, September.
    5. Xu, Mingxin & Li, Shiyuan & Wu, Yinghai & Jia, Lufei, 2017. "Reduction of recycled NO over char during oxy-fuel fluidized bed combustion: Effects of operating parameters," Applied Energy, Elsevier, vol. 199(C), pages 310-322.
    6. Singh, Ravi Inder & Kumar, Rajesh, 2016. "Current status and experimental investigation of oxy-fired fluidized bed," Renewable and Sustainable Energy Reviews, Elsevier, vol. 61(C), pages 398-420.
    7. Li, Shiyuan & Xu, Mingxin & Jia, Lufei & Tan, Li & Lu, Qinggang, 2016. "Influence of operating parameters on N2O emission in O2/CO2 combustion with high oxygen concentration in circulating fluidized bed," Applied Energy, Elsevier, vol. 173(C), pages 197-209.
    8. Guo, Zhihang & Wang, Qinhui & Fang, Mengxiang & Luo, Zhongyang & Cen, Kefa, 2014. "Thermodynamic and economic analysis of polygeneration system integrating atmospheric pressure coal pyrolysis technology with circulating fluidized bed power plant," Applied Energy, Elsevier, vol. 113(C), pages 1301-1314.
    9. Lee, Jaehee & Han, Sang-Jun & Wee, Jung-Ho, 2014. "Synthesis of dry sorbents for carbon dioxide capture using coal fly ash and its performance," Applied Energy, Elsevier, vol. 131(C), pages 40-47.
    10. Wang, Chang’an & Zhang, Xiaoming & Liu, Yinhe & Che, Defu, 2012. "Pyrolysis and combustion characteristics of coals in oxyfuel combustion," Applied Energy, Elsevier, vol. 97(C), pages 264-273.
    11. Zhihua Zhang, 2015. "Techno-Economic Assessment of Carbon Capture and Storage Facilities Coupled to Coal-Fired Power Plants," Energy & Environment, , vol. 26(6-7), pages 1069-1080, November.
    12. Chi, Chung-Cheng & Lin, Ta-Hui, 2013. "Oxy-oil combustion characteristics of an existing furnace," Applied Energy, Elsevier, vol. 102(C), pages 923-930.
    13. Nguyen, Hoang Khoi & Moon, Ji-Hong & Jo, Sung-Ho & Park, Sung Jin & Seo, Myung Won & Ra, Ho Won & Yoon, Sang-Jun & Yoon, Sung-Min & Song, Byungho & Lee, Uendo & Yang, Chang Won & Mun, Tae-Young & Lee,, 2020. "Oxy-combustion characteristics as a function of oxygen concentration and biomass co-firing ratio in a 0.1 MWth circulating fluidized bed combustion test-rig," Energy, Elsevier, vol. 196(C).
    14. Bu, Changsheng & Liu, Daoyin & Chen, Xiaoping & Pallarès, David & Gómez-Barea, Alberto, 2014. "Ignition behavior of single coal particle in a fluidized bed under O2/CO2 and O2/N2 atmospheres: A combination of visual image and particle temperature," Applied Energy, Elsevier, vol. 115(C), pages 301-308.
    15. Tola, Vittorio & Pettinau, Alberto, 2014. "Power generation plants with carbon capture and storage: A techno-economic comparison between coal combustion and gasification technologies," Applied Energy, Elsevier, vol. 113(C), pages 1461-1474.
    16. Bolea, Irene & Romeo, Luis M. & Pallarés, David, 2012. "The role of external heat exchangers in oxy-fuel circulating fluidized bed," Applied Energy, Elsevier, vol. 94(C), pages 215-223.
    17. Duan, Lunbo & Jiang, Zhongxiao & Chen, Xiaoping & Zhao, Changsui, 2013. "Investigation on water vapor effect on direct sulfation during wet-recycle oxy-coal combustion," Applied Energy, Elsevier, vol. 108(C), pages 121-127.
    18. Olateju, Babatunde & Kumar, Amit, 2013. "Techno-economic assessment of hydrogen production from underground coal gasification (UCG) in Western Canada with carbon capture and sequestration (CCS) for upgrading bitumen from oil sands," Applied Energy, Elsevier, vol. 111(C), pages 428-440.
    19. Moioli, Stefania & Giuffrida, Antonio & Romano, Matteo C. & Pellegrini, Laura A. & Lozza, Giovanni, 2016. "Assessment of MDEA absorption process for sequential H2S removal and CO2 capture in air-blown IGCC plants," Applied Energy, Elsevier, vol. 183(C), pages 1452-1470.
    20. Adrian K. James & Ronald W. Thring & Steve Helle & Harpuneet S. Ghuman, 2012. "Ash Management Review—Applications of Biomass Bottom Ash," Energies, MDPI, vol. 5(10), pages 1-18, October.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:118:y:2017:i:c:p:1286-1294. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.