IDEAS home Printed from https://ideas.repec.org/a/gam/jmathe/v8y2020i5p769-d356757.html
   My bibliography  Save this article

Numerical Simulation of Gas–Liquid Two-Phase Flow Characteristics of Centrifugal Pump Based on the CFD–PBM

Author

Listed:
  • Fan Zhang

    (National Research Center of Pumps, Jiangsu University, Zhenjiang 212013, China)

  • Lufeng Zhu

    (National Research Center of Pumps, Jiangsu University, Zhenjiang 212013, China)

  • Ke Chen

    (National Research Center of Pumps, Jiangsu University, Zhenjiang 212013, China)

  • Weicheng Yan

    (The School of Chemistry and Chemical Engineering, Jiangsu University, Zhenjiang 212013, China)

  • Desmond Appiah

    (National Research Center of Pumps, Jiangsu University, Zhenjiang 212013, China)

  • Bo Hu

    (Department of Energy and Power Engineering, Tsinghua University, Beijing 100084, China)

Abstract

This work seeks to apply the computational fluid dynamics–population balance model (CFD–PBM) to investigate the gas distribution and flow mechanism in the gas–liquid two-phase flow of a centrifugal pump. The findings show that the numerical simulation accurately captures the bubble distribution characteristics in the process of coalescence and breakage evolution. In addition, comparing the CFD–PBM with the Double Euler, the hydraulic head of the pump are similar, but the efficiency using the Double Euler is much higher—even close to single-phase. This is in contrast to previous experimental research. Then, the unsteady flow usually led to the formation of bubbles with larger diameters especially where vortices existed. In addition, the rotor–stator interaction was a main reason for bubble formation. Generally, it was observed that the coalescence rate was greater than the breakage rate; thus, the coalescence rate decreased until it equaled the breakage rate. Thereafter, the average diameter of the bubble in each part tended to be stable during the process of bubble evolution. Finally, the average diameter of bubbles seemed to increase from inlet to outlet. The results of this study may not only enhance the gas–liquid two-phase internal flow theory of centrifugal pumps, but also can serve as a benchmark for optimizations of reliable operation of hydraulic pumps under gas–liquid two-phase flow conditions.

Suggested Citation

  • Fan Zhang & Lufeng Zhu & Ke Chen & Weicheng Yan & Desmond Appiah & Bo Hu, 2020. "Numerical Simulation of Gas–Liquid Two-Phase Flow Characteristics of Centrifugal Pump Based on the CFD–PBM," Mathematics, MDPI, vol. 8(5), pages 1-19, May.
    • Handle: RePEc:gam:jmathe:v:8:y:2020:i:5:p:769-:d:356757
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2227-7390/8/5/769/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2227-7390/8/5/769/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Qiaorui Si & Haoyang Zhang & Gérard Bois & Jinfeng Zhang & Qianglei Cui & Shouqi Yuan, 2019. "Experimental Investigations on the Inner Flow Behavior of Centrifugal Pumps under Inlet Air-Water Two-Phase Conditions," Energies, MDPI, vol. 12(22), pages 1-14, November.
    2. Sina Yan & Shuaihui Sun & Xingqi Luo & Senlin Chen & Chenhao Li & Jianjun Feng, 2020. "Numerical Investigation on Bubble Distribution of a Multistage Centrifugal Pump Based on a Population Balance Model," Energies, MDPI, vol. 13(4), pages 1-15, February.
    3. Li, Xiaojun & Chen, Bo & Luo, Xianwu & Zhu, Zuchao, 2020. "Effects of flow pattern on hydraulic performance and energy conversion characterisation in a centrifugal pump," Renewable Energy, Elsevier, vol. 151(C), pages 475-487.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Shuaihui Sun & Pei Ren & Pengcheng Guo & Longgang Sun & Xiaobo Zheng, 2022. "Influence of the Gas Model on the Performance and Flow Field Prediction of a Gas–Liquid Two-Phase Hydraulic Turbine," Energies, MDPI, vol. 15(17), pages 1-18, August.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Pei, Yingju & Liu, Qingyou & Wang, Chuan & Wang, Guorong, 2021. "Energy efficiency prediction model and energy characteristics of subsea disc pump based on velocity slip and similarity theory," Energy, Elsevier, vol. 229(C).
    2. Chengshuo Wu & Jun Yang & Shuai Yang & Peng Wu & Bin Huang & Dazhuan Wu, 2023. "A Review of Fluid-Induced Excitations in Centrifugal Pumps," Mathematics, MDPI, vol. 11(4), pages 1-20, February.
    3. Yang, Gang & Shen, Xi & Shi, Lei & Zhang, Desheng & Zhao, Xutao & (Bart) van Esch, B.P.M., 2023. "Numerical investigation of hump characteristic improvement in a large vertical centrifugal pump with special emphasis on energy loss mechanism," Energy, Elsevier, vol. 273(C).
    4. Ji, Leilei & Li, Wei & Shi, Weidong & Tian, Fei & Agarwal, Ramesh, 2021. "Effect of blade thickness on rotating stall of mixed-flow pump using entropy generation analysis," Energy, Elsevier, vol. 236(C).
    5. Bin Huang & Kexin Pu & Peng Wu & Dazhuan Wu & Jianxing Leng, 2020. "Design, Selection and Application of Energy Recovery Device in Seawater Desalination: A Review," Energies, MDPI, vol. 13(16), pages 1-19, August.
    6. Chen, Weisheng & Li, Yaojun & Liu, Zhuqing & Hong, Yiping, 2023. "Understanding of energy conversion and losses in a centrifugal pump impeller," Energy, Elsevier, vol. 263(PB).
    7. Lijian Shi & Jun Zhu & Fangping Tang & Chuan Wang, 2020. "Multi-Disciplinary Optimization Design of Axial-Flow Pump Impellers Based on the Approximation Model," Energies, MDPI, vol. 13(4), pages 1-19, February.
    8. Qiaorui Si & Gérard Bois & Minquan Liao & Haoyang Zhang & Qianglei Cui & Shouqi Yuan, 2019. "A Comparative Study on Centrifugal Pump Designs and Two-Phase Flow Characteristic under Inlet Gas Entrainment Conditions," Energies, MDPI, vol. 13(1), pages 1-25, December.
    9. Hongyu, Guan & Wei, Jiang & Yuchuan, Wang & Hui, Tian & Ting, Li & Diyi, Chen, 2021. "Numerical simulation and experimental investigation on the influence of the clocking effect on the hydraulic performance of the centrifugal pump as turbine," Renewable Energy, Elsevier, vol. 168(C), pages 21-30.
    10. Shuaihui Sun & Pei Ren & Pengcheng Guo & Longgang Sun & Xiaobo Zheng, 2022. "Influence of the Gas Model on the Performance and Flow Field Prediction of a Gas–Liquid Two-Phase Hydraulic Turbine," Energies, MDPI, vol. 15(17), pages 1-18, August.
    11. Li, Xiaojun & Chen, Hui & Chen, Bo & Luo, Xianwu & Yang, Baofeng & Zhu, Zuchao, 2020. "Investigation of flow pattern and hydraulic performance of a centrifugal pump impeller through the PIV method," Renewable Energy, Elsevier, vol. 162(C), pages 561-574.
    12. Hongliang Wang & Bing Long & Chuan Wang & Chen Han & Linjian Li, 2020. "Effects of the Impeller Blade with a Slot Structure on the Centrifugal Pump Performance," Energies, MDPI, vol. 13(7), pages 1-17, April.
    13. Boštjan Zajec & Leon Cizelj & Boštjan Končar, 2022. "Experimental Analysis of Flow Boiling in Horizontal Annulus—The Effect of Heat Flux on Bubble Size Distributions," Energies, MDPI, vol. 15(6), pages 1-12, March.
    14. Michalis Mentzos & Ioannis Kassanos & Ioannis Anagnostopoulos & Andronikos Filios, 2024. "The Effect of Blade Angle Distribution on the Flow Field of a Centrifugal Impeller in Liquid-Gas Flow," Energies, MDPI, vol. 17(16), pages 1-22, August.
    15. Xiaoke He & Yingchong Zhang & Chuan Wang & Congcong Zhang & Li Cheng & Kun Chen & Bo Hu, 2020. "Influence of Critical Wall Roughness on the Performance of Double-Channel Sewage Pump," Energies, MDPI, vol. 13(2), pages 1-20, January.
    16. Lin, Tong & Li, Xiaojun & Zhu, Zuchao & Xie, Jing & Li, Yi & Yang, Hui, 2021. "Application of enstrophy dissipation to analyze energy loss in a centrifugal pump as turbine," Renewable Energy, Elsevier, vol. 163(C), pages 41-55.
    17. Asad Ali & Jianping Yuan & Fanjie Deng & Biaobiao Wang & Liangliang Liu & Qiaorui Si & Noman Ali Buttar, 2021. "Research Progress and Prospects of Multi-Stage Centrifugal Pump Capability for Handling Gas–Liquid Multiphase Flow: Comparison and Empirical Model Validation," Energies, MDPI, vol. 14(4), pages 1-34, February.
    18. Hang, Jianwei & Bai, Ling & Zhou, Ling & Jiang, Lei & Shi, Weidong & Agarwal, Ramesh, 2022. "Inter-stage energy characteristics of electrical submersible pump under gassy conditions," Energy, Elsevier, vol. 256(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jmathe:v:8:y:2020:i:5:p:769-:d:356757. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.