IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i9p3802-d1135955.html
   My bibliography  Save this article

Experimental Study of a PowerCore Filter Bed Operating in a Two-Stage System for Cleaning the Inlet Air of Internal Combustion Engines

Author

Listed:
  • Tadeusz Dziubak

    (Faculty of Mechanical Engineering, Military University of Technology, Gen. Sylwestra Kaliskiego Street 2, 00-908 Warsaw, Poland)

Abstract

Small dust grains cause a higher intensity of increase in the flow resistance of the fibrous filter bed, which, due to the established value of the permissible resistance, results in a shorter period of operation of the air filter and the vehicle. At the same time, the mass of dust per unit of filtration area takes on smaller values. Such a phenomenon occurs in the two-stage “multicyclone-baffle filter” engine inlet air filtration system. The main objective of this study was to experimentally determine the mass of dust retained per unit of filtration area (dust absorption coefficient k m ) of the PowerCore filter bed operating under two-stage filtration conditions, which cannot be found in the available literature. The original methodology and conditions for determining the dust absorption coefficient k m of a PowerCore filter bed operating under two-stage filtration conditions are presented. Tests were carried out on the characteristics of filtration efficiency and accuracy, as well as on the flow resistance of a filtration unit consisting of a single cyclone and a PowerCore test filter with an appropriately selected surface area of filter material. During the tests, conditions corresponding to the actual conditions of vehicle use and air filter operation were maintained, including filtration speed and the dust concentration in the air. The experimentally determined dust absorption coefficient of the PowerCore research filters operating in a two-stage filtration system took on values in the range of k m = 199–219 g/m 2 . The dust absorption coefficient k m of the PowerCore research filter operating under single-stage filtration conditions reached a value of k m = 434 g/m 2 , which is twice as high. Prediction of the mileage of a car equipped with a single-stage and two-stage “multi-cyclone-partition” filtration system was carried out, showing the usefulness of the experimentally determined dust absorption coefficients k m .

Suggested Citation

  • Tadeusz Dziubak, 2023. "Experimental Study of a PowerCore Filter Bed Operating in a Two-Stage System for Cleaning the Inlet Air of Internal Combustion Engines," Energies, MDPI, vol. 16(9), pages 1-21, April.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:9:p:3802-:d:1135955
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/9/3802/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/9/3802/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Tadeusz Dziubak, 2022. "Experimental Investigation of Possibilities to Improve Filtration Efficiency of Tangential Inlet Return Cyclones by Modification of Their Design," Energies, MDPI, vol. 15(11), pages 1-37, May.
    2. Tadeusz Dziubak & Sebastian Dominik Dziubak, 2022. "A Study on the Effect of Inlet Air Pollution on the Engine Component Wear and Operation," Energies, MDPI, vol. 15(3), pages 1-50, February.
    3. Tadeusz Dziubak & Mirosław Karczewski, 2022. "Experimental Studies of the Effect of Air Filter Pressure Drop on the Composition and Emission Changes of a Compression Ignition Internal Combustion Engine," Energies, MDPI, vol. 15(13), pages 1-31, June.
    4. Dharma Kumar, 1988. "Note from the Editor," The Indian Economic & Social History Review, , vol. 25(4), pages 399-399, December.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Wróblewski, Piotr, 2023. "Investigation of energy losses of the internal combustion engine taking into account the correlation of the hydrophobic and hydrophilic," Energy, Elsevier, vol. 264(C).
    2. Włodzimierz Kamiński, 2022. "Marine Slow-Speed Engines’ Cylinder Oil Lubrication Feed Rate Optimization in Real Operational Conditions," Energies, MDPI, vol. 15(22), pages 1-14, November.
    3. Jufang Zhang & Xiumin Yu & Zezhou Guo & Yinan Li & Jiahua Zhang & Dongjie Liu, 2022. "Study on Combustion and Emissions of a Spark Ignition Engine with Gasoline Port Injection Plus Acetone–Butanol–Ethanol (ABE) Direct Injection under Different Speeds and Loads," Energies, MDPI, vol. 15(19), pages 1-22, September.
    4. Grzegorz Szamrej & Mirosław Karczewski, 2024. "Exploring Hydrogen-Enriched Fuels and the Promise of HCNG in Industrial Dual-Fuel Engines," Energies, MDPI, vol. 17(7), pages 1-51, March.
    5. Ming Wen & Yufeng Li & Weiqing Zhu & Rulou Cao & Kai Sun, 2022. "Experimental Study on Effects of RCSL and RCTL Combustion Chamber for Combustion Process of Highly Intensified Diesel Engine," Energies, MDPI, vol. 15(17), pages 1-13, August.
    6. Tadeusz Dziubak, 2024. "Experimental Testing of Filter Materials for Two-Stage Inlet Air Systems of Internal Combustion Engines," Energies, MDPI, vol. 17(11), pages 1-39, May.
    7. Mateusz Oszczypała & Jarosław Ziółkowski & Jerzy Małachowski, 2022. "Analysis of Light Utility Vehicle Readiness in Military Transportation Systems Using Markov and Semi-Markov Processes," Energies, MDPI, vol. 15(14), pages 1-24, July.
    8. Aleksander Mazurkow & Wojciech Homik & Wojciech Lewicki & Zbigniew Łosiewicz, 2023. "Evaluation of Selected Dynamic Parameters of Rotating Turbocharger Units Based on Comparative Model and Bench Tests," Energies, MDPI, vol. 16(14), pages 1-18, July.
    9. Gabriele D’Antuono & Davide Lanni & Enzo Galloni & Gustavo Fontana, 2023. "Numerical Modeling and Simulation of a Spark-Ignition Engine Fueled with Ammonia-Hydrogen Blends," Energies, MDPI, vol. 16(6), pages 1-14, March.
    10. Tadeusz Dziubak & Mirosław Karczewski, 2022. "Experimental Study of the Effect of Air Filter Pressure Drop on Internal Combustion Engine Performance," Energies, MDPI, vol. 15(9), pages 1-32, April.
    11. Włodzimierz Kamiński & Iwona Michalska-Pożoga, 2023. "Possibility of Marine Low-Speed Engine Piston Ring Wear Prediction during Real Operational Conditions," Energies, MDPI, vol. 16(3), pages 1-13, February.
    12. Maciej Siedlecki & Natalia Szymlet & Paweł Fuć & Beata Kurc, 2022. "Analysis of the Possibilities of Reduction of Exhaust Emissions from a Farm Tractor by Retrofitting Exhaust Aftertreatment," Energies, MDPI, vol. 15(21), pages 1-17, October.
    13. Ziyang Wang & Masahiro Mae & Shoma Nishimura & Ryuji Matsuhashi, 2024. "Vehicular Fuel Consumption and CO 2 Emission Estimation Model Integrating Novel Driving Behavior Data Using Machine Learning," Energies, MDPI, vol. 17(6), pages 1-16, March.
    14. Serdar Halis & Hamit Solmaz & Seyfi Polat & H. Serdar Yücesu, 2023. "Numerical Investigation of a Reactivity-Controlled Compression Ignition Engine Fueled with N-Heptane and Iso-Octane," Sustainability, MDPI, vol. 15(13), pages 1-17, July.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:9:p:3802-:d:1135955. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.