IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i15p5696-d1206356.html
   My bibliography  Save this article

Evaluation of Multi-Utility Models with Municipal Solid Waste Combustion as the Primary Source under Specific Geographical and Operating Conditions

Author

Listed:
  • Zakariya Kaneesamkandi

    (Mechanical Engineering Department, King Saud University, Riyadh 11362, Saudi Arabia)

  • Abdul Sayeed

    (Mechanical Engineering Department, King Saud University, Riyadh 11362, Saudi Arabia)

Abstract

Developments in waste incineration technology in terms of efficient fuel preparation, combustion, and emissions reduction, as well as the growing needs of the community in terms of electricity, water, and air conditioning loads, are the prime motive for this study. This study presents a novel approach, in which three models of the fluidized bed combustion of municipal waste for simultaneous power generation, freshwater production, and district cooling are analyzed for their energy and exergy performance. The three simultaneously evaluated utility models are different configurations of a fluidized bed combustion system with Rankine cycle power generation, cooling with a vapor absorption refrigeration system, and fresh water production using multiple effect desalination. The output from the turbine, cooling system, and desalination system is determined using the Engineering Equations Solver for different boiler operating pressures. Energy and exergy analysis data for different pressures are used to identify the best configuration. Two variants of the absorption cooling system, namely, single effect and double effect, are considered. The variants of the multiple-effect desalination are the three-stage and five-stage methods. Input parameters used in this study are municipal solid waste generation and composition data collected for an urban community in an arid climate zone with high demand for electric power, cooling, and fresh water. Model 2, which contains two turbines with the reheating and cooling systems connected to a high-pressure turbine and water desalination connected to a low-pressure turbine, gave the best overall performance. Significant savings in terms of the replacement of conventional energy were observed from these waste conversion plants with greater benefits in arid weather conditions. The results obtained by different models under different operating criteria constitute a guideline for municipal planners for the selection of appropriate waste utilization technology, as well as the appropriate operations.

Suggested Citation

  • Zakariya Kaneesamkandi & Abdul Sayeed, 2023. "Evaluation of Multi-Utility Models with Municipal Solid Waste Combustion as the Primary Source under Specific Geographical and Operating Conditions," Energies, MDPI, vol. 16(15), pages 1-17, July.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:15:p:5696-:d:1206356
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/15/5696/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/15/5696/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Zaid M. Aldhafeeri & Hatem Alhazmi, 2022. "Sustainability Assessment of Municipal Solid Waste in Riyadh, Saudi Arabia, in the Framework of Circular Economy Transition," Sustainability, MDPI, vol. 14(9), pages 1-18, April.
    2. Oluwaseun Nubi & Stephen Morse & Richard J. Murphy, 2022. "Prospective Life Cycle Costing of Electricity Generation from Municipal Solid Waste in Nigeria," Sustainability, MDPI, vol. 14(20), pages 1-24, October.
    3. Mika Fabricius & Daniel Øland Tarp & Thomas Wehl Rasmussen & Ahmad Arabkoohsar, 2020. "Utilization of Excess Production of Waste-Fired CHP Plants for District Cooling Supply, an Effective Solution for a Serious Challenge," Energies, MDPI, vol. 13(13), pages 1-21, June.
    4. Udomsri, Seksan & Martin, Andrew R. & Martin, Viktoria, 2011. "Thermally driven cooling coupled with municipal solid waste-fired power plant: Application of combined heat, cooling and power in tropical urban areas," Applied Energy, Elsevier, vol. 88(5), pages 1532-1542, May.
    5. Yuanyuan Shao & Jinsheng Wang & Fernando Preto & Jesse Zhu & Chunbao Xu, 2012. "Ash Deposition in Biomass Combustion or Co-Firing for Power/Heat Generation," Energies, MDPI, vol. 5(12), pages 1-19, December.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Abdulmajeed Almadhi & Abdelhakim Abdelhadi & Rakan Alyamani, 2023. "Moving from Linear to Circular Economy in Saudi Arabia: Life-Cycle Assessment on Plastic Waste Management," Sustainability, MDPI, vol. 15(13), pages 1-22, July.
    2. Valerie Eveloy & Dereje S. Ayou, 2019. "Sustainable District Cooling Systems: Status, Challenges, and Future Opportunities, with Emphasis on Cooling-Dominated Regions," Energies, MDPI, vol. 12(2), pages 1-64, January.
    3. Tae-Yong Jeong & Lkhagvadorj Sh & Jong-Ho Kim & Byoung-Hwa Lee & Chung-Hwan Jeon, 2019. "Experimental Investigation of Ash Deposit Behavior during Co-Combustion of Bituminous Coal with Wood Pellets and Empty Fruit Bunches," Energies, MDPI, vol. 12(11), pages 1-17, May.
    4. Dominković, D.F. & Bin Abdul Rashid, K.A. & Romagnoli, A. & Pedersen, A.S. & Leong, K.C. & Krajačić, G. & Duić, N., 2017. "Potential of district cooling in hot and humid climates," Applied Energy, Elsevier, vol. 208(C), pages 49-61.
    5. Yize Liu & Theoklis Nikolaidis & Seyed Hossein Madani & Mohammad Sarkandi & Abdelaziz Gamil & Muhamad Firdaus Sainal & Seyed Vahid Hosseini, 2022. "Multi-Fidelity Combustor Design and Experimental Test for a Micro Gas Turbine System," Energies, MDPI, vol. 15(7), pages 1-29, March.
    6. Colmenar-Santos, Antonio & Rosales-Asensio, Enrique & Borge-Diez, David & Collado-Fernández, Eduardo, 2016. "Evaluation of the cost of using power plant reject heat in low-temperature district heating and cooling networks," Applied Energy, Elsevier, vol. 162(C), pages 892-907.
    7. Andrzej Greinert & Maria Mrówczyńska & Radosław Grech & Wojciech Szefner, 2020. "The Use of Plant Biomass Pellets for Energy Production by Combustion in Dedicated Furnaces," Energies, MDPI, vol. 13(2), pages 1-17, January.
    8. Manuel Raul Pelaez-Samaniego & Juan L. Espinoza & José Jara-Alvear & Pablo Arias-Reyes & Fernando Maldonado-Arias & Patricia Recalde-Galindo & Pablo Rosero & Tsai Garcia-Perez, 2020. "Potential and Impacts of Cogeneration in Tropical Climate Countries: Ecuador as a Case Study," Energies, MDPI, vol. 13(20), pages 1-26, October.
    9. Sobieraj, Jakub & Gądek, Waldemar & Jagodzińska, Katarzyna & Kalisz, Sylwester, 2021. "Investigations of optimal additive dose for Cl-rich biomasses," Renewable Energy, Elsevier, vol. 163(C), pages 2008-2017.
    10. Wiranarongkorn, Kunlanan & Phajam, Picharporn & Im-orb, Karittha & Saebea, Dang & Arpornwichanop, Amornchai, 2021. "Assessment and analysis of multi-biomass fuels for sustainable electricity generation," Renewable Energy, Elsevier, vol. 180(C), pages 1405-1418.
    11. Xueliang Yuan & Xiaohan Fan & Jiaxin Liang & Mengyue Liu & Yuqiang Teng & Qiao Ma & Qingsong Wang & Ruimin Mu & Jian Zuo, 2019. "Public Perception towards Waste-to-Energy as a Waste Management Strategy: A Case from Shandong, China," IJERPH, MDPI, vol. 16(16), pages 1-15, August.
    12. Sébastien Fournel & Joahnn H. Palacios & Stéphane Godbout & Michèle Heitz, 2015. "Effect of Additives and Fuel Blending on Emissions and Ash-Related Problems from Small-Scale Combustion of Reed Canary Grass," Agriculture, MDPI, vol. 5(3), pages 1-16, July.
    13. Joanna Irena Odzijewicz & Elżbieta Wołejko & Urszula Wydro & Mariola Wasil & Agata Jabłońska-Trypuć, 2022. "Utilization of Ashes from Biomass Combustion," Energies, MDPI, vol. 15(24), pages 1-16, December.
    14. Lara Febrero & Enrique Granada & David Patiño & Pablo Eguía & Araceli Regueiro, 2015. "A Comparative Study of Fouling and Bottom Ash from Woody Biomass Combustion in a Fixed-Bed Small-Scale Boiler and Evaluation of the Analytical Techniques Used," Sustainability, MDPI, vol. 7(5), pages 1-19, May.
    15. Zhou, Yuekuan & Zheng, Siqian & Hensen, Jan L.M., 2024. "Machine learning-based digital district heating/cooling with renewable integrations and advanced low-carbon transition," Renewable and Sustainable Energy Reviews, Elsevier, vol. 199(C).
    16. Inayat, Abrar & Raza, Mohsin, 2019. "District cooling system via renewable energy sources: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 107(C), pages 360-373.
    17. Hao Rong & Teng Wang & Min Zhou & Hao Wang & Haobo Hou & Yongjie Xue, 2017. "Combustion Characteristics and Slagging during Co-Combustion of Rice Husk and Sewage Sludge Blends," Energies, MDPI, vol. 10(4), pages 1-13, March.
    18. Barmina, Inesa & Valdmanis, Raimonds & Zake, Maija, 2018. "The effects of biomass co-gasification and co-firing on the development of combustion dynamics," Energy, Elsevier, vol. 146(C), pages 4-12.
    19. Fuller, Aaron & Omidiji, Yinka & Viefhaus, Tillman & Maier, Jörg & Scheffknecht, Günter, 2019. "The impact of an additive on fly ash formation/transformation from wood dust combustion in a lab-scale pulverized fuel reactor," Renewable Energy, Elsevier, vol. 136(C), pages 732-745.
    20. Lara Febrero & Enrique Granada & Araceli Regueiro & José Luis Míguez, 2015. "Influence of Combustion Parameters on Fouling Composition after Wood Pellet Burning in a Lab-Scale Low-Power Boiler," Energies, MDPI, vol. 8(9), pages 1-23, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:15:p:5696-:d:1206356. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.