IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i14p5291-d1190974.html
   My bibliography  Save this article

Effect of Monodisperse Coal Particles on the Maximum Drop Spreading after Impact on a Solid Wall

Author

Listed:
  • Alexander Ashikhmin

    (Heat Mass Transfer Laboratory, School of Energy & Power Engineering, National Research Tomsk Polytechnic University, 30 Lenin Ave., 634050 Tomsk, Russia)

  • Nikita Khomutov

    (Heat Mass Transfer Laboratory, School of Energy & Power Engineering, National Research Tomsk Polytechnic University, 30 Lenin Ave., 634050 Tomsk, Russia)

  • Roman Volkov

    (Heat Mass Transfer Laboratory, School of Energy & Power Engineering, National Research Tomsk Polytechnic University, 30 Lenin Ave., 634050 Tomsk, Russia)

  • Maxim Piskunov

    (Heat Mass Transfer Laboratory, School of Energy & Power Engineering, National Research Tomsk Polytechnic University, 30 Lenin Ave., 634050 Tomsk, Russia)

  • Pavel Strizhak

    (Heat Mass Transfer Laboratory, School of Energy & Power Engineering, National Research Tomsk Polytechnic University, 30 Lenin Ave., 634050 Tomsk, Russia)

Abstract

The effect of coal hydrophilic particles in water-glycerol drops on the maximum diameter of spreading along a hydrophobic solid surface is experimentally studied by analyzing the velocity of internal flows by Particle Image Velocimetry (PIV). The grinding fineness of coal particles was 45–80 μm and 120–140 μm. Their concentration was 0.06 wt.% and 1 wt.%. The impact of particle-laden drops on a solid surface occurred at Weber numbers ( We ) from 30 to 120. It revealed the interrelated influence of We and the concentration of coal particles on changes in the maximum absolute velocity of internal flows in a drop within the kinetic and spreading phases of the drop-wall impact. It is explored the behavior of internal convective flows in the longitudinal section of a drop parallel to the plane of the solid wall. The kinetic energy of the translational motion of coal particles in a spreading drop compensates for the energy expended by the drop on sliding friction along the wall. At We = 120, the inertia-driven spreading of the particle-laden drop is mainly determined by the dynamics of the deformable Taylor rim. An increase in We contributes to more noticeable differences in the convection velocities in spreading drops. When the drop spreading diameter rises at the maximum velocity of internal flows, a growth of the maximum spreading diameter occurs. The presence of coal particles causes a general tendency to reduce drop spreading.

Suggested Citation

  • Alexander Ashikhmin & Nikita Khomutov & Roman Volkov & Maxim Piskunov & Pavel Strizhak, 2023. "Effect of Monodisperse Coal Particles on the Maximum Drop Spreading after Impact on a Solid Wall," Energies, MDPI, vol. 16(14), pages 1-18, July.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:14:p:5291-:d:1190974
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/14/5291/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/14/5291/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Zhao, Zhenghui & Wang, Ruikun & Ge, Lichao & Wu, Junhong & Yin, Qianqian & Wang, Chunbo, 2019. "Energy utilization of coal-coking wastes via coal slurry preparation: The characteristics of slurrying, combustion, and pollutant emission," Energy, Elsevier, vol. 168(C), pages 609-618.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Dorokhov, V.V. & Kuznetsov, G.V. & Vershinina, K.Yu. & Strizhak, P.A., 2021. "Relative energy efficiency indicators calculated for high-moisture waste-based fuel blends using multiple-criteria decision-making," Energy, Elsevier, vol. 234(C).
    2. Vershinina, Kseniya & Shevyrev, Sergei & Strizhak, Pavel, 2021. "Coal and petroleum-derived components for high-moisture fuel slurries," Energy, Elsevier, vol. 219(C).
    3. Piskunov, Maxim & Romanov, Daniil & Strizhak, Pavel, 2023. "Stability and rheology of carbon-containing composite liquid fuels under subambient temperatures," Energy, Elsevier, vol. 278(PA).
    4. Mao, Lirui & Zheng, Mingdong & Li, Hanxu, 2023. "Acceleration effect of BDO tar on coal water slurry during co-gasification," Energy, Elsevier, vol. 262(PA).
    5. Hammerton, James M. & Li, Hu & Ross, Andrew B., 2020. "Char-diesel slurry fuels for microgeneration: Emission characteristics and engine performance," Energy, Elsevier, vol. 207(C).
    6. Zhang, Nan & Wang, Guangwei & Yu, Chunmei & Zhang, Jianliang & Dang, Han & Zhang, Cuiliu & Ning, Xiaojun & Wang, Chuan, 2022. "Physicochemical structure characteristics and combustion kinetics of low-rank coal by hydrothermal carbonization," Energy, Elsevier, vol. 238(PA).
    7. Dmitrii Antonov & Olga Gaidukova & Galina Nyashina & Dmitrii Razumov & Pavel Strizhak, 2022. "Prospects of Using Gas Hydrates in Power Plants," Energies, MDPI, vol. 15(12), pages 1-20, June.
    8. Lei, Yang & Chen, Yuming & Chen, Jinghai & Liu, Xinyan & Wu, Xiaoqin & Chen, Yuqiu, 2023. "A novel modeling strategy for the prediction on the concentration of H2 and CH4 in raw coke oven gas," Energy, Elsevier, vol. 273(C).
    9. Bolegenova, Saltanat & Askarova, Аliya & Georgiev, Aleksandar & Nugymanova, Aizhan & Maximov, Valeriy & Bolegenova, Symbat & Mamedov, Bolat, 2023. "The use of plasma technologies to optimize fuel combustion processes and reduce emissions of harmful substances," Energy, Elsevier, vol. 277(C).
    10. Gvozdyakov, Dmitry & Zenkov, Andrey, 2021. "Improvement of atomization characteristics of coal-water slurries," Energy, Elsevier, vol. 230(C).
    11. Maxim Belonogov & Vadim Dorokhov & Dmitrii Glushkov & Daria Kuznechenkova & Daniil Romanov, 2023. "Combustion Characteristics of Coal-Water Slurry Droplets in High-Temperature Air with the Addition of Syngas," Energies, MDPI, vol. 16(8), pages 1-17, April.
    12. Geniy Kuznetsov & Dmitrii Antonov & Maxim Piskunov & Leonid Yanovskyi & Olga Vysokomornaya, 2022. "Alternative Liquid Fuels for Power Plants and Engines for Aviation, Marine, and Land Applications," Energies, MDPI, vol. 15(24), pages 1-21, December.
    13. Zhang, Zongxi & Zhou, Yuguang & Zhao, Nan & Li, Huan & Tohniyaz, Bahargul & Mperejekumana, Philbert & Hong, Quan & Wu, Rucong & Li, Gang & Sultan, Muhammad & Zayan, Ali Mohammed Ibrahim & Cao, Jinxin , 2021. "Clean heating during winter season in Northern China: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 149(C).
    14. Klimenko, A. Yu. & Kuznetsov, G.V. & Podgornaya, E.R. & Volkov, R.S. & Strizhak, P.A., 2024. "The composition of an atomized slurry fuel jet," Energy, Elsevier, vol. 288(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:14:p:5291-:d:1190974. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.