IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2022i1p430-d1020225.html
   My bibliography  Save this article

Analysis of Low-Density Heat Flux Data by the Wavelet Method

Author

Listed:
  • Oleksandra Hotra

    (Department of Electronics and Information Technology, Lublin University of Technology, Nadbystrzycka 38D, 20-618 Lublin, Poland)

  • Svitlana Kovtun

    (Department of Monitoring and Diagnostic of Energy Objects, General Energy Institute of NAS of Ukraine, Antonovicha 172, 03057 Kyiv, Ukraine)

  • Oleg Dekusha

    (Department of Monitoring and Diagnostic of Energy Objects, General Energy Institute of NAS of Ukraine, Antonovicha 172, 03057 Kyiv, Ukraine)

  • Żaklin Grądz

    (Department of Electronics and Information Technology, Lublin University of Technology, Nadbystrzycka 38D, 20-618 Lublin, Poland)

  • Vitalii Babak

    (Department of Monitoring and Diagnostic of Energy Objects, General Energy Institute of NAS of Ukraine, Antonovicha 172, 03057 Kyiv, Ukraine)

  • Joanna Styczeń

    (Department of Construction, Lublin University of Technology, Nadbystrzycka 38D, 20-618 Lublin, Poland)

Abstract

When evaluating the energy efficiency of buildings and implementing the necessary measures to increase energy efficiency levels, thermal technical characteristics are determined. For this purpose, in situ measurements of the thermal resistance of external enclosing structures were carried out. One of the methods most often used by researchers is the non-destructive method—the heat flow meter (HFM) method regulated by ISO 9869. In the case of surveying a building with a high level of thermal resistance, researchers are faced with low-density heat flux measurements, which is always a difficult task due to significant fluctuations and the influence of external factors on the measurement results. This is due to the fact that it is difficult to determine what is a useful signal and what is a consequence of the effects of non-stationarity and heat transfer conditions. The article provides an example of low-density heat flux measurements when determining the thermal resistance of a building and proposes a data pre-processing procedure that allows for the reduction of heat flux fluctuations, which has a significant impact on the final result at low density. The proposed use of wavelet analysis in the pre-processing of low-density heat flux measurement data makes it possible to reconstruct them or reduce disturbances that occur during research. A comparison of the obtained results with the results of the calculation according to ISO 9869-1 showed a decrease in the standard deviation of the measurements from 5.74 to 2.81%. The results of this study can be used to reduce the noise of low-density heat flux and, as a result, reduce the standard deviation of the measurement when applying the HFM method of determining the thermal resistance of external enclosing structures.

Suggested Citation

  • Oleksandra Hotra & Svitlana Kovtun & Oleg Dekusha & Żaklin Grądz & Vitalii Babak & Joanna Styczeń, 2022. "Analysis of Low-Density Heat Flux Data by the Wavelet Method," Energies, MDPI, vol. 16(1), pages 1-16, December.
  • Handle: RePEc:gam:jeners:v:16:y:2022:i:1:p:430-:d:1020225
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/1/430/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/16/1/430/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Bienvenido-Huertas, David & Moyano, Juan & Marín, David & Fresco-Contreras, Rafael, 2019. "Review of in situ methods for assessing the thermal transmittance of walls," Renewable and Sustainable Energy Reviews, Elsevier, vol. 102(C), pages 356-371.
    2. Oleksandra Hotra & Svitlana Kovtun & Oleg Dekusha & Żaklin Grądz, 2021. "Prospects for the Application of Wavelet Analysis to the Results of Thermal Conductivity Express Control of Thermal Insulation Materials," Energies, MDPI, vol. 14(17), pages 1-15, August.
    3. Jahangiri, Ali & Mohammadi, Samira & Akbari, Mohammad, 2019. "Modeling the one-dimensional inverse heat transfer problem using a Haar wavelet collocation approach," Physica A: Statistical Mechanics and its Applications, Elsevier, vol. 525(C), pages 13-26.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Andrea Alongi & Luca Sala & Adriana Angelotti & Livio Mazzarella, 2023. "In Situ Measurement of Wall Thermal Properties: Parametric Investigation of the Heat Flow Meter Methods through Virtual Experiments Data," Energies, MDPI, vol. 16(10), pages 1-21, May.
    2. Doo-Sung Choi & Ye-Ji Lee & Ji-Hoon Moon & Yong-Shik Kim & Myeong-Jin Ko, 2023. "Estimating In-Situ R-Value of Highly Insulated Building Walls Based on the Measurement of Temperature and Heat Flux Inside the Wall," Energies, MDPI, vol. 16(15), pages 1-16, July.
    3. Sanjin Gumbarević & Bojan Milovanović & Bojana Dalbelo Bašić & Mergim Gaši, 2022. "Combining Deep Learning and the Heat Flux Method for In-Situ Thermal-Transmittance Measurement Improvement," Energies, MDPI, vol. 15(14), pages 1-19, July.
    4. Xun Liu & Zhenhan Ding & Xiaobo Li & Zhiyuan Xue, 2023. "Research Progress, Hotspots, and Trends of Using BIM to Reduce Building Energy Consumption: Visual Analysis Based on WOS Database," IJERPH, MDPI, vol. 20(4), pages 1-21, February.
    5. Víctor Echarri-Iribarren & Nyuk Hien Wong & Ana Sánchez-Ostiz, 2021. "Radiant Floors versus Radiant Walls Using Ceramic Thermal Panels in Mediterranean Dwellings: Annual Energy Demand and Cost-Effective Analysis," Sustainability, MDPI, vol. 13(2), pages 1-26, January.
    6. Bienvenido-Huertas, David & Rubio-Bellido, Carlos & Solís-Guzmán, Jaime & Oliveira, Miguel José, 2020. "Experimental characterisation of the periodic thermal properties of walls using artificial intelligence," Energy, Elsevier, vol. 203(C).
    7. Wu, Wentao & Zhang, Wei & Benner, Jingru & Malkawi, Ali, 2020. "Critical evaluation of analytical methods for thermally activated building systems," Renewable and Sustainable Energy Reviews, Elsevier, vol. 117(C).
    8. Tetiana Bilan & Mykola Kaplin & Vitaliy Makarov & Mykola Perov & Ihor Novitskii & Artur Zaporozhets & Valerii Havrysh & Vitalii Nitsenko, 2022. "The Balance and Optimization Model of Coal Supply in the Flow Representation of Domestic Production and Imports: The Ukrainian Case Study," Energies, MDPI, vol. 15(21), pages 1-19, October.
    9. David Bienvenido-Huertas & Juan Moyano & Carlos E. Rodríguez-Jiménez & Aurelio Muñoz-Rubio & Francisco Javier Bermúdez Rodríguez, 2020. "Quality Control of the Thermal Properties of Superstructures in Accommodation Spaces in Naval Constructions," Sustainability, MDPI, vol. 12(10), pages 1-18, May.
    10. Cristina Cornaro & Gianluigi Bovesecchi & Filippo Calcerano & Letizia Martinelli & Elena Gigliarelli, 2023. "An HBIM Integrated Approach Using Non-Destructive Techniques (NDT) to Support Energy and Environmental Improvement of Built Heritage: The Case Study of Palazzo Maffei Borghese in Rome," Sustainability, MDPI, vol. 15(14), pages 1-36, July.
    11. Ye-Ji Lee & Ji-Hoon Moon & Doo-Sung Choi & Myeong-Jin Ko, 2024. "Influences of Average Temperature Difference and Measurement Period on Estimation of In Situ Thermal Transmittance of Building Exterior Walls Using the Average Method of ISO 9869-1," Energies, MDPI, vol. 17(5), pages 1-16, March.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2022:i:1:p:430-:d:1020225. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.