IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i5p1757-d759751.html
   My bibliography  Save this article

A Production Performance Model of the Cyclic Steam Stimulation Process in Multilayer Heavy Oil Reservoirs

Author

Listed:
  • Tingen Fan

    (State Key Laboratory of Offshore Oil Exploitation, Beijing 100028, China
    CNOOC Research Institute Ltd., Beijing 100028, China)

  • Wenjiang Xu

    (China National Offshore Oil Corporation, Beijing 100010, China)

  • Wei Zheng

    (State Key Laboratory of Offshore Oil Exploitation, Beijing 100028, China
    CNOOC Research Institute Ltd., Beijing 100028, China)

  • Weidong Jiang

    (China National Offshore Oil Corporation, Beijing 100010, China)

  • Xiuchao Jiang

    (State Key Laboratory of Petroleum Resources and Prospecting, China University of Petroleum (Beijing), Beijing 102249, China)

  • Taichao Wang

    (State Key Laboratory of Offshore Oil Exploitation, Beijing 100028, China
    CNOOC Research Institute Ltd., Beijing 100028, China)

  • Xiaohu Dong

    (State Key Laboratory of Petroleum Resources and Prospecting, China University of Petroleum (Beijing), Beijing 102249, China)

Abstract

Cyclic steam stimulation (CSS) is a typical enhanced oil recovery method for heavy oil reservoirs. In this paper, a new model for the productivity of a CSS well in multilayer heavy oil reservoirs is proposed. First, for the steam volume of each formation layer, it is proposed that the total steam injection volume will be split by the formation factor ( Kh ) for the commingled steam injection mode. Then, based on the equivalent flow resistance principle, the productivity model can be derived. In this model, the heavy oil reservoir is composed of a cold zone, a hot water zone, and a steam zone. Next, using the energy conservation law, the equivalent heating radius can be calculated with the consideration of the steam overlay. Simultaneously, a correlation between the threshold pressure gradient (TPG) and oil mobility is also applied for the productivity formula in the cold zone and the hot water zone. Afterward, this model is validated by comparing the simulation results with the results of an actual CNOOC CSS well. A good agreement is observed, and the relative error of the cumulative oil production is about 2.20%. The sensitivity analysis results indicate that the effect of the bottom hole pressure is the most significant, followed by the TPG, and the effect of the steam overlay is relatively slight. The formation factor can affect the splitting of the steam volume in each layer; thus, the oil production rate will be impacted. The proposed mathematical model in this paper provides an effective method for the prediction of preliminary productivity of a CSS well in a multilayer heavy oil reservoir.

Suggested Citation

  • Tingen Fan & Wenjiang Xu & Wei Zheng & Weidong Jiang & Xiuchao Jiang & Taichao Wang & Xiaohu Dong, 2022. "A Production Performance Model of the Cyclic Steam Stimulation Process in Multilayer Heavy Oil Reservoirs," Energies, MDPI, vol. 15(5), pages 1-21, February.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:5:p:1757-:d:759751
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/5/1757/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/5/1757/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Dong, Xiaohu & Liu, Huiqing & Chen, Zhangxin & Wu, Keliu & Lu, Ning & Zhang, Qichen, 2019. "Enhanced oil recovery techniques for heavy oil and oilsands reservoirs after steam injection," Applied Energy, Elsevier, vol. 239(C), pages 1190-1211.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Kirill A. Bashmur & Oleg A. Kolenchukov & Vladimir V. Bukhtoyarov & Vadim S. Tynchenko & Sergei O. Kurashkin & Elena V. Tsygankova & Vladislav V. Kukartsev & Roman B. Sergienko, 2022. "Biofuel Technologies and Petroleum Industry: Synergy of Sustainable Development for the Eastern Siberian Arctic," Sustainability, MDPI, vol. 14(20), pages 1-25, October.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Wang, Sijia & Jiang, Lanlan & Cheng, Zucheng & Liu, Yu & Zhao, Jiafei & Song, Yongchen, 2021. "Experimental study on the CO2-decane displacement front behavior in high permeability sand evaluated by magnetic resonance imaging," Energy, Elsevier, vol. 217(C).
    2. Li, Jing & Zhang, Lisong & Yang, Feiyue & Sun, Luning, 2020. "Positive measure and potential implication for heavy oil recovery of dip reservoir using SAGD based on numerical analysis," Energy, Elsevier, vol. 193(C).
    3. Zhou, Yuhao & Wang, Yanwei, 2022. "An integrated framework based on deep learning algorithm for optimizing thermochemical production in heavy oil reservoirs," Energy, Elsevier, vol. 253(C).
    4. Anufriev, I.S. & Kopyev, E.P. & Alekseenko, S.V. & Sharypov, O.V. & Vigriyanov, M.S., 2022. "New ecology safe waste-to-energy technology of liquid fuel combustion with superheated steam," Energy, Elsevier, vol. 250(C).
    5. Zhang, Lisong & Li, Jing & Sun, Luning & Yang, Feiyue, 2021. "An influence mechanism of shale barrier on heavy oil recovery using SAGD based on theoretical and numerical analysis," Energy, Elsevier, vol. 216(C).
    6. Yiwei Wang & Yuan Wang & Sunhua Deng & Qiang Li & Jingjing Gu & Haoche Shui & Wei Guo, 2022. "Numerical Simulation Analysis of Heating Effect of Downhole Methane Catalytic Combustion Heater under High Pressure," Energies, MDPI, vol. 15(3), pages 1-23, February.
    7. Camilo Andrés Guerrero-Martin & Angie Tatiana Ortega-Ramírez & Paula Alejandra Perilla Rodríguez & Shalom Jireth Reyes López & Laura Estefanía Guerrero-Martin & Raúl Salinas-Silva & Stefanny Camacho-G, 2023. "Analysis of Environmental Sustainability through a Weighting Matrix in the Oil and Gas Industry," Sustainability, MDPI, vol. 15(11), pages 1-16, June.
    8. Ying Shi & Hong He & Yu Li & Fei Ding & Zhuo Zhou & Nuolin Xiong, 2023. "High-Temperature-Resistant Epoxy Resin Gel Behavior and Profile Control in Heavy Oil Steam Drive," Energies, MDPI, vol. 17(1), pages 1-14, December.
    9. Yao, Yue & Sun, Deqiang & Xu, Jin-Hua & Wang, Bin & Peng, Guohong & Sun, Bingmei, 2023. "Evaluation of enhanced oil recovery methods for mature continental heavy oil fields in China based on geology, technology and sustainability criteria," Energy, Elsevier, vol. 278(PB).
    10. Wang, Sen & Qin, Chaoxu & Feng, Qihong & Javadpour, Farzam & Rui, Zhenhua, 2021. "A framework for predicting the production performance of unconventional resources using deep learning," Applied Energy, Elsevier, vol. 295(C).
    11. Chai, Maojie & Nourozieh, Hossein & Chen, Zhangxin & Yang, Min, 2022. "A semi-compositional approach to model asphaltene precipitation and deposition in solvent-based bitumen recovery processes," Applied Energy, Elsevier, vol. 328(C).
    12. Anufriev, I.S., 2021. "Review of water/steam addition in liquid-fuel combustion systems for NOx reduction: Waste-to-energy trends," Renewable and Sustainable Energy Reviews, Elsevier, vol. 138(C).
    13. Yuanrui Zhu & Shijun Huang & Lun Zhao & Menglu Yang & Tong Wu, 2020. "A New Model for Discriminating the Source of Produced Water from Cyclic Steam Stimulation Wells in Edge-Bottom Water Reservoirs," Energies, MDPI, vol. 13(11), pages 1-15, May.
    14. Zhengbin Wu & Hanzhao Chen & Xidong Cai & Qiyang Gou & Liangliang Jiang & Kai Chen & Zhangxin Chen & Shu Jiang, 2023. "Current Status and Future Trends of In Situ Catalytic Upgrading of Extra Heavy Oil," Energies, MDPI, vol. 16(12), pages 1-29, June.
    15. Laura Osma & Luis García & Romel Pérez & Carolina Barbosa & Jesús Botett & Jorge Sandoval & Eduardo Manrique, 2019. "Benefit–Cost and Energy Efficiency Index to Support the Screening of Hybrid Cyclic Steam Stimulation Methods," Energies, MDPI, vol. 12(24), pages 1-16, December.
    16. Mateus-Rubiano, Camilo & Castillo, Andrea C. & León, Paola & Rueda, Luis & Molina V, Daniel & Leon, Adan Y., 2024. "Effect of hydrotreatment process on the physicochemical properties of a Colombian heavy crude oil post-catalytic aquathermolysis," Energy, Elsevier, vol. 298(C).
    17. Boris V. Malozyomov & Nikita V. Martyushev & Vladislav V. Kukartsev & Vadim S. Tynchenko & Vladimir V. Bukhtoyarov & Xiaogang Wu & Yadviga A. Tyncheko & Viktor A. Kukartsev, 2023. "Overview of Methods for Enhanced Oil Recovery from Conventional and Unconventional Reservoirs," Energies, MDPI, vol. 16(13), pages 1-48, June.
    18. Zhou, Guangzhao & Guo, Zanquan & Sun, Simin & Jin, Qingsheng, 2023. "A CNN-BiGRU-AM neural network for AI applications in shale oil production prediction," Applied Energy, Elsevier, vol. 344(C).
    19. Yang, Min & Liu, Yishan & Lu, Ning & Chai, Maojie & Wang, Sen & Feng, Qihong & Chen, Zhangxin, 2023. "Integration of ramped temperature oxidation and combustion tube tests for kinetic modeling of heavy oil in-Situ combustion," Energy, Elsevier, vol. 274(C).
    20. Yu, Peng, 2022. "Posterior probability-based hydraulic unit division and prediction: A case study," Energy, Elsevier, vol. 246(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:5:p:1757-:d:759751. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.