IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i22p7637-d679725.html
   My bibliography  Save this article

Experimental Study on the Impingement Characteristics of Self-Excited Oscillation Supercritical CO 2 Jets Produced by Organ-Pipe Nozzles

Author

Listed:
  • Mengda Zhang

    (School of Power and Mechanical Engineering, Wuhan University, Wuhan 430072, China)

  • Zhenlong Fang

    (School of Transportation and Logistics Engineering, Wuhan University of Technology, Wuhan 430063, China
    Sanya Science and Education Innovation Park, Wuhan University of Technology, Sanya 572025, China)

  • Yi’nan Qian

    (School of Power and Mechanical Engineering, Wuhan University, Wuhan 430072, China)

Abstract

Supercritical carbon dioxide (SCO 2 ) jets are a promising method to assist drilling, enhance oil–gas production, and reduce greenhouse gas emissions. To further improve the drilling efficiency of SCO 2 jet-assisted drilling, organ-pipe nozzles were applied to generate a self-excited oscillation SCO 2 jet (SEOSJ). The impact pressure oscillation and rock erosion capability of SEOSJs under both supercritical and gaseous CO 2 (GCO 2 ) ambient conditions were experimentally investigated. It was found that the impact pressure oscillation characteristics of SEOSJs produced by organ-pipe nozzles are dramatically affected by the oscillation chamber length. The optimum range of the dimensionless chamber length to generate the highest impact pressure peak and the strongest pressure oscillation is within 7–9. The dimensionless pressure peak and the pressure ratio decreases gradually with increasing pressure difference, whereas the pressure oscillation intensity increases with increasing pressure difference and the increasing rate decreases gradually. The dominant frequency was observed to decrease monotonically with increasing chamber length but increases with the increase of pressure difference. Moreover, the comparison of impingement characteristics of SEOSJs under different ambient conditions showed that the values of dimensionless peak impact pressure are similar under the two ambient conditions, and the SEOSJ achieves higher pressure oscillation intensity and dominant frequency in SCO 2 at the same pressure difference. The rock breaking ability of the SEOSJ is closely related to its axial impact pressure. The erosion depth and mass loss of sandstone caused by the organ-pipe nozzle with the best impact pressure performance is higher than those produced by other nozzles. The SEOSJ results in a deeper and narrower crater in SCO 2 than in GCO 2 under the same pressure difference. The reported results provide guidance for SEOSJ applications and the design of an organ-pipe nozzle used for jet-assisted drilling.

Suggested Citation

  • Mengda Zhang & Zhenlong Fang & Yi’nan Qian, 2021. "Experimental Study on the Impingement Characteristics of Self-Excited Oscillation Supercritical CO 2 Jets Produced by Organ-Pipe Nozzles," Energies, MDPI, vol. 14(22), pages 1-15, November.
    • Handle: RePEc:gam:jeners:v:14:y:2021:i:22:p:7637-:d:679725
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/22/7637/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/14/22/7637/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Boshen Liu & Fei Ma, 2020. "Erosion Characteristics and the Corresponding Self-Resonating Oscillations of Cavitating Jet on Oblique Surfaces," Energies, MDPI, vol. 13(10), pages 1-14, May.
    2. Zhenlong Fang & Qiang Wu & Mengda Zhang & Haoyang Liu & Pan Jiang & Deng Li, 2019. "Large Eddy Simulation of Self-Excited Oscillation Pulsed Jet (SEOPJ) Induced by a Helmholtz Oscillator in Underground Mining," Energies, MDPI, vol. 12(11), pages 1-20, June.
    3. Tengfei Cai & Yan Pan & Fei Ma & Pingping Xu, 2020. "Effects of Organ-Pipe Chamber Geometry on the Frequency and Erosion Characteristics of the Self-Excited Cavitating Waterjet," Energies, MDPI, vol. 13(4), pages 1-13, February.
    4. Liu, Bohan & Lu, Mingjian & Shui, Bo & Sun, Yuwei & Wei, Wei, 2022. "Thermal-hydraulic performance analysis of printed circuit heat exchanger precooler in the Brayton cycle for supercritical CO2 waste heat recovery," Applied Energy, Elsevier, vol. 305(C).
    5. Xiaoliang Wang & Yong Kang & Mengda Zhang & Miao Yuan & Deng Li, 2018. "The Effects of the Downstream Contraction Ratio of Organ-Pipe Nozzle on the Pressure Oscillations of Self-Resonating Waterjets," Energies, MDPI, vol. 11(11), pages 1-12, November.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Tengfei Cai & Yan Pan & Fei Ma & Pingping Xu, 2020. "Effects of Organ-Pipe Chamber Geometry on the Frequency and Erosion Characteristics of the Self-Excited Cavitating Waterjet," Energies, MDPI, vol. 13(4), pages 1-13, February.
    2. Peiyue Li & Wen Fu & Kaidi Zhang & Qiulong Li & Yi Zhang & Yanmo Li & Zhihua Wang & Xiuhua Hou & Yuwei Sun & Wei Wei, 2024. "Effect of Channel Shape on Heat Transfer and Mechanical Properties of Supercritical CO 2 Microchannel Heat Exchanger," Energies, MDPI, vol. 17(15), pages 1-17, July.
    3. Yuhui Xiao & Yuan Zhou & Yuan Yuan & Yanping Huang & Gengyuan Tian, 2023. "Research Advances in the Application of the Supercritical CO 2 Brayton Cycle to Reactor Systems: A Review," Energies, MDPI, vol. 16(21), pages 1-23, October.
    4. Ouyang, Tiancheng & Pan, Mingming & Tan, Xianlin & Huang, Youbin & Mo, Chunlan & Wang, Zhiping, 2023. "Advanced power-refrigeration-cycle integrated WHR system for marine natural gas engine base on multi-objective optimization," Energy, Elsevier, vol. 283(C).
    5. Khoshvaght-Aliabadi, Morteza & Ghodrati, Parvaneh & Kang, Yong Tae, 2023. "Optimal combination of converging and diverging minichannels in PCHE as precooler under diverse operating conditions of supercritical CO2," Energy, Elsevier, vol. 272(C).
    6. Khoshvaght-Aliabadi, Morteza & Ghodrati, Parvaneh & Mahian, Omid & Kang, Yong Tae, 2024. "CFD study of rib-enhanced printed circuit heat exchangers for precoolers in solar power plants' supercritical CO2 cycle," Energy, Elsevier, vol. 292(C).
    7. Wang, Yuan & Ren, Jing-Jie & Bi, Ming-Shu, 2023. "Analysis on the heat transfer performance of supercritical liquified natural gas in horizontal tubes during regasification process," Energy, Elsevier, vol. 262(PA).
    8. Kumar, Nitesh & Basu, Dipankar N., 2023. "Thermalhydraulic assessment and design optimization of incorporating flow obstructors in a supercritical minichannel heat sink," Applied Energy, Elsevier, vol. 349(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:22:p:7637-:d:679725. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.