IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v12y2019i7p1191-d217477.html
   My bibliography  Save this article

Drying of Lignite of Various Origins in a Pilot Scale Toroidal Fluidized Bed Dryer using Low Quality Heat

Author

Listed:
  • Halina Pawlak–Kruczek

    (Wroclaw University of Science and Technology, Faculty of Mechanical and Power Engineering, Department of Boilers, Combustion and Energy Processes, 59-400 Wrocław, Poland)

  • Michał Czerep

    (Wroclaw University of Science and Technology, Faculty of Mechanical and Power Engineering, Department of Boilers, Combustion and Energy Processes, 59-400 Wrocław, Poland)

  • Lukasz Niedzwiecki

    (Wroclaw University of Science and Technology, Faculty of Mechanical and Power Engineering, Department of Boilers, Combustion and Energy Processes, 59-400 Wrocław, Poland)

  • Emmanouil Karampinis

    (Centre for Research and Technology Hellas, Chemical Process and Energy Resources Institute, GR 502 00 Ptolemais, Greece)

  • Ioannis Violidakis

    (Centre for Research and Technology Hellas, Chemical Process and Energy Resources Institute, GR 502 00 Ptolemais, Greece)

  • Ioannis Avagianos

    (Centre for Research and Technology Hellas, Chemical Process and Energy Resources Institute, GR 502 00 Ptolemais, Greece)

  • Panagiotis Grammelis

    (Centre for Research and Technology Hellas, Chemical Process and Energy Resources Institute, GR 502 00 Ptolemais, Greece)

Abstract

An experimental study was carried out for lignites of different places of origin, i.e., Poland, Greece, Romania and Australia, using a toroidal bed dryer. The effect of the temperature on the drying efficiency, including the loss of moisture content over time under fixed drying conditions was the subject of the investigation. The main goal was to confirm the possibility of the use of a toroidal bed as a base for a drying system that could utilize low quality heat from sources such as flue gases from a boiler and determine the optimum parameters for such a system. The conducted study has conclusively proven the feasibility of the use of low temperature heat sources for drying lignite in a toroidal bed. A moisture content of 20% could be achieved for most of the tested lignites, using the toroidal bed, with reasonably short residence times (approx. 30 min) and an air temperature as low as 60 °C. Moreover, the change of the particle size distribution, to some degree, affected the final moisture content due to the entrainment of wet, fine particles. The study also determined that the in-bed attrition of the particles is partially responsible for the generation of fines.

Suggested Citation

  • Halina Pawlak–Kruczek & Michał Czerep & Lukasz Niedzwiecki & Emmanouil Karampinis & Ioannis Violidakis & Ioannis Avagianos & Panagiotis Grammelis, 2019. "Drying of Lignite of Various Origins in a Pilot Scale Toroidal Fluidized Bed Dryer using Low Quality Heat," Energies, MDPI, vol. 12(7), pages 1-22, March.
    • Handle: RePEc:gam:jeners:v:12:y:2019:i:7:p:1191-:d:217477
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/12/7/1191/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/12/7/1191/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Heng Chen & Zhen Qi & Qiao Chen & Yunyun Wu & Gang Xu & Yongping Yang, 2018. "Modified High Back-Pressure Heating System Integrated with Raw Coal Pre-Drying in Combined Heat and Power Unit," Energies, MDPI, vol. 11(9), pages 1-16, September.
    2. Xu, Cheng & Xu, Gang & Zhao, Shifei & Zhou, Luyao & Yang, Yongping & Zhang, Dongke, 2015. "An improved configuration of lignite pre-drying using a supplementary steam cycle in a lignite fired supercritical power plant," Applied Energy, Elsevier, vol. 160(C), pages 882-891.
    3. Anna Sciazko & Yosuke Komatsu & Marcin Zakrzewski & Taro Akiyama & Akira Hashimoto & Naoki Shikazono & Shozo Kaneko & Shinji Kimijima & Janusz S. Szmyd & Yoshinori Kobayashi, 2016. "Experimental Attempts to Investigate the Influence of Petrographic Properties on Drying Characteristics of Lignite in Superheated Steam Atmosphere," Energies, MDPI, vol. 9(5), pages 1-18, May.
    4. Agraniotis, Michalis & Koumanakos, Antonis & Doukelis, Aggelos & Karellas, Sotirios & Kakaras, Emmanuel, 2012. "Investigation of technical and economic aspects of pre-dried lignite utilisation in a modern lignite power plant towards zero CO2 emissions," Energy, Elsevier, vol. 45(1), pages 134-141.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Prabhakaran, SP Sathiya & Swaminathan, Ganapathiraman & Joshi, Viraj V., 2022. "Combustion and pyrolysis kinetics of Australian lignite coal and validation by artificial neural networks," Energy, Elsevier, vol. 242(C).
    2. Tadeáš Ochodek & Emmanouil Karampinis & Artur Pozarlik, 2022. "Contemporary Problems in Combustion—Fuels, Their Valorisation, Emissions, Flexibility and Auxiliary Systems," Energies, MDPI, vol. 15(5), pages 1-4, February.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Pawlak-Kruczek, Halina & Niedźwiecki, Łukasz & Ostrycharczyk, Michał & Czerep, Michał & Plutecki, Zbigniew, 2019. "Potential and methods for increasing the flexibility and efficiency of the lignite fired power unit, using integrated lignite drying," Energy, Elsevier, vol. 181(C), pages 1142-1151.
    2. Han, Xiaoqu & Liu, Ming & Zhai, Mengxu & Chong, Daotong & Yan, Junjie & Xiao, Feng, 2015. "Investigation on the off-design performances of flue gas pre-dried lignite-fired power system integrated with waste heat recovery at variable external working conditions," Energy, Elsevier, vol. 90(P2), pages 1743-1758.
    3. Fu, Pengbo & Yu, Hao & Li, Qiqi & Cheng, Tingting & Zhang, Fangzheng & Yang, Tao & Huang, Yuan & Li, Jianping & Fang, Xiangchen & Xiu, Guangli & Wang, Hualin, 2022. "Cyclone rotational drying of lignite based on particle high-speed self-rotation: Lower carrier gas temperature and shorter residence time," Energy, Elsevier, vol. 244(PB).
    4. Atsonios, K. & Violidakis, I. & Sfetsioris, K. & Rakopoulos, D.C. & Grammelis, P. & Kakaras, E., 2016. "Pre-dried lignite technology implementation in partial load/low demand cases for flexibility enhancement," Energy, Elsevier, vol. 96(C), pages 427-436.
    5. Somchart Chantasiriwan, 2023. "Reduction in Fuel Consumption in Biomass-Fired Power Plant Using Hybrid Drying System," Energies, MDPI, vol. 16(17), pages 1-14, August.
    6. Han, Yu & Sun, Yingying & Wu, Junjie, 2023. "A novel solar-driven waste heat recovery system in solar-fuel hybrid power plants," Energy, Elsevier, vol. 285(C).
    7. Ming Yan & Xinnan Song & Jin Tian & Xuebin Lv & Ze Zhang & Xiaoyan Yu & Shuting Zhang, 2020. "Construction of a New Type of Coal Moisture Control Device Based on the Characteristic of Indirect Drying Process of Coking Coal," Energies, MDPI, vol. 13(16), pages 1-20, August.
    8. Janusz Kotowicz & Sebastian Michalski & Mateusz Brzęczek, 2019. "The Characteristics of a Modern Oxy-Fuel Power Plant," Energies, MDPI, vol. 12(17), pages 1-34, September.
    9. Zhao, Haitao & Jiang, Peng & Chen, Zhe & Ezeh, Collins I. & Hong, Yuanda & Guo, Yishan & Zheng, Chenghang & Džapo, Hrvoje & Gao, Xiang & Wu, Tao, 2019. "Improvement of fuel sources and energy products flexibility in coal power plants via energy-cyber-physical-systems approach," Applied Energy, Elsevier, vol. 254(C).
    10. Braimakis, Konstantinos & Magiri-Skouloudi, Despina & Grimekis, Dimitrios & Karellas, Sotirios, 2020. "Εnergy-exergy analysis of ultra-supercritical biomass-fuelled steam power plants for industrial CHP, district heating and cooling," Renewable Energy, Elsevier, vol. 154(C), pages 252-269.
    11. Wang, Di & Xie, Xinyan & Wang, Chaonan & Zhou, Yunlong & Yang, Mei & Li, Xiaoli & Liu, Deying, 2021. "Thermo-economic analysis on an improved coal-fired power system integrated with S–CO2 brayton cycle," Energy, Elsevier, vol. 220(C).
    12. Han, Xiaoqu & Liu, Ming & Wang, Jinshi & Yan, Junjie & Liu, Jiping & Xiao, Feng, 2014. "Simulation study on lignite-fired power system integrated with flue gas drying and waste heat recovery – Performances under variable power loads coupled with off-design parameters," Energy, Elsevier, vol. 76(C), pages 406-418.
    13. Li, Zixiang & Miao, Zhengqing & Shen, Xusheng & Li, Jiangtao, 2018. "Effects of momentum ratio and velocity difference on combustion performance in lignite-fired pulverized boiler," Energy, Elsevier, vol. 165(PA), pages 825-839.
    14. Shifei Zhao & Weishu Wang & Zhihua Ge, 2020. "Energy and Exergy Evaluations of a Combined Heat and Power System with a High Back-Pressure Turbine under Full Operating Conditions," Energies, MDPI, vol. 13(17), pages 1-18, August.
    15. Xin, Tuantuan & Zhang, Yifei & Li, Xikang & Xu, Hongyu & Xu, Cheng, 2024. "A novel coal-based Allam cycle coupled to CO2 gasification with improved thermodynamic and economic performance," Energy, Elsevier, vol. 293(C).
    16. Pettinau, Alberto & Ferrara, Francesca & Amorino, Carlo, 2013. "Combustion vs. gasification for a demonstration CCS (carbon capture and storage) project in Italy: A techno-economic analysis," Energy, Elsevier, vol. 50(C), pages 160-169.
    17. Liu, Ming & Yan, JunJie & Chong, DaoTong & Liu, JiPing & Wang, JinShi, 2013. "Thermodynamic analysis of pre-drying methods for pre-dried lignite-fired power plant," Energy, Elsevier, vol. 49(C), pages 107-118.
    18. Xu, Cheng & Zhang, Qiang & Yang, Zhiping & Li, Xiaosa & Xu, Gang & Yang, Yongping, 2018. "An improved supercritical coal-fired power generation system incorporating a supplementary supercritical CO2 cycle," Applied Energy, Elsevier, vol. 231(C), pages 1319-1329.
    19. Xiaolong Yang & Yan Li & Dongxiao Niu & Lijie Sun, 2019. "Research on the Economic Benefit Evaluation of Combined Heat and Power (CHP) Technical Renovation Projects Based on the Improved Factor Analysis and Incremental Method in China," Sustainability, MDPI, vol. 11(19), pages 1-23, September.
    20. Zhang, Shunqi & Liu, Ming & Ma, Yuegeng & Liu, Jiping & Yan, Junjie, 2021. "Flexibility assessment of a modified double-reheat Rankine cycle integrating a regenerative turbine during recuperative heater shutdown processes," Energy, Elsevier, vol. 233(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:12:y:2019:i:7:p:1191-:d:217477. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.