IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v11y2018i4p799-d138877.html
   My bibliography  Save this article

Experimental Campaign Tests on Ultra Micro Gas Turbines, Fuel Supply Comparison and Optimization

Author

Listed:
  • Roberto Capata

    (Department of Mechanical and Aerospace Engineering, University of Roma “Sapienza”, 00184 Roma, Italy)

  • Matteo Saracchini

    (Department of Mechanical and Aerospace Engineering, University of Roma “Sapienza”, 00184 Roma, Italy)

Abstract

The increasing demand for miniaturized radio-controlled vehicles inspired the following research. The uses of these unmanned miniaturized/micro vehicles range from aero-modeling to drones for urban control and military applications too. The common characteristic of these vehicles is the need for a light and compact propulsion system. The radio-controlled (RC) turbines for modeling are ideally suited for this purpose, guaranteeing the necessary thrust with compactness and lightness. This device is a miniaturized turbojet, and it is generally composed of three basic elements: compressor, combustion chamber and turbine. The main goal of the paper is to evaluate the turbojet performance for considering the possibility of its use as a range extender in a hybrid vehicle. Considering the total volume constraints, it will be important to evaluate the specific fuel consumption. Also from the environmental point of view, the possibility of feeding the device with gas has been considered and, consequently, the needed device modifications performed. The test bench has been realized and assembled at the University Department Laboratory. Several different experimental configurations are reproduced and reported here, to obtain performance maps. The experiments results have been compared to previous tests results, as well as numerical simulations. Therefore, it has been possible to make a comparison between the two different fuels. The results show that this device can be used as a range extender for a hybrid vehicle. Moreover, the various tests have shown that, acting on the control unit, it is possible to feed the device with gas (mixture of propane and butane), obtaining a further benefit from the economic point of view. Surely, an in-depth study of the turbine management logic would produce a further advantage in terms of fuel consumption.

Suggested Citation

  • Roberto Capata & Matteo Saracchini, 2018. "Experimental Campaign Tests on Ultra Micro Gas Turbines, Fuel Supply Comparison and Optimization," Energies, MDPI, vol. 11(4), pages 1-17, March.
  • Handle: RePEc:gam:jeners:v:11:y:2018:i:4:p:799-:d:138877
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/11/4/799/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/11/4/799/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Schiffmann, J. & Favrat, D., 2010. "Design, experimental investigation and multi-objective optimization of a small-scale radial compressor for heat pump applications," Energy, Elsevier, vol. 35(1), pages 436-450.
    2. Roberto Capata & Enrico Sciubba, 2015. "Experimental Fitting of the Re-Scaled Balje Maps for Low-Reynolds Radial Turbomachinery," Energies, MDPI, vol. 8(8), pages 1-15, July.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Marcin Wołowicz & Piotr Kolasiński & Krzysztof Badyda, 2021. "Modern Small and Microcogeneration Systems—A Review," Energies, MDPI, vol. 14(3), pages 1-47, February.
    2. Khaoula Derbel & Károly Beneda, 2020. "Sliding Mode Control for Micro Turbojet Engine Using Turbofan Power Ratio as Control Law," Energies, MDPI, vol. 13(18), pages 1-23, September.
    3. Nicola Menga & Akhila Mothakani & Maria Grazia De Giorgi & Radoslaw Przysowa & Antonio Ficarella, 2022. "Extreme Learning Machine-Based Diagnostics for Component Degradation in a Microturbine," Energies, MDPI, vol. 15(19), pages 1-22, October.
    4. Wenjiao Qi & Qinghua Deng & Yu Jiang & Qi Yuan & Zhenping Feng, 2018. "Disc Thickness and Spacing Distance Impacts on Flow Characteristics of Multichannel Tesla Turbines," Energies, MDPI, vol. 12(1), pages 1-25, December.
    5. Roberto Capata, 2018. "Urban and Extra-Urban Hybrid Vehicles: A Technological Review," Energies, MDPI, vol. 11(11), pages 1-38, October.
    6. Heyu Wang & Kai Hong Luo, 2023. "Aerothermal Performance and Soot Emissions of Reacting Flow in a Micro-Gas Turbine Combustor," Energies, MDPI, vol. 16(7), pages 1-19, March.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Sebastián, Andrés & Abbas, Rubén & Valdés, Manuel, 2021. "Analytical prediction of Reynolds-number effects on miniaturized centrifugal compressors under off-design conditions," Energy, Elsevier, vol. 227(C).
    2. Menon, Ramanunni P. & Paolone, Mario & Maréchal, François, 2013. "Study of optimal design of polygeneration systems in optimal control strategies," Energy, Elsevier, vol. 55(C), pages 134-141.
    3. Masi, Massimo & Da Lio, Luca & Lazzaretto, Andrea, 2020. "An insight into the similarity approach to predict the maximum efficiency of organic Rankine cycle turbines," Energy, Elsevier, vol. 198(C).
    4. Wenjiao Qi & Qinghua Deng & Yu Jiang & Qi Yuan & Zhenping Feng, 2018. "Disc Thickness and Spacing Distance Impacts on Flow Characteristics of Multichannel Tesla Turbines," Energies, MDPI, vol. 12(1), pages 1-25, December.
    5. Roberto Capata, 2018. "Urban and Extra-Urban Hybrid Vehicles: A Technological Review," Energies, MDPI, vol. 11(11), pages 1-38, October.
    6. Li, Qubo & Piechna, Janusz & Müller, Norbert, 2011. "Numerical simulation of novel axial impeller patterns to compress water vapor as refrigerant," Energy, Elsevier, vol. 36(5), pages 2773-2781.
    7. Olmedo, L.E. & Schiffmann, J., 2023. "Towards a real-time capable hybrid-twin for gas-bearing supported high-speed turbocompressors," Energy, Elsevier, vol. 275(C).
    8. Diango, A. & Perilhon, C. & Descombes, G. & Danho, E., 2011. "Application of exergy balances for the optimization of non-adiabatic small turbomachines operation," Energy, Elsevier, vol. 36(5), pages 2924-2936.
    9. Uusitalo, Antti & Turunen-Saaresti, Teemu & Honkatukia, Juha & Tiainen, Jonna & Jaatinen-Värri, Ahti, 2020. "Numerical analysis of working fluids for large scale centrifugal compressor driven cascade heat pumps upgrading waste heat," Applied Energy, Elsevier, vol. 269(C).
    10. Julian Unterluggauer & Verena Sulzgruber & Clemens Kroiss & Johannes Riedl & Reinhard Jentsch & Reinhard Willinger, 2023. "Design for a Heat Pump with Sink Temperatures of 200 °C Using a Radial Compressor," Energies, MDPI, vol. 16(13), pages 1-21, June.
    11. Vering, Christian & Maier, Laura & Breuer, Katharina & Krützfeldt, Hannah & Streblow, Rita & Müller, Dirk, 2022. "Evaluating heat pump system design methods towards a sustainable heat supply in residential buildings," Applied Energy, Elsevier, vol. 308(C).
    12. Mounier, Violette & Olmedo, Luis Eric & Schiffmann, Jürg, 2018. "Small scale radial inflow turbine performance and pre-design maps for Organic Rankine Cycles," Energy, Elsevier, vol. 143(C), pages 1072-1084.
    13. Turan, Onder, 2012. "Exergetic effects of some design parameters on the small turbojet engine for unmanned air vehicle applications," Energy, Elsevier, vol. 46(1), pages 51-61.
    14. Wang, Y. & Wang, J. & He, W., 2022. "Development of efficient, flexible and affordable heat pumps for supporting heat and power decarbonisation in the UK and beyond: Review and perspectives," Renewable and Sustainable Energy Reviews, Elsevier, vol. 154(C).
    15. Demierre, J. & Henchoz, S. & Favrat, D., 2012. "Prototype of a thermally driven heat pump based on integrated Organic Rankine Cycles (ORC)," Energy, Elsevier, vol. 41(1), pages 10-17.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:11:y:2018:i:4:p:799-:d:138877. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.