IDEAS home Printed from https://ideas.repec.org/a/eee/renene/v113y2017icp835-845.html
   My bibliography  Save this article

Experimental investigation on anti-condensation characteristic of desiccant coated metal cabinet

Author

Listed:
  • Ge, T.S.
  • Hao, R.Y.
  • Dai, Y.J.
  • Wang, R.Z.
  • Yan, H.

Abstract

Condensation occurring on metal cabinet surface seriously affects the maintenance and operation safety. In order to prevent condensation, desiccant coating surface method is proposed and investigated in this paper. Basic operation model of desiccant coated cabinet to realize anti-condensation and regeneration is first introduced, then an experimental setup is established to investigate and compare both anti-condensation and regeneration capacities of zinc sheet samples with and without desiccant coating. Widely adopted silica gel is adopted as desiccant material in this study. Results show that silica gel coated sample can effectively extend the anti-condensation time 2 to 6 times longer. When surface temperature is between 35 °C and 50 °C under experimental conditions, the coated desiccant material can be regenerated and recycled. The corresponding longest regeneration time is 160 min. The dynamic adsorption capacity of coated silica gel is also analyzed and it is found that both adsorption rate and mass of silica gel increases under lower surface temperature, and improvement index gradually becomes less obvious with decreasing surface temperature, the corresponding saturated adsorption mass of silica gel before condensation is about 0.3 g/g. Finally a practical case study of desiccant coated cabinet is conducted at Shanghai and operation testing shows that occurrence probability of condensation for desiccant coated cabinet greatly decreases from 70% to 10% compared with conventional cabinet in plum rain season, and there is no condensation occurring within desiccant coated cabinet in early autumn. The performance of silica gel coated cabinet is tested under relatively extreme condition with simulated high humid environment (30 °C, 90%) lasting for 7–10 h, it is found that the cabinet could continuously operate for about 60 h without condensation. In conclusion, desiccant coating method is proven to be an effective way to prevent condensation.

Suggested Citation

  • Ge, T.S. & Hao, R.Y. & Dai, Y.J. & Wang, R.Z. & Yan, H., 2017. "Experimental investigation on anti-condensation characteristic of desiccant coated metal cabinet," Renewable Energy, Elsevier, vol. 113(C), pages 835-845.
    • Handle: RePEc:eee:renene:v:113:y:2017:i:c:p:835-845
    DOI: 10.1016/j.renene.2017.06.058
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0960148117305633
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.renene.2017.06.058?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Ge, T.S. & Dai, Y.J. & Wang, R.Z. & Peng, Z.Z., 2010. "Experimental comparison and analysis on silica gel and polymer coated fin-tube heat exchangers," Energy, Elsevier, vol. 35(7), pages 2893-2900.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Chen, Wanhe & Yin, Yonggao & Zhao, Xingwang & Fan, Fangsu & Cao, Bowen & Ji, Qiang & Xu, Guoying, 2023. "Sepiolite based humidity-control coating specially for alleviate the condensation problem of radiant cooling panel," Energy, Elsevier, vol. 272(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zheng, Xu & Zhang, Yu & Wan, Tinghao & Chen, Kang, 2023. "Experimental study on the performance of a novel superabsorbent polymer and activated carbon composite coated heat exchangers," Energy, Elsevier, vol. 281(C).
    2. Chen, W.D. & Vivekh, P. & Liu, M.Z. & Kumja, M. & Chua, K.J., 2021. "Energy improvement and performance prediction of desiccant coated dehumidifiers based on dimensional and scaling analysis," Applied Energy, Elsevier, vol. 303(C).
    3. Sun, X.Y. & Dai, Y.J. & Ge, T.S. & Zhao, Y. & Wang, R.Z., 2017. "Comparison of performance characteristics of desiccant coated air-water heat exchanger with conventional air-water heat exchanger – Experimental and analytical investigation," Energy, Elsevier, vol. 137(C), pages 399-411.
    4. Chai, Shaowei & Sun, Xiangyu & Zhao, Yao & Dai, Yanjun, 2019. "Experimental investigation on a fresh air dehumidification system using heat pump with desiccant coated heat exchanger," Energy, Elsevier, vol. 171(C), pages 306-314.
    5. Bui, Duc Thuan & Kum Ja, M. & Gordon, Jeffrey M. & Ng, Kim Choon & Chua, Kian Jon, 2017. "A thermodynamic perspective to study energy performance of vacuum-based membrane dehumidification," Energy, Elsevier, vol. 132(C), pages 106-115.
    6. Jagirdar, Mrinal & Lee, Poh Seng, 2018. "Mathematical modeling and performance evaluation of a desiccant coated fin-tube heat exchanger," Applied Energy, Elsevier, vol. 212(C), pages 401-415.
    7. Wang, Cong & Yang, Bianfeng & Ji, Xu & Zhang, Ren & Wu, Hailong, 2022. "Study on activated carbon/silica gel/lithium chloride composite desiccant for solid dehumidification," Energy, Elsevier, vol. 251(C).
    8. Zhang, J.Y. & Ge, T.S. & Dai, Y.J. & Zhao, Y. & Wang, R.Z., 2017. "Experimental investigation on solar powered desiccant coated heat exchanger humidification air conditioning system in winter," Energy, Elsevier, vol. 137(C), pages 468-478.
    9. Yang, Tianyu & Ge, Tianshu, 2024. "Performance study of a heat pump fresh air unit based on desiccant coated heat exchangers under different operation strategies," Energy, Elsevier, vol. 296(C).
    10. Entezari, Akram & Ge, T.S. & Wang, R.Z., 2018. "Water adsorption on the coated aluminum sheets by composite materials (LiCl + LiBr)/silica gel," Energy, Elsevier, vol. 160(C), pages 64-71.
    11. Karmakar, Avishek & Prabakaran, Vivekh & Zhao, Dan & Chua, Kian Jon, 2020. "A review of metal-organic frameworks (MOFs) as energy-efficient desiccants for adsorption driven heat-transformation applications," Applied Energy, Elsevier, vol. 269(C).
    12. Santori, G. & Frazzica, A. & Freni, A. & Galieni, M. & Bonaccorsi, L. & Polonara, F. & Restuccia, G., 2013. "Optimization and testing on an adsorption dishwasher," Energy, Elsevier, vol. 50(C), pages 170-176.
    13. Wang, Zhiyuan & Qian, Zhongdong, 2017. "Effects of concentration and size of silt particles on the performance of a double-suction centrifugal pump," Energy, Elsevier, vol. 123(C), pages 36-46.
    14. Feng, Y.H. & Dai, Y.J. & Wang, R.Z. & Ge, T.S., 2022. "Insights into desiccant-based internally-cooled dehumidification using porous sorbents: From a modeling viewpoint," Applied Energy, Elsevier, vol. 311(C).
    15. Chen, K. & Zheng, X. & Wang, S.N., 2022. "Investigation on activated carbon-sodium polyacrylate coated aluminum sheets for desiccant coated heat exchanger," Energy, Elsevier, vol. 245(C).
    16. Ilya Girnik & Tianyu Yang & Larisa Gordeeva & Wenwen Wang & Tianshu Ge & Yuri Aristov, 2020. "New Adsorption Method for Moisture and Heat Exchange in Ventilation Systems in Cold Countries: Concept and Mathematical Simulation," Energies, MDPI, vol. 13(6), pages 1-13, March.
    17. Venegas, Tomas & Qu, Ming & Nawaz, Kashif & Wang, Lingshi, 2021. "Critical review and future prospects for desiccant coated heat exchangers: Materials, design, and manufacturing," Renewable and Sustainable Energy Reviews, Elsevier, vol. 151(C).
    18. Zu, Kan & Qin, Menghao, 2022. "Optimization of the hygrothermal performance of novel metal-organic framework (MOF) based humidity pump: A CFD approach," Energy, Elsevier, vol. 259(C).
    19. Wang, Zhiyuan & Qian, Zhongdong & Lu, Jie & Wu, Pengfei, 2019. "Effects of flow rate and rotational speed on pressure fluctuations in a double-suction centrifugal pump," Energy, Elsevier, vol. 170(C), pages 212-227.
    20. Zheng, X. & Wang, R.Z. & Ge, T.S. & Hu, L.M., 2015. "Performance study of SAPO-34 and FAPO-34 desiccants for desiccant coated heat exchanger systems," Energy, Elsevier, vol. 93(P1), pages 88-94.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:renene:v:113:y:2017:i:c:p:835-845. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/renewable-energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.