IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v34y2009i9p1113-1121.html
   My bibliography  Save this article

Local entropy generation for saturated two-phase flow

Author

Listed:
  • Revellin, Rémi
  • Lips, Stéphane
  • Khandekar, Sameer
  • Bonjour, Jocelyn

Abstract

This paper addresses the estimation of local entropy generation rate for diabatic saturated two-phase flow of a pure fluid. Two different approaches have been adopted for this thermodynamic characterization: the separated flow model using the classical vapor flow quality, and the mixture model, using the thermodynamic vapor quality. Based on these two models, two distinct expressions for the local entropy generation have been proposed. The analysis explicitly shows the contribution of heat transfer and pressure drop respectively to the local entropy generation. The contribution due to phase-change process is also determined using the mixture model. The developed formulation is applied to analyze the thermodynamic performance of enhanced heat transfer tubes under different conditions. It is shown that enhanced tubes may be a relevant solution for reducing entropy generation at low mass velocities whereas smooth tubes remain the best solution at higher ones.

Suggested Citation

  • Revellin, Rémi & Lips, Stéphane & Khandekar, Sameer & Bonjour, Jocelyn, 2009. "Local entropy generation for saturated two-phase flow," Energy, Elsevier, vol. 34(9), pages 1113-1121.
    • Handle: RePEc:eee:energy:v:34:y:2009:i:9:p:1113-1121
    DOI: 10.1016/j.energy.2009.03.014
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544209001005
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2009.03.014?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Abbassi, H., 2007. "Entropy generation analysis in a uniformly heated microchannel heat sink," Energy, Elsevier, vol. 32(10), pages 1932-1947.
    2. Vargas, J.V.C. & Bejan, A., 2000. "Thermodynamic optimization of the match between two streams with phase change," Energy, Elsevier, vol. 25(1), pages 15-33.
    3. Lior, Noam & Sarmiento-Darkin, Wladimir & Al-Sharqawi, Hassan S., 2006. "The exergy fields in transport processes: Their calculation and use," Energy, Elsevier, vol. 31(5), pages 553-578.
    4. Collado, Francisco J., 2005. "The law of stable equilibrium and the entropy-based boiling curve for flow boiling," Energy, Elsevier, vol. 30(6), pages 807-819.
    5. Shiba, T. & Bejan, A., 2001. "Thermodynamic optimization of geometric structure in the counterflow heat exchanger for an environmental control system," Energy, Elsevier, vol. 26(5), pages 493-512.
    6. Haddad, O.M. & Alkam, M.K. & Khasawneh, M.T., 2004. "Entropy generation due to laminar forced convection in the entrance region of a concentric annulus," Energy, Elsevier, vol. 29(1), pages 35-55.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Shoukat A. Khan & Muataz A. Atieh & Muammer Koç, 2018. "Micro-Nano Scale Surface Coating for Nucleate Boiling Heat Transfer: A Critical Review," Energies, MDPI, vol. 11(11), pages 1-30, November.
    2. Aziz, A. & Khan, W.A., 2011. "Classical and minimum entropy generation analyses for steady state conduction with temperature dependent thermal conductivity and asymmetric thermal boundary conditions: Regular and functionally grade," Energy, Elsevier, vol. 36(10), pages 6195-6207.
    3. Ibáñez, Guillermo & López, Aracely & Pantoja, Joel & Moreira, Joel & Reyes, Juan A., 2013. "Optimum slip flow based on the minimization of entropy generation in parallel plate microchannels," Energy, Elsevier, vol. 50(C), pages 143-149.
    4. Ibáñez, Guillermo & Cuevas, Sergio, 2010. "Entropy generation minimization of a MHD (magnetohydrodynamic) flow in a microchannel," Energy, Elsevier, vol. 35(10), pages 4149-4155.
    5. Goudarzi, N. & Talebi, S., 2015. "Improving performance of two-phase natural circulation loops by reducing of entropy generation," Energy, Elsevier, vol. 93(P1), pages 882-899.
    6. Kaluri, Ram Satish & Basak, Tanmay, 2011. "Entropy generation due to natural convection in discretely heated porous square cavities," Energy, Elsevier, vol. 36(8), pages 5065-5080.
    7. Samuel O. Adesanya & J. A. Falade & J. C. Ukaegbu & K. S. Adekeye, 2016. "Mathematical Analysis of a Reactive Viscous Flow through a Channel Filled with a Porous Medium," Journal of Mathematics, Hindawi, vol. 2016, pages 1-8, December.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Sciacovelli, A. & Verda, V. & Sciubba, E., 2015. "Entropy generation analysis as a design tool—A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 43(C), pages 1167-1181.
    2. Shamshiri, Mehdi & Ashrafizaadeh, Mahmud & Shirani, Ebrahim, 2012. "Effects of rarefaction, viscous dissipation and rotation mode on the first and second law analyses of rarefied gaseous slip flows confined between a rotating shaft and its concentric housing," Energy, Elsevier, vol. 37(1), pages 359-370.
    3. Amani, E. & Nobari, M.R.H., 2011. "A numerical investigation of entropy generation in the entrance region of curved pipes at constant wall temperature," Energy, Elsevier, vol. 36(8), pages 4909-4918.
    4. Abbassi, H., 2007. "Entropy generation analysis in a uniformly heated microchannel heat sink," Energy, Elsevier, vol. 32(10), pages 1932-1947.
    5. Nunes, T.K. & Vargas, J.V.C. & Ordonez, J.C. & Shah, D. & Martinho, L.C.S., 2015. "Modeling, simulation and optimization of a vapor compression refrigeration system dynamic and steady state response," Applied Energy, Elsevier, vol. 158(C), pages 540-555.
    6. Toghyani, Mahboubeh & Rahimi, Amir, 2015. "Exergy analysis of an industrial unit of catalyst regeneration based on the results of modeling and simulation," Energy, Elsevier, vol. 91(C), pages 1049-1056.
    7. Le Roux, W.G. & Bello-Ochende, T. & Meyer, J.P., 2012. "Optimum performance of the small-scale open and direct solar thermal Brayton cycle at various environmental conditions and constraints," Energy, Elsevier, vol. 46(1), pages 42-50.
    8. Zebian, Hussam & Mitsos, Alexander, 2012. "A double-pinch criterion for regenerative Rankine cycles," Energy, Elsevier, vol. 40(1), pages 258-270.
    9. Song, Hongqing & Ou, Xunmin & Yuan, Jiehui & Yu, Mingxu & Wang, Cheng, 2017. "Energy consumption and greenhouse gas emissions of diesel/LNG heavy-duty vehicle fleets in China based on a bottom-up model analysis," Energy, Elsevier, vol. 140(P1), pages 966-978.
    10. Huang, Xing & Hong, Jiarong & Zhang, Yaning & Shuai, Yong & Yuan, Yuan & Li, Bingxi & Tan, Heping, 2017. "Exergy distribution characteristics of solar-thermal dissociation of NiFe2O4 in a solar reactor," Energy, Elsevier, vol. 123(C), pages 131-138.
    11. Ibáñez, Guillermo & Cuevas, Sergio, 2010. "Entropy generation minimization of a MHD (magnetohydrodynamic) flow in a microchannel," Energy, Elsevier, vol. 35(10), pages 4149-4155.
    12. Le Roux, W.G. & Bello-Ochende, T. & Meyer, J.P., 2011. "Operating conditions of an open and direct solar thermal Brayton cycle with optimised cavity receiver and recuperator," Energy, Elsevier, vol. 36(10), pages 6027-6036.
    13. Kaluri, Ram Satish & Basak, Tanmay, 2011. "Entropy generation due to natural convection in discretely heated porous square cavities," Energy, Elsevier, vol. 36(8), pages 5065-5080.
    14. Gaikwad, Harshad Sanjay & Basu, Dipankar Narayan & Mondal, Pranab Kumar, 2017. "Non-linear drag induced irreversibility minimization in a viscous dissipative flow through a micro-porous channel," Energy, Elsevier, vol. 119(C), pages 588-600.
    15. Wang, Yi-Hsien & Yang, Yue-Tzu, 2011. "Three-dimensional transient cooling simulations of a portable electronic device using PCM (phase change materials) in multi-fin heat sink," Energy, Elsevier, vol. 36(8), pages 5214-5224.
    16. Shamshiri, Mehdi & Ashrafizaadeh, Mahmud & Shirani, Ebrahim, 2012. "Advantages and disadvantages associated with introducing an extra rarefied gas layer into a rotating microsystem filled with a liquid lubricant: First and second law analyses," Energy, Elsevier, vol. 45(1), pages 716-728.
    17. Le Roux, W.G. & Bello-Ochende, T. & Meyer, J.P., 2013. "A review on the thermodynamic optimisation and modelling of the solar thermal Brayton cycle," Renewable and Sustainable Energy Reviews, Elsevier, vol. 28(C), pages 677-690.
    18. Samuel O. Adesanya & J. A. Falade & J. C. Ukaegbu & K. S. Adekeye, 2016. "Mathematical Analysis of a Reactive Viscous Flow through a Channel Filled with a Porous Medium," Journal of Mathematics, Hindawi, vol. 2016, pages 1-8, December.
    19. Ordonez, Juan Carlos & Bejan, Adrian, 2003. "Minimum power requirement for environmental control of aircraft," Energy, Elsevier, vol. 28(12), pages 1183-1202.
    20. Kralj, Anita Kovač, 2011. "Estimation of maximum steam pressure by a mathematical linear technique," Energy, Elsevier, vol. 36(5), pages 2434-2439.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:34:y:2009:i:9:p:1113-1121. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.