IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v278y2023ipbs036054422301383x.html
   My bibliography  Save this article

Performance evaluation of a novel heat pump system for drying with EVI-compressor driven precooling and reheating

Author

Listed:
  • Cheng, Jia-Hao
  • Cao, Xiang
  • Shao, Liang-Liang
  • Zhang, Chun-Lu

Abstract

Heat pump drying is widely used in the agricultural and industrial sectors. This study proposes a novel heat pump system for closed-loop drying, which employs an enhanced vapor injection (EVI) compressor (HPDEVI). The system precools the return air to a closer-to-saturation state to enhance dehumidification and reheats the dehumidified cold air while increasing the refrigerant subcooling. Meanwhile, EVI is fulfilled to modify the heat pump cycle. To demonstrate its superiority, the HPDEVI's energetic, exergetic and economic performances are compared to those of the basic configuration (HPDbasic) and the system with a stand-alone heat pipe (HPDHP). The results show that HPDEVI outperforms the other two systems by increasing latent heat ratio of evaporator, compressor isentropic efficiency and refrigerant subcooling. Under the design condition (Tdb = 45 °C, RH = 40%), HPDEVI reaches a specific moisture extraction rate (SMER) of 3.07 kg/kWh and a moisture extraction rate (MER) of 43.8 kg/h. These values are increased by 16.7% and 12.9% compared to HPDbasic, and 8.9% and 4.5% relative to HPDHP, respectively. Moreover, HPDEVI generates the lowest exergy destruction per latent heat of water removal at 0.367 W/W, and costs only 0.267 CNY per litre of water extracted after ten years of operation. Finally, the performance improvements of HPDEVI under off-design conditions are also revealed.

Suggested Citation

  • Cheng, Jia-Hao & Cao, Xiang & Shao, Liang-Liang & Zhang, Chun-Lu, 2023. "Performance evaluation of a novel heat pump system for drying with EVI-compressor driven precooling and reheating," Energy, Elsevier, vol. 278(PB).
  • Handle: RePEc:eee:energy:v:278:y:2023:i:pb:s036054422301383x
    DOI: 10.1016/j.energy.2023.127989
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S036054422301383X
    Download Restriction: Full text for ScienceDirect subscribers only

    File URL: https://libkey.io/10.1016/j.energy.2023.127989?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Redón, A. & Navarro-Peris, E. & Pitarch, M. & Gonzálvez-Macia, J. & Corberán, J.M., 2014. "Analysis and optimization of subcritical two-stage vapor injection heat pump systems," Applied Energy, Elsevier, vol. 124(C), pages 231-240.
    2. Mohammadi, Iman & Tabatabaekoloor, Reza & Motevali, Ali, 2019. "Effect of air recirculation and heat pump on mass transfer and energy parameters in drying of kiwifruit slices," Energy, Elsevier, vol. 170(C), pages 149-158.
    3. Shao, Liang-Liang & Yang, Liang & Zhang, Chun-Lu, 2010. "Comparison of heat pump performance using fin-and-tube and microchannel heat exchangers under frost conditions," Applied Energy, Elsevier, vol. 87(4), pages 1187-1197, April.
    4. El Fil, Bachir & Garimella, Srinivas, 2021. "Waste heat recovery in commercial gas-fired tumble dryers," Energy, Elsevier, vol. 218(C).
    5. Srimuang, W. & Amatachaya, P., 2012. "A review of the applications of heat pipe heat exchangers for heat recovery," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(6), pages 4303-4315.
    6. Zou, Huiming & Li, Xuan & Tang, Mingsheng & Wu, Jiang & Tian, Changqing & Butrymowicz, Dariusz & Ma, Yongde & Wang, Jin, 2020. "Temperature stage matching and experimental investigation of high-temperature cascade heat pump with vapor injection," Energy, Elsevier, vol. 212(C).
    7. Mei, Zhenyuan & Hwang, Yunho & Kim, Jaeyeon, 2022. "Thermodynamic analysis and LCCP evaluation of kangaroo heat pump cycle for electric vehicles," Energy, Elsevier, vol. 259(C).
    8. Wang, Jijin & Qv, Dehu & Yao, Yang & Ni, Long, 2021. "The difference between vapor injection cycle with flash tank and intermediate heat exchanger for air source heat pump: An experimental and theoretical study," Energy, Elsevier, vol. 221(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Li, Yunhai & Cui, Yu & Song, Zhiying & Zhao, Xudong & Li, Jing & Shen, Chao, 2023. "Eco-economic performance and application potential of a novel dual-source heat pump heating system," Energy, Elsevier, vol. 283(C).
    2. Jing, Siqi & Chen, Qi & Yu, Jianlin, 2024. "Analysis of an ejector-assisted flash tank vapor injection heat pump cycle with dual evaporators for dryer application," Energy, Elsevier, vol. 286(C).
    3. Konrad, Mary Elizabeth & MacDonald, Brendan D., 2023. "Cold climate air source heat pumps: Industry progress and thermodynamic analysis of market-available residential units," Renewable and Sustainable Energy Reviews, Elsevier, vol. 188(C).
    4. Ma, Xiaojing & Xu, Jinliang & Xie, Jian, 2021. "In-situ phase separation to improve phase change heat transfer performance," Energy, Elsevier, vol. 230(C).
    5. Sun, Fangtian & Fu, Lin & Sun, Jian & Zhang, Shigang, 2014. "A new ejector heat exchanger based on an ejector heat pump and a water-to-water heat exchanger," Applied Energy, Elsevier, vol. 121(C), pages 245-251.
    6. Dong, Yixiu & Yan, Hongzhi & Wang, Ruzhu, 2024. "Significant thermal upgrade via cascade high temperature heat pump with low GWP working fluids," Renewable and Sustainable Energy Reviews, Elsevier, vol. 190(PA).
    7. Jeon, Yongseok & Kim, Sunjae & Lee, Sang Hun & Chung, Hyun Joon & Kim, Yongchan, 2020. "Seasonal energy performance characteristics of novel ejector-expansion air conditioners with low-GWP refrigerants," Applied Energy, Elsevier, vol. 278(C).
    8. Byrne, Paul & Miriel, Jacques & Lenat, Yves, 2011. "Experimental study of an air-source heat pump for simultaneous heating and cooling – Part 2: Dynamic behaviour and two-phase thermosiphon defrosting technique," Applied Energy, Elsevier, vol. 88(9), pages 3072-3078.
    9. Jouhara, Hussam & Almahmoud, Sulaiman & Chauhan, Amisha & Delpech, Bertrand & Bianchi, Giuseppe & Tassou, Savvas A. & Llera, Rocio & Lago, Francisco & Arribas, Juan José, 2017. "Experimental and theoretical investigation of a flat heat pipe heat exchanger for waste heat recovery in the steel industry," Energy, Elsevier, vol. 141(C), pages 1928-1939.
    10. Zichen, Wang & Changqing, Du, 2021. "A comprehensive review on thermal management systems for power lithium-ion batteries," Renewable and Sustainable Energy Reviews, Elsevier, vol. 139(C).
    11. Pitarch, Miquel & Navarro-Peris, Emilio & Gonzálvez-Maciá, José & Corberán, José M., 2017. "Evaluation of different heat pump systems for sanitary hot water production using natural refrigerants," Applied Energy, Elsevier, vol. 190(C), pages 911-919.
    12. Llera, Rocio & Vigil, Miguel & Díaz-Díaz, Sara & Martínez Huerta, Gemma Marta, 2022. "Prospective environmental and techno-economic assessment of steam production by means of heat pipes in the steel industry," Energy, Elsevier, vol. 239(PD).
    13. Tang, Jinchen & Gong, Guangcai & Su, Huan & Wu, Fanhao & Herman, Cila, 2016. "Performance evaluation of a novel method of frost prevention and retardation for air source heat pumps using the orthogonal experiment design method," Applied Energy, Elsevier, vol. 169(C), pages 696-708.
    14. Wu, Jianghong & Ouyang, Guang & Hou, Puxiu & Xiao, Haobin, 2011. "Experimental investigation of frost formation on a parallel flow evaporator," Applied Energy, Elsevier, vol. 88(5), pages 1549-1556, May.
    15. Yao, Jian & Zheng, Sihang & Chen, Daochuan & Dai, Yanjun & Huang, Mingjun, 2021. "Performance improvement of vapor-injection heat pump system by employing PVT collector/evaporator for residential heating in cold climate region," Energy, Elsevier, vol. 219(C).
    16. Wang, Jijin & Qv, Dehu & Yao, Yang & Ni, Long, 2021. "The difference between vapor injection cycle with flash tank and intermediate heat exchanger for air source heat pump: An experimental and theoretical study," Energy, Elsevier, vol. 221(C).
    17. Qin, Fei & Zhang, Guiying & Xue, Qingfeng & Zou, Huiming & Tian, Changqing, 2017. "Experimental investigation and theoretical analysis of heat pump systems with two different injection portholes compressors for electric vehicles," Applied Energy, Elsevier, vol. 185(P2), pages 2085-2093.
    18. Kim, Dongwoo & Song, Kang Sub & Lim, Junyub & Kim, Yongchan, 2018. "Analysis of two-phase injection heat pump using artificial neural network considering APF and LCCP under various weather conditions," Energy, Elsevier, vol. 155(C), pages 117-127.
    19. Jia, Fan & Yin, Xiang & Cao, Feng & Fang, Jianmin & Wang, Anci & Wang, Xixi & Yang, Lichen, 2024. "A novel control method for the automotive CO2 heat pumps under inappropriate refrigerant charge conditions," Energy, Elsevier, vol. 286(C).
    20. Tian, Tong & Wang, Xinyue & Liu, Yang & Yang, Xuan & Sun, Bo & Li, Ji, 2023. "Nano-engineering enabled heat pipe battery: A powerful heat transfer infrastructure with capability of power generation," Applied Energy, Elsevier, vol. 348(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:278:y:2023:i:pb:s036054422301383x. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.