IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v263y2023ipas0360544222024458.html
   My bibliography  Save this article

Assessment on energy and exergy of combined supercritical CO2 Brayton cycles with sizing printed-circuit-heat-exchangers

Author

Listed:
  • Wang, Yiming
  • Xie, Gongnan
  • Zhu, Huaitao
  • Yuan, Han

Abstract

The supercritical carbon dioxide Brayton cycle is one of the alternative thermal schemes for advanced energy systems. In this study, ammonia absorption Refrigeration-reheat supercritical carbon dioxide Brayton combined cycle is constructed, and the thermodynamic performance of reheat supercritical carbon dioxide Brayton cycle with ammonia absorption refrigeration cycle are analyzed. The characteristics of Brayton cycle and ammonia absorption refrigeration cycle configuring with Printed Circuit Heat Exchanger are analyzed. The result shows that under controlled freezing-point storage condition, optimized combined cycle energy and exergy efficiency is 46% and 64.98%, electricity output and refrigeration capacity is 11.4 MW and 1.78 MW. Under air-conditioning refrigeration condition, optimized combined cycle energy and exergy efficiency is 50.28% and 65.04%, and electricity output and refrigeration capacity is 11.4 MW and 3 MW. Compared with combined cycle performance before optimization, average improvement of cycle energy efficiency, exergy efficiency and exergy destruction is 4.19%, 0.73% and 3.64%, which shows obvious improvement of cycle performance after optimization. Comparative analysis of printed circuit heat exchanger applied at recuperator and subcooler shows that heat transfer performance of single-faced etched printed circuit heat exchanger in straight channel is better than that of double-faced etched printed circuit heat exchanger for same heat transfer and pressure drop.

Suggested Citation

  • Wang, Yiming & Xie, Gongnan & Zhu, Huaitao & Yuan, Han, 2023. "Assessment on energy and exergy of combined supercritical CO2 Brayton cycles with sizing printed-circuit-heat-exchangers," Energy, Elsevier, vol. 263(PA).
    • Handle: RePEc:eee:energy:v:263:y:2023:i:pa:s0360544222024458
    DOI: 10.1016/j.energy.2022.125559
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544222024458
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2022.125559?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Larsen, Ulrik & Nguyen, Tuong-Van & Knudsen, Thomas & Haglind, Fredrik, 2014. "System analysis and optimisation of a Kalina split-cycle for waste heat recovery on large marine diesel engines," Energy, Elsevier, vol. 64(C), pages 484-494.
    2. Chen, Kang & Zheng, Shaoxiong & Du, Yang & Fan, Gang & Dai, Yiping & Chen, Haichao, 2021. "Thermodynamic and economic comparison of novel parallel and serial combined cooling and power systems based on sCO2 cycle," Energy, Elsevier, vol. 215(PA).
    3. Zhou, Aozheng & Li, Xue-song & Ren, Xiao-dong & Song, Jian & Gu, Chun-wei, 2020. "Thermodynamic and economic analysis of a supercritical carbon dioxide (S–CO2) recompression cycle with the radial-inflow turbine efficiency prediction," Energy, Elsevier, vol. 191(C).
    4. Muhammad, Hafiz Ali & Cho, Junhyun & Cho, Jongjae & Choi, Bongsu & Roh, Chulwoo & Ishfaq, Hafiz Ahmad & Lee, Gilbong & Shin, Hyungki & Baik, Young-Jin & Lee, Beomjoon, 2022. "Performance improvement of supercritical carbon dioxide power cycle at elevated heat sink temperatures," Energy, Elsevier, vol. 239(PD).
    5. Armanto P. Simanjuntak & Jae-Young Lee, 2020. "Mechanical Integrity Assessment of Two-Side Etched Type Printed Circuit Heat Exchanger with Additional Elliptical Channel," Energies, MDPI, vol. 13(18), pages 1-17, September.
    6. Liu, Yaping & Wang, Ying & Huang, Diangui, 2019. "Supercritical CO2 Brayton cycle: A state-of-the-art review," Energy, Elsevier, vol. 189(C).
    7. Jiang, Yuan & Liese, Eric & Zitney, Stephen E. & Bhattacharyya, Debangsu, 2018. "Design and dynamic modeling of printed circuit heat exchangers for supercritical carbon dioxide Brayton power cycles," Applied Energy, Elsevier, vol. 231(C), pages 1019-1032.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Khoshvaght-Aliabadi, Morteza & Ghodrati, Parvaneh & Mahian, Omid & Kang, Yong Tae, 2024. "Performance evaluation of non-uniform twisted designs in precooler of supercritical CO2 power cycle," Energy, Elsevier, vol. 292(C).
    2. Zhang, Enbo & Watanabe, Toshinori & Lai, Zitian & Bai, Bofeng, 2024. "A compressible flow solver for turbomachinery of the real gases with strongly variable properties," Energy, Elsevier, vol. 290(C).
    3. Liu, Zhongyan & Guan, Hongwei & Shao, Jiawei & Jin, Xu & Su, Wei & Zhang, Hao & Li, Heng & Sun, Dahan & Wei, Tengfei, 2024. "Thermodynamic and advanced exergy analysis of a trans-critical CO2 energy storage system integrated with heat supply and solar energy," Energy, Elsevier, vol. 302(C).
    4. Li, Zhen & Lu, Daogang & Wang, Zhichao & Cao, Qiong, 2023. "Analysis on flow and heat transfer performance of SCO2 in airfoil channels with different fin angles of attack," Energy, Elsevier, vol. 282(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yang, Jingze & Yang, Zhen & Duan, Yuanyuan, 2022. "A review on integrated design and off-design operation of solar power tower system with S–CO2 Brayton cycle," Energy, Elsevier, vol. 246(C).
    2. Edwin Espinel Blanco & Guillermo Valencia Ochoa & Jorge Duarte Forero, 2020. "Thermodynamic, Exergy and Environmental Impact Assessment of S-CO 2 Brayton Cycle Coupled with ORC as Bottoming Cycle," Energies, MDPI, vol. 13(9), pages 1-24, May.
    3. Thanganadar, Dhinesh & Fornarelli, Francesco & Camporeale, Sergio & Asfand, Faisal & Patchigolla, Kumar, 2021. "Off-design and annual performance analysis of supercritical carbon dioxide cycle with thermal storage for CSP application," Applied Energy, Elsevier, vol. 282(PA).
    4. N Shankar Ganesh & T Srinivas & G Uma Maheswari & S Mahendiran & D Manivannan, 2019. "Development of optimized energy system," Energy & Environment, , vol. 30(7), pages 1190-1205, November.
    5. Zhu, Sipeng & Ma, Zetai & Zhang, Kun & Deng, Kangyao, 2020. "Energy and exergy analysis of the combined cycle power plant recovering waste heat from the marine two-stroke engine under design and off-design conditions," Energy, Elsevier, vol. 210(C).
    6. Ouyang, Tiancheng & Wang, Zhiping & Wang, Geng & Zhao, Zhongkai & Xie, Shutao & Li, Xiaoqing, 2021. "Advanced thermo-economic scheme and multi-objective optimization for exploiting the waste heat potentiality of marine natural gas engine," Energy, Elsevier, vol. 236(C).
    7. Moradpoor, Iraj & Ebrahimi, Masood, 2019. "Thermo-environ analyses of a novel trigeneration cycle based on clean technologies of molten carbonate fuel cell, stirling engine and Kalina cycle," Energy, Elsevier, vol. 185(C), pages 1005-1016.
    8. Marco Bicchi & Michele Marconcini & Ernani Fulvio Bellobuono & Elisabetta Belardini & Lorenzo Toni & Andrea Arnone, 2023. "Multi-Point Surrogate-Based Approach for Assessing Impacts of Geometric Variations on Centrifugal Compressor Performance," Energies, MDPI, vol. 16(4), pages 1-21, February.
    9. Ma, Teng & Li, Ming-Jia & Xu, Jin-Liang & Cao, Feng, 2019. "Thermodynamic analysis and performance prediction on dynamic response characteristic of PCHE in 1000 MW S-CO2 coal fired power plant," Energy, Elsevier, vol. 175(C), pages 123-138.
    10. Jihoo Jung & Jehyun Lee & Sangjin Choi & Woonho Baek, 2022. "Information Analysis on Foreign Institution for International R&D Collaboration Using Natural Language Processing," Energies, MDPI, vol. 16(1), pages 1-17, December.
    11. Li, Ligeng & Tian, Hua & Liu, Peng & Shi, Lingfeng & Shu, Gequn, 2021. "Optimization of CO2 Transcritical Power Cycle (CTPC) for engine waste heat recovery based on split concept," Energy, Elsevier, vol. 229(C).
    12. Tong, Yongjing & Duan, Liqiang & Yang, Ming & Pang, Liping, 2022. "Design optimization of a new supercritical CO2 single reheat coal-fired power generation system," Energy, Elsevier, vol. 239(PB).
    13. Zhao, Tian & Li, Hang & Li, Xia & Sun, Qing-Han & Fang, Xuan-Yi & Ma, Huan & Chen, Qun, 2024. "A frequency domain dynamic simulation method for heat exchangers and thermal systems," Energy, Elsevier, vol. 286(C).
    14. Xia, Jiaxi & Wang, Jiangfeng & Lou, Juwei & Hu, Jianjun & Yao, Sen, 2023. "Thermodynamic, economic, environmental analysis and multi-objective optimization of a novel combined cooling and power system for cascade utilization of engine waste heat," Energy, Elsevier, vol. 277(C).
    15. Gürgen, Samet & Altın, İsmail, 2022. "Novel decision-making strategy for working fluid selection in Organic Rankine Cycle: A case study for waste heat recovery of a marine diesel engine," Energy, Elsevier, vol. 252(C).
    16. Zaharil, Hafiz Aman, 2021. "An investigation on the usage of different supercritical fluids in parabolic trough solar collector," Renewable Energy, Elsevier, vol. 168(C), pages 676-691.
    17. Zeng, Rong & Gan, Jijuan & Guo, Baoxin & Zhang, Xiaofeng & Li, Hongqiang & Yin, Wei & Zhang, Guoqiang, 2023. "Thermodynamic performance analysis of solid oxide fuel cell - combined cooling, heating and power system with integrated supercritical CO2 power cycle - organic Rankine cycle and absorption refrigerat," Energy, Elsevier, vol. 283(C).
    18. Dingchen Wu & Mingshan Wei & Ran Tian & Siyu Zheng & Jundi He, 2022. "A Review of Flow and Heat Transfer Characteristics of Supercritical Carbon Dioxide under Cooling Conditions in Energy and Power Systems," Energies, MDPI, vol. 15(23), pages 1-28, November.
    19. Qin, Lei & Xie, Gongnan & Ma, Yuan & Li, Shulei, 2023. "Thermodynamic analysis and multi-objective optimization of a waste heat recovery system with a combined supercritical/transcritical CO2 cycle," Energy, Elsevier, vol. 265(C).
    20. Andrés Meana-Fernández & Juan M. González-Caballín & Roberto Martínez-Pérez & Francisco J. Rubio-Serrano & Antonio J. Gutiérrez-Trashorras, 2022. "Power Plant Cycles: Evolution towards More Sustainable and Environmentally Friendly Technologies," Energies, MDPI, vol. 15(23), pages 1-27, November.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:263:y:2023:i:pa:s0360544222024458. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.