IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v324y2022ics0306261922010029.html
   My bibliography  Save this article

Molten chloride salt technology for next-generation CSP plants: Compatibility of Fe-based alloys with purified molten MgCl2-KCl-NaCl salt at 700 °C

Author

Listed:
  • Gong, Qing
  • Shi, Hao
  • Chai, Yan
  • Yu, Rui
  • Weisenburger, Alfons
  • Wang, Dihua
  • Bonk, Alexander
  • Bauer, Thomas
  • Ding, Wenjin

Abstract

Molten chlorides, such as MgCl2-KCl-NaCl, are promising advanced high-temperature (up to 800 °C) thermal energy storage (TES) materials in next-generation concentrating solar power (CSP) plants. However, their high corrosivity to commercial Fe-Cr-Ni alloys impedes the commercial applications of chloride-TES. In this work, we investigated the corrosion of two selected commercial Fe-based alloys (SS 310 and In 800H) in molten MgCl2-KCl-NaCl salt, aiming to study the feasibility of affordable Fe-based alloys instead of expensive Ni-based alloys in the chloride-TES system. The alloy samples were immersed in the liquid-Mg-purified molten salt at 700 °C for 2000 h under a protective inert gas atmosphere. After the corrosion test, SEM-EDX microstructural analysis and mass loss analysis showed that corrosion rates of the immersed alloy samples were lower than 15 µm/year, and the corrosion rates had a decreasing tendency with increasing immersion time during the 2000-hour test. To our best knowledge, this is the first experimental demonstration that corrosion rates of the Fe-based alloys in molten MgCl2-KCl-NaCl salt at 700 °C can be controlled below the target (15 µm/year) proposed by the US Department of Energy (DOE). Using affordable Fe-based alloys as main structural materials, the cost of chloride-TES (27 USD/kWh) could be comparable to that of commercial nitrate-TES (20–33 USD/kWh). Taking advantage of chloride-TES with higher operating temperature, the next-generation CSP plant could use an advanced power cycle (e.g., sCO2 Brayton) to have a much higher energy conversion efficiency, leading to a significantly lower Levelized Cost of Electricity (LCOE) than the current commercial CSP plant.

Suggested Citation

  • Gong, Qing & Shi, Hao & Chai, Yan & Yu, Rui & Weisenburger, Alfons & Wang, Dihua & Bonk, Alexander & Bauer, Thomas & Ding, Wenjin, 2022. "Molten chloride salt technology for next-generation CSP plants: Compatibility of Fe-based alloys with purified molten MgCl2-KCl-NaCl salt at 700 °C," Applied Energy, Elsevier, vol. 324(C).
    • Handle: RePEc:eee:appene:v:324:y:2022:i:c:s0306261922010029
    DOI: 10.1016/j.apenergy.2022.119708
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306261922010029
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.apenergy.2022.119708?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Villada, Carolina & Bonk, Alexander & Bauer, Thomas & Bolívar, Francisco, 2018. "High-temperature stability of nitrate/nitrite molten salt mixtures under different atmospheres," Applied Energy, Elsevier, vol. 226(C), pages 107-115.
    2. Wei, Xiaolan & Song, Ming & Wang, Weilong & Ding, Jing & Yang, Jianping, 2015. "Design and thermal properties of a novel ternary chloride eutectics for high-temperature solar energy storage," Applied Energy, Elsevier, vol. 156(C), pages 306-310.
    3. Vignarooban, K. & Xu, Xinhai & Arvay, A. & Hsu, K. & Kannan, A.M., 2015. "Heat transfer fluids for concentrating solar power systems – A review," Applied Energy, Elsevier, vol. 146(C), pages 383-396.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Adrián Caraballo & Santos Galán-Casado & Ángel Caballero & Sara Serena, 2021. "Molten Salts for Sensible Thermal Energy Storage: A Review and an Energy Performance Analysis," Energies, MDPI, vol. 14(4), pages 1-15, February.
    2. Kondaiah, P. & Pitchumani, R., 2024. "Electrodeposited nickel coatings for exceptional corrosion mitigation in industrial grade molten chloride salts for concentrating solar power," Renewable and Sustainable Energy Reviews, Elsevier, vol. 189(PB).
    3. Zhang, Shengchun & Wang, Zhifeng & Wu, Zhiyong & Bai, Fengwu & Huang, Pingrui, 2019. "Numerical investigation of the heat transport in a very loose packed granular bed air receiver with a non-uniform energy flux distribution," Renewable Energy, Elsevier, vol. 138(C), pages 987-998.
    4. Sadeghi, Shayan & Ghandehariun, Samane, 2022. "A standalone solar thermochemical water splitting hydrogen plant with high-temperature molten salt: Thermodynamic and economic analyses and multi-objective optimization," Energy, Elsevier, vol. 240(C).
    5. Zhao, Yawen & Hong, Hui & Jin, Hongguang, 2017. "Optimization of the solar field size for the solar–coal hybrid system," Applied Energy, Elsevier, vol. 185(P2), pages 1162-1172.
    6. Yang, S. & Sensoy, T.S. & Ordonez, J.C., 2018. "Dynamic 3D volume element model of a parabolic trough solar collector for simulation and optimization," Applied Energy, Elsevier, vol. 217(C), pages 509-526.
    7. Manzolini, Giampaolo & Lucca, Gaia & Binotti, Marco & Lozza, Giovanni, 2021. "A two-step procedure for the selection of innovative high temperature heat transfer fluids in solar tower power plants," Renewable Energy, Elsevier, vol. 177(C), pages 807-822.
    8. Saranprabhu, M.K. & Rajan, K.S., 2019. "Magnesium oxide nanoparticles dispersed solar salt with improved solid phase thermal conductivity and specific heat for latent heat thermal energy storage," Renewable Energy, Elsevier, vol. 141(C), pages 451-459.
    9. Peiró, Gerard & Prieto, Cristina & Gasia, Jaume & Jové, Aleix & Miró, Laia & Cabeza, Luisa F., 2018. "Two-tank molten salts thermal energy storage system for solar power plants at pilot plant scale: Lessons learnt and recommendations for its design, start-up and operation," Renewable Energy, Elsevier, vol. 121(C), pages 236-248.
    10. Mena, R. & Escobar, R. & Lorca, Á. & Negrete-Pincetic, M. & Olivares, D., 2019. "The impact of concentrated solar power in electric power systems: A Chilean case study," Applied Energy, Elsevier, vol. 235(C), pages 258-283.
    11. Bai, Zhang & Gu, Yucheng & Wang, Shuoshuo & Jiang, Tieliu & Kong, Debin & Li, Qi, 2023. "Applying the solar solid particles as heat carrier to enhance the solar-driven biomass gasification with dynamic operation power generation performance analysis," Applied Energy, Elsevier, vol. 351(C).
    12. Sau, S. & Corsaro, N. & Crescenzi, T. & D’Ottavi, C. & Liberatore, R. & Licoccia, S. & Russo, V. & Tarquini, P. & Tizzoni, A.C., 2016. "Techno-economic comparison between CSP plants presenting two different heat transfer fluids," Applied Energy, Elsevier, vol. 168(C), pages 96-109.
    13. Du, Lichan & Ding, Jing & Tian, Heqing & Wang, Weilong & Wei, Xiaolan & Song, Ming, 2017. "Thermal properties and thermal stability of the ternary eutectic salt NaCl-CaCl2-MgCl2 used in high-temperature thermal energy storage process," Applied Energy, Elsevier, vol. 204(C), pages 1225-1230.
    14. Khalil Anwar, M. & Yilbas, B.S. & Shuja, S.Z., 2016. "A thermal battery mimicking a concentrated volumetric solar receiver," Applied Energy, Elsevier, vol. 175(C), pages 16-30.
    15. Haiting Liu & Jiewen Deng & Yue Guan & Liwei Wang, 2022. "Study of Heat Flux Density of Dish Solar Cavity Heat Absorber," Energies, MDPI, vol. 15(21), pages 1-12, October.
    16. Wei, Xiaolan & Qin, Bo & Yang, Chuntao & Wang, Weilong & Ding, Jing & Wang, Yan & Peng, Qiang, 2019. "Nox emission of ternary nitrate molten salts in high-temperature heat storage and transfer process," Applied Energy, Elsevier, vol. 236(C), pages 147-154.
    17. Haiming Long & Yunkun Lu & Liang Chang & Haifeng Zhang & Jingcen Zhang & Gaoqun Zhang & Junjie Hao, 2022. "Molecular Dynamics Simulation of Thermophysical Properties and the Microstructure of Na 2 CO 3 Heat Storage Materials," Energies, MDPI, vol. 15(19), pages 1-13, September.
    18. Ephraim Bonah Agyekum & Tomiwa Sunday Adebayo & Festus Victor Bekun & Nallapaneni Manoj Kumar & Manoj Kumar Panjwani, 2021. "Effect of Two Different Heat Transfer Fluids on the Performance of Solar Tower CSP by Comparing Recompression Supercritical CO 2 and Rankine Power Cycles, China," Energies, MDPI, vol. 14(12), pages 1-19, June.
    19. Conroy, Tim & Collins, Maurice N. & Grimes, Ronan, 2020. "A review of steady-state thermal and mechanical modelling on tubular solar receivers," Renewable and Sustainable Energy Reviews, Elsevier, vol. 119(C).
    20. Gioele Di Marcoberardino & Costante Mario Invernizzi & Paolo Iora & Luca Arosio & Marcello Canavese & Angelo Lunghi & Antonella Mazzei, 2022. "Thermal Stability and Thermodynamic Performances of Pure Siloxanes and Their Mixtures in Organic Rankine Cycles," Energies, MDPI, vol. 15(10), pages 1-20, May.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:324:y:2022:i:c:s0306261922010029. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.