IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v12y2020i2p488-d306561.html
   My bibliography  Save this article

Study on Supersonic Dehydration Efficiency of High Pressure Natural Gas

Author

Listed:
  • Zhenya Duan

    (College to Electromechanical Engineering, Qingdao University of Science and Technology, Qingdao 266061, China)

  • Zhiwei Ma

    (College to Electromechanical Engineering, Qingdao University of Science and Technology, Qingdao 266061, China)

  • Ying Guo

    (College to Electromechanical Engineering, Qingdao University of Science and Technology, Qingdao 266061, China)

  • Junmei Zhang

    (College of Chemical Engineering, Qingdao University of Science and Technology, Qingdao 266042, China)

  • Shujie Sun

    (College to Electromechanical Engineering, Qingdao University of Science and Technology, Qingdao 266061, China)

  • Longhui Liang

    (Nanjing Tica Thermal Technology Co. Ltd., Nanjing 210038, China)

Abstract

Supersonic cyclone separator is a novel type of natural gas dewatering device that overcomes the shortcomings of traditional dewatering methods. In order to investigate the factors affecting the separation efficiency and improve the separation performance of the supersonic cyclone separator, the discrete particle model was employed in numerical calculation. On the basis of an accurate numerical model, the flow field of supersonic cyclone separator was analyzed, the trajectories of droplets were predicted, and the factors affecting the separation efficiency of droplets were investigated. The numerical results indicated that Laval nozzle could provide the necessary conditions for the condensation of water vapor. The swirler can throw droplets onto the wall or into the separator, both of which are foundations for realizing the separation of droplets. Droplets had three typical trajectories affected by centrifugal effect and inertia effect. The existence of a shock wave increases the swirl intensity of droplets, which is conducive to the separation of droplets. The diameter of droplets should be increased as much as possible in order to improve separation efficiency, and the gas–liquid area ratio should be about 45.25%, and the number of vanes should be 10.

Suggested Citation

  • Zhenya Duan & Zhiwei Ma & Ying Guo & Junmei Zhang & Shujie Sun & Longhui Liang, 2020. "Study on Supersonic Dehydration Efficiency of High Pressure Natural Gas," Sustainability, MDPI, vol. 12(2), pages 1-15, January.
    • Handle: RePEc:gam:jsusta:v:12:y:2020:i:2:p:488-:d:306561
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/12/2/488/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/12/2/488/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Min Fu & Yang Yang & Lixin Tian & Zaili Zhen, 2017. "The Spatiotemporal Dynamics of Natural Gas Imports in OECD Countries," Sustainability, MDPI, vol. 9(11), pages 1-19, November.
    2. Yang, Yan & Wen, Chuang & Wang, Shuli & Feng, Yuqing, 2014. "Theoretical and numerical analysis on pressure recovery of supersonic separators for natural gas dehydration," Applied Energy, Elsevier, vol. 132(C), pages 248-253.
    3. Wen, Chuang & Cao, Xuewen & Yang, Yan & Li, Wenlong, 2012. "Numerical simulation of natural gas flows in diffusers for supersonic separators," Energy, Elsevier, vol. 37(1), pages 195-200.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Llorenç Macia & Robert Castilla & Pedro Javier Gamez-Montero & Gustavo Raush, 2022. "Multi-Factor Design for a Vacuum Ejector Improvement by In-Depth Analysis of Construction Parameters," Sustainability, MDPI, vol. 14(16), pages 1-16, August.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Bian, Jiang & Cao, Xuewen & Yang, Wen & Edem, Mawugbe Ayivi & Yin, Pengbo & Jiang, Wenming, 2018. "Supersonic liquefaction properties of natural gas in the Laval nozzle," Energy, Elsevier, vol. 159(C), pages 706-715.
    2. Shooshtari, S.H. Rajaee & Shahsavand, A., 2017. "Maximization of energy recovery inside supersonic separator in the presence of condensation and normal shock wave," Energy, Elsevier, vol. 120(C), pages 153-163.
    3. Wen, Chuang & Karvounis, Nikolas & Walther, Jens Honore & Yan, Yuying & Feng, Yuqing & Yang, Yan, 2019. "An efficient approach to separate CO2 using supersonic flows for carbon capture and storage," Applied Energy, Elsevier, vol. 238(C), pages 311-319.
    4. Farzaneh-Gord, Mahmood & Sadi, Meisam, 2014. "Improving vortex tube performance based on vortex generator design," Energy, Elsevier, vol. 72(C), pages 492-500.
    5. Zhang, Bo & Guo, Yaning & Li, Nian & He, Peng & Guo, Xiangji, 2023. "Experimental study of gas–liquid behavior in three-flow vortex tube with sintered metal porous material as the drain part," Energy, Elsevier, vol. 263(PA).
    6. Zhang, Zhifei & Li, Tie & Shi, Weiquan, 2019. "Ambient Tracer-LIF for 2-D quantitative measurement of fuel concentration in gas jets," Energy, Elsevier, vol. 171(C), pages 372-384.
    7. Yang, Yan & Wen, Chuang & Wang, Shuli & Feng, Yuqing, 2014. "Theoretical and numerical analysis on pressure recovery of supersonic separators for natural gas dehydration," Applied Energy, Elsevier, vol. 132(C), pages 248-253.
    8. Liu, Yang & Cao, Xuewen & Guo, Dan & Cao, Hengguang & Bian, Jiang, 2023. "Influence of shock wave/boundary layer interaction on condensation flow and energy recovery in supersonic nozzle," Energy, Elsevier, vol. 263(PA).
    9. Kun Huang & Xingyu Zhou & Cheng Huang & Lin Wang & Dequan Li & Jinrei Zhao, 2023. "Heat Transfer Analysis and Operation Optimization of an Intermediate Fluid Vaporizer," Energies, MDPI, vol. 16(3), pages 1-23, January.
    10. Bian, Jiang & Cao, Xuewen & Yang, Wen & Song, Xiaodan & Xiang, Chengcheng & Gao, Song, 2019. "Condensation characteristics of natural gas in the supersonic liquefaction process," Energy, Elsevier, vol. 168(C), pages 99-110.
    11. Xiong, Yaxuan & An, Shuo & Xu, Peng & Ding, Yulong & Li, Chuan & Zhang, Qunli & Chen, Hongbing, 2018. "A novel expander-depending natural gas pressure regulation configuration: Performance analysis," Applied Energy, Elsevier, vol. 220(C), pages 21-35.
    12. Liu, Yang & Cao, Xuewen & Chong, Daotong & Yang, Wen & Zhao, Ziyuan & Bian, Jiang, 2023. "Effects of energy conversion under shock wave on the effective liquefaction efficiency in the nozzle during natural gas dehydration," Energy, Elsevier, vol. 283(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:12:y:2020:i:2:p:488-:d:306561. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.