IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i4p1912-d1068980.html
   My bibliography  Save this article

Experimental Research to Increase the Combustion Efficiency in the Top-Lit Updraft Principle Based Gasifier

Author

Listed:
  • Ioan Pavel

    (National Institute of Research & Development for Optoelectronics/INOE 2000, Subsidiary Hydraulics and Pneumatics Research Institute/IHP, Cutitul de Argint 14, 040558 Bucharest, Romania)

  • Radu Iulian Rădoi

    (National Institute of Research & Development for Optoelectronics/INOE 2000, Subsidiary Hydraulics and Pneumatics Research Institute/IHP, Cutitul de Argint 14, 040558 Bucharest, Romania)

  • Gabriela Matache

    (National Institute of Research & Development for Optoelectronics/INOE 2000, Subsidiary Hydraulics and Pneumatics Research Institute/IHP, Cutitul de Argint 14, 040558 Bucharest, Romania)

  • Ana-Maria Carla Popescu

    (National Institute of Research & Development for Optoelectronics/INOE 2000, Subsidiary Hydraulics and Pneumatics Research Institute/IHP, Cutitul de Argint 14, 040558 Bucharest, Romania)

  • Kati Pavel

    (National Institute of Research & Development for Optoelectronics/INOE 2000, Subsidiary Hydraulics and Pneumatics Research Institute/IHP, Cutitul de Argint 14, 040558 Bucharest, Romania)

Abstract

The recovery of vegetal waste for energy purposes is one of the ways to increase the amount of energy obtained from renewable sources. The Top-Lit Updraft (TLUD) gasification and combustion process is recognized as the least polluting of all other combustion processes, resulting in a sterile charcoal called biochar, which can be used as an amendment in agricultural soils. The purpose of this research was to determine the influence of excess air in the combustion area compared to the (theoretical) calculated requirement for a TLUD energy module. Most scientific publications on this topic recommend primary/secondary air flow rate ratios of 1/3 or 1/4. In this study, the two recommended ratios were tested, and it was found that better energy results correspond to the ratio of 1/3. For this 1/3 ratio, the investigations continued in order to optimize the combustion process. The results achieved demonstrate that the excess combustion air flow of 30% improves the performance of the energy module due to the increase in oxygen supply and the increase in air speed in the combustion area of the syngas resulting from gasification. Increasing the excess combustion air flow rate by +50% had the effect of lowering the temperature in the flame due to the cooling of the combustion gases caused by a too high rate of excess cold air flow.

Suggested Citation

  • Ioan Pavel & Radu Iulian Rădoi & Gabriela Matache & Ana-Maria Carla Popescu & Kati Pavel, 2023. "Experimental Research to Increase the Combustion Efficiency in the Top-Lit Updraft Principle Based Gasifier," Energies, MDPI, vol. 16(4), pages 1-19, February.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:4:p:1912-:d:1068980
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/4/1912/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/4/1912/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Toklu, E., 2017. "Biomass energy potential and utilization in Turkey," Renewable Energy, Elsevier, vol. 107(C), pages 235-244.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Abdul, Daud & Wenqi, Jiang & Tanveer, Arsalan, 2022. "Prioritization of renewable energy source for electricity generation through AHP-VIKOR integrated methodology," Renewable Energy, Elsevier, vol. 184(C), pages 1018-1032.
    2. Alkan, Ömer & Albayrak, Özlem Karadağ, 2020. "Ranking of renewable energy sources for regions in Turkey by fuzzy entropy based fuzzy COPRAS and fuzzy MULTIMOORA," Renewable Energy, Elsevier, vol. 162(C), pages 712-726.
    3. Gupta, Shubhi & Gupta, Goutam Kishore & Mondal, Monoj Kumar, 2019. "Slow pyrolysis of chemically treated walnut shell for valuable products: Effect of process parameters and in-depth product analysis," Energy, Elsevier, vol. 181(C), pages 665-676.
    4. Jung, Sungyup & Lee, Jechan & Moon, Deok Hyun & Kim, Ki-Hyun & Kwon, Eilhann E., 2021. "Upgrading biogas into syngas through dry reforming," Renewable and Sustainable Energy Reviews, Elsevier, vol. 143(C).
    5. Alba Mondragón-Valero & Borja Velázquez-Martí & Domingo M. Salazar & Isabel López-Cortés, 2018. "Influence of Fertilization and Rootstocks in the Biomass Energy Characterization of Prunus dulcis (Miller)," Energies, MDPI, vol. 11(5), pages 1-12, May.
    6. Wajahat Ullah Khan Tareen & Zuha Anjum & Nabila Yasin & Leenah Siddiqui & Ifzana Farhat & Suheel Abdullah Malik & Saad Mekhilef & Mehdi Seyedmahmoudian & Ben Horan & Mohamed Darwish & Muhammad Aamir &, 2018. "The Prospective Non-Conventional Alternate and Renewable Energy Sources in Pakistan—A Focus on Biomass Energy for Power Generation, Transportation, and Industrial Fuel," Energies, MDPI, vol. 11(9), pages 1-49, September.
    7. Noushabadi, Abolfazl Sajadi & Dashti, Amir & Ahmadijokani, Farhad & Hu, Jinguang & Mohammadi, Amir H., 2021. "Estimation of higher heating values (HHVs) of biomass fuels based on ultimate analysis using machine learning techniques and improved equation," Renewable Energy, Elsevier, vol. 179(C), pages 550-562.
    8. Sharafi laleh, Shayan & Fatemi Alavi, Seyed Hamed & Soltani, Saeed & Mahmoudi, S.M.S. & Rosen, Marc A., 2024. "A novel supercritical carbon dioxide combined cycle fueled by biomass: Thermodynamic assessment," Renewable Energy, Elsevier, vol. 222(C).
    9. Sheng Zhong & Shuwen Niu & Yipeng Wang, 2018. "Research on Potential Evaluation and Sustainable Development of Rural Biomass Energy in Gansu Province of China," Sustainability, MDPI, vol. 10(10), pages 1-20, October.
    10. Dennis Krüger & Özge Çepelioğullar Mutlu, 2021. "Demonstration of a Top-Lit Updraft Based Pyrolytic Burner with Low Emission Operation and Automatic Process Control," Energies, MDPI, vol. 14(13), pages 1-16, June.
    11. Angesom Gebrezgabiher Tesfay & Asfafaw Haileselassie Tesfay & Muyiwa Samuel Adaramola, 2024. "Quantifying Agricultural Residues Biomass Resources and the Energy Potentials with Characterization of Their Nature and Ethiopian Case Consumption Inference," Energies, MDPI, vol. 17(18), pages 1-24, September.
    12. Mantas Svazas & Valentinas Navickas, 2024. "Energy Transformation Development Strategies: Evaluation of Asset Conversion in the Regions," Energies, MDPI, vol. 17(7), pages 1-23, March.
    13. Naqvi, Salman Raza & Tariq, Rumaisa & Hameed, Zeeshan & Ali, Imtiaz & Naqvi, Muhammad & Chen, Wei-Hsin & Ceylan, Selim & Rashid, Harith & Ahmad, Junaid & Taqvi, Syed A. & Shahbaz, Muhammad, 2019. "Pyrolysis of high ash sewage sludge: Kinetics and thermodynamic analysis using Coats-Redfern method," Renewable Energy, Elsevier, vol. 131(C), pages 854-860.
    14. Zhang, Xiaofeng & Yan, Renshi & Zeng, Rong & Zhu, Ruilin & Kong, Xiaoying & He, Yecong & Li, Hongqiang, 2022. "Integrated performance optimization of a biomass-based hybrid hydrogen/thermal energy storage system for building and hydrogen vehicles," Renewable Energy, Elsevier, vol. 187(C), pages 801-818.
    15. KS Rajmohan & C Ramya & Sunita Varjani, 2021. "Trends and advances in bioenergy production and sustainable solid waste management," Energy & Environment, , vol. 32(6), pages 1059-1085, September.
    16. Atilgan Atilgan & Anna Krakowiak-Bal & Hasan Ertop & Burak Saltuk & Mateusz Malinowski, 2023. "The Energy Potential of Waste from Banana Production: A Case Study of the Mediterranean Region," Energies, MDPI, vol. 16(14), pages 1-13, July.
    17. Ibrahim Mosly & Anas A. Makki, 2018. "Current Status and Willingness to Adopt Renewable Energy Technologies in Saudi Arabia," Sustainability, MDPI, vol. 10(11), pages 1-20, November.
    18. Tan, Liping & Cai, Lei & Fu, Yidan & Zhou, Zining & Guan, Yanwen, 2023. "Numerical investigation of biomass and liquefied natural gas driven oxy-fuel combustion power system," Renewable Energy, Elsevier, vol. 208(C), pages 94-104.
    19. Dal-Bó, Vanessa & Lira, Taisa & Arrieche, Leonardo & Bacelos, Marcelo, 2019. "Process synthesis for coffee husks to energy using hierarchical approaches," Renewable Energy, Elsevier, vol. 142(C), pages 195-206.
    20. Avcıoğlu, A.O. & Dayıoğlu, M.A. & Türker, U., 2019. "Assessment of the energy potential of agricultural biomass residues in Turkey," Renewable Energy, Elsevier, vol. 138(C), pages 610-619.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:4:p:1912-:d:1068980. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.