IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i22p8363-d967505.html
   My bibliography  Save this article

Efficiency Improvement of Magnetic Coupler with Nanocrystalline Alloy Film for UAV Wireless Charging System with a Carbon Fiber Fuselage

Author

Listed:
  • Fengshuo Yang

    (School of Electrical Engineering and Automation, Harbin Institute of Technology, Harbin 150001, China)

  • Jinhai Jiang

    (School of Electrical Engineering and Automation, Harbin Institute of Technology, Harbin 150001, China)

  • Chuanyu Sun

    (School of Electrical Engineering and Automation, Harbin Institute of Technology, Harbin 150001, China)

  • Aina He

    (Ningbo Institute of Materials Technology and Engineering, Chinese Academy of Sciences, Ningbo 315200, China)

  • Wanqi Chen

    (School of Electrical Engineering and Automation, Harbin Institute of Technology, Harbin 150001, China)

  • Yu Lan

    (School of Electrical Engineering and Automation, Harbin Institute of Technology, Harbin 150001, China)

  • Kai Song

    (School of Electrical Engineering and Automation, Harbin Institute of Technology, Harbin 150001, China)

Abstract

Existing research on the magnetic coupler of unmanned aerial vehicle (UAV) wireless charging systems usually ignores the UAV fuselage, but the fuselage causes eddy current loss and reduces a system’s efficiency. Therefore, aiming at the above problems, this paper proposes a design for a magnetic coupler using nanocrystalline cores to reduce the loss caused by the UAV fuselage. First, the parameters of the asymmetric circular coils were designed for higher mutual inductance. The losses caused by the windings and cores were also calculated. Second, for the loss effect of the carbon fiber fuselage, the fuselage was modeled as an additional coil coupled with both the transmitting and receiving coils. The fact that the eddy current induced by the fuselage leads to efficiency reduction is revealed, which has been generally ignored by previous research. Then, the effect of the nanocrystalline alloy was analyzed based on the magnetic circuit model. An optimized nanocrystalline alloy film was applied to reduce eddy current loss and improve coupler efficiency. Finally, an experimental prototype with a 500 W output, 90.3% efficiency, and a 300 mm air gap were fabricated. When compared to the design without UAV material considerations, the coupler efficiency was improved by 7.9%.

Suggested Citation

  • Fengshuo Yang & Jinhai Jiang & Chuanyu Sun & Aina He & Wanqi Chen & Yu Lan & Kai Song, 2022. "Efficiency Improvement of Magnetic Coupler with Nanocrystalline Alloy Film for UAV Wireless Charging System with a Carbon Fiber Fuselage," Energies, MDPI, vol. 15(22), pages 1-17, November.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:22:p:8363-:d:967505
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/22/8363/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/22/8363/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Tommaso Campi & Silvano Cruciani & Mauro Feliziani, 2018. "Wireless Power Transfer Technology Applied to an Autonomous Electric UAV with a Small Secondary Coil," Energies, MDPI, vol. 11(2), pages 1-15, February.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Ahmed O. MohamedZain & Lee Wei Hou & Huangshen Chua & Kianmeng Yap & Lau Kim Boon, 2023. "The Design and Fabrication of Multiple-Transmitter Coils and Single-Receiver Coils for a Wireless Power Transfer System to Charge a 3s LiPo Drone’s Battery," Energies, MDPI, vol. 16(9), pages 1-23, April.
    2. Adrian Chmielewski & Piotr Piórkowski & Jakub Możaryn & Stepan Ozana, 2023. "Sustainable Development of Operational Infrastructure for Electric Vehicles: A Case Study for Poland," Energies, MDPI, vol. 16(11), pages 1-43, June.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ahmed O. MohamedZain & Lee Wei Hou & Huangshen Chua & Kianmeng Yap & Lau Kim Boon, 2023. "The Design and Fabrication of Multiple-Transmitter Coils and Single-Receiver Coils for a Wireless Power Transfer System to Charge a 3s LiPo Drone’s Battery," Energies, MDPI, vol. 16(9), pages 1-23, April.
    2. Abdullah Mohiuddin & Tarek Taha & Yahya Zweiri & Dongming Gan, 2019. "UAV Payload Transportation via RTDP Based Optimized Velocity Profiles," Energies, MDPI, vol. 12(16), pages 1-25, August.
    3. Zhengwang He & Zhiyong Li & Ruoyue Wang & Ying Fan & Minqian Xu, 2021. "A New Arrangement of Active Coils for Wireless Charging of UAV," Energies, MDPI, vol. 14(18), pages 1-11, September.
    4. Ghada Bouattour & Mohamed Elhawy & Slim Naifar & Christian Viehweger & Houda Ben Jmaa Derbel & Olfa Kanoun, 2020. "Multiplexed Supply of a MISO Wireless Power Transfer System for Battery-Free Wireless Sensors," Energies, MDPI, vol. 13(5), pages 1-23, March.
    5. Aleksandra Tiurlikova & Nikita Stepanov & Konstantin Mikhaylov, 2019. "Wireless power transfer from unmanned aerial vehicle to low-power wide area network nodes: Performance and business prospects for LoRaWAN," International Journal of Distributed Sensor Networks, , vol. 15(11), pages 15501477198, November.
    6. Tommaso Campi & Silvano Cruciani & Francesca Maradei & Mauro Feliziani, 2021. "Efficient Wireless Drone Charging Pad for Any Landing Position and Orientation," Energies, MDPI, vol. 14(23), pages 1-14, December.
    7. Andrea Carloni & Federico Baronti & Roberto Di Rienzo & Roberto Roncella & Roberto Saletti, 2021. "On the Sizing of the DC-Link Capacitor to Increase the Power Transfer in a Series-Series Inductive Resonant Wireless Charging Station," Energies, MDPI, vol. 14(3), pages 1-13, January.
    8. Linlin Tan & Kamal Eldin Idris Elnail & Minghao Ju & Xueliang Huang, 2019. "Comparative Analysis and Design of the Shielding Techniques in WPT Systems for Charging EVs," Energies, MDPI, vol. 12(11), pages 1-20, June.
    9. Mohammad Fatin Fatihur Rahman & Shurui Fan & Yan Zhang & Lei Chen, 2021. "A Comparative Study on Application of Unmanned Aerial Vehicle Systems in Agriculture," Agriculture, MDPI, vol. 11(1), pages 1-26, January.
    10. Marojahan Tampubolon & Laskar Pamungkas & Huang-Jen Chiu & Yu-Chen Liu & Yao-Ching Hsieh, 2018. "Dynamic Wireless Power Transfer for Logistic Robots," Energies, MDPI, vol. 11(3), pages 1-13, February.
    11. Andrea Carloni & Federico Baronti & Roberto Di Rienzo & Roberto Roncella & Roberto Saletti, 2020. "Effect of the DC-Link Capacitor Size on the Wireless Inductive-Coupled Opportunity-Charging of a Drone Battery," Energies, MDPI, vol. 13(10), pages 1-13, May.
    12. Tommaso Campi & Silvano Cruciani & Francesca Maradei & Mauro Feliziani, 2019. "Innovative Design of Drone Landing Gear Used as a Receiving Coil in Wireless Charging Application," Energies, MDPI, vol. 12(18), pages 1-20, September.
    13. Lin Chen & Jianfeng Hong & Zaifa Lin & Daqing Luo & Mingjie Guan & Wenxiang Chen, 2020. "A Converter with Automatic Stage Transition Control for Inductive Power Transfer," Energies, MDPI, vol. 13(20), pages 1-14, October.
    14. Aqeel Mahmood Jawad & Rosdiadee Nordin & Haider Mahmood Jawad & Sadik Kamel Gharghan & Asma’ Abu-Samah & Mahmood Jawad Abu-Alshaeer & Nor Fadzilah Abdullah, 2022. "Wireless Drone Charging Station Using Class-E Power Amplifier in Vertical Alignment and Lateral Misalignment Conditions," Energies, MDPI, vol. 15(4), pages 1-29, February.
    15. Kyungtae Kim & Han-Joon Kim & Dong-Wook Seo & Ji-Woong Choi, 2021. "Analysis on Influences of Intra-Couplings in a MISO Magnetic Beamforming Wireless Power Transfer System," Energies, MDPI, vol. 14(16), pages 1-23, August.
    16. Aqeel Mahmood Jawad & Rosdiadee Nordin & Sadik Kamel Gharghan & Haider Mahmood Jawad & Mahamod Ismail & Mahmood Jawad Abu-AlShaeer, 2018. "Single-Tube and Multi-Turn Coil Near-Field Wireless Power Transfer for Low-Power Home Appliances," Energies, MDPI, vol. 11(8), pages 1-19, July.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:22:p:8363-:d:967505. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.