IDEAS home Printed from https://ideas.repec.org/a/eee/renene/v205y2023icp238-247.html
   My bibliography  Save this article

Synthesis of methyl esters from Hippophae rhamnoides via pilot scale hydrodynamic cavitation intensification reactor

Author

Listed:
  • Alsaiari, Mabkhoot
  • Bokhari, Awais
  • Chuah, Lai Fatt
  • Mubashir, Muhammad
  • Harraz, Farid A.
  • Almohana, Abdulaziz Ibrahim
  • Show, Pau Loke
  • Awasthi, Mukesh Kumar
  • Rizk, Moustafa A.

Abstract

The current research demonstrates the capability of hydrodynamic cavitation (HC) for the manufacture of ester sourcing Hippophae rhamnoides (HiRO) seed oil, which is non-edible in nature. According to the authors' best knowledge, the HC pilot developed assembly has not been put to use in any research pertaining to the manufacturing of biodiesel from HiRO triglycerides. The vast majority of the research indicates that optimising the system for the production of biodiesel based on a particular criterion, such as yield, can lead to only one portion of the research. In order to achieve maximum efficiency in the transesterification reaction, it is necessary to optimise not only the amount of output but also the cavitational parameters. The process of transesterification was initiated to overcome mass transfer resistance. In a pilot HC reactor, four novel geometries (orifices disk) cavities were explored. These cavities were helped along by a double diaphragm pump. It was shown that the mass transfer barrier between immiscible reactants can be decreased by increasing the interfacial area, and this effect was observed during the transesterification reaction, which is characterised by significant turbulence induced by cavitating bubbles. This was accomplished by increasing the surface area of the interface between the reactants. When compared to mechanical stirring, using an orifice plate with 21 holes that were 1 mm in diameter resulted in an eightfold increase in yield efficiency and a sixfold reduction in response reaction time at 2 bar inlet pressure. Utilising the hydrodynamic cavitation contributes to the procedure's reduced impact on the natural environment. In conclusion, the Hippophae rhamnoides oil methyl ester (HiROM) that was produced through the process of hydrodynamic cavitation was demonstrated to be both time and energy efficient. The characteristics of the methyl ester that was synthesised were in accordance with the requirements of both EN14214 and ASTM D6751.

Suggested Citation

  • Alsaiari, Mabkhoot & Bokhari, Awais & Chuah, Lai Fatt & Mubashir, Muhammad & Harraz, Farid A. & Almohana, Abdulaziz Ibrahim & Show, Pau Loke & Awasthi, Mukesh Kumar & Rizk, Moustafa A., 2023. "Synthesis of methyl esters from Hippophae rhamnoides via pilot scale hydrodynamic cavitation intensification reactor," Renewable Energy, Elsevier, vol. 205(C), pages 238-247.
  • Handle: RePEc:eee:renene:v:205:y:2023:i:c:p:238-247
    DOI: 10.1016/j.renene.2023.01.072
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0960148123000812
    Download Restriction: Full text for ScienceDirect subscribers only

    File URL: https://libkey.io/10.1016/j.renene.2023.01.072?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Mukhtar, Ahmad & Saqib, Sidra & Lin, Hongfei & Hassan Shah, Mansoor Ul & Ullah, Sami & Younas, Muhammad & Rezakazemi, Mashallah & Ibrahim, Muhammad & Mahmood, Abid & Asif, Saira & Bokhari, Awais, 2022. "Current status and challenges in the heterogeneous catalysis for biodiesel production," Renewable and Sustainable Energy Reviews, Elsevier, vol. 157(C).
    2. Gholami, Ali & Hajinezhad, Ahmad & Pourfayaz, Fathollah & Ahmadi, Mohammad Hossein, 2018. "The effect of hydrodynamic and ultrasonic cavitation on biodiesel production: An exergy analysis approach," Energy, Elsevier, vol. 160(C), pages 478-489.
    3. Pal, Amit & Verma, Ashish & Kachhwaha, S.S. & Maji, S., 2010. "Biodiesel production through hydrodynamic cavitation and performance testing," Renewable Energy, Elsevier, vol. 35(3), pages 619-624.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Gómez-Castro, F.I. & Gutiérrez-Antonio, C. & Romero-Izquierdo, A.G. & May-Vázquez, M.M. & Hernández, S., 2023. "Intensified technologies for the production of triglyceride-based biofuels: Current status and future trends," Renewable and Sustainable Energy Reviews, Elsevier, vol. 184(C).
    2. Sun, Xun & Liu, Shuai & Manickam, Sivakumar & Tao, Yang & Yoon, Joon Yong & Xuan, Xiaoxu, 2023. "Intensification of biodiesel production by hydrodynamic cavitation: A critical review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 179(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Sun, Xun & Liu, Shuai & Manickam, Sivakumar & Tao, Yang & Yoon, Joon Yong & Xuan, Xiaoxu, 2023. "Intensification of biodiesel production by hydrodynamic cavitation: A critical review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 179(C).
    2. Jagtap, Sharad P. & Pawar, Anand N. & Lahane, Subhash, 2020. "Improving the usability of biodiesel blend in low heat rejection diesel engine through combustion, performance and emission analysis," Renewable Energy, Elsevier, vol. 155(C), pages 628-644.
    3. Nahas, Lea & Dahdah, Eliane & Aouad, Samer & El Khoury, Bilal & Gennequin, Cedric & Abi Aad, Edmond & Estephane, Jane, 2023. "Highly efficient scallop seashell-derived catalyst for biodiesel production from sunflower and waste cooking oils: Reaction kinetics and effect of calcination temperature studies," Renewable Energy, Elsevier, vol. 202(C), pages 1086-1095.
    4. Ahmad Abbaszadeh-Mayvan & Barat Ghobadian & Gholamhassan Najafi & Talal Yusaf, 2018. "Intensification of Continuous Biodiesel Production from Waste Cooking Oils Using Shockwave Power Reactor: Process Evaluation and Optimization through Response Surface Methodology (RSM)," Energies, MDPI, vol. 11(10), pages 1-13, October.
    5. Mahmoodi-Eshkaftaki, Mahmood & Dalvi-Isfahan, Mohsen, 2024. "Multiple exegetically optimization of ultrasonic pretreatment and substrate mixture for biohydrogen and biomethane improvement," Energy, Elsevier, vol. 292(C).
    6. Xie, Wenlei & Wang, Xiangxiang & Guo, Lihong, 2024. "Utilization of Keplerate-type polyoxomolybdates {Mo132} supported on hierarchical porous SOM-ZIF-8 as reusable catalyst boosts biodiesel production from acidic soybean oils by simultaneous transesteri," Renewable Energy, Elsevier, vol. 225(C).
    7. Kamil, Mohammed & Ramadan, Khalid M. & Olabi, Abdul Ghani & Al-Ali, Eman I. & Ma, Xiao & Awad, Omar I., 2020. "Economic, technical, and environmental viability of biodiesel blends derived from coffee waste," Renewable Energy, Elsevier, vol. 147(P1), pages 1880-1894.
    8. Oza, Suvik & Kodgire, Pravin & Kachhwaha, Surendra Singh & Lam, Man Kee & Yusup, Suzana & Chai, Yee Ho & Rokhum, Samuel Lalthazuala, 2024. "A review on sustainable and scalable biodiesel production using ultra-sonication technology," Renewable Energy, Elsevier, vol. 226(C).
    9. Spinelli, D. & Jez, S. & Pogni, R. & Basosi, R., 2013. "Environmental and life cycle analysis of a biodiesel production line from sunflower in the Province of Siena (Italy)," Energy Policy, Elsevier, vol. 59(C), pages 492-506.
    10. Han, Xiaoxiang & Jiang, Shengchou & Chen, Ziyi & Zeng, Zhiwei & Chen, Qing & Niu, Fuge & Pan, Weichun & Tang, Xiujuan & Liu, Shang-Bin, 2023. "Highly active sulfonic ionic liquid modified heteropoly acid composite catalysts for efficient production of ethyl palmitate," Renewable Energy, Elsevier, vol. 215(C).
    11. Xue, Jinlin & Grift, Tony E. & Hansen, Alan C., 2011. "Effect of biodiesel on engine performances and emissions," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(2), pages 1098-1116, February.
    12. Fazal, M.A. & Haseeb, A.S.M.A. & Masjuki, H.H., 2011. "Biodiesel feasibility study: An evaluation of material compatibility; performance; emission and engine durability," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(2), pages 1314-1324, February.
    13. Ming-Chien Hsiao & Li-Wen Chang & Shuhn-Shyurng Hou, 2019. "Study of Solid Calcium Diglyceroxide for Biodiesel Production from Waste Cooking Oil Using a High Speed Homogenizer," Energies, MDPI, vol. 12(17), pages 1-11, August.
    14. Teo, Siow Hwa & Islam, Aminul & Mansir, Nasar & Shamsuddin, Mohd Razali & Joseph, Collin G. & Goto, Motonobu & Taufiq-Yap, Yun Hin, 2022. "Sustainable biofuel production approach: Critical methanol green transesterification by efficient and stable heterogeneous catalyst," Renewable and Sustainable Energy Reviews, Elsevier, vol. 169(C).
    15. Ghorbani, Bahram & Mahyari, Kimiya Borzoo & Mehrpooya, Mehdi & Hamedi, Mohammad-Hossein, 2020. "Introducing a hybrid renewable energy system for production of power and fresh water using parabolic trough solar collectors and LNG cold energy recovery," Renewable Energy, Elsevier, vol. 148(C), pages 1227-1243.
    16. Ge, Mingming & Manikkam, Pratulya & Ghossein, Joe & Kumar Subramanian, Roshan & Coutier-Delgosha, Olivier & Zhang, Guangjian, 2022. "Dynamic mode decomposition to classify cavitating flow regimes induced by thermodynamic effects," Energy, Elsevier, vol. 254(PC).
    17. Othman, Mohd Fahmi & Adam, Abdullah & Najafi, G. & Mamat, Rizalman, 2017. "Green fuel as alternative fuel for diesel engine: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 80(C), pages 694-709.
    18. Tesfa, B. & Mishra, R. & Zhang, C. & Gu, F. & Ball, A.D., 2013. "Combustion and performance characteristics of CI (compression ignition) engine running with biodiesel," Energy, Elsevier, vol. 51(C), pages 101-115.
    19. Mennani, Mehdi & Kasbaji, Meriem & Ait Benhamou, Anass & Boussetta, Abdelghani & Kassab, Zineb & El Achaby, Mounir & Grimi, Nabil & Moubarik, Amine, 2024. "The potential of lignin-functionalized metal catalysts - A systematic review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 189(PA).
    20. José A. León & Gisela Montero & Marcos A. Coronado & José R. Ayala & Daniela G. Montes & Laura J. Pérez & Lisandra Quintana & Jesús M. Armenta, 2022. "Thermodynamic Analysis of Waste Vegetable Oil Conversion to Biodiesel with Solar Energy," Energies, MDPI, vol. 15(5), pages 1-17, March.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:renene:v:205:y:2023:i:c:p:238-247. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/renewable-energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.