IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v177y2019icp421-432.html
   My bibliography  Save this article

Measurement of soot volume fraction and primary particle diameter in oxygen enriched ethylene diffusion flames using the laser-induced incandescence technique

Author

Listed:
  • Zhang, Yindi
  • Liu, Fengshan
  • Clavel, Daniel
  • Smallwood, Gregory J.
  • Lou, Chun

Abstract

The paper presents an experimental investigation of the effect of oxygen concentration in the oxidizer (O2+N2) on distributions of soot volume fraction (SVF) and flame centerline primary particle size in laminar coflow ethylene diffusion flames. The base flame has an oxygen index (OI, oxygen mole fraction in the oxidizer stream) of 21%. Three additional flames, with OI of 30%, 40% and 50%, are also examined. The fuel flow rate was maintained constant in all the experiments. The two-dimensional laser-induced incandescence (2D-LII) and two-color spectral band measurement based on the response spectrum of R, and G bands of a color 3-CCD camera are applied to measure distributions of SVF. The time resolved laser-induced incandescence (TIRE-LII) is used to measure SVF and primary particle size along the flame centerline at different heights above burner (HAB). The results of SVF are compared among the two-color method, 2D-LII, and light-of-sight attenuation (LOSA) from the literature in the base flame and compared between TIRE-LII and two-color spectral band method in oxygen enriched flames. Good agreements are observed in the measured SVF from different methods. Soot primary particle sizes, measured by TIRE-LII, are compared with those based on transmission electron microscopy (TEM) image analysis from the literature and a fairly good agreement is observed. The results indicate that soot yields increase and the flame becomes shorter and brighter with increasing OI. The primary particle diameter increases firstly and then decreases with the normalized HAB by the visible flame height (hf). At the same HAB/hf, the primary particle diameter generally increases with increasing OI from 21% up to 50%.

Suggested Citation

  • Zhang, Yindi & Liu, Fengshan & Clavel, Daniel & Smallwood, Gregory J. & Lou, Chun, 2019. "Measurement of soot volume fraction and primary particle diameter in oxygen enriched ethylene diffusion flames using the laser-induced incandescence technique," Energy, Elsevier, vol. 177(C), pages 421-432.
  • Handle: RePEc:eee:energy:v:177:y:2019:i:c:p:421-432
    DOI: 10.1016/j.energy.2019.04.062
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544219306851
    Download Restriction: Full text for ScienceDirect subscribers only

    File URL: https://libkey.io/10.1016/j.energy.2019.04.062?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Sánchez, N.E. & Callejas, A. & Millera, A. & Bilbao, R. & Alzueta, M.U., 2012. "Formation of PAH and soot during acetylene pyrolysis at different gas residence times and reaction temperatures," Energy, Elsevier, vol. 43(1), pages 30-36.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Xu, Lei & Yan, Fuwu & Zhou, Mengxiang & Wang, Yu, 2021. "An experimental and modeling study on sooting characteristics of laminar counterflow diffusion flames with partial premixing," Energy, Elsevier, vol. 218(C).
    2. Liu, Qianqian & Sun, Jingyun & Li, Shuanglong & Zhang, Feng & Gu, Mingyan & Wang, Yang, 2024. "Study of soot microscopic characteristics in hydrogen/methane/ethylene co-flow diffusion flame," Energy, Elsevier, vol. 290(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Kang, Yinhu & Sun, Yuming & Lu, Xiaofeng & Gou, Xiaolong & Sun, Sicong & Yan, Jin & Song, Yangfan & Zhang, Pengyuan & Wang, Quanhai & Ji, Xuanyu, 2018. "Soot formation characteristics of ethylene premixed burner-stabilized stagnation flame with dimethyl ether addition," Energy, Elsevier, vol. 150(C), pages 709-721.
    2. Yan, Binhang & Cheng, Yan & Li, Tianyang & Cheng, Yi, 2017. "Detailed kinetic modeling of acetylene decomposition/soot formation during quenching of coal pyrolysis in thermal plasma," Energy, Elsevier, vol. 121(C), pages 10-20.
    3. Arnal, C. & Alzueta, M.U. & Millera, A. & Bilbao, R., 2012. "Influence of water vapor addition on soot oxidation at high temperature," Energy, Elsevier, vol. 43(1), pages 55-63.
    4. Luo, Minye & Liu, Dong, 2018. "Effects of dimethyl ether addition on soot formation, evolution and characteristics in flame-wall interactions," Energy, Elsevier, vol. 164(C), pages 642-654.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:177:y:2019:i:c:p:421-432. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.