IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v98y2012icp174-189.html
   My bibliography  Save this article

Development and assessment of a new methodology for end of combustion detection and its application to cycle resolved heat release analysis in IC engines

Author

Listed:
  • Baratta, Mirko
  • Misul, Daniela

Abstract

The heat release analysis has proved to be a powerful diagnostic tool for the analysis of the combustion process in spark ignition engines. Still, a fine tuning of the heat transfer correlations embedded in the heat release models is necessary for a correct diagnostic analysis of the pressure signal. To that end, a new methodology has been developed and assessed to properly locate the end of combustion on the basis of the heat release intensity. The results produced by the proposed method have been compared to those obtained by applying different methodologies available in the literature. The newly developed method has proved to be accurate and consistent and has allowed a reliable estimation of the end of combustion on a cycle-by-cycle basis. An extensive burn rate analysis has also been accomplished by means of a heat release model previously developed and purposely modified to embed the new end of combustion detection procedure. The main combustion related quantities have been considered for the experimental investigation to appropriately quantify the engine cyclic variability as a function of the relative air-to-fuel ratio. The experimental tests have been performed on a naturally aspirated 2L engine featuring a fast-burn combustion chamber and running on gasoline and natural gas as well as on a 1.2L turbocharged natural gas engine displaying a disk shaped combustion chamber. The diagnostic tool has proved to properly match the nonlinear behavior of the quantities related to the combustion duration in the cycle-resolved analysis and a general good agreement with previous works has emerged as far as the coefficient of variations of the main combustion parameters are concerned. Moreover, thanks to the automatic facet the proposed methodology retains, it is strongly recommended when an extensive cycle-by-cycle and cylinder-to-cylinder analysis needs to be performed. Finally, regardless of the considered fuel, the heat release model embedding the EOC detection procedure proved to be capable of properly detecting the combustion features induced by a fast-burn combustion chamber with respect to a traditional one. As a matter of fact, smaller Δθ10–90% values and an overall reduced cyclic dispersion were highlighted for the 2L engine.

Suggested Citation

  • Baratta, Mirko & Misul, Daniela, 2012. "Development and assessment of a new methodology for end of combustion detection and its application to cycle resolved heat release analysis in IC engines," Applied Energy, Elsevier, vol. 98(C), pages 174-189.
    • Handle: RePEc:eee:appene:v:98:y:2012:i:c:p:174-189
    DOI: 10.1016/j.apenergy.2012.03.020
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306261912002243
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.apenergy.2012.03.020?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Bayraktar, Hakan, 2007. "Theoretical investigation of flame propagation process in an SI engine running on gasoline–ethanol blends," Renewable Energy, Elsevier, vol. 32(5), pages 758-771.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Abbaszadehmosayebi, G. & Ganippa, Lionel, 2014. "Determination of specific heat ratio and error analysis for engine heat release calculations," Applied Energy, Elsevier, vol. 122(C), pages 143-150.
    2. Zhao, Junfeng & Wang, Junmin, 2013. "Control-oriented multi-phase combustion model for biodiesel fueled engines," Applied Energy, Elsevier, vol. 108(C), pages 92-99.
    3. Ortiz-Soto, Elliott A. & Lavoie, George A. & Martz, Jason B. & Wooldridge, Margaret S. & Assanis, Dennis N., 2014. "Enhanced heat release analysis for advanced multi-mode combustion engine experiments," Applied Energy, Elsevier, vol. 136(C), pages 465-479.
    4. Min Zhang & Wanhua Su & Zhi Jia, 2024. "Study of Efficient and Clean Combustion of Diesel–Natural Gas Engine at Low Loads with Concentration and Temperature Stratified Combustion," Energies, MDPI, vol. 17(17), pages 1-22, August.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Curto-Risso, P.L. & Medina, A. & Calvo Hernández, A. & Guzmán-Vargas, L. & Angulo-Brown, F., 2011. "On cycle-to-cycle heat release variations in a simulated spark ignition heat engine," Applied Energy, Elsevier, vol. 88(5), pages 1557-1567, May.
    2. Zhen, Xudong & Wang, Yang, 2013. "Study of ignition in a high compression ratio SI (spark ignition) methanol engine using LES (large eddy simulation) with detailed chemical kinetics," Energy, Elsevier, vol. 59(C), pages 549-558.
    3. Chen, Wei-Cheng & Sheng, Chung-Teh & Liu, Yu-Cheng & Chen, Wei-Jen & Huang, Wen-Luh & Chang, Shih-Hsien & Chang, Wei-Che, 2014. "Optimizing the efficiency of anhydrous ethanol purification via regenerable molecular sieve," Applied Energy, Elsevier, vol. 135(C), pages 483-489.
    4. Navarro, Emilio & Leo, Teresa J. & Corral, Roberto, 2013. "CO2 emissions from a spark ignition engine operating on natural gas–hydrogen blends (HCNG)," Applied Energy, Elsevier, vol. 101(C), pages 112-120.
    5. Thangavel, Venugopal & Momula, Sai Yashwanth & Gosala, Dheeraj Bharadwaj & Asvathanarayanan, Ramesh, 2016. "Experimental studies on simultaneous injection of ethanol–gasoline and n-butanol–gasoline in the intake port of a four stroke SI engine," Renewable Energy, Elsevier, vol. 91(C), pages 347-360.
    6. Thangavelu, Saravana Kannan & Ahmed, Abu Saleh & Ani, Farid Nasir, 2016. "Review on bioethanol as alternative fuel for spark ignition engines," Renewable and Sustainable Energy Reviews, Elsevier, vol. 56(C), pages 820-835.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:98:y:2012:i:c:p:174-189. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.