Experimental study on a dual synthetic jets liquid cooling device

To address the growing heat dissipation requirements of high heat flux electronic devices, this work presents experimental research on a dual synthetic jets (DSJ) liquid cooling device. The effects of different heat flux, channel inlet flow rates, driving frequencies, and other parameters on the device ability have been explored. The experimental results indicate that the wall temperature increases by increasing the heat flux. Raising the channel inlet flow rate will reduce wall temperature. When DSJ is off, increasing the inlet flow rate from 0.16 L/min to 0.40 L/min results in a maximum temperature decrease of 6.30 °C and a pressure drop increase of 2.20 kPa. There is essentially no change in the pressure drop when DSJ is operating. When the inlet flow rate is 0.16 L/min, the maximum wall temperature at DSJ on is reduced by 6.83 °C compared with DSJ off. The convective heat transfer coefficient was raised by 40.55%. The vibrating diaphragm exhibits better low-frequency characteristics when working underwater. The convective heat transfer coefficient increases by 36.46% when the driving frequency is 20 Hz. Increasing the driving voltage, the device cooling performance increased. By increasing the driving voltage to 240 V, the wall temperature decreased by 6.30 °C, a decrease of 13.82%, and the convective heat transfer coefficient raised by 28.51%. The device overall performance increased by a maximum of 39.55% after DSJ on compared with DSJ off.