IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v16y2024i8p3214-d1374163.html
   My bibliography  Save this article

Expectations and Outcomes when Quantifying Energy Improvements Achieved by Building Envelope Retrofitting

Author

Listed:
  • Fernando Martín-Consuegra

    (Instituto de Ciencias de la Construcción Eduardo Torroja, CSIC, c/Serrano Galvache, 4, 28002 Madrid, Spain)

  • Camila Andrea Ludueña

    (Escuela Técnica Superior de Arquitectura, Universidad Politécnica de Madrid, Avda. Juan de Herrera 4, 28040 Madrid, Spain)

  • Fernando De Frutos

    (Instituto de Ciencias de la Construcción Eduardo Torroja, CSIC, c/Serrano Galvache, 4, 28002 Madrid, Spain)

  • Borja Frutos

    (Instituto de Ciencias de la Construcción Eduardo Torroja, CSIC, c/Serrano Galvache, 4, 28002 Madrid, Spain)

  • Carmen Alonso

    (Instituto de Ciencias de la Construcción Eduardo Torroja, CSIC, c/Serrano Galvache, 4, 28002 Madrid, Spain)

  • Ignacio Oteiza

    (Instituto de Ciencias de la Construcción Eduardo Torroja, CSIC, c/Serrano Galvache, 4, 28002 Madrid, Spain)

Abstract

This paper assesses the energy efficiency of two buildings constructed in the 1960s in Madrid. One of the buildings is refurbished including passive energy efficiency improvements, while the other remains in its original state. The area is one of a series of low-income residential inefficient developments built by the state on the capital’s outskirts in the 1950s. Their buildings require huge amounts of energy to meet occupants’ basic energy needs. This paper quantifies the energy savings and improved comfort achieved by building envelope energy retrofitting. For this purpose, it proposes a comprehensive methodology spanning data monitoring in homes in buildings, occupant surveys and energy simulation models—a standard approach to estimating improvement potential. Our aim is to compare the expected energy savings predicted by energy certificates with monitored data. The paper concludes that the comfort level in the retrofitted building improved tangibly but that the differing behaviours of the building’s occupants make the energy saving difficult to quantify with any precision. The calibrated model targets energy consumption savings after renovation of approximately 25% in heating and 50% in cooling for a typical household of four people with basic comfort needs reasonably met. Regarding heating consumption, the results of the calibrated model are lower than expected savings using the official certificate input data. However, cooling consumption savings were found to be greater than expected.

Suggested Citation

  • Fernando Martín-Consuegra & Camila Andrea Ludueña & Fernando De Frutos & Borja Frutos & Carmen Alonso & Ignacio Oteiza, 2024. "Expectations and Outcomes when Quantifying Energy Improvements Achieved by Building Envelope Retrofitting," Sustainability, MDPI, vol. 16(8), pages 1-25, April.
    • Handle: RePEc:gam:jsusta:v:16:y:2024:i:8:p:3214-:d:1374163
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/16/8/3214/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/16/8/3214/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Sun, Kaiyu & Hong, Tianzhen & Taylor-Lange, Sarah C. & Piette, Mary Ann, 2016. "A pattern-based automated approach to building energy model calibration," Applied Energy, Elsevier, vol. 165(C), pages 214-224.
    2. Berger, Tania & Höltl, Andrea, 2019. "Thermal insulation of rental residential housing: Do energy poor households benefit? A case study in Krems, Austria," Energy Policy, Elsevier, vol. 127(C), pages 341-349.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Bruno Mataloto & Daniel Calé & Kaiser Carimo & Joao C. Ferreira & Ricardo Resende, 2021. "3D IoT System for Environmental and Energy Consumption Monitoring System," Sustainability, MDPI, vol. 13(3), pages 1-19, February.
    2. Ray Galvin, 2024. "How Not to Reduce Carbon Dioxide Emissions: An Unbalanced Focus on Energy Efficiency in Germany’s Building Rehabilitation Policies," Energies, MDPI, vol. 17(17), pages 1-20, September.
    3. Glasgo, Brock & Hendrickson, Chris & Azevedo, Inês Lima, 2017. "Assessing the value of information in residential building simulation: Comparing simulated and actual building loads at the circuit level," Applied Energy, Elsevier, vol. 203(C), pages 348-363.
    4. Jeong, Kwangbok & Hong, Taehoon & Kim, Jimin & Cho, Kyuman, 2019. "Development of a multi-objective optimization model for determining the optimal CO2 emissions reduction strategies for a multi-family housing complex," Renewable and Sustainable Energy Reviews, Elsevier, vol. 110(C), pages 118-131.
    5. Kwon, Minji & Cong, Shuchen & Nock, Destenie & Huang, Luling & Qiu, Yueming (Lucy) & Xing, Bo, 2023. "Forgone summertime comfort as a function of avoided electricity use," Energy Policy, Elsevier, vol. 183(C).
    6. Nagpal, Shreshth & Hanson, Jared & Reinhart, Christoph, 2019. "A framework for using calibrated campus-wide building energy models for continuous planning and greenhouse gas emissions reduction tracking," Applied Energy, Elsevier, vol. 241(C), pages 82-97.
    7. Glasgo, Brock & Khan, Nyla & Azevedo, Inês Lima, 2020. "Simulating a residential building stock to support regional efficiency policy," Applied Energy, Elsevier, vol. 261(C).
    8. Santos, Luis Guilherme Resende & Afshari, Afshin & Norford, Leslie K. & Mao, Jiachen, 2018. "Evaluating approaches for district-wide energy model calibration considering the Urban Heat Island effect," Applied Energy, Elsevier, vol. 215(C), pages 31-40.
    9. Chen, Yixing & Hong, Tianzhen, 2018. "Impacts of building geometry modeling methods on the simulation results of urban building energy models," Applied Energy, Elsevier, vol. 215(C), pages 717-735.
    10. Calama-González, Carmen María & Symonds, Phil & Petrou, Giorgos & Suárez, Rafael & León-Rodríguez, Ángel Luis, 2021. "Bayesian calibration of building energy models for uncertainty analysis through test cells monitoring," Applied Energy, Elsevier, vol. 282(PA).
    11. Enríquez, R. & Jiménez, M.J. & Heras, M.R., 2017. "Towards non-intrusive thermal load Monitoring of buildings: BES calibration," Applied Energy, Elsevier, vol. 191(C), pages 44-54.
    12. Chersoni, Giulia & DellaValle, Nives & Fontana, Magda, 2022. "Modelling thermal insulation investment choice in the EU via a behaviourally informed agent-based model," Energy Policy, Elsevier, vol. 163(C).
    13. Ahn, Jonghoon & Cho, Soolyeon, 2017. "Anti-logic or common sense that can hinder machine’s energy performance: Energy and comfort control models based on artificial intelligence responding to abnormal indoor environments," Applied Energy, Elsevier, vol. 204(C), pages 117-130.
    14. Huang, Luling & Nock, Destenie & Cong, Shuchen & Qiu, Yueming (Lucy), 2023. "Inequalities across cooling and heating in households: Energy equity gaps," Energy Policy, Elsevier, vol. 182(C).
    15. Burillo, Daniel & Chester, Mikhail V. & Pincetl, Stephanie & Fournier, Eric D. & Reyna, Janet, 2019. "Forecasting peak electricity demand for Los Angeles considering higher air temperatures due to climate change," Applied Energy, Elsevier, vol. 236(C), pages 1-9.
    16. Laura Gabrielli & Aurora Greta Ruggeri & Massimiliano Scarpa, 2023. "Roadmap to a Sustainable Energy System: Is Uncertainty a Major Barrier to Investments for Building Energy Retrofit Projects in Wide City Compartments?," Energies, MDPI, vol. 16(11), pages 1-21, May.
    17. An, Jingjing & Yan, Da & Hong, Tianzhen & Sun, Kaiyu, 2017. "A novel stochastic modeling method to simulate cooling loads in residential districts," Applied Energy, Elsevier, vol. 206(C), pages 134-149.
    18. Kyung Hwa Cho & Sun Sook Kim, 2019. "Energy Performance Assessment According to Data Acquisition Levels of Existing Buildings," Energies, MDPI, vol. 12(6), pages 1-17, March.
    19. Yu, Xinqiao & Yan, Da & Sun, Kaiyu & Hong, Tianzhen & Zhu, Dandan, 2016. "Comparative study of the cooling energy performance of variable refrigerant flow systems and variable air volume systems in office buildings," Applied Energy, Elsevier, vol. 183(C), pages 725-736.
    20. Chen, Yixing & Hong, Tianzhen & Piette, Mary Ann, 2017. "Automatic generation and simulation of urban building energy models based on city datasets for city-scale building retrofit analysis," Applied Energy, Elsevier, vol. 205(C), pages 323-335.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:16:y:2024:i:8:p:3214-:d:1374163. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.