IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v18y2025i5p1295-d1606630.html
   My bibliography  Save this article

Design of a Simplified Experimental Test Case to Study Rotor–Stator Interactions in Hydraulic Machinery

Author

Listed:
  • Benoit Dussault

    (Mechanical Engineering Department, Hydropower Innovation Center (Heki), Université Laval, Québec, QC G1V 0A6, Canada)

  • Yves St-Amant

    (Mechanical Engineering Department, Hydropower Innovation Center (Heki), Université Laval, Québec, QC G1V 0A6, Canada)

  • Sébastien Houde

    (Mechanical Engineering Department, Hydropower Innovation Center (Heki), Université Laval, Québec, QC G1V 0A6, Canada)

Abstract

Because of the introduction of significant amounts of electricity from intermittent energy, such as solar and wind, on power grids, hydraulic turbines undergo more transient operation with varying rotation speeds. Start and stop sequences are known to induce significant mechanical stress in the runner, decreasing its lifespan. Complex fluid–structure interactions are responsible for those high-stress levels, but the precise mechanisms are still elusive, even if many experimental and numerical studies were devoted to the subject. One possible mechanism identified through limited measurements on large turbines operating in powerhouses is rotor–stator interactions. It is already known that rotor–stator interaction (RSI) in constant-speed operating conditions can lead to runner failure when the RSI frequency is close to the natural frequencies of specific structural modes. Start and stop sequence investigations show that RSI can induce a transient resonance while the runner is accelerating/decelerating, which generates a frequency sweep that excites the structure. Studying transient RSI-induced resonance of structural modes associated with hydraulic turbine runners is complex because of the geometry and the potential impacts from other flow-induced excitations. This paper presents the development and validation of an experimental setup specifically designed to reproduce RSI-induced resonances in a rotating circular structure with cyclic periodicity mimicking the structural behavior of a Francis runner. Such a setup does not exist in the literature and will be beneficial for studying RSI during speed variations, with the potential to provide valuable insights into the dynamic behavior of turbines during transient conditions. The paper outlines the different design steps and the construction and validation of the experiment and its simplified runner. It presents important results from preliminary analyses that outline the approach’s success in investigating transient RSI in hydraulic turbines.

Suggested Citation

  • Benoit Dussault & Yves St-Amant & Sébastien Houde, 2025. "Design of a Simplified Experimental Test Case to Study Rotor–Stator Interactions in Hydraulic Machinery," Energies, MDPI, vol. 18(5), pages 1-23, March.
    • Handle: RePEc:gam:jeners:v:18:y:2025:i:5:p:1295-:d:1606630
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/18/5/1295/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/18/5/1295/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Unterluggauer, Julian & Sulzgruber, Verena & Doujak, Eduard & Bauer, Christian, 2020. "Experimental and numerical study of a prototype Francis turbine startup," Renewable Energy, Elsevier, vol. 157(C), pages 1212-1221.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Fahlbeck, Jonathan & Nilsson, Håkan & Arabnejad, Mohammad Hossein & Salehi, Saeed, 2024. "Performance characteristics of a contra-rotating pump-turbine in turbine and pump modes under cavitating flow conditions," Renewable Energy, Elsevier, vol. 237(PB).
    2. Alerci, A.L. & Vagnoni, E. & Paolone, M., 2023. "Structural impact of the start-up sequence on Pelton turbines lifetime: Analytical prediction and polynomial optimization," Renewable Energy, Elsevier, vol. 218(C).
    3. Sun, Longgang & Xu, Hongyang & Li, Chenxi & Guo, Pengcheng & Xu, Zhuofei, 2024. "Unsteady assessment and alleviation of inter-blade vortex in Francis turbine," Applied Energy, Elsevier, vol. 358(C).
    4. Eduard Doujak & Anton Maly & Julian Unterluggauer & Franz Haller & Michael Maier & Christian Blasbichler & Simon Stadler, 2023. "Fatigue Strength Analysis of a Prototype Francis Turbine in a Multilevel Lifetime Assessment Procedure Part III: Instrumentation and Prototype Site Measurement," Energies, MDPI, vol. 16(16), pages 1-39, August.
    5. Raluca Gabriela Iovănel & Arash Soltani Dehkharqani & Diana Maria Bucur & Michel Jose Cervantes, 2022. "Numerical Simulation and Experimental Validation of a Kaplan Prototype Turbine Operating on a Cam Curve," Energies, MDPI, vol. 15(11), pages 1-24, June.
    6. Su, Wen-Tao & Binama, Maxime & Li, Yang & Zhao, Yue, 2020. "Study on the method of reducing the pressure fluctuation of hydraulic turbine by optimizing the draft tube pressure distribution," Renewable Energy, Elsevier, vol. 162(C), pages 550-560.
    7. Salehi, Saeed & Nilsson, Håkan & Lillberg, Eric & Edh, Nicolas, 2021. "An in-depth numerical analysis of transient flow field in a Francis turbine during shutdown," Renewable Energy, Elsevier, vol. 179(C), pages 2322-2347.
    8. Zhumei Luo & Cong Nie & Shunli Lv & Tao Guo & Suoming Gao, 2022. "The Effect of J-Groove on Vortex Suppression and Energy Dissipation in a Draft Tube of Francis Turbine," Energies, MDPI, vol. 15(5), pages 1-20, February.
    9. Salehi, Saeed & Nilsson, Håkan, 2022. "Flow-induced pulsations in Francis turbines during startup - A consequence of an intermittent energy system," Renewable Energy, Elsevier, vol. 188(C), pages 1166-1183.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:18:y:2025:i:5:p:1295-:d:1606630. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.