IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i2p471-d721507.html
   My bibliography  Save this article

Faulty Line Selection Method Based on Comprehensive Dynamic Time Warping Distance in a Flexible Grounding System

Author

Listed:
  • Yu He

    (School of Electrical and Electronic Engineering, Shandong University of Technology, Zibo 255000, China)

  • Xinhui Zhang

    (School of Electrical and Electronic Engineering, Shandong University of Technology, Zibo 255000, China)

  • Wenhao Wu

    (School of Electrical and Electronic Engineering, Shandong University of Technology, Zibo 255000, China)

  • Jun Zhang

    (School of Electrical and Electronic Engineering, Shandong University of Technology, Zibo 255000, China)

  • Wenyuan Bai

    (School of Electrical and Electronic Engineering, Shandong University of Technology, Zibo 255000, China)

  • Aiyu Guo

    (School of Electrical and Electronic Engineering, Shandong University of Technology, Zibo 255000, China)

  • Yu Chen

    (School of Electrical and Electronic Engineering, Shandong University of Technology, Zibo 255000, China)

Abstract

A flexible grounding system is a system in which the neutral point of the power supply is grounded via the arc suppression coil in parallel with a low-resistance resistor. When operating normally or a temporary ground fault occurs, the arc suppression coil is used for grounding, whereas the small resistance is switched on when a permanent ground fault occurs. At present, the problem of low protection sensitivity when a high-resistance ground fault occurs in a flexible grounding system has not been solved yet. According to the characteristics of low waveform similarity between the faulty line and the non-faulty line when a single-phase grounding fault occurred, a new faulty line selection method based on a combination of Dynamic Time Warping (DTW) distance and the transient projection method is proposed in this paper. Firstly, the fault transient signal is extracted by a digital filter as a basis for faulty line selection. Secondly, the transient zero-sequence current of each line is projected onto the busbar transient zero-sequence voltage, and the projected DTW distance of each line is calculated. Finally, according to the calculation formula of waveform comprehensive similarity coefficient, the Comprehensive DTW (CDTW) distance is obtained, and the top three CDTW distance values are selected to determine the faulty line. If the maximum value is greater than the sum of the other two CDTW distance values, the line corresponding to the maximum value is judged as the faulty line; otherwise, it is judged as a busbar fault. The simulation results based on MATLAB/Simulink and field data test show that the method can accurately determine the faulty line under diverse fault conditions.

Suggested Citation

  • Yu He & Xinhui Zhang & Wenhao Wu & Jun Zhang & Wenyuan Bai & Aiyu Guo & Yu Chen, 2022. "Faulty Line Selection Method Based on Comprehensive Dynamic Time Warping Distance in a Flexible Grounding System," Energies, MDPI, vol. 15(2), pages 1-16, January.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:2:p:471-:d:721507
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/2/471/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/2/471/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Yaojing Tang & Yongle Chang & Jinrui Tang & Bin Xu & Mingkang Ye & Hongbo Yang, 2021. "A Novel Faulty Phase Selection Method for Single-Phase-to-Ground Fault in Distribution System Based on Transient Current Similarity Measurement," Energies, MDPI, vol. 14(15), pages 1-19, August.
    2. Wenquan Shao & Jie Bai & Yuan Cheng & Zhihua Zhang & Ning Li, 2019. "Research on a Faulty Line Selection Method Based on the Zero-Sequence Disturbance Power of Resonant Grounded Distribution Networks," Energies, MDPI, vol. 12(5), pages 1-18, March.
    3. Veerapandiyan Veerasamy & Noor Izzri Abdul Wahab & Rajeswari Ramachandran & Muhammad Mansoor & Mariammal Thirumeni & Mohammad Lutfi Othman, 2018. "High Impedance Fault Detection in Medium Voltage Distribution Network Using Discrete Wavelet Transform and Adaptive Neuro-Fuzzy Inference System," Energies, MDPI, vol. 11(12), pages 1-24, November.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Bartosz Olejnik & Beata Zięba, 2022. "Improving the Efficiency of Earth Fault Detection by Fault Current Passage Indicators in Medium-Voltage Compensated Overhead Networks," Energies, MDPI, vol. 15(23), pages 1-19, November.
    2. Dumitru Toader & Maria Vintan & Claudiu Solea & Daniela Vesa & Marian Greconici, 2021. "Analysis of the Possibilities of Selective Detection of a Single Line-to-Ground Fault in a Medium Voltage Network with Isolated Neutral," Energies, MDPI, vol. 14(21), pages 1-19, October.
    3. Francinei L. Vieira & Pedro H. M. Santos & José M. Carvalho Filho & Roberto C. Leborgne & Marino P. Leite, 2019. "A Voltage-Based Approach for Series High Impedance Fault Detection and Location in Distribution Systems Using Smart Meters," Energies, MDPI, vol. 12(15), pages 1-16, August.
    4. Elhadi Aker & Mohammad Lutfi Othman & Veerapandiyan Veerasamy & Ishak bin Aris & Noor Izzri Abdul Wahab & Hashim Hizam, 2020. "Fault Detection and Classification of Shunt Compensated Transmission Line Using Discrete Wavelet Transform and Naive Bayes Classifier," Energies, MDPI, vol. 13(1), pages 1-24, January.
    5. Yih-Der Lee & Jheng-Lun Jiang & Yuan-Hsiang Ho & Wei-Chen Lin & Hsin-Ching Chih & Wei-Tzer Huang, 2020. "Neutral Current Reduction in Three-Phase Four-Wire Distribution Feeders by Optimal Phase Arrangement Based on a Full-Scale Net Load Model Derived from the FTU Data," Energies, MDPI, vol. 13(7), pages 1-20, April.
    6. Kewen Wei & Jing Zhang & Yu He & Gang Yao & Yikun Zhang, 2020. "Faulty Feeder Detection Method Based on VMD–FFT and Pearson Correlation Coefficient of Non-Power Frequency Component in Resonant Grounded Systems," Energies, MDPI, vol. 13(18), pages 1-19, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:2:p:471-:d:721507. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.