IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i13p4687-d848375.html
   My bibliography  Save this article

Thermal Comfort—Case Study in a Lightweight Passive House

Author

Listed:
  • Krzysztof Wąs

    (Department of Rural Building, Faculty of Environmental Engineering, University of Agriculture in Krakow, 30-059 Krakow, Poland)

  • Jan Radoń

    (Department of Rural Building, Faculty of Environmental Engineering, University of Agriculture in Krakow, 30-059 Krakow, Poland)

  • Agnieszka Sadłowska-Sałęga

    (Department of Rural Building, Faculty of Environmental Engineering, University of Agriculture in Krakow, 30-059 Krakow, Poland)

Abstract

Saving energy while maintaining a high-quality internal environment is an increasingly important scientific and technological challenge in the building sector. This paper presents the results from a long-term study on thermal comfort in a passive house situated in the south of Poland. The building was constructed in 2010 with the use of prefabricated, lightweight technology. The main energy source is a ground source heat pump which powers the floor heating and DHW. The building is also equipped with a mechanical ventilation system with heat recovery and a ground source heat exchanger. A lightweight building structure which has active systems with limited capabilities (especially for cooling) is a combination which increases the difficulty of maintaining a proper inner environmental condition. Extensive experimental investigations on hygrothermal performance and energy use have been carried out in the building for several years. The measurement results, such as inner air temperature and humidity, as well as the inner surface temperature of partitions, could be directly used to determine basic thermal comfort indicators, including PMV and PPD . Any missing data that has not been directly measured, such as the surface temperature of the windows, floors, and some of the other elements of the building envelope, have been calculated using WUFI ® PLUS software and validated with the available measurements. These results are not final; the full measurement of thermal comfort as an applied methodology did not consider human adaptation and assumed constant clothing insulation. Nevertheless, in general, the results show good thermal comfort conditions inside the building under research conditions. This was also confirmed via a survey of the inhabitants: 2 adults and 3 children.

Suggested Citation

  • Krzysztof Wąs & Jan Radoń & Agnieszka Sadłowska-Sałęga, 2022. "Thermal Comfort—Case Study in a Lightweight Passive House," Energies, MDPI, vol. 15(13), pages 1-21, June.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:13:p:4687-:d:848375
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/13/4687/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/13/4687/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Nikolaos Kampelis & Nikolaos Sifakis & Dionysia Kolokotsa & Konstantinos Gobakis & Konstantinos Kalaitzakis & Daniela Isidori & Cristina Cristalli, 2019. "HVAC Optimization Genetic Algorithm for Industrial Near-Zero-Energy Building Demand Response," Energies, MDPI, vol. 12(11), pages 1-23, June.
    2. Małgorzata Fedorczak-Cisak & Marcin Furtak & Jolanta Gintowt & Alicja Kowalska-Koczwara & Filip Pachla & Krzysztof Stypuła & Tadeusz Tatara, 2018. "Thermal and Vibration Comfort Analysis of a Nearly Zero-Energy Building in Poland," Sustainability, MDPI, vol. 10(10), pages 1-19, October.
    3. Piotr Michalak, 2021. "Selected Aspects of Indoor Climate in a Passive Office Building with a Thermally Activated Building System: A Case Study from Poland," Energies, MDPI, vol. 14(4), pages 1-22, February.
    4. Grzegorz Nawalany & Paweł Sokołowski, 2019. "Building–Soil Thermal Interaction: A Case Study," Energies, MDPI, vol. 12(15), pages 1-12, July.
    5. Ilaria Ballarini & Giovanna De Luca & Argun Paragamyan & Anna Pellegrino & Vincenzo Corrado, 2019. "Transformation of an Office Building into a Nearly Zero Energy Building (nZEB): Implications for Thermal and Visual Comfort and Energy Performance," Energies, MDPI, vol. 12(5), pages 1-18, March.
    6. Zhang, Sheng & Lin, Zhang, 2020. "Standard effective temperature based adaptive-rational thermal comfort model," Applied Energy, Elsevier, vol. 264(C).
    7. Xiaolong Xu & Guohui Feng & Dandan Chi & Ming Liu & Baoyue Dou, 2018. "Optimization of Performance Parameter Design and Energy Use Prediction for Nearly Zero Energy Buildings," Energies, MDPI, vol. 11(12), pages 1-23, November.
    8. Stephan, André & Crawford, Robert H. & de Myttenaere, Kristel, 2013. "A comprehensive assessment of the life cycle energy demand of passive houses," Applied Energy, Elsevier, vol. 112(C), pages 23-34.
    9. Janice Foster & Tim Sharpe & Anna Poston & Chris Morgan & Filbert Musau, 2016. "Scottish Passive House: Insights into Environmental Conditions in Monitored Passive Houses," Sustainability, MDPI, vol. 8(5), pages 1-24, April.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Krzysztof Wąs & Jan Radoń & Agnieszka Sadłowska-Sałęga, 2020. "Maintenance of Passive House Standard in the Light of Long-Term Study on Energy Use in a Prefabricated Lightweight Passive House in Central Europe," Energies, MDPI, vol. 13(11), pages 1-22, June.
    2. Przemysław Markiewicz-Zahorski & Joanna Rucińska & Małgorzata Fedorczak-Cisak & Michał Zielina, 2021. "Building Energy Performance Analysis after Changing Its Form of Use from an Office to a Residential Building," Energies, MDPI, vol. 14(3), pages 1-24, January.
    3. Fang Wang & Wen-Jia Yang & Wei-Feng Sun, 2020. "Heat Transfer and Energy Consumption of Passive House in a Severely Cold Area: Simulation Analyses," Energies, MDPI, vol. 13(3), pages 1-19, February.
    4. Simon Ravyts & Mauricio Dalla Vecchia & Giel Van den Broeck & Johan Driesen, 2019. "Review on Building-Integrated Photovoltaics Electrical System Requirements and Module-Integrated Converter Recommendations," Energies, MDPI, vol. 12(8), pages 1-21, April.
    5. Khencha Khadidja & Biara Ratiba Wided & Belmili Hocine, 2020. "Techno-economic study of BIPV in typical Sahara region in Algeria," Journal of Economic Development, Environment and People, Alliance of Central-Eastern European Universities, vol. 9(1), pages 27-57, September.
    6. Seif Khiati & Rafik Belarbi & Ammar Yahia, 2023. "Sustainable Buildings: A Choice, or a Must for Our Future?," Energies, MDPI, vol. 16(6), pages 1-5, March.
    7. Colclough, Shane & McGrath, Teresa, 2015. "Net energy analysis of a solar combi system with Seasonal Thermal Energy Store," Applied Energy, Elsevier, vol. 147(C), pages 611-616.
    8. Kittisak Lohwanitchai & Daranee Jareemit, 2021. "Modeling Energy Efficiency Performance and Cost-Benefit Analysis Achieving Net-Zero Energy Building Design: Case Studies of Three Representative Offices in Thailand," Sustainability, MDPI, vol. 13(9), pages 1-24, May.
    9. Sierra-Pérez, Jorge & Rodríguez-Soria, Beatriz & Boschmonart-Rives, Jesús & Gabarrell, Xavier, 2018. "Integrated life cycle assessment and thermodynamic simulation of a public building’s envelope renovation: Conventional vs. Passivhaus proposal," Applied Energy, Elsevier, vol. 212(C), pages 1510-1521.
    10. Grzegorz Nawalany & Paweł Sokołowski, 2020. "Improved Energy Management in an Intermittently Heated Building Using a Large Broiler House in Central Europe as an Example," Energies, MDPI, vol. 13(6), pages 1-12, March.
    11. Abd Alla, Sara & Bianco, Vincenzo & Tagliafico, Luca A. & Scarpa, Federico, 2020. "Life-cycle approach to the estimation of energy efficiency measures in the buildings sector," Applied Energy, Elsevier, vol. 264(C).
    12. Amir Faraji & Maria Rashidi & Fatemeh Rezaei & Payam Rahnamayiezekavat, 2023. "A Meta-Synthesis Review of Occupant Comfort Assessment in Buildings (2002–2022)," Sustainability, MDPI, vol. 15(5), pages 1-36, February.
    13. Bartosz Radomski & Tomasz Mróz, 2021. "The Methodology for Designing Residential Buildings with a Positive Energy Balance—Case Study," Energies, MDPI, vol. 14(16), pages 1-19, August.
    14. Hawks, M.A. & Cho, S., 2024. "Review and analysis of current solutions and trends for zero energy building (ZEB) thermal systems," Renewable and Sustainable Energy Reviews, Elsevier, vol. 189(PB).
    15. Marek Borowski & Klaudia Zwolińska & Marcin Czerwiński, 2022. "An Experimental Study of Thermal Comfort and Indoor Air Quality—A Case Study of a Hotel Building," Energies, MDPI, vol. 15(6), pages 1-18, March.
    16. Paweł Sokołowski & Grzegorz Nawalany & Małgorzata Michalik, 2022. "Analysis of the Impact of Flooring Material and Construction Solutions on Heat Exchange with the Ground in a Historic Wooden Building," Energies, MDPI, vol. 15(16), pages 1-17, August.
    17. Bartosz Radomski & Tomasz Mróz, 2021. "The Methodology for Designing Residential Buildings with a Positive Energy Balance—General Approach," Energies, MDPI, vol. 14(15), pages 1-16, August.
    18. Paweł Sokołowski & Grzegorz Nawalany & Tomasz Jakubowski & Ernest Popardowski & Vasyl Lopushniak & Atilgan Atilgan, 2022. "Numerical Analysis of Thermal Impact between the Cooling Facility and the Ground," Energies, MDPI, vol. 15(24), pages 1-16, December.
    19. ChungYeon Won & SangTae No & Qamar Alhadidi, 2019. "Factors Affecting Energy Performance of Large-Scale Office Buildings: Analysis of Benchmarking Data from New York City and Chicago," Energies, MDPI, vol. 12(24), pages 1-17, December.
    20. Camille Pajot & Nils Artiges & Benoit Delinchant & Simon Rouchier & Frédéric Wurtz & Yves Maréchal, 2019. "An Approach to Study District Thermal Flexibility Using Generative Modeling from Existing Data," Energies, MDPI, vol. 12(19), pages 1-22, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:13:p:4687-:d:848375. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.