IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i17p5403-d625758.html
   My bibliography  Save this article

Experimental Analysis of Temperature Influence on Waste Tire Pyrolysis

Author

Listed:
  • Zoran Čepić

    (Faculty of Technical Sciences, University of Novi Sad, 21000 Novi Sad, Serbia)

  • Višnja Mihajlović

    (Technical Faculty “Mihajlo Pupin”, University of Novi Sad, 23000 Zrenjanin, Serbia)

  • Slavko Đurić

    (Faculty of Transport and Traffic Engineering, University of East Sarajevo, 74000 Doboj, Bosnia and Herzegovina)

  • Milan Milotić

    (Faculty of Transport and Traffic Engineering, University of East Sarajevo, 74000 Doboj, Bosnia and Herzegovina)

  • Milena Stošić

    (Faculty of Technical Sciences, University of Novi Sad, 21000 Novi Sad, Serbia)

  • Borivoj Stepanov

    (Faculty of Technical Sciences, University of Novi Sad, 21000 Novi Sad, Serbia)

  • Milana Ilić Mićunović

    (Faculty of Technical Sciences, University of Novi Sad, 21000 Novi Sad, Serbia)

Abstract

Pyrolysis is an optimal thermochemical process for obtaining valuable products (char, oil, and gas) from waste tires. The preliminary research was done on the three groups of samples acquired by cutting the same waste tire of a passenger vehicle into cylindrical granules with a base diameter of 3, 7, and 11 mm. Each batch weighed 10 g. The heating rate was 14 °C/min, and the final pyrolysis temperature was 750 °C, with 90 s residence time. After the pyrolysis product yields were determined for all of the three sample groups, further research was performed only on 3 mm granules, with the same heating rate, but with altered final pyrolytic temperatures (400, 450, 500, 550, 600, 650, 700, and 750 °C). The results of this study show that thermochemical decomposition of the waste tire sample takes place in the temperature range of 200–500 °C, with three distinct phases of degradation. The highest yield of the pyrolytic oil was achieved at a temperature of 500 °C, but further heating of volatile matters reduced the oil yield, and simultaneously increased the yield of gas, due to the existence of secondary cracking reactions. The analysis of pyrolytic oil and char showed that these products can be used as fuel.

Suggested Citation

  • Zoran Čepić & Višnja Mihajlović & Slavko Đurić & Milan Milotić & Milena Stošić & Borivoj Stepanov & Milana Ilić Mićunović, 2021. "Experimental Analysis of Temperature Influence on Waste Tire Pyrolysis," Energies, MDPI, vol. 14(17), pages 1-11, August.
    • Handle: RePEc:gam:jeners:v:14:y:2021:i:17:p:5403-:d:625758
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/17/5403/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/14/17/5403/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Mohammad I. Jahirul & Farhad M. Hossain & Mohammad G. Rasul & Ashfaque Ahmed Chowdhury, 2021. "A Review on the Thermochemical Recycling of Waste Tyres to Oil for Automobile Engine Application," Energies, MDPI, vol. 14(13), pages 1-18, June.
    2. Grzegorz Maj, 2018. "Emission Factors and Energy Properties of Agro and Forest Biomass in Aspect of Sustainability of Energy Sector," Energies, MDPI, vol. 11(6), pages 1-12, June.
    3. Liu, Lulu & Cai, Guojun & Zhang, Jun & Liu, Xiaoyan & Liu, Kai, 2020. "Evaluation of engineering properties and environmental effect of recycled waste tire-sand/soil in geotechnical engineering: A compressive review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 126(C).
    4. Joanna Wnorowska & Szymon Ciukaj & Sylwester Kalisz, 2021. "Thermogravimetric Analysis of Solid Biofuels with Additive under Air Atmosphere," Energies, MDPI, vol. 14(8), pages 1-19, April.
    5. Amir Rowhani & Thomas J. Rainey, 2016. "Scrap Tyre Management Pathways and Their Use as a Fuel—A Review," Energies, MDPI, vol. 9(11), pages 1-26, October.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Hisham Afash & Bertug Ozarisoy & Hasim Altan & Cenk Budayan, 2023. "Recycling of Tire Waste Using Pyrolysis: An Environmental Perspective," Sustainability, MDPI, vol. 15(19), pages 1-21, September.
    2. Jaroslaw Krzywanski & Wojciech Nowak & Karol Sztekler, 2022. "Novel Combustion Techniques for Clean Energy," Energies, MDPI, vol. 15(13), pages 1-3, June.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zhang, Menghui & Qi, Yongfeng & Zhang, Wan & Wang, Meiting & Li, Jingyi & Lu, Yi & Zhang, Sheng & He, Jiazheng & Cao, Hao & Tao, Xuan & Xu, Hanlu & Zhang, Sheng, 2024. "A review on waste tires pyrolysis for energy and material recovery from the optimization perspective," Renewable and Sustainable Energy Reviews, Elsevier, vol. 199(C).
    2. Nives Jovičić & Alan Antonović & Ana Matin & Suzana Antolović & Sanja Kalambura & Tajana Krička, 2022. "Biomass Valorization of Walnut Shell for Liquefaction Efficiency," Energies, MDPI, vol. 15(2), pages 1-13, January.
    3. Gheorghe Lazaroiu & Lucian Mihaescu & Gabriel Negreanu & Constantin Pana & Ionel Pisa & Alexandru Cernat & Dana-Alexandra Ciupageanu, 2018. "Experimental Investigations of Innovative Biomass Energy Harnessing Solutions," Energies, MDPI, vol. 11(12), pages 1-18, December.
    4. Zhang, Jiehan & Wang, Xinkun & Chen, Zhaohui & Zhang, Xinyu & Yue, Junrong & Zhou, Ridong & Lai, Dengguo & Yu, Jian & Li, Jianling & Xu, Guangwen, 2024. "Regulation of volatile reactions through thermal/catalytic cracking during scrap tires pyrolysis for high-valued chemicals production," Energy, Elsevier, vol. 294(C).
    5. Galina Nyashina & Pavel Strizhak, 2018. "Impact of Forest Fuels on Gas Emissions in Coal Slurry Fuel Combustion," Energies, MDPI, vol. 11(9), pages 1-16, September.
    6. T. M. Indra Mahlia & I. M. Rizwanul Fattah, 2021. "Energy for Sustainable Future," Energies, MDPI, vol. 14(23), pages 1-2, November.
    7. Irina Glushankova & Aleksandr Ketov & Marina Krasnovskikh & Larisa Rudakova & Iakov Vaisman, 2019. "End of Life Tires as a Possible Source of Toxic Substances Emission in the Process of Combustion," Resources, MDPI, vol. 8(2), pages 1-10, June.
    8. Wang, Yangyang & Liu, Yangyang & Xu, Zaifeng & Yin, Kexin & Zhou, Yaru & Zhang, Jifu & Cui, Peizhe & Ma, Shinan & Wang, Yinglong & Zhu, Zhaoyou, 2024. "A review on renewable energy-based chemical engineering design and optimization," Renewable and Sustainable Energy Reviews, Elsevier, vol. 189(PB).
    9. Grzegorz Zając & Joanna Szyszlak-Bargłowicz & Wojciech Gołębiowski & Małgorzata Szczepanik, 2018. "Chemical Characteristics of Biomass Ashes," Energies, MDPI, vol. 11(11), pages 1-15, October.
    10. Alammar, Ahmed A. & Rezk, Ahmed & Alaswad, Abed & Fernando, Julia & Olabi, A.G. & Decker, Stephanie & Ruhumuliza, Joseph & Gasana, Quénan, 2022. "The technical, economic, and environmental feasibility of a bioheat-driven adsorption cooling system for food cold storing: A case study of Rwanda," Energy, Elsevier, vol. 258(C).
    11. Pedro Mora & Arturo Alarcón & Sandra Tercero & Bernardo Llamas, 2021. "Method to assess biomass in scrap tires: Spanish cement sector as a case study," Environment, Development and Sustainability: A Multidisciplinary Approach to the Theory and Practice of Sustainable Development, Springer, vol. 23(6), pages 8524-8541, June.
    12. Jerzy Jackowski & Marcin Żmuda & Marcin Wieczorek & Andrzej Zuska, 2021. "Quasi-Static Research of ATV/UTV Non-Pneumatic Tires," Energies, MDPI, vol. 14(20), pages 1-12, October.
    13. Pedro Mora & Arturo Alarcón & Laura Sánchez-Martín & Bernardo Llamas, 2021. "Biomass Content in Scrap Tires and Its Use as Sustainable Energy Resource: A CO 2 Mitigation Assessment," Sustainability, MDPI, vol. 13(6), pages 1-12, March.
    14. Shiqiao Yang & Ming Lei & Min Li & Chao Liu & Beichen Xue & Rui Xiao, 2022. "Comprehensive Estimation of Combustion Behavior and Thermochemical Structure Evolution of Four Typical Industrial Polymeric Wastes," Energies, MDPI, vol. 15(7), pages 1-22, March.
    15. Vinay Atgur & G. Manavendra & Nagaraj R. Banapurmath & Boggarapu Nageswar Rao & Ali A. Rajhi & T. M. Yunus Khan & Chandramouli Vadlamudi & Sanjay Krishnappa & Ashok M. Sajjan & R. Venkatesh, 2022. "Essence of Thermal Analysis to Assess Biodiesel Combustion Performance," Energies, MDPI, vol. 15(18), pages 1-23, September.
    16. Wang, Jun & Liu, Zhiming & Ding, Guangya & Fu, Hongtao & Cai, Guojun, 2021. "Watt-level road-compatible piezoelectric energy harvester for LED-induced lamp system," Energy, Elsevier, vol. 229(C).
    17. Grzegorz Maj & Agnieszka Najda & Kamila Klimek & Sebastian Balant, 2019. "Estimation of Energy and Emissions Properties of Waste from Various Species of Mint in the Herbal Products Industry," Energies, MDPI, vol. 13(1), pages 1-13, December.
    18. Garikai T. Marangwanda & Daniel M. Madyira & Patrick G. Ndungu & Chido H. Chihobo, 2021. "Combustion Characterisation of Bituminous Coal and Pinus Sawdust Blends by Use of Thermo-Gravimetric Analysis," Energies, MDPI, vol. 14(22), pages 1-19, November.
    19. Martínez, Juan Daniel, 2021. "An overview of the end-of-life tires status in some Latin American countries: Proposing pyrolysis for a circular economy," Renewable and Sustainable Energy Reviews, Elsevier, vol. 144(C).
    20. Nusrat H. Zerin & Mohammad G. Rasul & M. I. Jahirul & A.S.M. Sayem & R. Haque, 2023. "Electrochemical Application of Activated Carbon Derived from End-of-Life Tyres: A Technological Review," Sustainability, MDPI, vol. 16(1), pages 1-19, December.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:17:p:5403-:d:625758. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.