IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2020i1p94-d468772.html
   My bibliography  Save this article

Experimental Study and Conjugate Heat Transfer Simulation of Turbulent Flow in a 90° Curved Square Pipe

Author

Listed:
  • Guanming Guo

    (Graduate School of Engineering, Hiroshima University, Hiroshima 7390046, Japan)

  • Masaya Kamigaki

    (Graduate School of Engineering, Hiroshima University, Hiroshima 7390046, Japan)

  • Qiwei Zhang

    (Graduate School of Engineering, Hiroshima University, Hiroshima 7390046, Japan
    School of Mechanical Engineering, Yanshan University, Qinhuangdao 066000, China)

  • Yuuya Inoue

    (Graduate School of Engineering, Hiroshima University, Hiroshima 7390046, Japan)

  • Keiya Nishida

    (Graduate School of Advanced Science and Engineering, Hiroshima University, Hiroshima 7390046, Japan)

  • Hitoshi Hongou

    (Mazda Motor Corporation, Hiroshima 7308670, Japan)

  • Masanobu Koutoku

    (Mazda Motor Corporation, Hiroshima 7308670, Japan)

  • Ryo Yamamoto

    (Mazda Motor Corporation, Hiroshima 7308670, Japan)

  • Hieaki Yokohata

    (Mazda Motor Corporation, Hiroshima 7308670, Japan)

  • Shinji Sumi

    (Mazda Motor Corporation, Hiroshima 7308670, Japan)

  • Yoichi Ogata

    (Graduate School of Advanced Science and Engineering, Hiroshima University, Hiroshima 7390046, Japan)

Abstract

This paper discusses the turbulent flow and heat transfer from a uniform air flow with high temperature to the outside through a 90° curved square pipe. Both conjugate heat transfer (CHT) simulation and experiments of temperature field measurements at cross sections of the pipe are performed. A straight pipe is investigated and compared with the 90° curved pipe. The temperature of the air flow at the inlet of the pipe is set at 402 K, and the corresponding Reynolds number is approximately 6 × 10 4 . To obtain the spatial average temperature at each cross section, the temperature fields are measured along the streamwise of the pipes and in the circumferential direction using thermocouples at each cross section from the inlet to the outlet of both the straight and curved pipes. Furthermore, the simulation is performed for turbulent flow and heat transfer inside the pipe wall using the Re-normalization group (RNG) k-ε turbulence model and CHT method. Both the experimental and numerical results show that the curvature of the pipe result in a deviation and impingement in the high-temperature core and a separation between the wall and air, resulting in a secondary flow pattern of the temperature distribution.

Suggested Citation

  • Guanming Guo & Masaya Kamigaki & Qiwei Zhang & Yuuya Inoue & Keiya Nishida & Hitoshi Hongou & Masanobu Koutoku & Ryo Yamamoto & Hieaki Yokohata & Shinji Sumi & Yoichi Ogata, 2020. "Experimental Study and Conjugate Heat Transfer Simulation of Turbulent Flow in a 90° Curved Square Pipe," Energies, MDPI, vol. 14(1), pages 1-21, December.
  • Handle: RePEc:gam:jeners:v:14:y:2020:i:1:p:94-:d:468772
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/1/94/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/14/1/94/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Yan Wang & Quanlin Dong & Pengfei Wang, 2015. "Numerical Investigation on Fluid Flow in a 90-Degree Curved Pipe with Large Curvature Ratio," Mathematical Problems in Engineering, Hindawi, vol. 2015, pages 1-12, August.
    2. Naphon, Paisarn & Wongwises, Somchai, 2006. "A review of flow and heat transfer characteristics in curved tubes," Renewable and Sustainable Energy Reviews, Elsevier, vol. 10(5), pages 463-490, October.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Amani, E. & Nobari, M.R.H., 2011. "A numerical investigation of entropy generation in the entrance region of curved pipes at constant wall temperature," Energy, Elsevier, vol. 36(8), pages 4909-4918.
    2. Zhou, Chaohui & Ni, Long & Yao, Yang, 2018. "Heat transfer analysis of multi-row helically coiled tube heat exchangers for surface water-source heat pump," Energy, Elsevier, vol. 163(C), pages 1032-1049.
    3. Guanming Guo & Masaya Kamigaki & Yuuya Inoue & Keiya Nishida & Hitoshi Hongou & Masanobu Koutoku & Ryo Yamamoto & Hideaki Yokohata & Shinji Sumi & Yoichi Ogata, 2021. "Experimental Study and Conjugate Heat Transfer Simulation of Pulsating Flow in Straight and 90° Curved Square Pipes," Energies, MDPI, vol. 14(13), pages 1-20, July.
    4. Balaji, K. & Iniyan, S. & Goic, Ranko, 2018. "Thermal performance of solar water heater using velocity enhancer," Renewable Energy, Elsevier, vol. 115(C), pages 887-895.
    5. Khamis Mansour, M., 2013. "Thermal analysis of novel minichannel-based solar flat-plate collector," Energy, Elsevier, vol. 60(C), pages 333-343.
    6. Diaconu, Bogdan M. & Varga, Szabolcs & Oliveira, Armando C., 2010. "Experimental study of natural convection heat transfer in a microencapsulated phase change material slurry," Energy, Elsevier, vol. 35(6), pages 2688-2693.
    7. Huminic, Gabriela & Huminic, Angel, 2016. "Heat transfer and flow characteristics of conventional fluids and nanofluids in curved tubes: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 58(C), pages 1327-1347.
    8. Kumar, Rajneesh & Varun, & Kumar, Anoop, 2016. "Thermal and fluid dynamic characteristics of flow through triangular cross-sectional duct: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 61(C), pages 123-140.
    9. Yuki Kato & Kenmei Fujimoto & Guanming Guo & Mikimasa Kawaguchi & Masaya Kamigaki & Masanobu Koutoku & Hitoshi Hongou & Haruna Yanagida & Yoichi Ogata, 2023. "Heat Transfer Characteristics of Turbulent Flow in Double-90°-Bend Pipes," Energies, MDPI, vol. 16(21), pages 1-25, October.
    10. Jaisankar, S. & Radhakrishnan, T.K. & Sheeba, K.N., 2009. "Studies on heat transfer and friction factor characteristics of thermosyphon solar water heating system with helical twisted tapes," Energy, Elsevier, vol. 34(9), pages 1054-1064.
    11. Haiyan Qiang & Wanli Li & Junqi Xu & Yanran Wang, 2019. "Experimental test and numerical analysis for curvature ratios effect on the heat transfer and flow characteristics of a multi-layer winding hose," International Journal of Distributed Sensor Networks, , vol. 15(4), pages 15501477198, April.
    12. Jaisankar, S. & Ananth, J. & Thulasi, S. & Jayasuthakar, S.T. & Sheeba, K.N., 2011. "A comprehensive review on solar water heaters," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(6), pages 3045-3050, August.
    13. Miftah Altwieb & Rakesh Mishra & Aliyu M. Aliyu & Krzysztof J. Kubiak, 2022. "Heat Transfer Enhancement by Perforated and Louvred Fin Heat Exchangers," Energies, MDPI, vol. 15(2), pages 1-16, January.
    14. Liu, Xinxin & Xu, Xiaoxiao & Liu, Chao & Bai, Wanjin & Dang, Chaobin, 2018. "Heat transfer deterioration in helically coiled heat exchangers in trans-critical CO2 Rankine cycles," Energy, Elsevier, vol. 147(C), pages 1-14.
    15. Guo, Jiangfeng & Xu, Mingtian & Cai, Jun & Huai, Xiulan, 2011. "Viscous dissipation effect on entropy generation in curved square microchannels," Energy, Elsevier, vol. 36(8), pages 5416-5423.
    16. Diaconu, Bogdan M. & Varga, Szabolcs & Oliveira, Armando C., 2010. "Experimental assessment of heat storage properties and heat transfer characteristics of a phase change material slurry for air conditioning applications," Applied Energy, Elsevier, vol. 87(2), pages 620-628, February.
    17. Bahiraei, Farid & Saray, Rahim Khoshbakhti & Salehzadeh, Aidin, 2011. "Investigation of potential of improvement of helical coils based on avoidable and unavoidable exergy destruction concepts," Energy, Elsevier, vol. 36(5), pages 3113-3119.
    18. Delgado, M. & Lázaro, A. & Mazo, J. & Peñalosa, C. & Marín, J.M. & Zalba, B., 2017. "Experimental analysis of a coiled stirred tank containing a low cost PCM emulsion as a thermal energy storage system," Energy, Elsevier, vol. 138(C), pages 590-601.
    19. Konstantin Osintsev & Sergei Aliukov & Sulpan Kuskarbekova, 2021. "Development of Methodological Bases of the Processes of Steam Formation in Coil Type Boilers Using Solar Concentrators," Energies, MDPI, vol. 14(8), pages 1-22, April.
    20. Zhang, Shijie & Xu, Xiaoxiao & Liu, Chao & Dang, Chaobin, 2020. "A review on application and heat transfer enhancement of supercritical CO2 in low-grade heat conversion," Applied Energy, Elsevier, vol. 269(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2020:i:1:p:94-:d:468772. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.