IDEAS home Printed from https://ideas.repec.org/a/eee/rensus/v11y2007i6p1087-1116.html
   My bibliography  Save this article

Experimental and CFD investigation of an ICSSWH at various inclinations

Author

Listed:
  • Henderson, D.
  • Junaidi, H.
  • Muneer, T.
  • Grassie, T.
  • Currie, J.

Abstract

The integrated collector storage (ICS) is the type of solar water heater that has retained its existance for well over a century. The flat absorber plate ICS collector type is a relatively recent addition. Being effective, low cost and simple to manufacture, their importance has been further enhanced by the recent upsurge in efforts to effectively tap renewable energy resources. Having different inclinations based on latitude, the design of flat plate heaters can benefit from extensive amount of research on the topic of natural convection in inclined cavities. More than half-century of exploration on inclined cavities has witnessed added activity particularly in the last three decades. Despite this consistent research, efforts to apply the outcomes to the flat plate collectors have been few and collectors reported in the literature appear to be deficient in embedding the knowledge into the design parameters. For an ICS type heater, natural convection studies gain even more weight as the apparatus is functionally an assembly of two natural convection cavities: an air cavity (space between the absorber and cover plates) and a water cavity (water storage tank). An extensive review of previous studies on inclined cavities relevant to flat plate collectors has been complied and discussed. Experimental tests of the ICS heater have been conducted for controlled heat flux up to 400 W. The thermal performance of the heater is recorded experimentally at angles 0-60° from horizontal, in 15° intervals. CFD analysis is also carried out for the same and is found to be in good agreement with previous studies. It was found that for any given constant value of heat flux, the performance of the heater is a strong function of the angle of inclination. The optimum configuration of the heater for Edinburgh conditions (latitude 55°55'N) is also evaluated. The present study also covers the convective behavior inside the water tank, which has been neglected in the past. A step-by-step build-up approach is adopted to resolve water tank behavior as its treatment as a simple natural convention cavity is invalid. This article would serve as a design guide for developing heaters tailored for a specific geographical location.

Suggested Citation

  • Henderson, D. & Junaidi, H. & Muneer, T. & Grassie, T. & Currie, J., 2007. "Experimental and CFD investigation of an ICSSWH at various inclinations," Renewable and Sustainable Energy Reviews, Elsevier, vol. 11(6), pages 1087-1116, August.
    • Handle: RePEc:eee:rensus:v:11:y:2007:i:6:p:1087-1116
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S1364-0321(05)00122-X
    Download Restriction: Full text for ScienceDirect subscribers only
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Smyth, M. & Eames, P.C. & Norton, B., 2004. "Techno-economic appraisal of an integrated collector/storage solar water heater," Renewable Energy, Elsevier, vol. 29(9), pages 1503-1514.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Souliotis, Manolis & Papaefthimiou, Spiros & Caouris, Yiannis G. & Zacharopoulos, Aggelos & Quinlan, Patrick & Smyth, Mervyn, 2017. "Integrated collector storage solar water heater under partial vacuum," Energy, Elsevier, vol. 139(C), pages 991-1002.
    2. Missirlis, D. & Martinopoulos, G. & Tsilingiridis, G. & Yakinthos, K. & Kyriakis, N., 2014. "Investigation of the heat transfer behaviour of a polymer solar collector for different manifold configurations," Renewable Energy, Elsevier, vol. 68(C), pages 715-723.
    3. Martinopoulos, G. & Missirlis, D. & Tsilingiridis, G. & Yakinthos, K. & Kyriakis, N., 2010. "CFD modeling of a polymer solar collector," Renewable Energy, Elsevier, vol. 35(7), pages 1499-1508.
    4. Gertzos, K.P. & Caouris, Y.G. & Panidis, Th., 2010. "Optimal design and placement of serpentine heat exchangers for indirect heat withdrawal, inside flat plate integrated collector storage solar water heaters (ICSSWH)," Renewable Energy, Elsevier, vol. 35(8), pages 1741-1750.
    5. Garnier, C. & Currie, J. & Muneer, T., 2009. "Integrated collector storage solar water heater: Temperature stratification," Applied Energy, Elsevier, vol. 86(9), pages 1465-1469, September.
    6. Tagliafico, Luca A. & Scarpa, Federico & De Rosa, Mattia, 2014. "Dynamic thermal models and CFD analysis for flat-plate thermal solar collectors – A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 30(C), pages 526-537.
    7. Garnier, Celine & Muneer, Tariq & Currie, John, 2018. "Numerical and empirical evaluation of a novel building integrated collector storage solar water heater," Renewable Energy, Elsevier, vol. 126(C), pages 281-295.
    8. Cerón, J.F. & Pérez-García, J. & Solano, J.P. & García, A. & Herrero-Martín, R., 2015. "A coupled numerical model for tube-on-sheet flat-plate solar liquid collectors. Analysis and validation of the heat transfer mechanisms," Applied Energy, Elsevier, vol. 140(C), pages 275-287.
    9. Devanarayanan, K. & Kalidasa Murugavel, K., 2014. "Integrated collector storage solar water heater with compound parabolic concentrator – development and progress," Renewable and Sustainable Energy Reviews, Elsevier, vol. 39(C), pages 51-64.
    10. Azzolin, Marco & Mariani, Andrea & Moro, Lorenzo & Tolotto, Andrea & Toninelli, Paolo & Del Col, Davide, 2018. "Mathematical model of a thermosyphon integrated storage solar collector," Renewable Energy, Elsevier, vol. 128(PA), pages 400-415.
    11. Barone, G. & Buonomano, A. & Palmieri, V. & Palombo, A., 2022. "A prototypal high-vacuum integrated collector storage solar water heater: Experimentation, design, and optimization through a new in-house 3D dynamic simulation model," Energy, Elsevier, vol. 238(PC).
    12. Souliotis, M. & Chemisana, D. & Caouris, Y.G. & Tripanagnostopoulos, Y., 2013. "Experimental study of integrated collector storage solar water heaters," Renewable Energy, Elsevier, vol. 50(C), pages 1083-1094.
    13. Herrando, María & Ramos, Alba & Zabalza, Ignacio & Markides, Christos N., 2019. "A comprehensive assessment of alternative absorber-exchanger designs for hybrid PVT-water collectors," Applied Energy, Elsevier, vol. 235(C), pages 1583-1602.
    14. Abel Velasco & Sergi Jiménez García & Alfredo Guardo & Alfred Fontanals & Mònica Egusquiza, 2017. "Assessment of the Use of Venetian Blinds as Solar Thermal Collectors in Double Skin Facades in Mediterranean Climates," Energies, MDPI, vol. 10(11), pages 1-15, November.
    15. Herrando, María & Fantoni, Guillermo & Cubero, Ana & Simón-Allué, Raquel & Guedea, Isabel & Fueyo, Norberto, 2023. "Numerical analysis of the fluid flow and heat transfer of a hybrid PV-thermal collector and performance assessment," Renewable Energy, Elsevier, vol. 209(C), pages 122-132.
    16. Muneer, T. & Asif, M. & Cizmecioglu, Z. & Ozturk, H.K., 2008. "Prospects for solar water heating within Turkish textile industry," Renewable and Sustainable Energy Reviews, Elsevier, vol. 12(3), pages 807-823, April.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Chong, K.K. & Chay, K.G. & Chin, K.H., 2012. "Study of a solar water heater using stationary V-trough collector," Renewable Energy, Elsevier, vol. 39(1), pages 207-215.
    2. Farzan, Hadi & Ameri, Mehran & Mahmoudi, Mojtaba, 2023. "Thermal assessment of a new planar thermal diode integrated collector storage solar water heater in different partial vacuums: An experimental study," Renewable Energy, Elsevier, vol. 208(C), pages 119-129.
    3. Zou, Bin & Dong, Jiankai & Yao, Yang & Jiang, Yiqiang, 2016. "An experimental investigation on a small-sized parabolic trough solar collector for water heating in cold areas," Applied Energy, Elsevier, vol. 163(C), pages 396-407.
    4. Singh, Ramkishore & Lazarus, Ian J. & Souliotis, Manolis, 2016. "Recent developments in integrated collector storage (ICS) solar water heaters: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 54(C), pages 270-298.
    5. Yassen, Tadahmun A. & Mokhlif, Nassir D. & Eleiwi, Muhammad Asmail, 2019. "Performance investigation of an integrated solar water heater with corrugated absorber surface for domestic use," Renewable Energy, Elsevier, vol. 138(C), pages 852-860.
    6. Raisul Islam, M. & Sumathy, K. & Ullah Khan, Samee, 2013. "Solar water heating systems and their market trends," Renewable and Sustainable Energy Reviews, Elsevier, vol. 17(C), pages 1-25.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:rensus:v:11:y:2007:i:6:p:1087-1116. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/600126/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.