IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v34y2009i2p153-158.html
   My bibliography  Save this article

End-use energy analysis in the Malaysian industrial sector

Author

Listed:
  • Saidur, R.
  • Rahim, N.A.
  • Masjuki, H.H.
  • Mekhilef, S.
  • Ping, H.W.
  • Jamaluddin, M.F.

Abstract

The industrial sector is the second largest consumer of energy in Malaysia. In this energy audit, the most important parameters that have been collected are as follows: power rating and operation time of energy-consuming equipments/machineries; fossil fuel and other sources of energy use; production figure; peak and off-peak tariff usage behavior and power factor. These data were then analyzed to investigate the breakdown of end-use equipments/machineries energy use, the peak and off-peak usage behavior, power factor trend and specific energy use. The results of the energy audit showed that the highest electrical energy-using equipment was an electric motor followed by pumps and air compressors. The specific energy use has been estimated and compared with four Indonesian industries and it was found that three Malaysian industries were more efficient than the Indonesian counterpart. The study also found that about 64% electrical energy was used in peak hours by the industries and the average power factor ranged from 0.88 to 0.92. The study also estimated energy and bill savings using highly efficient electrical motors along with the payback period.

Suggested Citation

  • Saidur, R. & Rahim, N.A. & Masjuki, H.H. & Mekhilef, S. & Ping, H.W. & Jamaluddin, M.F., 2009. "End-use energy analysis in the Malaysian industrial sector," Energy, Elsevier, vol. 34(2), pages 153-158.
    • Handle: RePEc:eee:energy:v:34:y:2009:i:2:p:153-158
    DOI: 10.1016/j.energy.2008.11.004
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544208003137
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2008.11.004?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Fromme, JW, 1996. "Energy conservation in the Russian manufacturing industry. Potentials and obstacles," Energy Policy, Elsevier, vol. 24(3), pages 245-252, March.
    2. Garcia, Agenor Gomes Pinto & Szklo, Alexandre S. & Schaeffer, Roberto & McNeil, Michael A., 2007. "Energy-efficiency standards for electric motors in Brazilian industry," Energy Policy, Elsevier, vol. 35(6), pages 3424-3439, June.
    3. Ghaddar, Nesreen & Mezher, Toufic, 1999. "Modeling of current and future energyintensity and greenhouse gas emissions ofthe Lebanese industrial sector: assessmentof mitigation options," Applied Energy, Elsevier, vol. 63(1), pages 53-74, May.
    4. Zamzam Jaafar, Mohd. & Kheng, Wong Hwee & Kamaruddin, Norhayati, 2003. "Greener energy solutions for a sustainable future: issues and challenges for Malaysia," Energy Policy, Elsevier, vol. 31(11), pages 1061-1072, September.
    5. Thollander, Patrik & Karlsson, Magnus & Söderström, Mats & Creutz, Dan, 2005. "Reducing industrial energy costs through energy-efficiency measures in a liberalized European electricity market: case study of a Swedish iron foundry," Applied Energy, Elsevier, vol. 81(2), pages 115-126, June.
    6. Davoudpour, Hamid & Ahadi, Mohammad Sadegh, 2006. "The potential for greenhouse gases mitigation in household sector of Iran: cases of price reform/efficiency improvement and scenario for 2000-2010," Energy Policy, Elsevier, vol. 34(1), pages 40-49, January.
    7. Ozturk, Harun Kemal, 2005. "Energy usage and cost in textile industry: A case study for Turkey," Energy, Elsevier, vol. 30(13), pages 2424-2446.
    8. Chan, David Yih-Liang & Yang, Kuang-Han & Hsu, Chung-Hsuan & Chien, Min-Hsien & Hong, Gui-Bing, 2007. "Current situation of energy conservation in high energy-consuming industries in Taiwan," Energy Policy, Elsevier, vol. 35(1), pages 202-209, January.
    9. Mahlia, T.M.I, 2002. "Emissions from electricity generation in Malaysia," Renewable Energy, Elsevier, vol. 27(2), pages 293-300.
    10. Ibrik, Imad H. & Mahmoud, Marwan M., 2005. "Energy efficiency improvement procedures and audit results of electrical, thermal and solar applications in Palestine," Energy Policy, Elsevier, vol. 33(5), pages 651-658, March.
    11. Saidur, R. & Masjuki, H.H. & Jamaluddin, M.Y. & Ahmed, S., 2007. "Energy and associated greenhouse gas emissions from household appliances in Malaysia," Energy Policy, Elsevier, vol. 35(3), pages 1648-1657, March.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Saidur, R. & Rahim, N.A. & Ping, H.W. & Jahirul, M.I. & Mekhilef, S. & Masjuki, H.H., 2009. "Energy and emission analysis for industrial motors in Malaysia," Energy Policy, Elsevier, vol. 37(9), pages 3650-3658, September.
    2. Saidur, R., 2010. "A review on electrical motors energy use and energy savings," Renewable and Sustainable Energy Reviews, Elsevier, vol. 14(3), pages 877-898, April.
    3. Saidur, R. & Mekhilef, S., 2010. "Energy use, energy savings and emission analysis in the Malaysian rubber producing industries," Applied Energy, Elsevier, vol. 87(8), pages 2746-2758, August.
    4. Saidur, R. & Rahim, N.A. & Hasanuzzaman, M., 2010. "A review on compressed-air energy use and energy savings," Renewable and Sustainable Energy Reviews, Elsevier, vol. 14(4), pages 1135-1153, May.
    5. Hong, Gui-Bing & Ma, Chih-Ming & Chen, Hua-Wei & Chuang, Kai-Jen & Chang, Chang-Tang & Su, Te-Li, 2011. "Energy flow analysis in pulp and paper industry," Energy, Elsevier, vol. 36(5), pages 3063-3068.
    6. Hong, Gui-Bing & Su, Te-Li & Lee, Jenq-Daw & Hsu, Tsung-Chi & Chen, Hua-Wei, 2010. "Energy conservation potential in Taiwanese textile industry," Energy Policy, Elsevier, vol. 38(11), pages 7048-7053, November.
    7. Renato M. Lazzarin & Marco Noro, 2017. "Energy efficiency opportunities in the service plants of cast iron foundries in Italy," International Journal of Low-Carbon Technologies, Oxford University Press, vol. 12(2), pages 96-109.
    8. Aranda-Usón, Alfonso & Ferreira, Germán & Mainar-Toledo, M.D. & Scarpellini, Sabina & Llera Sastresa, Eva, 2012. "Energy consumption analysis of Spanish food and drink, textile, chemical and non-metallic mineral products sectors," Energy, Elsevier, vol. 42(1), pages 477-485.
    9. Thirugnanasambandam, M. & Hasanuzzaman, M. & Saidur, R. & Ali, M.B. & Rajakarunakaran, S. & Devaraj, D. & Rahim, N.A., 2011. "Analysis of electrical motors load factors and energy savings in an Indian cement industry," Energy, Elsevier, vol. 36(7), pages 4307-4314.
    10. Li, Yingjian & Li, Jiezhi & Qiu, Qi & Xu, Yafei, 2010. "Energy auditing and energy conservation potential for glass works," Applied Energy, Elsevier, vol. 87(8), pages 2438-2446, August.
    11. Chan, David Yih-Liang & Yang, Kuang-Han & Hsu, Chung-Hsuan & Chien, Min-Hsien & Hong, Gui-Bing, 2007. "Current situation of energy conservation in high energy-consuming industries in Taiwan," Energy Policy, Elsevier, vol. 35(1), pages 202-209, January.
    12. Habib Hussain Khan & Nahla Samargandi & Adeel Ahmed, 2021. "Economic development, energy consumption, and climate change: An empirical account from Malaysia," Natural Resources Forum, Blackwell Publishing, vol. 45(4), pages 397-423, November.
    13. Yih-Liang Chan, David & Yang, Kuang-Han & Lee, Jenq-Daw & Hong, Gui-Bing, 2010. "The case study of furnace use and energy conservation in iron and steel industry," Energy, Elsevier, vol. 35(4), pages 1665-1670.
    14. Saidur, R. & Mahlia, T.M.I., 2010. "Energy, economic and environmental benefits of using high-efficiency motors to replace standard motors for the Malaysian industries," Energy Policy, Elsevier, vol. 38(8), pages 4617-4625, August.
    15. Jing, Ong Li & Bashir, Mohammed J.K. & Kao, Jehng-Jung, 2015. "Solar radiation based benefit and cost evaluation for solar water heater expansion in Malaysia," Renewable and Sustainable Energy Reviews, Elsevier, vol. 48(C), pages 328-335.
    16. Prasad, Ravita D. & Bansal, R.C. & Raturi, Atul, 2014. "Multi-faceted energy planning: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 38(C), pages 686-699.
    17. Su, Te-Li & Chan, David Yih-Liang & Hung, Ching-Yuan & Hong, Gui-Bing, 2013. "The status of energy conservation in Taiwan's cement industry," Energy Policy, Elsevier, vol. 60(C), pages 481-486.
    18. Basri, Nor Afifah & Ramli, Ahmad Termizi & Aliyu, Abubakar Sadiq, 2015. "Malaysia energy strategy towards sustainability: A panoramic overview of the benefits and challenges," Renewable and Sustainable Energy Reviews, Elsevier, vol. 42(C), pages 1094-1105.
    19. Saidur, R. & Hasanuzzaman, M. & Yogeswaran, S. & Mohammed, H.A. & Hossain, M.S., 2010. "An end-use energy analysis in a Malaysian public hospital," Energy, Elsevier, vol. 35(12), pages 4780-4785.
    20. Habib, Mohammad Ahsan & Hasanuzzaman, M. & Hosenuzzaman, M. & Salman, Asif & Mehadi, Md Riyad, 2016. "Energy consumption, energy saving and emission reduction of a garment industrial building in Bangladesh," Energy, Elsevier, vol. 112(C), pages 91-100.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:34:y:2009:i:2:p:153-158. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.