IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v238y2022ipas0360544221019319.html
   My bibliography  Save this article

Numerical analysis of high temperature minichannel heat exchanger for recuperative microturbine system

Author

Listed:
  • Wajs, Jan
  • Kura, Tomasz
  • Mikielewicz, Dariusz
  • Fornalik-Wajs, Elzbieta
  • Mikielewicz, Jarosław

Abstract

Considering the development of energy sector, distributed small-scale power generation, e.g., gas micro-CHP, is attracting considerable interest. In such installations, the heat exchanger is one of the key components possessing a significant influence on overall performance. Most studies concentrate on units operating below 900 °C, which do not fulfil the requirements of gas micro-CHP. Therefore, there remains a challenge to design a compact heat exchanger with passive technologies of heat transfer enhancement. This work describes the implementation of the own construction of a plate minichannel heat exchanger for high-efficiency gas microturbine engines with an external combustion chamber, supplied with air at a temperature of about 1000 °C. The results of this study will greatly contribute to the increase of system efficiency. To understand transport phenomena occurring inside it, a numerical model of the entire heat exchanger was developed in OpenFOAM. Defined boundary conditions were based on experimental data used also to validate the numerical model. The pressure drop experimental and numerical results agreed within the 2%–14% range, while the heat rate ones – within the 1%–8% of the range. In addition, numerical analysis exhibited the limits of thermal and exergetic efficiency values possible to be obtained, when the boundary conditions are strongly controlled.

Suggested Citation

  • Wajs, Jan & Kura, Tomasz & Mikielewicz, Dariusz & Fornalik-Wajs, Elzbieta & Mikielewicz, Jarosław, 2022. "Numerical analysis of high temperature minichannel heat exchanger for recuperative microturbine system," Energy, Elsevier, vol. 238(PA).
    • Handle: RePEc:eee:energy:v:238:y:2022:i:pa:s0360544221019319
    DOI: 10.1016/j.energy.2021.121683
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544221019319
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2021.121683?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Zhang, Pan & Ma, Ting & Li, Wei-Dong & Ma, Guang-Yu & Wang, Qiu-Wang, 2018. "Design and optimization of a novel high temperature heat exchanger for waste heat cascade recovery from exhaust flue gases," Energy, Elsevier, vol. 160(C), pages 3-18.
    2. Krzysztof Kosowski & Karol Tucki & Marian Piwowarski & Robert Stępień & Olga Orynycz & Wojciech Włodarski & Anna Bączyk, 2019. "Thermodynamic Cycle Concepts for High-Efficiency Power Plans. Part A: Public Power Plants 60+," Sustainability, MDPI, vol. 11(2), pages 1-11, January.
    3. Krzysztof Kosowski & Karol Tucki & Marian Piwowarski & Robert Stępień & Olga Orynycz & Wojciech Włodarski, 2019. "Thermodynamic Cycle Concepts for High-Efficiency Power Plants. Part B: Prosumer and Distributed Power Industry," Sustainability, MDPI, vol. 11(9), pages 1-13, May.
    4. Wajs, Jan & Mikielewicz, Dariusz & Jakubowska, Blanka, 2018. "Performance of the domestic micro ORC equipped with the shell-and-tube condenser with minichannels," Energy, Elsevier, vol. 157(C), pages 853-861.
    5. Dariusz Mikielewicz & Krzysztof Kosowski & Karol Tucki & Marian Piwowarski & Robert Stępień & Olga Orynycz & Wojciech Włodarski, 2019. "Gas Turbine Cycle with External Combustion Chamber for Prosumer and Distributed Energy Systems," Energies, MDPI, vol. 12(18), pages 1-19, September.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Li, Mingqiang & Ngwaka, Ugochukwu & Moeini Korbekandi, Ramin & Baker, Nick & Wu, Dawei & Tsolakis, Athanasios, 2023. "A closed-loop linear engine generator using inert gases: A performance and exergy study," Energy, Elsevier, vol. 281(C).
    2. Magdalena Piasecka & Artur Piasecki & Norbert Dadas, 2022. "Experimental Study and CFD Modeling of Fluid Flow and Heat Transfer Characteristics in a Mini-Channel Heat Sink Using Simcenter STAR-CCM+ Software," Energies, MDPI, vol. 15(2), pages 1-20, January.
    3. Daniarta, Sindu & Imre, Attila R. & Kolasiński, Piotr, 2022. "Thermodynamic efficiency of subcritical and transcritical power cycles utilizing selected ACZ working fluids," Energy, Elsevier, vol. 254(PA).
    4. Močnik, Urban & Čikić, Ante & Muhič, Simon, 2024. "Numerical and experimental analysis of fluid flow and flow visualization at low Reynolds numbers in a dimple pattern plate heat exchanger," Energy, Elsevier, vol. 288(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Marian Piwowarski & Krzysztof Kosowski, 2020. "Advanced Turbine Cycles with Organic Media," Energies, MDPI, vol. 13(6), pages 1-11, March.
    2. Jan Wajs & Michał Bajor & Dariusz Mikielewicz, 2019. "Thermal-Hydraulic Studies on the Shell-and-Tube Heat Exchanger with Minijets," Energies, MDPI, vol. 12(17), pages 1-12, August.
    3. Włodarski, Wojciech, 2019. "A model development and experimental verification for a vapour microturbine with a permanent magnet synchronous generator," Applied Energy, Elsevier, vol. 252(C), pages 1-1.
    4. Karol Tucki & Olga Orynycz & Remigiusz Mruk & Antoni Świć & Katarzyna Botwińska, 2019. "Modeling of Biofuel’s Emissivity for Fuel Choice Management," Sustainability, MDPI, vol. 11(23), pages 1-22, December.
    5. Olga Orynycz & Karol Tucki & Miron Prystasz, 2020. "Implementation of Lean Management as a Tool for Decrease of Energy Consumption and CO 2 Emissions in the Fast Food Restaurant," Energies, MDPI, vol. 13(5), pages 1-26, March.
    6. Marcin Jamróz & Marian Piwowarski & Paweł Ziemiański & Gabriel Pawlak, 2021. "Technical and Economic Analysis of the Supercritical Combined Gas-Steam Cycle," Energies, MDPI, vol. 14(11), pages 1-21, May.
    7. Krzysztof Kosowski & Marian Piwowarski, 2020. "Subcritical Thermodynamic Cycles with Organic Medium and Isothermal Expansion," Energies, MDPI, vol. 13(17), pages 1-12, August.
    8. Karol Tucki & Olga Orynycz & Mateusz Mitoraj-Wojtanek, 2020. "Perspectives for Mitigation of CO 2 Emission due to Development of Electromobility in Several Countries," Energies, MDPI, vol. 13(16), pages 1-24, August.
    9. Andrii Radchenko & Eugeniy Trushliakov & Krzysztof Kosowski & Dariusz Mikielewicz & Mykola Radchenko, 2020. "Innovative Turbine Intake Air Cooling Systems and Their Rational Designing," Energies, MDPI, vol. 13(23), pages 1-22, November.
    10. Karol Tucki & Olga Orynycz & Antoni Świć & Mateusz Mitoraj-Wojtanek, 2019. "The Development of Electromobility in Poland and EU States as a Tool for Management of CO 2 Emissions," Energies, MDPI, vol. 12(15), pages 1-22, July.
    11. Dariusz Mikielewicz & Krzysztof Kosowski & Karol Tucki & Marian Piwowarski & Robert Stępień & Olga Orynycz & Wojciech Włodarski, 2019. "Influence of Different Biofuels on the Efficiency of Gas Turbine Cycles for Prosumer and Distributed Energy Power Plants," Energies, MDPI, vol. 12(16), pages 1-21, August.
    12. Krzysztof Kosowski & Karol Tucki & Marian Piwowarski & Robert Stępień & Olga Orynycz & Wojciech Włodarski, 2019. "Thermodynamic Cycle Concepts for High-Efficiency Power Plants. Part B: Prosumer and Distributed Power Industry," Sustainability, MDPI, vol. 11(9), pages 1-13, May.
    13. Karol Tucki & Olga Orynycz & Andrzej Wasiak & Antoni Świć & Joanna Wichłacz, 2019. "The Impact of Fuel Type on the Output Parameters of a New Biofuel Burner," Energies, MDPI, vol. 12(7), pages 1-12, April.
    14. Karol Tucki & Remigiusz Mruk & Olga Orynycz & Andrzej Wasiak & Antoni Świć, 2019. "Thermodynamic Fundamentals for Fuel Production Management," Sustainability, MDPI, vol. 11(16), pages 1-19, August.
    15. Zhang, Jianan & Qin, Kan & Li, Daijin & Luo, Kai & Dang, Jianjun, 2020. "Potential of Organic Rankine Cycles for Unmanned Underwater Vehicles," Energy, Elsevier, vol. 192(C).
    16. Miguel Castro Oliveira & Muriel Iten & Pedro L. Cruz & Helena Monteiro, 2020. "Review on Energy Efficiency Progresses, Technologies and Strategies in the Ceramic Sector Focusing on Waste Heat Recovery," Energies, MDPI, vol. 13(22), pages 1-24, November.
    17. Andrii Radchenko & Mykola Radchenko & Hanna Koshlak & Roman Radchenko & Serhiy Forduy, 2022. "Enhancing the Efficiency of Integrated Energy Systems by the Redistribution of Heat Based on Monitoring Data," Energies, MDPI, vol. 15(22), pages 1-18, November.
    18. Krzysztof Sornek, 2020. "Prototypical Biomass-Fired Micro-Cogeneration Systems—Energy and Ecological Analysis," Energies, MDPI, vol. 13(15), pages 1-16, July.
    19. Marcin Dębowski & Izabela Świca & Joanna Kazimierowicz & Marcin Zieliński, 2022. "Large Scale Microalgae Biofuel Technology—Development Perspectives in Light of the Barriers and Limitations," Energies, MDPI, vol. 16(1), pages 1-23, December.
    20. Pei Lu & Zheng Liang & Xianglong Luo & Yangkai Xia & Jin Wang & Kaihuang Chen & Yingzong Liang & Jianyong Chen & Zhi Yang & Jiacheng He & Ying Chen, 2023. "Design and Optimization of Organic Rankine Cycle Based on Heat Transfer Enhancement and Novel Heat Exchanger: A Review," Energies, MDPI, vol. 16(3), pages 1-34, January.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:238:y:2022:i:pa:s0360544221019319. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.